• Environmental Engineering Research
• /
• 제14권4호
• /
• pp.220-225
• /
• 2009

The water quality in eutrophic lakes is affected by serious problems, such as abnormal increasing of Cyanobacteria. The purpose of this study was to investigate the possibility of a modified flotation system using a hybrid technique formed by chemical compounds and an electrostatic bridge. Therefore, experiments using the hybrid technique were performed to measure the zeta potential value on the phytoplankton surface and the removal efficiencies of phytoplankton, ammonia nitrogen, nitrate nitrogen and phosphoric acid. The results were as follows: Firstly, the zeta potential of M.aeruginosa was observed to approach charge neutralization due to adhesion of magnesium hydroxide precipitate on the phytoplankton surface in the pH range 10.5 to 11. Secondly, the concentration of chlorophyll-a decreased from about 150 to 20${\mu}g$g/L, with a maximum removal efficiency of 84% due to coagulation with pH values higher than 10. Thirdly, the N$H_4$-N concentration was observed to decrease from 0.62 to 0.54mg-N/L (13%), and the P$O_4$-P concentration, which is a limiting factor to the formation of algae blooms, decreased from 0.27 to 0.02mg-P/L (92%). These findings suggest that the modified flotation system can be applied for the purification of the raw water of numerous lakes containing high phytoplankton populations and elevated pH.

• 한국정보통신학회논문지
• /
• 제17권6호
• /
• pp.1286-1291
• /
• 2013

부족한 주파수 자원의 효율성을 높이기 위하여 다중 사용자 기반 Massive MIMO에 대한 활발한 연구가 이루어진다. 이렇게 많은 송신 안테나를 사용하는 Massive MIMO 기술은 기지국의 기저대역 (Baseband)과 Radio Frequency와 같은 전송단의 하드웨어 복잡도와 빔포밍 벡터 계산량이 급격히 증가시키는 문제를 야기한다. 이러한 문제점은 기지국에서 전송단의 개수를 송신 안테나 수보다 작게 제한하고, 전체 송신 안테나들 중에서 채널 상태를 고려하여 전송단의 개수에 해당하는 안테나만을 선택하여 데이터를 전송함으로써 큰 성능 저하 없이 해결될 수 있다. 따라서, 본 논문에서는 다중 사용자 기반의 Massive MIMO 시스템에 적용할 수 있는 간단하고 효율적인 안테나 선택 기법을 제안한다.

• Nuclear Engineering and Technology
• /
• 제52권3호
• /
• pp.626-632
• /
• 2020

Radiation Portal Monitors (RPMs) are our primary border defense against nuclear smuggling, but are they still the best way to spend limited funds? The purpose of this research is to strategically compare RPM defense at the border with state-side mobile detectors. Limiting the problem to a comparison of two technologies, a decision-maker can prioritize how to best allocate resources, by reinforcing the border with stationary overt RPMs, or by investing in Mobile Radiation Detection Systems (MRDs) which are harder for an adversary to detect but may have other weaknesses. An abstract, symmetric network was studied to understand the impact of initial conditions on a network. An asymmetric network, loosely modeled on a state transportation system, is then examined for the technology that will maximally suppress the adversary's success rate. We conclude that MRDs, which have the advantage of discrete operation, outperform RPMs deployed to a border. We also conclude that MRDs maintain this strategic advantage if they operate with one-tenth the relative efficiency of their stationary counter-parts or better.

• 천문학회보
• /
• 제39권2호
• /
• pp.45.2-45.2
• /
• 2014

To measure the mass distribution of galaxy systems weak-lensing analysis has been widely used because it directly measures the total mass of a system regardless of its baryon content and dynamical state. However, the weak-lensing only provides a map of projected surface mass density. On the other hand, galaxy redshift surveys provide a map of the three-dimensional galaxy distribution. It thus can resolve the structures along the line of sight projected in the weak-lensing map. Therefore, the comparison of structures identified in the weak-lensing maps and in the redshift surveys is an important test of the issues limiting applications of weak-lensing to the identification of galaxy clusters. Geller et al. (2010) and Kurtz et al. (2012) compared massive clusters identified in a dense redshift survey with significant weak-lensing map convergence peaks. Both assessments of the efficiency of weak-lensing map for cluster identification did not draw a general conclusion, because the sample is so small. Thus, we additionally perform deep imaging observations of fields in a dense galaxy redshift survey that contain galaxy clusters at z~0.2-0.5, using CFHT Megacam.

• 전기학회논문지
• /
• 제65권4호
• /
• pp.601-610
• /
• 2016

The light-emitting diode (LED) has been used in a variety of industrial fields and for general 0lighting purposes on account of its high efficiency, low power consumption and long lifespan. The LED is driven by direct current; therefore, an AC/DC converter is typically required for its use. An electrolytic capacitor is generally used for stabilizing DC voltage during use of the AC/DC converter. However, this capacitor has a short lifespan, which makes it a limiting factor in LED lighting. Furthermore, LED lighting requires a dimmable control to enable energy savings and fulfil a growing consumer demand. In this paper, the dimmable single-stage power factor correction (PFC) continuous conduction mode (CCM) flyback converter that employs no electrolytic capacitor is presented. The LC resonant filter is alternatively applied to reduce the 120[Hz] ripple on the output. And the optimum value of the LC resonant filter parameters considering both efficient and performance is analysed. Simulation and experimental results verify the satisfactory operation of the converter.

• 한국가시화정보학회:학술대회논문집
• /
• 한국가시화정보학회 2003년도 추계학술대회 논문집
• /
• pp.81-82
• /
• 2003

We have developed the method for the conjugation of biotinylated DNA to streptavidin-coated QDs. QD-DNA conjugates and a high-sensitive fluorescence imaging technique are adopted to visualize gene transport across the membrane of the live cell in real time. Endocytotic cellular uptake of oligonucleotide and electrically-mediated plasmid DNA transfer into the live cell are monitored by a quantitative microscopic imaging system. Long-term kinetic study enables us to reveal the unknown mechanisms and rate-limiting steps of extracellular and intracellular transport of biomolecules. We designed experimental protocols to conjugate the oligonucleotide or the plasmid DNA to commercially available streptavidin-coated QDs. Gel electrophoresis is used to verify the effect of incubation time and the molar ratio of QDs and DNA on the conjugation efficiency. It is possible to fractionate the QD-DNA conjugates according to the DNA concentration and obtain the purified conjugates by a gel extraction technique.

• 대한기계학회논문집A
• /
• 제24권12호
• /
• pp.3053-3060
• /
• 2000

Alternative formulation is presented for robust optimization problems and an efficient computational scheme for reliability estimation is proposed. Both design variables and design parameters considered as random variables about their nominal values. To ensure the robustness of objective performance a new cost function bounding the performance and a new constraint limiting the performance variation are introduced. The constraint variations are regulated by considering the probability of feasibility. Each probability constraint is transformed into a sub-optimization problem and then is resolved with the modified advanced first order second moment(AFOSM) method for computational efficiency. The proposed robust optimization method has advantages that the mean value and the variation of the performance function are controlled simultaneously and the second order sensitivity information is not required even in case of gradient based optimization. The suggested method is examined by solving three examples and the results are compared with those for deterministic case and those available in literature.

• 국제초고층학회논문집
• /
• 제5권4호
• /
• pp.319-326
• /
• 2016

The ingenuity of structural engineers in the field of tall and super-tall buildings has led to some of the most remarkable inventions. During this evolution of structural engineering concepts in the last 100 years, the technical challenges that engineers encountered were extraordinary and the advances were unprecedented. However, as the accomplishments of structural engineers are progressing, the desire for taller and safer structures is also increasing. The diagrid structural system is part of this evolving process as it develops a new paradigm for tall building design combining engineering efficiency and new architectural expression. The first appearances of this type of tall buildings have already been constructed and the interest of both engineering and architectural communities is growing mainly due to the many advantages compared to other structural systems. This paper presents a simple approach on optimizing member sizes for the diagonals of steel diagrid tall buildings. The optimizing method is based on minimizing the volume of the diagonal elements of a diagrid structure. The constraints are coming from the stiffness-based design, limiting the tip deflection of the building to widely accepted regulative limits. In addition, the current paper attempts to open the discussion on the important topic of optimization and robustness for tall buildings and also studies the future of the diagrid structural system.

• 한국가스학회지
• /
• 제15권4호
• /
• pp.33-38
• /
• 2011

The introduction of alternative fuels is beneficial to overcome the fuel shortage and reduce engine exhaust emissions. LPG and CNG are relatively clean fuel and considered as most promising alternative automotive fuels worldwide because of its emission reduction potential and lower fuel price compared to gasoline. Now a day’s adaptation of dual fuel approach is the growing as common trend. The two fuels can be successfully implemented with existing gasoline engine with little modification. The present study was done to analyze the performance and emissions analysis of a multi cylinder spark ignition engine fuelled with the benefits of CNG and LPG aseffective alternate automotive fuels by simply using them in an unmodified petrol engine. The test results indicate, the energy content of CNG and LPG is the most limiting factor in acceptance for fuel economy and performance reasons. Thermal efficiency was high for CNG lowest for gasoline and LPG between the two. BSFC, CO and HC were low and NOx was high for CNG and low for gasoline, LPG lies between the two.

• 한국전산유체공학회:학술대회논문집
• /
• 한국전산유체공학회 2011년 춘계학술대회논문집
• /
• pp.387-391
• /
• 2011

Since MEMS based micro actuators or generating devices have high efficiency per volume, plenty of research are ongoing. Among them, MEMS based millimeter-scale micro gas' turbine is one of the most powerful issue for replacing chemical batteries. However, since limiting of MEMS manufacturing technique, it is very difficult that makes wide turbine bearing area. It causes low DN number, so sufficient bearing force is hard to achieve. Thus, the most important issue on micro gas turbine is proper bearing design which can keep rotor stable during operation. In order to that, micro-scale gas-lubricated bearing is generally used. In this paper, basic feasibility study and design of journal bearing for 10mm diameter micro gas turbine is described Journal bearing is hydrostatic gas-lubricated type. Numerical simulation is performed with ANSYS CFX 11.0 which is commercial numerical tool. Repulsive force when there is radial displacement in bearing and returning time is calculated using steady and unsteady cases. Auto re-meshing technic is used for moving mesh unsteady cases which simulate displacement of axis and its movement. The simulation results are used for further design of micro gas turbine, and experiment will be done later.