• 대한방사선기술학회지:방사선기술과학
• /
• 제42권6호
• /
• pp.423-428
• /
• 2019

The Precise measurement of the knee's Congruence angle is required for diagnosis of patella dislocation. The purpose of this study is to consider the distortion diagram and usefulness about the test of the bilateral side and one side through the evaluating congruence angle from Merchant view of patellofemoral joint to central X-ray. We've evaluated the sulcus angle and Congruence angle following central X-ray's changes when we took Merchant view of patellofemoral joint aimed to right lower limb from human whole body phantom. The subject of the evaluation was classified as normal group and varus group, and the varus group has experimented with External rotation of legs as 15° and 30°. When normal groups result as 0, 7.5, 15 cm, it was measured as 17.25 ± 1.34°, 19.60 ± 1.41°, 20.55 ± 1.77° each. The gap between minimal and maximum angle was 3.3°, and the value was shown as getting bigger when it further away from the centeral X-ray. When Congruence angle in 15° varus group was 0, 7.5, 15 cm, it was each 16.45 ± 1.34°, 17.10 ± 0.99°, 17.80 ± 1.13°. And when Congruence angle in 30° varus group was 0, 7.5, 15 cm, it was measured each 18.35 ± 1.63°, 18.95 ± 1.06°, 19.60 ± 1.41°. The difference between minimum and maximum of angle in 15° varus group and 30° varus group was each 1.35° and 1.25°, the angles have shown as increasing the further away from the center. The patellofemoral joint showed that the congruence angle increases as the further away from Central X-ray, and also it is judged that is possible to change the congruence angle by a degree of varus knee. Thus, accurate measurement of the congruence angle is shown to advantage that methods for examining by split each side at two times than methods for examining both sides at a time. Therefore, it is expected to helpful on the diagnostic side of patella dislocation and subluxation.

• 한국전문물리치료학회지
• /
• 제22권3호
• /
• pp.12-22
• /
• 2015

The purpose of this study was to investigate the effect of taping on knee joint for patellofemoral compressive force (PCF) during stair descent for elderly women. Ten healthy elderly women voluntarily participated in this study. A three-dimensional motion analysis system and force plates were used to analyze the movements of the joints for the lower extremities. The results were as follows: There were no significant differences for the maximum PCF, maximum quadriceps contraction force and maximum knee extension moment (p>.05) but, there was a pattern decreasing all values with the taping during stair descent. There were significant differences for the knee and ankle angle on the event of maximum PCF (p<.05) and there was a pattern decreasing all values with the taping during stair descent. Therefore, taping on the knee would be effective to relieve the pain like patellofemoral pain syndrome in the knee joint.

• 한국운동역학회지
• /
• 제31권1호
• /
• pp.64-71
• /
• 2021

Objective: This study investigated the different in isokinetic peak strength of the knee joint, and kinetics and kinematics in drop landing pattern of lower limb between the patellofemoral pain syndrome (PFPS) patients and normal. Method: 30 adult females were divided into the PFPS (age: 23.13±2.77 yrs; height: 160.97±3.79 cm, weight: 51.19±4.86 kg) and normal group (age: 22.80±2.54 yrs, height: 164.40±5.77 cm, weight: 56.14±8.16 kg), with 15 subjects in each group. To examine the knee isokinetic peak strength, kinematics and kinetics in peak vertical ground reaction force during drop landing. Results: The knee peak torque (Nm) and relative strength (%) were significantly weaker PFPS group than normal group. In addition, PFPS group had significantly greater hip flexion angle (°) than normal group. Moreover, normal group had significantly greater moment of hip abduction, hip internal rotation, and left ankle eversion than PFPS group, and PFPS group had significantly greater moment of knee internal rotation. Finally, there was significant differences between the groups at anteroposterior center of pressure. Conclusion: The PFPS patients had weakened knee strength, and which can result in an unstable landing pattern and cause of more stress in the knee joints despite to effort of reduce vertical ground reaction force.

• 한국전문물리치료학회지
• /
• 제23권1호
• /
• pp.20-30
• /
• 2016

Background: Total knee arthroplasty (TKA) recovers the alignment of the knee joint, but fails to automatically restore the alignment and function of the hip and ankle joints. It may affect the alignment and stability of the knee joint, therefore therapeutic intervention in hip and ankle joint is necessary for the rehabilitation process after TKA. Objects: The aim of this study was to comparison of the effects of the two exercise methods on the coronal plane alignment after TKA. This study conducted an experiment by dividing subjects into a lower extremity isometric co-contraction group (LEIC) and a quadriceps isolated isometric contraction (QIIC) group. Methods: A total of 37 subjects were randomly assigned to the LEIC ($n_1$=19) or the QIIC ($n_2$=18). Exercise was applied to five times per week for three weeks, starting on the eighth day after surgery. Range of motion exercises were performed as a common intervention and then each group performed quadriceps isometric contraction exercises with 10 sets of 5 repetitions. Radiological imaging was performed prior to surgery, one month and six months after surgery. In addition, the hip-knee-ankle angle (HKA) and tibiotalar angle (TTA) were measured. Results: The HKA was close to neutral in the LEIC rather than the QIIC (p<.05). The LEIC showed varus and the QIIC exhibited valgus TTA (p<.05). In a comparison of HKA and TTA over time, there was no significant change in either group (p>.05). According to the comparison of the TTA before surgery, the LEIC showed significant changes in the varus direction (p<.05), while there was no significant change in the QIIC (p>.05). Conclusion: The LEIC method triggered changes in the TTA and brought the HKA close to the neutral. Thus, LEIC is more effective than QIIC in creating stability in the coronal plane alignment of the knee and ankle joints after TKA.

• 한국정밀공학회지
• /
• 제22권4호
• /
• pp.188-193
• /
• 2005

The purpose of this paper is to develop a more precise damper model of the joint for the quantification of the joint mechanical properties. We modified the linear damper model of a knee joint model to nonlinear one. The normalized RMS errors between the simulated and measured joint angle trajectories during passive pendulum test became smaller with the nonlinear damper model than those of the linear one which indicates the nonlinear damper model is better in precision and accuracy. The error between the experimental and simulated knee joint moment also reduced with the nonlinear damper model. The reduction in both the trajectory error and the moment error was significant at the latter part of the pendulum test where the joint angular velocity was small. The nonlinearity of the damper was significantly greater at thin subject group and this indicates the nonlinearity is a useful index of joint mechanical properties.

• 한국운동역학회지
• /
• 제27권3호
• /
• pp.189-195
• /
• 2017

Objective: The aim of this study was to examine the effect of foot landing type (forefoot vs. rearfoot landing) on kinematics, kinetics, and energy absorption of hip, knee, and ankle joints. Method: Twenty-five healthy men performed single-leg landings with two different foot landing types: forefoot and rearfoot landing. A motion-capture system equipped with eight infrared cameras and a synchronized force plate embedded in the floor was used. Three-dimensional kinematic and kinetic parameters were compared using paired two-tailed Student's t-tests at a significance level of .05. Results: On initial contact, a greater knee flexion angle was shown during rearfoot landing (p < .001), but the lower knee flexion angle was found at peak vertical ground reaction force (GRF) (p < .001). On initial contact, ankles showed plantarflexion, inversion, and external rotation during forefoot landing, while dorsiflexion, eversion, and internal rotation were shown during rearfoot landing (p < .001, all). At peak vertical GRF, the knee extension moment and ankle plantarflexion moment were lower in rearfoot landing than in forefoot landing (p = .003 and p < .001, respectively). From initial contact to peak vertical GRF, the negative work of the hip, knee, and ankle joint was significantly reduced during rearfoot landing (p < .001, all). The contribution to the total work of the ankle joint was the greatest during forefoot landing, whereas the contribution to the total work of the hip joint was the greatest during rearfoot landing. Conclusion: These results suggest that the energy absorption strategy was changed during rearfoot landing compared with forefoot landing according to lower-extremity joint kinematics and kinetics.

• 전기학회논문지
• /
• 제56권4호
• /
• pp.817-819
• /
• 2007

The purpose of this work is to develop a measurement system of the pendulum test with minimal restriction of experimental environment and little influence of noise. In this work, we developed a vision system without any line between markers and a camera. The system performance is little influenced by the experimental environment, if light are sufficient to recognize markers. For the validation of the system, we compared knee joint angle trajectories measured by the developed system and by the magnetic sensor system during the nominal pendulum test and the maximum speed voluntary knee joint rotation. The joint angle trajectories of the developed system during both tests matched well with those of the magnetic system. Therefore, we suggest the vision system as an alternative to the previous systems with limited practicality for the pendulum test.

• 한국운동역학회지
• /
• 제14권1호
• /
• pp.1-12
• /
• 2004

The purpose of this study is to provide training materials for practical use by investigating the kinematical variables of the successful landing by the type of the salto backward such as Tuck, Pike. For this study, the subjects are 4 male national gymnasts using 3-dimensional cinematographic method. Based on the results of this study, the conclusions are drawn as follows. 1. In flight phase, Tuck and Pike show fast extension after completing minimum angle of hip joint passing through the peak. It is very important factor to control body with gaining time before landing while decreasing the velocity of flight rotaion. 2. In Landing phase, the angles of each joint for successful landing are shown as $92deg{\sim}100deg$ for knee angle, $52deg{\sim}57deg$ for hip angle, and $56deg{\sim}70deg$ for shoulder angle. 3. Tuck and Pike dramatically decrease the height of COG, and horizontal/vertical velocity of COG from TD to LD. Also, it is shown that the knee angle, the hip angle and the shoulder angle decrease drastically. On the other hand, the angular velocity of trunk rotation shows negative direction and due to this, the angle of trunk rotation is shown as re-flexion.

• 대한방사선기술학회지:방사선기술과학
• /
• 제46권5호
• /
• pp.395-399
• /
• 2023

The knee arthritis patients are generally performed standing position radiography. However, patients with pain caused by degenerative diseases or injuries in the knee have difficulty maintaining a standing position. Therefore, this study aims to develop a knee joint standing weight bearing projection assist device to solve these problems when patients undergo knee radiography due to various diseases. The design of the knee joint weight-bearing radiography assist device is carried out with 3D design and drawing production to secure basic data, electric support and frame manufacture. A fixed device for maintaining the patient's knee standing weight-bearing projection, an electric digital height device, a digital protractor, and a safety device were designed. The arm support is made of PVC with a cushion to relieve the impact and make it easier to remove debris. The digital electric device can be moved up and down according to the patient's height, and a remote control is attached. The safety device is made to be adjustable in size by attaching metal hooks on both sides of the frame and to shield the scrotum. A digital protractor was attached to the side frame to set the desired knee angle. When a self-made assist device was used to perform a knee joint standing weight bearing projection, it helped maintain arm support and lower extremities position. In addition, the height could be adjusted using an assist device during standing projections, which helped the patient maintain the position.

• PNF and Movement
• /
• 제20권2호
• /
• pp.189-201
• /
• 2022

Purpose: The purpose of this study was to investigate the effect of McConnell taping and Kinesio taping on pain and lower extremity joint angles when patients with patellofemoral pain syndrome (PFPS) ascend stairs. Methods: Fifty young adults who were experiencing anterior knee pain due to PFPS were selected as participants. Then, 25 patients were randomly assigned to the McConnell taping group and 25 to the Kinesio taping group. Pain and lower extremity joint angle were measured while ascending stairs before and after the intervention. A paired t-test was performed to evaluate the amount of change in the parameter values after the intervention within the groups, and an independent t-test was used to compare the results of the groups. Results: In the within-group comparisons, a statistically significant difference was found in both groups between the anterior knee pain scale scores recorded before and after the intervention (p < 0.05). A statistically significant difference was also found between the groups (p < 0.05). Comparison of the lower extremity joint angles at initial contact, loading response, terminal stance, and pre-swing within the groups showed that there were statistically significant differences in the hip, knee flexion, abduction, lateral rotation, and dorsiflexion angles in both the McConnell and Kinesio taping groups (p < 0.05). There was also a statistically significant difference in all angles between the groups during the following events (p < 0.05): (1) at initial contact, (2) at loading response (except hip flexion angle), (3) at terminal stance (except hip flexion and lateral rotation angles), and (4) at pre-swing (except hip, knee abduction, and inversion angles). Conclusion: McConnell taping and Kinesio taping both effectively improved the occurrence of knee pain and the lower extremity joint angles during stair ascent in patients with PFPS. However, McConnell taping had a significant impact on pain reduction and lower extremity joint angles compared to Kinesio taping.