• Journal of Food Hygiene and Safety
• /
• v.22 no.1
• /
• pp.63-75
• /
• 2007

A survey on sanitary management at 98 food service institutions located in Jeollabuk-Do were conducted. Food service institutions included 13 hospitals, 38 schools, 40 enterprises, and 7 others. The sterilization in boiling water was used for disinfection of tableware, spoon and chopsticks, and dish towel. Cooking kit, refrigerator, chopping board, and knife were sterilized with disinfectant. Frequency of sanitary training program on employees was 56.1% for 1 time/month, 12.2% for 2-3 times/month, and 11.3% for 1 time/week. Preparing ratio of defrosting, warehouse and rest room, and washing and sterilization diary were 73.8, 60.5, and 54.5%, respectively. However, checking ratio of environments (9.5%), personal sanitation (10.8%), and sanitary training program diary(8.4%) were low. Major obstacle factors on the introduction of Hazard analysis critical control point (HACCP) system into food service institutions were lack of equipment and facilities (54.1%) and lack of understanding and data on HACCP system (17.3%). Therefore, in order to reduce the outbreak of food-borne diseases increasing frequency, we estimated that the introduction of sanitary management system and the conversion of dietician' perception on sanitary managements in food service institutions were needed.

• Journal of Food Hygiene and Safety
• /
• v.31 no.4
• /
• pp.264-271
• /
• 2016

The purpose of this study was to investigate contamination sources of baby leafy vegetables by assessing microbial loads on baby leafy vegetables and agricultural inputs contacted with the vegetables. To estimate microbial loads, fecal indicators (coliform and Escherichia coli) and foodborne pathogens (E. coli O157:H7, Salmonella spp., Staphylococcus aureus, Listeria monocytogenes, and Bacillus cereus) were examined. A total of 126 samples including eleven kinds of leafy vegetables, irrigation water, media, and tools were tested, resulting in coliform contamination observed from most of samples. For E. coli, 10.3% (13/126) of the samples were positive including irrigation water, knife, handler, media, tools, and three kinds of leafy vegetables. B. cereus was detected from 38% (48/126) of the samples including media, tools and three kinds of leafy vegetables. No E. coli O157:H7, Salmonella spp., and L. monocytogenes was detected. This result implies that contacting with agricultural inputs could explain microbial load of baby leafy vegetables.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.36 no.6C
• /
• pp.349-354
• /
• 2011

Passive millimeter wave imaging has the capability of detecting concealed objects under clothing. Also, passive millimeter imaging can obtain interpretable images under low visibility conditions like rain, fog, smoke, and dust. However, the image quality is often degraded due to low spatial resolution, low signal level, and low temperature resolution. This paper addresses image registration and fusion between passive millimeter images and visual images. The goal of this study is to combine and visualize two different types of information together: human subject's identity and concealed objects. The image registration process is composed of body boundary detection and an affine transform maximizing cross-correlation coefficients of two edge images. The image fusion process comprises three stages: discrete wavelet transform for image decomposition, a fusion rule for merging the coefficients, and the inverse transform for image synthesis. In the experiments, various types of metallic and non-metallic objects such as a knife, gel or liquid type beauty aids and a phone are detected by passive millimeter wave imaging. The registration and fusion process can visualize the meaningful information from two different types of sensors.

• Journal of Veterinary Clinics
• /
• v.31 no.5
• /
• pp.367-370
• /
• 2014

The study was to observe hemodynamic alterations of cardiac function to design a model of canine mitral valve insufficiency (MVI) based on chordae tendinae rupture (CTR). Ten healthy beagles with normal heart function were used in this study. To measure hemodynamics, the patient monitor was equipped for invasive blood pressure and a Swan-Ganz catheter. Hemodynamic alterations were checked promptly during CTR procedures. MVI model was made by transection of the chordae tendinae with small arthroscopy hook knife through $5^{th}$ intercostal open chest. Color Doppler at the level of the mitral valve showed high-velocity regurgitant flow immediately after CTR at intraoperative echocardiography. In hemodynamic measurements, pulmonary capillary wedge pressure (PCWP) was significantly increased, while mean arterial pressure (MAP), venous pressure (VP), pulmonary arterial pressure (PAP), cardiac output (CO) and cardiac index (CI) were significantly decreased after CTR. It was known that the left atrium was overloaded by regurgitant volume from the left ventricle. In conclusion, the MVI model induced by CTR technique in this study should be used as suitable one for the effective research of canine mitral valve disease. Further study should be needed to measure the chronic alternation of mitral valve in the model.

• Proceedings of the Korea Crystallographic Association Conference
• /
• 2002.11a
• /
• pp.5-6
• /
• 2002

The new spectrometer for X-ray Induced Electron Emission Spectroscopy (XIEES) .has been recently developed in KRISS in collaboration with PTI (Russia). The spectrometer allows to perform research using the XAFS, SXAFS, XANES techniques (D.C.Koningsberger and R.Prins, 1988) as well as the number of techniques from XIEES field(L.A.Bakaleinikov et all, 1992). The experiments may be carried out with registration of transmitted through the sample x-rays (to investigate bulk samples) or/and total electron yield (TEY) from the sample surface that gives the high (down to several atomic mono-layers in soft x-ray region) near surface sensitivity. The combination of these methods together give the possibility to obtain a quantitative information on elemental composition, chemical state, atomic structure for powder samples and solids, including non-crystalline materials (the long range order is not required). The optical design of spectrometer is made according to Johannesson true focusing schematics and presented on the Fig.1. Five stepping motors are used to maintain the focusing condition during the photon energy scan (crystal angle, crystal position along rail, sample goniometer rail angle, sample goniometer position along rail and sample goniometer angle relatively of rail). All movements can be done independently and simultaneously that speeds up the setting of photon energy and allows the using of crystals with different Rowland radil. At present six curved crystals with different d-values and one flat synthetic multilayer are installed on revolver-type monochromator. This arrangement allows the wide range of x-rays from 100 eV up to 25 keV to be obtained. Another 4 stepping motors set exit slit width, sample angle, channeltron position and x-ray detector position. The differential pumping allows to unite vacuum chambers of spectrometer and x-ray generator avoiding the absorption of soft x-rays on Be foil of a window and in atmosphere. Another feature of vacuum system is separation of walls of vacuum chamber (which are deformed by the atmospheric pressure) from optical elements of spectrometer. This warrantees that the optical elements are precisely positioned. The detecting system of the spectrometer consists of two proportional counters, one scintillating detector and one channeltron detector. First proportional counter can be used as I/sub 0/-detector in transmission mode or by measuring the fluorescence from exit slit edge. The last installation can be used to measure the reference data (that is necessary in XANES measurements), in this case the reference sample is installed on slit knife edge. The second proportional counter measures the intensity of x-rays transmitted through the sample. The scintillating detector is used in the same way but on the air for the hard x-rays and for alignment purposes. Total electron yield from the sample is measured by channeltron. The spectrometer is fully controlled by special software that gives the high flexibility and reliability in carrying out of the experiments. Fig.2 and fig.3 present the typical XAFS spectra measured with spectrometer.

• The Journal of the Korea Contents Association
• /
• v.14 no.9
• /
• pp.362-370
• /
• 2014

This study measured and analyzed the correlation coefficient between movements of thoracoabdominal tumors and external respiration in a free-breathing state, using cyberknife image guided radiotherapy(IGRT). This study subjects included a total of 30 patients with lung tumors(n=10), liver tumors(n=10) and pancreatic tumor(n=10) who underwent radiotherapy, and the movements of tumors were analyzed using converted log data of the tumor motion tracking system(MTS). In a free-breathing state, In relation to Peason's correlation coefficient between external respiration and lung tumors in the entire treatment process, the correlation coefficient was 0.646(p<0.05) in the cranio-caudal direction, 0.365(p<0.088) in the left and right direction and 0.196(p<0.115) in the antero-posterior direction. The correlation coefficient of liver tumors was 0.841(p<0.000) in the cranio-caudal direction, 0.346 (p<0.179) in the left and right direction and 0.691(p<0.001) in the antero-posterior direction. The correlation coefficient of Pancreatic tumors was 0.683(p<0.000) in the cranio-caudal direction, 0.397(p<0.006) in the left and right direction and 0.268(p<0.127) in the antero-posterior direction. In conclusion, the measurement findings of thoracoabdominal tumor movement using IGRT would be helpful in determining an accurate target volume. Moreover, the analysis of correlation between external respiration and movements of internal tumors would provide important information to correct movements of tumors for diverse radiotherapy techniques.

• Journal of Conservation Science
• /
• v.34 no.2
• /
• pp.87-96
• /
• 2018

This study analyzed the influence of folding time on the forge welded bar and hammer scale produced using the traditional refining and forge welding reproduction experiment. In the case of the forge welded bar, increasing the forging time decreased the percentage of impurities and porosity from 26.09% to 1.8%. Additionally, the hardness increased by an average of 36.88 HV. In other words, the microstructure gradually became more precise. For the hammer scale, the amount of T Fe increased with forging time. X-ray diffraction analysis revealed the presence of quartz, fayalite, $w{\ddot{u}stite$, and magnetite. The amount of quartz decreased as the forging time increased. In addition, as the forging time increased, the granular $w{\ddot{u}stite$ changed into a cohesive, long, white band. The results provide information on the characteristics of the forge welded bar and hammer scale produced in the refining and forging process. This information can be used as technical data for ancient steel making processes as well as for future technological systems.

• Food Science and Preservation
• /
• v.21 no.2
• /
• pp.151-156
• /
• 2014

This study was conducted to inhibit the browning of fresh-cut lotus roots by blanching in a Glycyrrhiza glabra L. and Astragalus membranaceus Bunge extract solution (0.5%). Lotus roots were cut to 1 cm using a knife. The fresh-cut lotus roots were blanched at $50^{\circ}C$ in distilled water (DW, Cont), Glycyrrhiza glabra L. extract solution (GE), and Astragalus membranaceus Bunge extract solution (AE). After treatment, they were packaged with 0.04 mm PE bags and were stored at $10^{\circ}C$ for 12 days. Their color, hardness, DPPH radical scavenging activity, pH, and total soluble solids were then investigated. During storage, the samples treated with GE and AE had high $L^*$ values. They were also found to have higher values compared to the control group in the analysis of the browning index. No difference was found, however, in the hardness analysis. With regard to the DPPH radical scavenging activity, the sample treated with Glycyrrhiza glabra L. extract had the highest activity. In the pH analysis, all the groups were found to have a decrease tendency for all the storage periods. The total soluble solids decreased in the control group and slightly increased in the AE and GE groups. These results show that blanching in Glycyrrhiza glabra L. or Astragalus membranaceus Bunge extract is effective for preventing the browning of fresh-cut lotus roots.

• Progress in Medical Physics
• /
• v.15 no.4
• /
• pp.179-185
• /
• 2004

To deal with tumor motion from respiration is one of the important issues for the advanced treatment techniques, such as the intensity modulated radiation therapy (IMRT), the image guided radiation therapy (IGRT), the three dimensional conformal therapy (3D-CRT) and the Cyber Knife. Studies including the active breath control (ABC) and the gated radiation therapy have been reported. Authors have developed the device for reducing the respiration effects and the diaphragm motions with this device were observed to determined the effectiveness of the device. The device consists of four belts to immobilize diaphragm motion and the vacuum cushion. Diaphragm motions without and with device were monitored fluoroscopically. Diaphragm motion ranges were found to be 1.14 ～ 3.14 cm (average 2.14 cm) without the device and 0.72～1.95 cm (average 1.16 cm) with the device. The motion ranges were decreased 20 ～ 68.4% (average 44.9%.) However, the respiration cycle was increased from 4.4 seconds to 3.7 seconds. The CTV-PTV margin could be decreased significantly with the device developed in this study, which may be applied to the treatments of the tumor sited diaphragm region.

• Korean Journal of Social Welfare
• /
• v.68 no.3
• /
• pp.73-103
• /
• 2016

In this study, it investigates the life of normal adolescents who have parents with intellectual disability and their difficulties which suggested social welfare meanings of this study. In order to conduct wide and in-depth analysis on cases by utilizing the characteristics of qualitative case studies, it describes and analyzes the intellectual disability parents' normal children in detail from the viewpoint of an insider through in-depth interviews, various sources and diverse data collecting methods. As for the subject of this study, both parents should be persons with intellectual disability and their child shall be non-disabled and at least a high school student or older. Through the intentional sampling, five late adolescents who were in high school, all males participated in the study. The data collection process had been conducted from January 2014 to May, which is commonly utilized for qualitative case studies, and comparative analysis between cases were practiced for analysis. For credibility of the research results, it obtained severity at each stage by meeting the standard. The analysis results were largely divided into "growth story of non-disabled adolescents" and "life of non-disabled adolescents". Nine upper categories analyzed the common features in each case. The nine categories were "no one tells me to study", "advance while learning the sense of academic achievement", "hide into my own space", "having to grown up early", "different parents but same love", "relatives raised me", "have a friend who accepts me as I am", "being pressed by poverty", and "standing on a knife edge of being hurt and taking heart". Based on the in-depth research on normal teens that have intellectually disabled parents, theoretically speaking, this study expanded the prospect of study on intellectually disabled to their normal, intellectual teenage children. As for practical significance, understanding their parents' intellectual disability, parenting technique training, case management from the community level is suggested. Rregular real condition research of the families, allowance system for economic support et al. is suggested in policy aspect.