• Biotechnology and Bioprocess Engineering:BBE
• /
• v.6 no.6
• /
• pp.433-437
• /
• 2001

The extraction of panaxynol and panaxydol from Korean ginseng was found to be op-timal at 55$^{\circ}C$ for the shaking method, 80$^{\circ}C$ for the soxhlet method, and 65$^{\circ}C$ for the supercritical extraction method. The amount of extracted panaxydol and panaxynol, and their increased over a period of 12 h with the shaking method. The soxhlet method produced an extract with the largest panaxydol/panaxynol ratio. A reduced particle size enhanced extraction, however the ration of panaxydol/panaxynol decreased. Swelling in water was found to be detrimental for the extrac-tion of panaxydol and panaxynol.

• Journal of Korean Society of Occupational and Environmental Hygiene
• /
• v.26 no.3
• /
• pp.307-316
• /
• 2016

Objectives: In general, NIOSH method 5506 is most widely used for the occupational exposure measurement of PAHs, but 2-4 ring PAHs have poor desorption efficiency, especially for a filter. The purpose of this study was to determine a method to increase the desorption efficiency of 16-PAHs using an ultrasonic extraction procedure. Methods: Test samples prepared spiked XAD-2 tubes and PTFE filters in the range of $0.01-1.0{\mu}g/mL$ for desorption efficiency study. Four different extraction solvents, acetonitrile, acetone, tetrahydrofuran and dichloromethane, were tested in order to select the most suitable solvent for the extraction of the 16 PAHs. The addition of dimethyl sulfoxide and sonication time were considered in order to determine the method with the highest extraction efficiency. All samples were made in three sets and analysis was replicated seven times by HPLC. Results: Acetonitrile and acetone were the optimized as an extraction solvent and desorption efficiency of 2-ring PAHs such as naphthalene, acenaphthylene were increased 3~19% with dimethyl sulfoxide for XAD-2. Acetone was the best extraction solvent for PTFE filter and the desorption efficiency was increased 3~13% for 2- to 4-ring PAHs. The optimum sonication time was 60 minutes and desorption efficiency increased with extraction time. Conclusions: As a result, the best extraction solvent was acetone with dimethyl sulfoxide for ultrasonic extraction procedure and the desorption efficiency of this method was better than NIOSH 5506's. This study could be applied as a method for occupational exposure measurement of PAHs.

• KOREAN JOURNAL OF CROP SCIENCE
• /
• v.45 no.3
• /
• pp.211-215
• /
• 2000

Lipid extraction preceding fatty acid methyl esters preparation for gas-liquid chromatography is time-consuming and cumbersome. We performed one-step extraction/methylation method with a mixture of methanol-heptane-benzene-DMP-H$_2$SO$_4$ without prior fat extraction. The simultaneous digestion and lipid transmethylation takes place at 8$0^{\circ}C$ in a single phase. After cooling till room temperature, two phases are formed. The upper one of the phases contains the fatty acid methyl esters ready for GLC. The fatty acid composition of major industrial crops obtained by the one step extraction/methylation method (method 1 and 2) was almost identical with the fatty acid composition of the pure fats extracted with hexane by the Soxtec instrument (method 3). Due to its simplicity, speed, and reduced organic solvent the one-step extraction/methylation method (method 1 and 2) should be useful to determine overall fatty acid composition, especially in situations where many samples have to be analyzed.

• Proceedings of the Korean Society of Precision Engineering Conference
• /
• 2002.10a
• /
• pp.404-406
• /
• 2002

In this paper, the method of image feature extraction is proposed. This method employ the energy field analysis, outlier removal algorithm and ring projection. Using this algorithm, we achieve rotation-translation-scale invariant feature extraction. The force field are exploited to automatically locate the extrema of a small number of potential energy wells and associated potential channels. The image feature is acquired from relationship of local extrema using the ring projection method.

• Food Science and Preservation
• /
• v.6 no.3
• /
• pp.324-327
• /
• 1999

This study was carried out to establish the extraction method of red ginseng extract without saponin decomposition. Red ginseng was extracted with impulse vacuum system and multi-stage extraction method. Crude saponin content of red ginseng extract (RGE) from impulse vacuum system was 5.4-5.9%, while that of RGE from multi-stage extraction method was 8.2-8.3%. However, HPLC Patterns indicated that saponins of RGE from impulse vacuum system were hardly decomposed, while those of RGE from multi-stage extraction method were decomposed, especially in ginsenoside -Rgl and -Re saponin. Also, the yields of red ginseng by impulse vacuum system were 15 to 20 times higher than that of multi-stage extraction method.

• KSBB Journal
• /
• v.15 no.3
• /
• pp.307-312
• /
• 2000

Physiologically active material ${\beta}$-glucan extracted from mushroom has an antitumor effect. Agaricus blazei murill(A blazel) fruiting bodies were reported to contain large amounts of ${\beta}$-glucan. The purpose of this study was to maximize ${\beta}$-glucn extraction from A. blazei by microwave assisted extraction method. Optimal extraction conditions were obtained under various extraction time and applied power which was examined as 200, 500 and 650 watt. The structure and concentrations of the raffinates were analyzed by nuclear magnetic resonance spectroscopy(NMR) and infrared spectroscopy(IR) It was proved that the extraction yield of microwave assisted extraction method was higher than that of conventional solvent extraction method. It was also observed that microwave assisted extraction method requires less amounts of solvents and extraction time compared to the conventional solvent extraction method.

• Journal of the Korean Society of Tobacco Science
• /
• v.36 no.1
• /
• pp.26-33
• /
• 2014

Simultaneous determination of crop protection agents(CPAs) in food are done with multi-residue methods, which are composed of sample clean-up, concentration, chromatographic separation and detection. Stir Bar Sorptive Extraction(SBSE) technique is used for sample preparation of various analytes in several fields. The aim of this study was to develop a sensitive and fast method based on SBSE followed by thermal desorption - gas chromatography - mass spectrometry(TD - GC/MS) to determine CPAs in tobacco sample. For the analysis of tobacco sample prior to the SBSE method, solvent extraction or ultrasound-assisted solvent extraction was performed. methanol was used as the extraction solvent. The extract was then diluted with water. Finally, the sample was subjected to SBSE. A method for fast screening of crop protection agents in tobacco using SBSE-TD - GC/MS has been developed. About 17 CPAs including organochlorine, organophosphorous and others were identified and quantified. This method showed good linearity and high sensitivity for most of the target CPAs. The method was applied to the determination of CPAs at ng/mL levels in tobacco sample. This method is simple, rapid and may be applied in detection of other components.

• Food Science and Preservation
• /
• v.23 no.2
• /
• pp.233-238
• /
• 2016

A effect of extraction methods, including stirrer extraction method (SE), ultrasonification extraction method (USE), reflux extraction method (RE), autoclave extraction (AE) and low temperature high pressure extraction (LE) method on the antioxidative and antimicrobial activities of ethanol extracts of Oenothera biennis was investigated. The extraction yield (46.33%), total polyphenol (463.05 mg GAE/g) and flavonoid (71.71 mg RHE/g) content of Oenothera biennis extract obtained by RE were higher than those from other extraction methods. The antimicrobial activity of Oenothera biennis extract was only observed against Bacillus cereus among other tested organisms (Bacillus cereus, Staphylococcus aureus, Escherichia coli and Salmonella Typhimurium). Oenothera biennis obtained by RE showed the best DPPH radical scavenging ability (74.40%), ABTS radical scavenging ability (65.29%), reducing power (1.370 ($OD_{700}$)) and ferrous ion chelating ability (90.14%) compared with other tested extraction methods tested. The RE method was the most efficient method for extracting crude antioxidant and antimicrobial substances from Oenothera biennis. These results suggested that Oenothera biennis obtained by RE could be used as a bioactive and functional material in the food industry.

• Journal of Life Science
• /
• v.9 no.5
• /
• pp.575-580
• /
• 1999

Even if odorous compounds remained very low concentration in water, it caused strong odor. Because Geosmin and most of odorous compound had very vaporization, those were difficult to analyze with GC/MSD and Purge & Trap. So, we needed pre-treatment method for decreasing amounts of extracting solvents, improving recovery efficiencies and increasing analytical efficiencies. This study developed efficient technology for analyzing odorous compounds, using various adsorbents and extracting solvents. The optimum adsorbent was XAD resins. Especially, XAD-2, XAD-7 and XAD-2010 were superior, but XAD-2 of these and MTBE was the optimum extraction solvent. Other extraction solvent's efficiency was in order of MTBE>Dichloromethane>n-Hexane>Diethylether. The optimum NaCl dosage for increasing efficiency was 5g in liquid-liquid extraction method. The shaking time(0∼24hr) had no concern with adsorption efficiency. The optimum adsorbent was XAD-2 resin and extraction solvent was MTBE. Dosing NaCl, adsorption efficiency was increased in liquid-liquid extraction method, but NaCl has no effect on liquid-solid extraction method. In this experimental results, this method will apply to not only Geosmin but other well-known odorous compounds (2-MIB, IBMP, IPMP, TCA) and algae toxins (Mycrocystin, Anatoxin etc)

• Analytical Science and Technology
• /
• v.34 no.4
• /
• pp.153-159
• /
• 2021

In this study, we describe the development of a new high-performance liquid chromatography (HPLC) method for the simultaneous analysis of six bioactive compounds (including gallic acid, epicatechin 3-gallate, quercitrin, afzelin, quercetin, and kaempferol) from Orostachys japonicus. The extraction method was investigated and optimization of the extraction time (min), solvent composition (%), and solvent to material ratio were conducted. As a result, 30 min extraction with 50% methanol and 40:1 mL/g of solvent: material ratio achieved the highest extraction efficiency with a yield of 3.32 mg/g. Furthermore, the developed HPLC method was validated and the correlation coefficient (R) values were within the satisfactory range of 0.9995-0.9999 over the linearity range of 1.53-417 ㎍/mL. The limit of detection and limit of quantification for the six active components were between 0.03-0.08 ㎍/mL and 0.08-0.26 ㎍/mL, respectively. With these newly optimized and developed methods, four batches of O. japonicus were analyzed to confirm the high extraction efficiency of the method and the feasibility of an application.