• Journal of Korea Technology Innovation Society
• /
• v.10 no.4
• /
• pp.605-628
• /
• 2007

We analyze the embedded structure of the cooperative research network of innovation studies in Korea by employing the social network methodology. The network covers all the contributing authors of two journals such as JTI and KTIS, which are the representative journals in the area. Across the networks, the following is noted: networks are highly segmented and the link density is low. However, the KTIS network contains a huge component with 131 authors which implies the existence of a strong cooperative research infrastructure. We derived three sub-networks such as technology economics, technology management, and technology policy. The technology policy network has the lowest link density, while the technology management network of KTIS shows relatively high cohesion among the researchers. Simulation analysis for the mean links of networks by author affiliation divided into university and others show no significant difference between the two networks. We also found a higher ratio of linkage within affiliated network than between networks, rejecting our hypothesis that researchers will not discriminate their research partners due to strong governmental inducement of academia-res each-industry cooperation. The explainability of indices from network structure such as structural holes and clustering coefficients on the performance of researchers measured by the number of citations confirms the results reported in Oh, Choi & Kim (2006) which dealt with the research network of information systems.

• Korean Journal of Plant Taxonomy
• /
• v.38 no.1
• /
• pp.51-61
• /
• 2008

Leaves are indeterminate organs and possess a lot of genes which is involved in establishing leaf polarities. These polarities are regulated relatively early during leaf development and defined relative to the factors intrinsic to the primordia and interactions with the shoot apical meristem (SAM). Recently, several genes that control the polarity of lateral organs have been identified. Our genetic study of deformed root and leaf1 (drl1) mutant, which produces narrow, filament‐like leaves and defective meristems, revealed that DRL1 is involved in the regulation of SAM activity and leaf polarity. The DRL1 gene was found to encode a novel protein showing homology to Elongator‐associate protein (EAP) of yeast KTI12. The amino acid sequence of DRL1 is universally conserved in prokaryotes and eukaryotes. DRL1 and the plant DRL1 homologs clearly formed a monophyletic clade, suggesting the evolutionary conservation of DRL1 homologs was maintained in the genomes of all land plants.

• Current Optics and Photonics
• /
• v.3 no.4
• /
• pp.342-349
• /
• 2019

We present a theoretical research concerning terahertz (THz) wave generation with $KTiOPO_4$ (KTP) by collinear phase matching (CPM) stimulated polariton scattering (SPS). Both CPM and corresponding nonzero nonlinear coefficients can be simultaneously realized with $s{\rightarrow}f+f$ in yz plane, $s{\rightarrow}f+s$ with ${\theta}$ < ${\Omega}$ in xz plane and $s{\rightarrow}f+f$ with ${\theta}$ < ${\Omega}$ in xz plane. The effective nonlinear coefficients including electronic nonlinearities and ionic nonlinearities are calculated. Based on the parameter values of refractive indices, absorption coefficients and effective nonlinear coefficients, we simulate THz wave intensities generated with CPM SPS by solving coupled wave equations and give the relationship among the maximum THz wave intensity, optimal crystal length and the angle ${\theta}$. The calculation results demonstrate that CPM SPS with KTP can generate THz waves with high intensities and quantum conversion efficiencies.

• Journal of the Korea Safety Management & Science
• /
• v.17 no.4
• /
• pp.77-86
• /
• 2015

In the industrial accident that occurred in the recent contract type of business or establishment (including subcontractor) employers and contractors who demand among employers, would be liable to have a proper discussion on how to prevent industrial accidents. To resolve this issue, it introduced the discussion with the Japanese legal system, which has a system similar to the Occupational Safety and seeks to help us in our country's future institutional improvements.

• Medical Lasers
• /
• v.9 no.2
• /
• pp.126-133
• /
• 2020

Recurrent respiratory papillomatosis (RRP) is a benign tumor that occurs in the respiratory tract, especially in the larynx. The etiology of RRP is human papillomavirus (HPV). According to the age of occurrence, RRP is divided into childhood-onset and adult-onset types. Generally, childhood-onset RRP shows a high recurrence rate and diffuse involvement in the respiratory tract. Adult-onset RRP is more localized and appears more frequently as a solitary lesion. It may be the result of sexual transmission or the proliferation of latent HPV infections. At present, the treatment of choice for RRP is CO₂ laser ablation. In addition, pulse dye laser or KTP (KTiOPO: potassium-titanyl-phosphate) lasers are also used. Non-surgical adjuvant therapies can be applied in cases requiring repetitive surgery or with diffuse extensions. This review will introduce the clinical features of RRP and various treatment options including lasers.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.3 no.1
• /
• pp.12-17
• /
• 1993

Growth runs of KTP single crystals were carried out by the hydrothermal method. KTP powders used for the crystal growth were prepared as a single phase by the solid state reaction of a stoichiometric mixture of $KH_2PO_4 and TiO_2$ at TEX>$800^{\circ}C$ and subsequently by the hydrothermal treatment at $250^{\circ}C$ 4m KF solution. The most effective solvents for the crystal growth of KTP were KF and K $K_2HPO_4$ solutions. Solubilities of KTP in these solutions were positive over the range $350~450^{\circ}C$.Seed crystals of good quality could be obtained by the horizontal temperature gradient method at temperatures over the range 380~430^{\circ}C$ in these solutions. The hydrothermal conditions for the high growth rates of seed crystals are as follows: growth method; vertical temperature gradient method, solvent; 4m KF or $K_2HPO_4$ solution, temperature region; $400~450^{\circ}C$, pressure region; $1000~1500kg/cm^2$, where solubility of KTP was large enough to proceed the growth. Under such conditions, seed crystals of KTP are grown at a rate of approximately 0.06-0.08mm/day in the direction of the c-axis. Morphologies of grown crystals tended to be bounded by (100), (011) and (201) faces.

• Korean Journal of Crystallography
• /
• v.4 no.1
• /
• pp.42-48
• /
• 1993

KTP(KTiOPO4) single crystals were grown by the TSSG(top seeded solution growth) method using the Ksp401s flux. A heat-pipe based growing furnace was used, and the temperature stability and the homogenity of the growing solution in the platinum crucible were within the level of It 0.5℃ and ±0.9℃, respectively. The effects of some operating variables such as operating temperature range, initial cooling rate, forced stirring, reuse of the flux were investigated. As the initial cooling rate was decreased to the degree of 0.1℃/hr and some proper stirring effect by the crystal rotation was introduced to the present experimental condition, bigger and better crystals without inclusion grew. A single crystal with the maximum sixte of 44 ×39 ×17mm3 was obtained and showed the SHG conversion efficiency of 21.39) even without the anti-refilection coating.

• Proceedings of the Optical Society of Korea Conference
• /
• 2000.08a
• /
• pp.88-89
• /
• 2000

The properties for self-frequency doubling (SFD) is unique phenomena for a small number of special single crystals. It is known that there are serious limitations to vary the concentration of active ions, for example high doping of active ions from 1 to 50 atomic %, in nonlinear materials. Until now, the Nd:YAl$_3$(BO$_3$)$_4$ (YAB) and Nd:(Ce,Gd)Sc$_3$(BO$_3$)$_4$ (CSB) crystals with high doping rates are well studied for the application of SFD purpose. They have much useful SFD properties, but also have big problems in crystal growth. In case of YAB crystal, it can be grown by solution melt method with very low growth rates and easy occurrence of inclusions. In case of CSB crystal, it has optically heterogeneity problems because of disarrangement of ions in huntite structure [1]. These problems make above crystals not so attractive for optical applications. Some popular nonlinear materials, such as LiNbO$_3$(LN), KTiOPO$_4$(KTP), LiB$_3$O$_{5}$ (LBO) crystals, are impossible to substitute by Rare Earth activators because of their crystallo-chemical problems of structure. When we dope active ions with the requisite concentrations for laser generation, it results in decreasing of optical quality of crystals or destroying of acentrosymmetric structure. (omitted)d)

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.4 no.1
• /
• pp.100-104
• /
• 1994

KTP seed crystals were grown by the hydrothermal method and the properties of grown crystals were investigated by means of infrared spectrophotometer. The hydrothermal conditions for high growth rates of seed crystals are as follows: temperature ranges, between , $430 and 450^{\circ}C $ ; hydrothermal solvent, 4m KF solution ; temperatures difference, $30<{\triangle}T<65^{\circ}C$ ; filling %, 65% ; growth method, vertical temperature gradient method. Under these conditions, morphologies of the grown KTP single crystals tended to be bounded by (100), (011) and (201) faces and hydroxyl groups were observed in the grown crystals.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2008.11a
• /
• pp.35-36
• /
• 2008

PTC thermistor are characterized by an increase in the electrical resistance with temperature. The PTC materials of middle Curie point were produced or that of high Curie point (above $200^{\circ}C$), it was determined that compositional modifications of $Pb^{2+}$ for $Ba^{2+}$ produce change sin the Curie point to higher temperature. PTC ceramic materials with the Curie point above $120^{\circ}C$ were prepared by adding $PbTiO_3$, PbO or $Pb_3O_4$ into $BaTiO_3$. Thereby, adding $Pb^{2+}$ into $BaTiO_3$-based PTC material to improve Tc was studied broadly, however, weal know that PbO was poisonous and prone to volatilize, then to pollute the circumstance and hurt to people, so we should dope other innocuous additives instead of lead to increase Tc of composite PTC material. In order to prepare lead-free $BaTiO_3$-based PTC with middle Curie point, the incorporation on $Bi_{1/2}K_{1/2}TiO_3$ into $BaTiO_3$-based ceramics was investigated on samples containing 0, 1, 2, 3, 4, and 50mol% of $Bi_{1/2}K_{1/2}TiO_3$. $Bi_{1/2}K_{1/2}TiO_3$ was compounded as standby material by conventional solid-state reaction technique. The starting materials were $Bi_2O_3$, $K_2CO_3$, $BaCO_3$ and $TiO_2$ powder, and using solid-state reaction method, too. The microstructures of samples were investigated by SEM, DSC, XRD and dielectric properties. Phase composition and lattice parameters were investigated by X-ray diffraction.