• 한국산학기술학회논문지
• /
• 제7권3호
• /
• pp.344-349
• /
• 2006

[ $60{\sim}70nm$ ] 급의 design rule을 가진 고집적 반도체 소자를 제작하려면, 트랜지스터 형성 이후의 공정에서 thermal budget을 줄이기 위하여 공정의 온도를 낮추는 것이 중요하다. 본 연구에서는 고온의 습식 산화막을 대체할 수 있는 저온의 LPCVD (Low-Pressure Chemical Vapor Deposition) $SiO_2$(LTO : Low-Temperature Oxide) 박막 증착공정을 제시하였으며, ONO (Oxide/Nitride/Oxide) 구조의 커패시터를 형성하여 증착된 LTO 박막의 전기적인 신뢰성을 평가하였다. LTO 박막은 5 MV/cm 이하의 전기장 영역에서는 고온의 습식 산화막과 크게 차이가 없는 누설전류 특성을 보였으나, 더 높은 전기장의 영역에서는 훨씬 더 우수함을 보여주었다.

• 센서학회지
• /
• 제26권6호
• /
• pp.438-444
• /
• 2017

In this paper, we focus on optimization of the in-situ phosphorous (P) doping of low-pressure chemical vapor deposited (LPCVD) poly Si resistors for obtaining near-zero temperature coefficient of resistance (TCR) at temperature range from 25 to $600^{\circ}C$. The deposited poly Si films were annealed by rapid thermal anneal (RTA) process at the temperature range from 900 to $1000^{\circ}C$ for 90s in nitrogen ambient to relieve intrinsic stress and decrease the TCR in the poly Si layer and get the Ohmic contact. After the RTA process, a roughness of the thin film was slightly changed but the grain size and crystallinity of the thin film with the increase in anneal temperature. The film annealed at $1,000^{\circ}C$ showed the behavior of Schottky contact and had dislocations in the films. Ohmic contact and TCR of $334.4{\pm}8.2$ (ppm/K) within 4 inch wafer were obtained in the measuring temperature range of 25 to $600^{\circ}C$ for the optimized 200 nm thick-poly Si film with width/length of $20{\mu}m/1,800{\mu}m$. This shows the potential of in-situ P doped LPCVD poly Si as a resistor for pressure sensor in harsh environment applications.

• 대한전자공학회:학술대회논문집
• /
• 대한전자공학회 1999년도 추계종합학술대회 논문집
• /
• pp.883-886
• /
• 1999

We deposited tungsten gate electrode on gate SiO$_2$by thermal LPCVD with WF$_{6}$, SiH$_4$ and H$_2$. The resistivity was ~10$\mu$Ωcm and exhibited good adhesion ability on oxide when the temperature was higher than 40$0^{\circ}C$. We find that, however, both the low-field current and the charge-trapping characteristics were inferior to the control devices. The oxide degradation by fluorine during the tungsten deposition must be minimized to use the tungsten as alternative gate electrode.e.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1997년도 하계학술대회 논문집 C
• /
• pp.1264-1266
• /
• 1997

This paper reports the characteristic of tile MIS structure composed of the LPCVD nitride on the oxide for the hydrogen gas detection. Pt was used as catalytic metal for detecting the hydrogen gas and the flat band voltage shift was measured at various hydrogen concentration. We found the flat band voltage shift was proportional to the hydrogen concentration.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1994년도 하계학술대회 논문집 C
• /
• pp.1239-1242
• /
• 1994

We have characterized XeCl excimer-laser-induced crystallization of thin amorphous silicon films deposited by PECVD (${\alpha}-Si:H$) and LPCVD(${\alpha}-Si$). The electrical and optical properties and surface roughness of crystallized thin films have been measured. The dc conductivities, crystallinity and surface roughness of the films increased as the laser energy density and shot density were increased. Also, we have investigated the effects of 2-step annealing employing SPC and ELA. The properties of 2-step annealed films were better than those of films annealed by ELA only.

• 한국표면공학회지
• /
• 제36권2호
• /
• pp.141-147
• /
• 2003

Silicon carbide thin film was deposited in APCVD and LPCVD system with 1,3-DSB precursor 1,3-DSB is the single precursor to deposit SiC on Si at low temperature. SiC film was deposited at $850^{\circ}C$ lower than ordinary temperature ($1000~1200^{\circ}C$) in CVD process. SiC thin film glowed to high oriented (111) plane in APCVD system. In LPCVD system, SiC film groved to preferred (220) plane at same temperature. This discrepancy between preferred planes can be described by the difference of deposition mechanism. Amorphous phase and crystal defect were observed in APCVD system with the main growth mechanism of mass transport limited region. But in LPCVD system, we got the SIC film of uniform, faceted structure and high quality.

• 대한전기학회논문지
• /
• 제41권7호
• /
• pp.760-765
• /
• 1992

The material properties and the TFT characteristics fabricated on SiOS12T substrate by LPCVD using SiHS14T gas were investigated. The deposition rate showed Arrhenius behavior with an activation energy of 31Kcal/mol. And the transition temperature form amorphous to crystalline deposition was observed at 570$^{\circ}C$-580$^{\circ}C$. The strong(220) texture was observed as the deposition temperature increases. XRD analysis showed that the film texture of the as-deposited polycrystalline silicon does not change after annealing at 850$^{\circ}C$. The fabricated TFT's based on the as-deposited amorphous film showed superior electrical characteristics to those of the as-deposited polycrystalline films. It is considered that the different electrical characteristics result from the difference of flat band voltage(VS1FBT) due to the interface trap density between the gate oxide and the active channel.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1987년도 전기.전자공학 학술대회 논문집(I)
• /
• pp.429-432
• /
• 1987

A new LOCOS (Local Oxidation of Silicon) process using a thin nitride film directly deposited on the silicon substrate by LPCVD has been developed in order to reduce the bird's beak length. SEM studies showed that nitride thickness of 50nm can decrease the bird's beak length down to 0.2um with 450nm field oxide. No crystalline defects are observed around the bird's beak after the Wright etch. A 30% improvement in current density was obtained when this new method was applied to MOS transistors (W/L*2.9/20.4) compared to conventional LOCOS process (bird's beak length=0.7um). Other various electrical parameters improved by this new simple LOCOS process are reported in this paper.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2000년도 추계학술대회 논문집
• /
• pp.459-462
• /
• 2000

A new method for the fabrication of poly-Si films is reported using by alternating magnetic flux crystallization (AMFC) of LPCVD a-Si films. In this work we have studied the crystallization of LPCVD a-Si films by alternating magnetic flux. A-Si films were 1200$\AA$-thick deposited at 48$0^{\circ}C$ at a total pressure of 0.25Torr using Si$_2$H$_{6}$/H$_2$. After this step, these a-Si films were thermally annealed by Alternating Magnetic Flux at 43$0^{\circ}C$ for 1hours. The annealed films were characterized using X-ray diffraction (XRD), Raman Spectra, Atomic Force Microscopy(AFM). Both alternating magnetic flux crystallization and solid phase crystallization were investigated to compare enhanced crystallization a-Si. We have found that the low temperature crystallization method at 43$0^{\circ}C$ by alternating magnetic flux.x.

• 한국전기전자재료학회논문지
• /
• 제11권4호
• /
• pp.255-260
• /
• 1998

Behavior of solid phase crystallizations (SPC) of RF sputtered and LPCVD amorphous hydrogenated silicon film were investigated. LPCVD films showed the higher degree of crystallinity and larger grain size than sputtered films. The applicable degree of crystallinity was also obtained from sputtered films. The deposition method of amorphous silicon film influenced the behavior of post annealing SPC. Observed degree of crystallinity of sputtered films strongly depended on the partial pressure of hydrogen in deposition. The higher deposition temperature of sputtering provided the better crystallinity after SPC. Due to the high degree of poly-crystallinity, the retardation of larger grain growth was observed on sputtering film.