• Journal of The Korean Astronomical Society
• /
• v.29 no.spc1
• /
• pp.241-242
• /
• 1996

The UBV observations of the close binary system CW Cephei were made from August 198:3 to December 1984 during 25 nights using the 61cm Boller and Chivens reflector at the Sobaeksan Astronomy Observatory. The new UBV light curves were analyzed with the recent Wilson-Devinney binary model. Our photometric solution for CW Cep were well consistent with those of Clausen &. Gimenez (1991). Using our photometric solution and Popper & Hill (1991) spectroscopic one, each absolute masses and radii of components for CW Cep were derived as 13.63 M$\bigodot$ and 5.83 R$\bigodot$ for the primary, and 12.18 M$\bigodot$ and 5.14 R$\bigodot$ for the secondary, respectively.

• The Bulletin of The Korean Astronomical Society
• /
• v.42 no.2
• /
• pp.86.3-86.3
• /
• 2017

2개의 케플러 접촉쌍성인 KIC 8804824와 KIC 10229723의 초정밀 측광 자료를 가장 최신 버전의 윌슨-디비니 코드로 분석하여 정밀한 측광 해를 산출하고, 그 잔차들을 매우 자세하게 조사하였다. 두 개의 케플러 접촉 쌍성은 제2식이 편평한 광도곡선을 가지고 있어, 이 두 쌍성은 W UMa형 A sub-group에 속한다. 또한, 광도곡선의 모양이 매우 대칭이며, 시간에 따른 변화가 크지 않다. 두 별의 측광 해를 살펴 본 결과, 두 별은 모두 주성의 온도가 부성의 온도보다 높고, 0.2보다 작은 극단적인 질량비와 90도에 거의 가까운 궤도경사각을 갖고 있다. 무엇보다도, 두 별의 측광 해의 잔차에서 공통적으로 전 위상에 걸쳐 모형화 되지 않은 특이한 구조를 발견하였다. 이 구조는 phase smearing 효과를 고려하더라도 그 구조의 모습만이 약간 달라질 뿐, 구조의 진폭에는 크게 영향을 미치지 않는 것을 발견하였다. 흥미롭게도 이 현상은 두 별의 주기가 각각 다름에도 불구하고 공통적으로 나타나며, 관측된 전 쿼터에 대해 나타난다. 이 현상의 가능한 원인에 대해 논의한다.

• Journal of the Semiconductor & Display Technology
• /
• v.2 no.2
• /
• pp.9-15
• /
• 2003

This paper proposes a thickness measurement method of silicon-oxide and poly-silicon film deposited on 12" silicon wafer for spin etcher. Halogen lamp is used as a light source for generating a wide-band spectrum, which is guided and focused on the wafer surface through a optical fiber cable. Interference signal from the film is detected by optical sensor to determine the thickness of the film using spectrum analysis and several signal processing techniques including curve-fitting and adaptive filtering. Test wafers with three kinds of priori-known films, polysilicon(300 nm), silicon-oxide(500 nm) and silicon-oxide(600 nm), are measured while the wafer is spinning at 20 Hz and DI water flowing on the wafer surface. From experiment results the algorithm presented in the paper is proved to be effective with accuracy of maximum 0.8% error.rror.

• Current Optics and Photonics
• /
• v.1 no.3
• /
• pp.233-238
• /
• 2017

In this paper we propose a freeform secondary lens for an LED fishing/working lamp (LFWL). This innovative LED lamp is used to replace the traditional HID fishing lamp, to satisfy the lighting demands of fishing and the on-board activities on fishing boats. To realize the freeform lens's geometry, Gaussian decomposition is involved in our optics-design process for approaching the targeted light intensity distribution curve (LIDC) of the LFWL lens. The simulated results show that the illumination on the deck, on the sea's surface, and underwater shows only small differences between LED fishing/working lamps and HID fishing lamps. Meanwhile, a lighting efficiency of 91% with just one third of the power consumption can be achieved, when the proposed LED fishing/working lamps are used instead of HID fishing lamps.

• Journal of the Korean Society of Safety
• /
• v.26 no.2
• /
• pp.1-5
• /
• 2011

In order to evaluate fatigue endurance for an ultra-light weight inline skate frame, FEM analysis was performed. Tensile properties and a S-N curve were determined through tensile and fatigue tests on a modified Al-7075+$S_c$ alloy. The yield and ultimate tensile strengths were 553.3 MPa and 705.5 MPa, respectively. The fatigue endurance limit of this alloy was 201.2 MPa. For evaluating the fatigue endurance of the inline skate frame, the S-N data were compared with the stress analysis results through FEM analysis of the frame. The maximum Von-Mises stress of the frame was determined 106 MPa through FEM analysis of the frame, assuming that the rider weight is 75 Kg. Conclusively, on the basis of fatigue limit, the inline skate frame has a safety factor of approximately 2.0.

• Journal of the Korean Society of Clothing and Textiles
• /
• v.25 no.7
• /
• pp.1314-1320
• /
• 2001

Dyeing properties of rosemary colorants on wool fabrics were investigated. Reosemary colorants were characterized by UV and FT-IR analysis. Effect of dyeing condition on dye uptake and effect of mordanting on dye uptake, color change of colorfastness were explored. Rosemary colorants showed high affinity to wool fiber and its isotherm adsorption curve was Langmuir type. Therefore, it was considered that ionic bonding was involved in the adsorption of rosemary colorants to wool fiber. Rosemary colarants produced mainly yellowish color on wool fabric. The dyed wool fabrics showed generally high colorfastness except fastness to washing and light. Mordanting did not improve any colorfastness except that Sn mordant improved the light fastness. Bacterial reduction rate was increased up to 100% at 5% dye concentration. Therefore, antimicrobial activity of rosemary extract was confirmed.

• Korea-Australia Rheology Journal
• /
• v.19 no.3
• /
• pp.109-115
• /
• 2007

A new microchip-based aggregometer that uses a stirring-aided disaggregation mechanism in a microchip was developed to measure red blood cell (RBC) aggregation in blood and RBC suspensions. Conventional methods of RBC disaggregation, such as the rotational Couette system, were replaced with a newly designed stirring-induced disaggregation mechanism. Using a stirrer in a microchip, the aggregated RBCs stored in a microchip can be easily disaggregated. With an abrupt halt of the stirring, the backscattered light intensity can be measured in a microchip with respect to time. The time recording of the backscattered light intensity (syllectogram) shows an exponential decreasing curve representing the RBC aggregation. By analyzing the syllectogram, aggregation indices such as AI and M were determined. The results showed excellent agreement with LORCA. The essential feature of this design is the incorporation of a disposable microchip and the stirring-induced disaggregation mechanism.

• Journal of the Optical Society of Korea
• /
• v.9 no.2
• /
• pp.49-53
• /
• 2005

We report a new configuration of a reflection-type confocal scanning optical microscope system for measuring the refractive index profile of an optical waveguide. Several improvements on the earlier design are proposed; a light emitting diode (LED) at 650 nm wavelength instead of a laser diode (LD) or He-Ne laser is used as a light source for better index precision, and a simple longitudinal linear scanning and curve fitting techniques are adapted instead of a servo control for maintaining an optical confocal arrangement. We have obtained spatial resolution of 700 nm and an index precision of $2\times10^{-4}$. To verify the system's capability, the refractive index profiles of a conventional multimode fiber and a home-made four-mode fiber were examined with our proposed measurement method.

• Journal of Astronomy and Space Sciences
• /
• v.6 no.1
• /
• pp.41-47
• /
• 1989

UBV photoelectric observations of RS CVn type variable star HD 8358 were made using the 61cm reflector at Sobaeksan Astronomical Observatory. The data were obtained on 15 nights from October 1987 to December 1988. Double peaks of maximum light is seen from the light curve and continuous change of phase in notified from the times of maximum lights. The colors of October, 1987 - January, 1988 observations are bluer in $\Delta(b-\upsilon)$, but redder in $\Delta(\upsilon$-b), than those of November -December, 1988 observations.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.7 no.2
• /
• pp.1-12
• /
• 1970

In this paper, theoretical and experimental study about the light modulation at X-band(9375MHz) micro wave, using the linear electro-optic effect, has been described. The electro-optic crystal, KDP (potassium dihydrogen phosphate)is used for modulator crystals which is composed resonated modulator. Output performances of modulated wave through movable short positions are presented. It was critically respond from 2. And the output modulated intensity was compared with theoretical curve. Consequently, in spite of many problems remain yet, most promissing and more sucessful modulator configurations are compleely given.