• Journal of the Korean Institute of Telematics and Electronics A
• /
• v.31A no.8
• /
• pp.16-25
• /
• 1994

The prediction of crosstalk in one of important problems in estimating the EMC of a system for high speed digital signal transmission. Crosstalk curves are shown in terms of characteristic impedance of lines spacing between lines and rise time of pulse by using general multiple coupled transmission line equation and harmonic-balance method. The coupled symmetrical two-line on dielectric material epoxy-glass FR 4(${\varepsilon}_r$), is fabricated to measure crosstalk occuring at the near end and far end of the passive line. The inter-line is inserted to reduce crosstalk between two microstrip lines. The simulation results and the measurement results are shown and found to be very close.

• Journal of Korea Society of Industrial Information Systems
• /
• v.15 no.3
• /
• pp.59-65
• /
• 2010

This paper proposes a modified heuristic mixed model assembly line (MMAL) balancing algorithm that provides consistent station assignments on a model by model basis as well as on a station by station. Basically, some of single model line balancing techniques are modified and incorporated to be fit into the MMAL. The proposed algorithm is based on N.T. Thomopoulos' [8] method and supplemented with several well proven single model line balancing techniques proposed in the literature until recently. Hoffman's precedence matrix [2] is used to indicate the ordering relations among tasks. Arcus' Rule IX [1] is applied to generate rapidly a fairly large number of feasible solutions. Consequently, this proposed algorithm reduces the fluctuations in operation times among the models as well as the stations and the balance delays. A numerical example shows that the proposed algorithm can provide a good feasible solution in a relatively short time and generate relatively better solutions comparing to other three existing methods.

• Journal of Power Electronics
• /
• v.12 no.1
• /
• pp.88-97
• /
• 2012

This paper presents a method for the digital control of a high power factor AC/DC converter employing the power balance control technique to achieve a fast response of the output voltage control. To avoid the effects of an output voltage ripple in the voltage control loop, the average output voltage is sampled and used as a feedback signal for the output voltage controller. The proposed control technique was verified by simulations using MATLAB/Simulink and its implementation was realized by a dsPIC30F4011 digital signal processor to control a CUK topology AC/DC converter with a 48V output voltage and a 250 W output power. The experimental results agree with the simulation results. The proposed control technique achieves a fast transient response with a lower line current distortion than is achieved when using a conventional proportional-integral controller and the power balance control technique with the conventional sampling method.

• Journal of The Korean Society of Agricultural Engineers
• /
• v.54 no.1
• /
• pp.93-97
• /
• 2012

Agricultural water reservoirs upstream of the intake on the basis of the intaking water volume is being made. Therefore, the supply capacity of reservoirs are not considered when the water balance analysis, storm water reservoirs are based on agriculture and further secured by the reservoir water is not used to using natural river water analysis. To overcome these problems can supply reservoirs are available to permit analysis of how much the quantity of water balance analysis, it should be reflected in the line to help. In this study, the natural daily flow data and apply the dimensions of the reservoir, and for more than 30 years of the long-term water balance analysis conducted by Date Youngsan river basin can supply reservoirs are large quantity of permits available is presented.

• Proceedings of the KIEE Conference
• /
• 2006.07a
• /
• pp.274-275
• /
• 2006

The IEEE std 738 and Cigre Electra documents are well known as the standard of calculating the ampacity of overhead conductors. Although these two standards use the same basic heat balance concept, they use different applicable methods to calculate ampacity ratings. This paper examines the concept of basic heat balance equation and the differences of each term of basic heat balance equation.

• Journal of Advanced Marine Engineering and Technology
• /
• v.22 no.6
• /
• pp.854-861
• /
• 1998

The demand of LNG as a cheap and clean energy which does not cause an environmental problem has sharply been increased in Korea. In general LNG is stored in a cargo tank specially designed as a liquid state below $-162^{\circ}C$. The main engine of a LNG carrier is generally a steam boiler because LNG is a highly flammable fluid with the possibility of explosion. The main engine of a cargo ship has to be capable of the propulsion load and various auxiliary loads for the safe navigation since it is the primary energy source. Therefore the evaluation of a main boiler's energy capacity is a key design point in the planning of LNG carrier's construction. This research is to develop the computational program for the analysis of steam boiler Heat balance for LNG carrier.

• Proceedings of the Korean Institute of IIIuminating and Electrical Installation Engineers Conference
• /
• 2007.05a
• /
• pp.33-38
• /
• 2007

This paper presents a experimental evidence of the generation of the earth potential and communication line noise from the electric railway. There is a critical measurement err in case of measuring the electrical power induced noise voltage and degree of cable balance in the field of earth potential generated. As a results, it has been found that the conventional cable has more noise immunity than shielded cable near the railway where the earth current flows through the sheath layer.

• ETRI Journal
• /
• v.6 no.4
• /
• pp.41-44
• /
• 1984

디지틀 가입자 교환기 및 가입자 장치의 Subscriber, Line Circuit(SLC)에서는 서비스의 질 및 가격의 저렴화 추구에 따라 디지털 신호처리(DSP) 기술의 응용을 위한 연구가 크게 활성화되고 있다. 본 연구에서는 기존 SLC에서의 CODEC과 필터 기능, 2선 임피던스 정합 및 transhybrid balance기능을 DSP의 programmability 및 flexibility를 최대로 활용, 디지틀 필터에 의해 실현할 수 있도록 그 구성을 시도하였다.

• Journal of Korea Game Society
• /
• v.15 no.4
• /
• pp.49-58
• /
• 2015

Due to the improving mobile environments, we can play RPG in not only computer online field but also mobile field. It is difference from hardware environment between them so that mobile RPG has been changed and modified to play in mobile environment except RPG's frame and basic element. This Study has investigated the model to evaluate the balance of battle that is based on the RPG. Although there is an assessment model studied with a focus on the MMORPG, It is difficult to apply to the entire balance in RPG especially mobile RPG. Former model has used only basic element because there were so many kinds of variables such as user's controls, other players and objects in game. The reason why that model just gave a guide line about battle balance. In this paper, the new assessment model to include the balance factors such as BUFF, NURF and PASSIVE could be possible for applying the balance of mobile RPG on recent trends. As a result, the new model can measure numerical calculations compared to the previous model.

• Wind and Structures
• /
• v.8 no.2
• /
• pp.89-106
• /
• 2005

For estimating the vortex excited vibrations of overhead transmission lines, the Energy Balance Principle (EBP) is well established for spans damped near the ends. Although it involves radical simplifications, the method is known to give useful estimates of the maximum vibration levels. For very long spans, there often is the need for a large number of in-span fittings, such as in-span Stockbridge dampers, aircraft warning spheres etc. This adds complexity to the problem and makes the energy balance principle in its original form unsuitable. In this paper, a modified version of EBP is described taking into account in-span damping and in particular also aircraft warning spheres. In the first step the complex transcendental eigenvalue problem is solved for the conductor with in-span fittings. With the thus determined complex eigenvalues and eigenfunctions a modified energy balance principle is then used for scaling the amplitudes of vibrations at each resonance frequency. Bending strains are then estimated at the critical points of the conductor. The approach has been used by the authors for studying the influence of in-span Stockbridge dampers and aircraft warning spheres; and for optimizing their positions in the span. The modeling of the aircraft warning sphere is also described in some detail.