• Korean Chemical Engineering Research
• /
• v.40 no.6
• /
• pp.735-740
• /
• 2002

In order to improve the anti-fogging property of polymer films, organic-inorganic hybrid coating solutions which have good hydrophilic property and transmission in the range of visible light were synthesized by the sol-gel method. The coating solutions were prepared by adding glycidoxypropyl trimethoxysilane(GPS) to a colloidal silica(15 nm) suspension(Ludox). GPS as silane coupling agent forms strong bonds to the colloidal silica and surrounding polymer matrix and links two different materials together. Solutions prepared by addition of GPS at the acidic condition resulted in coatings that were less prone to cracking, while those at the basic condition caused coatings with more cracking. These resulted in better hydrophilic property and transmission in the range of visible light for the solution prepared at the acidic condition(pH 2). Compared with coatings under acidic conditions, coatings prepared at basic conditions showed worse hydrophilic property and transmission in the range of visible light.

• Journal of Power Electronics
• /
• v.16 no.6
• /
• pp.2024-2034
• /
• 2016

This paper presents a DC-DC buck converter with a Phase-Locked Loop (PLL) that can compensates for power efficiency degradation over a wide input range. Its switching frequency is kept at 2 MHz and the delay difference between the High side driver and the Low side driver can be minimized with respect to Process, Voltage and Temperature (PVT) variations by adopting the PLL. The operation mode of the proposed DC-DC buck converter is automatically changed to Pulse Width Modulation (PWM) or PWM frequency modes according to the load condition (heavy load or light load) while supporting a maximum load current of up to 1.2 A. The PWM frequency mode is used to extend the CCM region under the light load condition for the PWM operation. As a result, high efficiency can be achieved under the light load condition by the PWM frequency mode and the delay compensation with the PLL. The proposed DC-DC buck converter is fabricated with a $0.18{\mu}m$ BCD process, and the die area is $3.96mm^2$. It is implemented to have over a 90 % efficiency at an output voltage of 5 V when the input range is between 8 V and 20 V. As a result, the variation in the power efficiency is less than 1 % and the maximum efficiency of the proposed DC-DC buck converter with the PLL is 95.4 %.

• Korean Journal of Medicinal Crop Science
• /
• v.24 no.4
• /
• pp.277-283
• /
• 2016

Background: The photosynthetic efficiency cool-season, semi-shade ginseng is normal at low morning temperatures, but drops at high afternoon temperatures. Therefore, optimal plant performance would be ensured if it were possible to control daily light transmission rates (LTR). Methods and Results: Plants were grown in a controlled light environment that replicated 11 AM conditions and comparatively analyzed against plant grown under normal conditions. Growth in the controlled light environment resulted in a 2.81 fold increase in photosynthetic efficiency with no change in chlorophyll content, although LTR were high due to low morning temperatures. Increased aerial plant growth was observed in the ginseng plants adapted to the controlled light environment, which in turn influenced root weight. An 81% increase in fresh root weight (33.3 g per plant on average) was observed in 4-year-old ginseng plants grown in controlled light environment compared to the plants grown following conventional practices (18.4 g per plant on average). With regard to the inorganic composition of leaves of 4-year-old ginseng plants grown in controlled light environment, an increased in Fe content was observed, while Mn and Zn content decreased, and total ginsenoside content of roots increased 2.37 fold. Conclusions: Growth of ginseng under a favorable light environment, such as the condition which exist naturally at 11 AM and are suitable for the plant's photosynthetic activity creates the possibility of large scale production, excellent-quality ginseng.

• Physical Therapy Rehabilitation Science
• /
• v.5 no.3
• /
• pp.138-142
• /
• 2016

Objective: The purpose of this study was to investigate how light touch with a finger affects balance ability when a posture is maintained in the condition of visual information blockage and to provide a fundamental material for developing balance ability in the process of rehabilitation treatment. Design: Cross-sectional study. Methods: The study subjects were 17 healthy men and women in their twenties and thirties who were studying at S University in Seoul. The system was comprised of an equilateral triangular force platform. Subjects were asked to step on the foot position of the force platform (Good Balance, Finland) barefooted for 30 seconds, with eyes closed, hands hanging down loosely, and feet comfortably apart. It was connected to a laptop by using Bluetooth technology. An experiment was conducted in the following three circumstances: 1) no-touch trial, 2) light touch to the back (T7 area), and 3) light touch to the middle finger of the left hand. Each subject was given a 10-minute break between consecutive measurements. The experimental circumstances were performed randomly. Anteroposterior sway (APSV), mediolateral sway velocity (MLSV), and velocity moment (VM) were measured. Results: The APSVs (mm/s) were $9.32{\pm}3.37$ and $5.45{\pm}2.98$; the MLSVs (mm/s), $6.39{\pm}3.35$ and $3.31{\pm}2.48$; and VM ($mm^2/s$), $17.13{\pm}11.75$ and $6.76{\pm}8.31$ in the first and second experimental circumstances, respectively. APSV, MLSV, and VM values were significantly improved with the 1) no-touch trial and 2) light touch to the back trail conditions compared with the 3) light touch to the middle finger of the left hand condition (p<0.05). Conclusions: This study revealed that the balance ability for maintaining a body posture was influenced more by light touch to the back (T7) than by light touch with the sensitive fingertip and body sway diminished after visual information was blocked.

• Korean Journal of Microbiology
• /
• v.43 no.2
• /
• pp.77-82
• /
• 2007

In a homothallic ascomycete Aspergillus nidulans, sexual development is inhibited by various environmental stresses such as acetate medium, visible light and high osmolarity conditions. In order to study the genes involved in this stress-related regulatory network, we first attempted to isolate mutants that could develop cleistothecia even in the presence of any of those stresses including intensive visible light. More than 10,000 mutants were screened and 167 mutants were analyzed. Among them, 152 mutants underwent sexual development under the single stress condition of either high osmotic, high acetate or light condition but no sexual development in more than two stresses. Six mutants can produce cleistothecia under light or acetate stress but not in salt stress. Moreover, 6 mutants showed the ability to develop cleistothecia under the light but not under the acetate or osmo-stress. The mutants were revealed to have independent single gene mutation and grouped into different complementation groups (silA-F). The mutant alleles were all recessive to that of wild type. The light responsiveness of development implies the existence of delicate regulation process including reception and translocation of light signaling and determination of development.

• Journal of Environmental Health Sciences
• /
• v.23 no.4
• /
• pp.82-90
• /
• 1997

This study was conducted to establish an ideal condition for obtaining maximum extraction efficiencies using an array of soil types and under a wide variety of conditions. Nine characteristic compounds were studied: benzene, toluene, ethylbenzene, o-xylene, m-xylene, p-xylene, n-propylbenzene, 1,2,4-trimethylbenzene, and n-butylbenzene which were found in gasoline. Increasing the moisture content resulted in decreased recovery, and recovery of hydrocarbons from wet soils was significantly lower than from dry soils. For the batch extraction process, 4 hours of extraction time was sufficient to give optimum recovery of the contaminants. With methanol as an extraction solvent, maximum recovery time appeared to be reached quicker for BTEX components than with 2-propanol. The 2 to 1 ratio of solvent/soil was chosen as a compromise to provide for the indicated minimum solvent use and high extraction efficiency. The 0.4 mg/g soil contamination was adequate to show quantitative recovery. The percent recovery of BTEX was concentration dependent more than the semivolatile compounds. Methanol and 2-propanol consistently gave higher efficiency than water. Methanol was superior to 2-propanol in removing contaminants from silty clay loam soil. Using the most efficient extraction procedure, the average recovery of the light hydrocarbons from the three soils was 66 percent. Recoveries were also dependent on soil type, solvent type, extraction time, solvent amount, contaminant concentration, and compounds volatility. This study provided a useful screening technique for procedures that can be used to remediate soils contaminated with light hydrocarbons.

• Journal of Dental Rehabilitation and Applied Science
• /
• v.31 no.1
• /
• pp.1-9
• /
• 2015

Purpose: The purpose of this study was to evaluate the mechanical properties of several dual-cure cements by different curing modes. Materials and Methods: One resin-modified glass ionomer cement (FujiCEM 2), two conventional dual-cure resin cements (RelyX ARC, Multilink N), and two dual-cure self-adhesive resin cements (RelyX U200, G-CEM LinkAce) were used. To evaluate the influence of the curing methods, each cements divided into four conditions (n = 20); Condition 1: self-curing for 10 minutes, Condition 2: immediate after 20 seconds light-curing, Condition 3: 24 hours after self-curing, Condition 4: 24 hours after light-curing. The compressive strength and diametral tensile strength were measured with a universal testing machine. All data were statistically analyzed using t-test, one-way ANOVA and Scheffe's test. Results: The results showed the compressive strength and diametral tensile strength after 24 hours in all curing modes were higher than immediate except RelyX ARC light-cured and Multilink N light-cured. The FujiCEM 2 showed lowest values (P < 0.05). Conclusion: The outcome was cement-depend, but there is no significant difference about compressive strength and diametral tensile strength between dual-cure self-adhesive resin cements and conventional resin cements. And this result will be used as a base line data selecting resin cement for favorable long-term prognosis.

• Journal of Bio-Environment Control
• /
• v.22 no.1
• /
• pp.43-47
• /
• 2013

This study was conducted to develop the most effective method in promoting onion set in cultivars 'Josaengsseondebol' and 'Daeji' for all year-round production. This was done by extending the day length for 41 days. For both cultivars, the period to reach the maximum number of leaves developed was shortened as the exposure to day length increased. Between the two cultivars, 'Josaengsseondebol' reaches its maximum leaf formation for a shorter duration compared with 'Daeji'. In effect to bulb size, cultivar 'Josaengsseondebol' having a night break of 1, 2, and 16 hours light condition had better bulb enlargement compared with the non-treated bulbs. In the case of cultivar 'Daeji', only bulbs exposed to a night break of 2 and 16 hours light condition had better bulb enlargement. The percentage of marketable set yield in cultivar 'Josaengsseondebol' having a night break of 1 hr, 2 hrs, 16 hrs light condition, and control or untreated bulbs were 84%, 92%, 90%, and 6% respectively. In the case of cultivar 'Daeji', treated with a night break of 1 hr, 2 hrs, 16 hrs light condition, and untreated bulbs had a percentage marketable set yield of 7%, 55%, 64%, and 0% respectively. Based on these results, it is therefore concluded that night break treatment is considered to be effective method in promoting off-season onion set cultivation in cultivar 'Josaengsseondebol'.

• KOREAN JOURNAL OF CROP SCIENCE
• /
• v.41 no.6
• /
• pp.725-728
• /
• 1996

This study was conducted to investigate effect of leaf temperature on light response and respiration during short-term exposure to a sequnce of PPFD cycle(100-200-300-400$\mu$ mol m$^{-2}$ s$^{-1}$ ) under increasing leaf temperature sequnce up to 3$0^{\circ}C$ and in dark condition, increasing up to 46$^{\circ}C$ with step size (1$^{\circ}C$) in Panax ginseng C. A. Meyer. When leaflet exposed to low light intensity and temperature, Rubisco activity was higher than remained activity in high condition. Leaves adapted to 100$\mu$mol m$^{-2}$ s$^{-1}$ PPFD had a peak response similar to that of 200$\mu$mol m$^{-2}$ s$^{-1}$ at 18$^{\circ}C$, but in above PPFD cycle(300, 400$\mu$mol m$^{-2}$ s$^{-1}$ ) it represented at 17$^{\circ}C$ and 16$^{\circ}C$, re-spectively. $CO_2$ evolution in dark condition increased rapidly when leaf temperature was increased up to 28$^{\circ}C$ and then 'dipped' below steady-state level from above 4$0^{\circ}C$. Thus, Pananx ginseng is able to take advantage of irradiance increase and decrease of $CO_2$ evolution in dark condition to control leaf temperature.mperature.

• Fashion & Textile Research Journal
• /
• v.7 no.6
• /
• pp.665-672
• /
• 2005

The purpose of this study was to assess the feasibility and the effects of near infrared lighted garments on thermo-physiological responses in human body. Seven healthy adult men were recruited for this study. All subjects were informed the contents and purpose of this study. The experiment was carried out in a climate chamber of $32^{\circ}C$, 60%RH with 'Rest', 'Exercise' and 'Recovery' period. The experimental garments consisted of briefs, undershirts(sleeveless), nightclothes, T-shirts, knee-trousers and socks. Subjects participated in two experiments, one was wearing near infrared lighted garments(NIR-O), the other was wearing regular garments(NIR-X). The order of experiment was randomized, and subjects wore experimental garments before 24 hours in order to benefit by near infrared light. Measurement items included rectal temperature ($T_{re}$), mean skin temperature ($\bar{T}_{sk}$), sweat rate, heart rate, oxygen uptake and subjective sensation. The results are as follows: As to the variation of rectal temperature and mean skin temperature, value of wearing NIR-X was higher than value of wearing NIR-O, indicating a significant level of difference (p<.001). Sweat rate under NIR-O and NIR-X condition were 575.35 g and 535.75 g, respectively. Heart rate value of NIR-X condition was higher than NIR-O. Oxygen uptake measured during experiment was the higher in NIR-X condition with significant difference (p<.001). In the subjective sensation, the value of NIR-O condition was higher than NIR-X condition without significantly difference.