• Journal of the Korean Institute of Gas
• /
• v.12 no.4
• /
• pp.21-28
• /
• 2008

A numerical analysis is achieved to elucidate the behavior of lifted flames and characteristics of flow near flame zone according to the exit velocity of triple flame, Poiseuille and uniform distribution. For the cases of Poiseuille and uniform nozzle exit velocity, we reviewed previous results with the present numerical results and investigated characteristics of the flame structure near the flame zone comparing with liftoff height generalized by momentum flux. In addition, a close inquiry into the combustion flow characteristics near flame zone was made with the characteristics of velocity, pressure, temperature and chemical reaction. From nozzle to flame zone, center line velocity profile traced well with the velocity profile of typical cold jet flow, but very near the flame zone, this study examined phenomenon that flow velocity decreases very quickly before the flame zone and then increases very quickly after the flame zone. Because flame zone acts as a barrier at the flow region which is before the flame zone and accelerate the flow velocity when it pass through the flame zone. This phenomenon was not clarified previous cold jet flow.

• Journal of computational fluids engineering
• /
• v.3 no.2
• /
• pp.52-64
• /
• 1998

Numerical simulations on the flowfield of lifting chamber for Wing-In-Ground vehicle were performed using Fluent/UNS 4.2 software. The trend of lifting force in lifting chamber and parametric study of geometric and fluid variables were primarily investigated. Selected parameters for investigation are inlet velocity, height between chamber and water level, depth of the skirt, location of inlet, variaton of height at bow and stern. Also, air capturing capabilities from downstream of the propeller were evaluated at the air inlet. The lifting force was increased linearly with the increased of inlet velocity and nonlinearly with the decrease of height force was increased with increased depth. It turned out to have very minor effect on lifting force to change the location of air inlet for lifting chamber, installed on top surface. Tilting the vehicle when it was lifted, the lifting forces, generated in each case, showed no appreciable changes.

• Journal of the Korean Association of Oral and Maxillofacial Surgeons
• /
• v.35 no.5
• /
• pp.346-352
• /
• 2009

There have been reports of successful bone formation with sinus floor elevation by simply elevating the maxillary sinus membrane and filling the sinus cavity below the lifted sinus membrane with a blood clot. But, in a review of the current literature, we found no animal study that substantiated blood clot's ability in this respect. The aim of this study was to investigate the effect of the method of maxillary sinus floor augmentation using the patient's own venous blood in conjunction with a sinus membrane elevation procedure. An implant was placed bilaterally in the maxillary sinus of six adult mongrel dogs so that it protruded 8 mm into the maxillary sinus after sinus membrane elevation. On one side of the maxillary sinus, the resultant space between the membrane and the sinus floor was filled with autologous venous blood retrieved from the dog. On the opposite side, the maxillary sinus was left untreated as a control. The implants were left in place for six months. The mean height of the newly formed bone in the sinus was 3.7 mm on the side without venous blood and 3.5 mm on the side with venous blood (p>0.05). There was no difference between the two sides regarding new bone height in the sinus. Our results indicate that filling the space between the lifted sinus membrane and the sinus floor with venous blood has no effect on bone formation around implants placed in the maxillary sinus cavity.

• 한국연소학회:학술대회논문집
• /
• 2002.06a
• /
• pp.99-105
• /
• 2002

The concentration gradient effects on triple flame have been studied experimentally using a slot burner in order to stabilize stationary triple flame in coflowing stream. By means of contraction we generate the coflowing stream with uniform velocity and linear concentration gradient at the outlet of the slot. In this paper we investigated the response of the triple flame. to the concentration gradient, like the stability, the liftoff height, and the structure of triple flame. Flow velocity is measured with Laser Doppler Velocimetry. As the concentration gradient increases. the flame propagation velocity in immediately upstream triple point increases until the liftoff height of triple flame becomes minimum, and then decreases.

• Proceedings of the KSME Conference
• /
• 2001.11a
• /
• pp.453-458
• /
• 2001

The stability of turbulent nonpremixed interacting flames is investigated in terms of nozzle configuration shapes which depend on the existence of the center nozzles. Six nozzle arrangements which are cross 4, 5, 8, 9, square 8 and circular 8 nozzles are used for the experiment. Those are arranged to see the effect of the center nozzle out of multi-nozzle. There are many parameters that affect flame stability in multi-nozzle flame such as nozzle separation distance, fuel flowrates and nozzle configuration, but the most important factor is the existence of nozzles in the center area from the nozzle arrangement. As the number of nozzle in the area is reduced, more air can be entrained into the center of flame base and then tag flame is formed. In the case of circular 8 nozzles, blowout flowrates are above 5.4 times compared with that of single equivalent area nozzle.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.34 no.4
• /
• pp.399-408
• /
• 2010

The characteristics of lifted laminar propane flames diluted with nitrogen have been investigated experimentally to elucidate self-excitation and the effects of flame curvature. Flame oscillation modes are classified as follows: oscillation induced by heat loss, a combination of oscillations induced by heat loss and buoyancy, and a combination of the oscillations induced by heat loss and diffusive thermal instability. It is shown that the oscillation induced only by heat loss is not relevant to the diffusive thermal instability and hydrodynamic instability caused by buoyancy; this oscillation is observed under all lift-off flame conditions irrespective of the fuel Lewis number. These experimental evidences are displayed through the analysis of the power spectrum for the temporal variation of lift-off height. The possible mechanism of the oscillation induced by heat loss is also discussed.

• The Journal of Korean Physical Therapy
• /
• v.27 no.5
• /
• pp.299-303
• /
• 2015

Purpose: The objective of this study was to examine the changes in muscle activity on the anterior deltoid muscle depending on the stretch rate of kinesio tape when applying kinesio tape in healthy adult subjects. Methods: This study was a single-blind randomized controlled trial, including 22 healthy participants (male 15, female 7) with no pathology or past history of shoulder who participated voluntarily. Participants applied a different stretch rate of the kinesio tape, and the functional activity was tested. The stretch rate of kinesio tape was 0%, 10%, and 20%. Subjects lifted a weight (5% of their body weight) to their shoulder height. Subjects lifted a weight up to an angle of 90 degrees in the sagittal plane, and muscle activities (biceps brachii, anterior deltoid, middle deltoid, upper trapezius) were assessed using EMG (electromyography). Analysis of muscle activity was divided into two parts (lift weight and keep holding). The EMG activity of each muscle was normalized to the value of reference voluntary contraction (%RVC) and explored using repeated ANOVA. Results: There were no significant differences in muscle activity depending on the ratio of tape stretch when lifting a weight (p>0.05). There were no significant differences in muscle activity depending on the ratio of tape stretch when holding a weight (p>0.05). Conclusion: According to the results of this study, in the case of applying kinesio taping therapy for healthy people, it was found that the stretch rate of the tape does not have an effect on muscle activity.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.26 no.10
• /
• pp.1458-1464
• /
• 2002

$CO_2$ is well known greenhouse gas which is the major source of global warming. Reducing $CO_2$ emission in combustion process can be achieved by increasing combustion efficiency, oxygen enriched combustion and recirculation of the emitted $CO_2$ gas. Stability of non-premixed flame in oxygen enriched environment will be affected by the amount of oxygen, kind of diluents and fuel exit velocity. The effects of these parameters on flame liftoff and blowout are studied experimentally oxidizer coflowing burner. Experiments were divided into three cases according as where $CO_2$gas was supplied. - 1) to coflowing air, 2) to fuel with 0$_2$-$N_2$ coflow, 3) to coflowing oxygen. Flame in air coflowing case was lifted in turbulent region. Flame lift and blowout in laminar region with the increase in $CO_2$ volume fraction in $CO_2$-Air mixture makes flame lift and blowout in laminar region. Increase in oxygen volume fraction makes flame stable-i.e. flame liftoff and blowout occur at higher fuel flowrates. Liftoff height was non-linear function of nozzle exit velocity and affected by the $O_2$ volume fraction. It was found that the flame in $O_2$-$N_2$ coflow case was more stable than $O_2$-$CO_2$ case, Liftoff heights vs (nozzle exit velocity/laminar burning velocity)$^{3.8}$ has a good correlation in $O_2$-$CO_2$ oxidizer case.

• Proceedings of the Korean Society of Propulsion Engineers Conference
• /
• 2011.11a
• /
• pp.595-598
• /
• 2011

Supersonic combustion phenomena in the main combustor of a dual combustion ramjet (DCR) engine are studied numerically. Since the supersonic combustion is affected significantly by the compressibility effects parametric studies have been carried out for the constant are length and the divergence angle. Numerical studies with fixed inflow condition for different geometric configurations reveals that the supersonic combustion in DCR combustor has the characteristics of lifting flame, where the lifting flame is maintained near the injector tip for the case of long combustor length with small divergence angle, but the lifting height is significantly increase for large divergence angle resulting flame blow-out of the combustor. Therefore, it is concluded that flame stability should be considered sufficiently in the design o DCR combustor.

• 한국연소학회:학술대회논문집
• /
• 2003.05a
• /
• pp.255-260
• /
• 2003

Characteristics of methane jet diffusion flames using pure oxygen with recirculating $CO_{2}$ as an oxidizer were investigated experimentally. A coflow burner was considered, and the diameter of confinement was larger than that of the coflow. No stabilized flame could be observed over 75% of $CO_{2}$ volume percent. A comparison between air and $O_{2}/CO_{2}$ mixture was made in terms of liftoff velocity, flame liftoff height, and blowout conditions. As results, more stable flame could be observed with $O_{2}/CO_{2}$ mixture for the case of having similar flame temperature.