• KIEE International Transactions on Power Engineering
• /
• v.3A no.4
• /
• pp.191-197
• /
• 2003

Accurate detection and classification of faults on transmission lines is vitally important. In this respect, many different types of faults occur, such as inter alia low impedance faults (LIF) and high impedance faults (HIF). The latter in particular pose difficulties for the commonly employed conventional overcurrent and distance relays, and if undetected, can cause damage to expensive equipment, threaten life and cause fire hazards. Although HIFs are far less common than LIFs, it is imperative that any protection device should be able to satisfactorily deal with both HIFs and LIFs. Because of the randomness and asymmetric characteristics of HIFs, their modeling is difficult and numerous papers relating to various HIF models have been published. In this paper, the model of HIFs in transmission lines is accomplished using the characteristics of a ZnO arrester, which is then implemented within the overall transmission system model based on the electromagnetic transients program (EMTP). This paper proposes an algorithm for fault detection and classification for both LIFs and HIFs using Adaptive Network-based Fuzzy Inference System (ANFIS). The inputs into ANFIS are current signals only based on Root-Mean-Square (RMS) values of 3-phase currents and zero sequence current. The performance of the proposed algorithm is tested on a typical 154 kV Korean transmission line system under various fault conditions. Test results demonstrate that the ANFIS can detect and classify faults including LIFs and HIFs accurately within half a cycle.

• Proceedings of the IEEK Conference
• /
• 2000.06d
• /
• pp.198-201
• /
• 2000

We propose a method for analyzing the document structure. This method consists of two processes, segmentation and classification. The segmentation first divides a low resolution image, and then finely splits the original document image using projection profiles. The classification deterimines each segmented region as text, line, table or image. An experiment with 238 documents images shows that the segmentation accuracy is 99.1% and the classification accuracy is 97.3%.

• Smart Structures and Systems
• /
• v.25 no.2
• /
• pp.255-264
• /
• 2020

This paper deals with a defect classification technique that considers the structural characteristics of a refrigerant compressor. First, the pressure pulsation of the refrigerant flowing in the suction pipe of a normal compressor was measured at the same time as the acceleration of the shell surface, and then the transfer function between the two signals was estimated. Next, the frequency-weighted acceleration signals of the defect classification target compressors were generated using the estimated transfer function. The estimation of the variance of the transfer function is presented to formulate the frequency-weighted acceleration signals. The estimated frequency-weighted accelerations were applied to defect classification using frequency-domain features. Experiments were performed using commercial compressors to verify the technique. The results confirmed that it is possible to perform an effective defect classification of the refrigerant compressor by the shell surface acceleration of the compressor. The proposed method could make it possible to improve the total inspection performance for compressors in a mass-production line.

• Journal of the Korea Institute of Military Science and Technology
• /
• v.3 no.1
• /
• pp.76-84
• /
• 2000

As first step of any acoustic defence system, a attacking target warning system needs to be extremely reliable. This means the system must ensure a high probability of target classification together with a very low false alarm rate. In this paper, a algorithms for underwater target automatic classification is available for use in the passive sonar will be presented. In first, we will describe the precise automatic extraction of frequency lines for the detection of acoustic signatures. Also, a neural network and fuzzy based algorithms for target classification will be described. Thus the performances of these algorithms are very good with a high probability of classification.

• Journal of Information Technology Services
• /
• v.2 no.2
• /
• pp.87-95
• /
• 2003

With the increasing proliferation of World Wide Web, electronic mail systems have become very widely used communication tools. Researches on e-mail classification have been very important in that e-mail classification system is a major engine for e-mail response management systems which mine unstructured e-mail messages and automatically categorize them. in this research we develop e-mail classifiers for e-mail Response Management Systems (ERMS) using naive bayesian learning and centroid-based classification. We analyze which method performs better under which conditions, comparing classification accuracies which may depend on the structure, the size of training data set and number of classes, using the different data set of an on-line shopping mall and a credit card company. The developed e-mail classifiers have been successfully implemented in practice. The experimental results show that naive bayesian learning performs better, while centroid-based classification is more robust in terms of classification accuracy.

• Archives of Plastic Surgery
• /
• v.35 no.5
• /
• pp.581-588
• /
• 2008

Purpose: It is generally accepted that anatomical structures of the soft tissue in Asian faces are quite different from those in Caucasian. It is presumed that these differences are due to collagen rich thick dermis and durable superficial musculo-apponeurotic system (SMAS) in Asian. We classified the aging lower eyelids and reviewed the operative procedures according to the types of aging lower eyelids in Asian. Methods: We compared preoperative and postoperative photos of 117 patients over 30 years of age, who underwent lower blepharoplasty at the Kyunghee Medical Center from January 2001 to April 2006. We classified the patients based on the degree of skin laxity, presence of nasojugal groove and malar bag, the extent of aging process. We also reviewed the operative procedures according to each type of classification. Results: We classified our patients into four types as following. Type I patients showed minimal skin-muscle excess confined to lower eyelids regardless of the facial line. For these patients, we performed only transcutaneous or transconjunctival blepharoplasty. In type II patients, nasojugal grooves were shown and skin- muscle laxity was limited to the medial side of imaginary vertical line at lateral margin of pupil. In these cases, we performed free fat graft or fat repositioning on nasojugal groove or fat removal and septal duplication confined to medial side. Type III patients displayed more advanced medial bulging and remarkable laxity over the lateral side, the same operation methods as those of type II were applied at the lateral side of the line. Type IV patients demonstrated extensive midfacial aging changes including malar bags and underwent superficial subciliary cheek lift. Conclusion: The lower eyelid aging of Asian is different from those of Caucasian. We think that our classification is useful in selection of appropriate operative procedure to address specific problems for Asian patients.

• Journal of Korean Society of Transportation
• /
• v.27 no.4
• /
• pp.55-61
• /
• 2009

In order to observe the impact of a type of vehicles for traffic flows and pavement, vehicle classifications is conducted. Korean Ministry of Land, Transport and Maritime Affairs provides 12-type vehicle classifications on National expressways, National highways, and Provincial roads. Current AVC (Automatic Vehicle Classification) devices decide vehicle types comparing measurements of vehicle lengths, wheelbases, overhangs etc. to a reference table including those of all types of models. This study developed an algorithm for macroscopic vehicle classification which is less sensitive to tuning sensors and updating the reference table. For those characteristics, trend lines in vehicle lengths and wheelbases are employed. To assess the algorithm developed, vehicle lengths and wheelbases were collected from an AVC device. In this experiment, this algorithm showed the accuracy of 88.2 % compared to true values obtained from video replaying. Our efforts in this study are expected to contribute to developing devices for macroscopic vehicle classification.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2008.04c
• /
• pp.111-114
• /
• 2008

The paper considers the relation between on-line monitoring and diagnostics on the one hand and high-voltage (HV) withstand and partial discharge (PD) on-site testing on the other. HV testing supplies the basic data (fingerprints) for diagnostics. In case of warnings by on-line diagnostic systems, off-line withstand and PD testing delivers the best possible information about defects and enables the classification of the risk. Because alternating voltage (AC) is the most important test voltage, the AC generation on site is considered. Frequency tuned resonant (ACRF) test systems are best adapted to on-site conditions. They can be simply combined with PD measuring equipment. The available ACRF test systems and their application to electric power equipment -from cable systems to power transformers - is described.

• East Asian mathematical journal
• /
• v.37 no.4
• /
• pp.355-379
• /
• 2021

In this article, we investigated plane figures introduced in elementary school mathematics in the perspective of traditional classification, and also analyzed plane figures focused on the invariance of plane figures out of traditional classification. In the view of traditional classification, how to treat trapezoids was a key argument. In the current mathematics curriculum of the elementary school mathematics, the concept of sliding, flipping, and turning are introduced as part of development activities of spatial sense, but it is rare to apply them directly to figures. For example, how are squares and rectangles different in terms of symmetry? One of the main purposes of geometry learning is the classification of figures. Thus, the activity of classifying plane figures from a symmetrical point of view has sufficiently educational significance from Klein's point of view.

• The korean journal of orthodontics
• /
• v.22 no.4 s.39
• /
• pp.881-920
• /
• 1992

This study was designed to assess profile preferences among Korean youths in the year 1992. Facial esthetics was evaluated by means of silhouette profiles, eliminating the influence of a number of aspects that may affect judgment when normal lateral photographs are used. The main points of preference to be clarified here are as follows. First, on facial convexity, Second, on nasion depth, Third, on mentolabial sulcus depth, Fourth, on the position of upper and lower lips, Fifth, on facial type according to Angle's classification of malocclusion, Sixth, on Song's tangents. The 54 subjects printed in questionnaire as black and white silhouettes were selected from 300 tracings from cephalometric radiographs of people whose age ranging from 11 to 20 years. Photographs of six female subjects were retouched by computer graphic software and printed in color and black/white photographs which were used for adaptation of eyes of participants in selecting profiles in silhouette. They constitute 2 questions. The 54 subjects were grouped as 22 questions, each of them composed of 6 subjects, according to the aspects to be clarified. Twenty four questions in total were asked to assess profile preferences. For the assessment, the profile line, the facial esthetic triangle, Song's tangents, and Angle's classification of malocclusion were introduced. The profile line is composed of 11 component points which are Trichion, Glabella, Nasion, Pronasale, Subnasale, Labrale superius, Stomion, Labrale inferius, Supramentale, Pogonion, and Gnathion. The facial esthetic triangle is composed of 3 tangents: A-tangent which is the tangent of dorsum of nose, B-tangent which is the line passing through Sn and Ls, and C-tangent which is drawn on the turning point of the curve which lies between mentolabial sulcus (Sm) and pogonion (Pg). Angle's classification has 3 types of malocclusion which are Class I, Class II, and Class III. Class II malocclusion is subdivided into Division 1 and Division 2. The participants of the survey were composed of 861 college students (448 male students, 413 female students) whose majors grouped as Fine Arts. Liberal Arts, and Natural Sciences, and whose mean age 21.8 years. The statistics program SPSS/PC + of SPSS Inc. was used to analyze answers of participants. Crosstabulation, Chi-square test, and Kendall test were done. The conclusions are as follows: First, Korean youths have a tendency to prefer the slightly convex face to the flat or concave face. Second, they prefer a moderately deep nasion. Third, they prefer a moderately deep mentolabial sulcus. Fourth, they prefer the position of lips which are near to Ricketts' E-line. The position of the upper lip which is slightly posterior to E-line is preferred. The upper lip which lies too far anterior or posterior to the lower lip is not perferred. Fifth, they prefer most, according to Angle's Classification of Malocclusion, Class I facial profile which has a slight inclination to Class II division 2. The order of preference is Class I, Class II division 2, Class III, and Class II division 1. Sixth, they prefer the type 2 and 3 of Song's tangents. The facial profile within which A-and B-tangent meet is preferred. The facial profile which has Cotangent that .meets with A-tangent slightly posterior to the crossing point of A-and B-tangent or that parallels with B-tangent is preferred.