• Corrosion Science and Technology
• /
• v.19 no.1
• /
• pp.43-50
• /
• 2020

In this study, the effects of KCl(s) and K₂SO₄(s) on the oxidation characteristics of 2.25Cr-1Mo steel were investigated for 500 h in 10O₂ + 10CO₂ (vol%) gas environmen at 650 ℃. Oxidation kinetics were characterized by weight gain, oxide layer thickness, and fitted models for the experiment data were proposed. The fitted models presented considerable agreement with the experimental data. The oxide layer was analyzed using the scanning electron microscope, optical microscope, and energy dispersive X-ray spectroscopy. The oxidation kinetics of 2.25Cr-1Mo steel with KCl and K₂SO₄ coatings showed significantly different oxidation kinetics. KCl accelerated the oxidation rate very much and had linear oxidation behavior. In contrast, K₂SO₄ had no significant effect, which had parabolic kinetics. The oxide layer was commonly composed of Fe₂O₃, Fe₃O₄, and FeCr₂O₄ spinel. KCl strongly accelerated the oxidation rates of 2.25Cr-1Mo steel in the high-temperature oxidation environment. Conversely, K₂SO₄ had little effect on the oxidation rates.

• Journal of Surface Science and Engineering
• /
• v.47 no.1
• /
• pp.48-52
• /
• 2014

Electric conductivities of $LaCl_3$-KCl binary melts have been measured by the Kohlausch bridge method over the range from their liquidus temperatures to about 1280 K. The electric conductivity increased with the content of KCl for all over the composition range of binary melts. The composition dependence of the electric conductivity and molar conductivity for the binary melt showed a non-linear relation from the additivity line, and the deviation showed a maximum value at about 60 mol.% KCl. The deviation implies the existence of complex ion of $LaCl^{4-}$ in the melt. Activation energy for electric conductivity of the binary melts decreased monotonously with increasing content of KCl.

• Resources Recycling
• /
• v.26 no.6
• /
• pp.38-44
• /
• 2017

As by-pass dust (BPD) made from cement manufactured process is designated waste, it is required to bury as high cost. The main component of BPD is potassium chloride (KCl), and used for the fertilizer. For using KCl to the fertilizer, the pH value of KCl is required as neutral or weak acid. However, it is not suitable to apply BPD into the fertilizer directly without any other treatment because BPD's pH value is shown 12.0~12.5; a high base. In this study, the carbon dioxide ($CO_2$) was used for removing calcium oxide (CaO) and reducing pH value during manufacturing process of KCl. We fixed inner condition of the carbon test chamber as $25^{\circ}C$-50RH%, and retained 0~7 hours under the 20 vol% of $CO_2$ atmosphere. After experiment, we analyzed the content of CaO and pH value from each samples. The more time exposed to $CO_2$, the content of CaO and pH value are shown. Furthermore, pH value exposed in 6 hours nearly reached 7.

• Journal of the Korean Electrochemical Society
• /
• v.20 no.1
• /
• pp.7-12
• /
• 2017

Using a precursor of $LiNi_{0.6}Co_{0.2}Mn_{0.2}O_2$ as a starting material, a surface-modified cathode material was obtained by coating with KCl, where the added KCl reduces residual Li compounds such as $Li_2CO_3$ and LiOH, on the surface. The resulting electrochemical properties were investigated. The amounts of $Li_2CO_3$ and LiOH decreased from 8,464 ppm to 1,639 ppm and from 8,088 ppm to 6,287 ppm, respectively, with 1 wt% KCl added $LiNi_{0.6}Co_{0.2}Mn_{0.2}O_2$ that had been calcined at $800^{\circ}C$. X-ray diffraction results revealed that 1 wt% of KCl added $LiNi_{0.6}Co_{0.2}Mn_{0.2}O_2$ did not affect the parent structure but enhanced the development of hexagonal crystallites. Additionally, the charge transfer resistance ($R_{ct}$) decreased dramatically from $225{\Omega}$ to $99{\Omega}$, and the discharge capacity increased to 182.73mAh/g. Using atomic force microscopy, we observed that the surface area decreased by half because of the exothermic heat released by the Li residues. The reduced surface area protects the cathode material from reacting with the electrolyte and hinders the development of a solid electrolyte interphase (SEI) film on the surface of the oxide particles. Finally, we found that the introduction of KCl into $LiNi_{0.6}Co_{0.2}Mn_{0.2}O_2$ is a very effective method of enhancing the electrochemical properties of this active material by reducing the residual Li. To the best of our knowledge, this report is the first to demonstrate this phenomenon.

• Journal of Nuclear Fuel Cycle and Waste Technology(JNFCWT)
• /
• v.13 no.3
• /
• pp.181-186
• /
• 2015

It is necessary to develop an effective waste salt treatment technology for the minimization of radioactive waste generation from the pyroprocessing of spent nuclear fuel. For this reason, the separation characteristics of NdCl₃ from LiCl-KCl eutectic salt in a reactive distillation process using Li₂CO₃ or K₂CO₃ were observed. NdCl₃ was converted into oxychloride (NdOCl) or oxide (Nd₂O₃) in the reaction model between NdCl₃ and the carbonates using HSC-Chemistry, and this result was confirmed in the reactive distillation test of the LiCl-KCl-NdCl₃ system using the carbonates. Based on these results, the reactive distillation process conditions were determined to separate NdCl₃ into an oxide form (Nd₂O₃) which can be easily fabricated into a final waste form.

• Nuclear Engineering and Technology
• /
• v.54 no.2
• /
• pp.653-660
• /
• 2022

The interaction between UN and CdCl₂ in the LiCl-KCl molten eutectic was studied at 1023 K. The chlorination was monitored by sampling and recording the redox potential of the medium. At 1023 K the chlorination of UN with cadmium chloride in the molten LiCl-KCl eutectic proceeds completely and results in the formation of uranium chlorides. The melts of the LiCl-KCl-UCl₃ or LiCl-KCl-UCl₄ compositions can be obtained by the end of experiment depending on the presence of metallic cadmium in the reaction zone. The higher the concentration of the chlorinating agent, the faster the reaction rate. At [CdCl₂]/[UN] = 1.65 (10% excess) the reaction proceeds to completion in about 7.5 h. At [CdCl₂]/[UN] = 7 the complete chlorination takes 2.5-3 h.

• Journal of Bio-Environment Control
• /
• v.29 no.4
• /
• pp.354-364
• /
• 2020

This study was conducted to examine the potential of inducing salinity stress on cylindrical paper pot tomato seedlings to inhibit overgrowth. Potassium fertilizers, sulfate of potash (K₂SO₄), muriate of potash (KCl), and monopotassium phosphate (KH₂PO₄), were prepared as two solutions of (5 and 10) dS·m^-1 salinity level, respectively, to investigate the influence on tomato (Lycopersicon esculentum Mill.) seedling growth. We also investigated the adaptability and survivability of treated tomato seedlings with high-salinity potassium (10 dS·m^-1 KCl) to harsh environmental conditions (water deficit, low temperature, and storage conditions). Repeated addition of high-salinity level KCl, K₂SO₄, or KH₂PO₄ markedly decreased the dry matter of shoot and root, leaf area, and net assimilate rates (NAR) but increased the stem diameter of seedlings. Among the three sources, the relative growth rate of plant height (RGR_H) was most sensitive to KCl addition; increasing salinity levels of KCl solution decreased the RGR_H of seedlings. The compactness, which directly reflects the stocky growth index, increased in KCl or KH₂PO₄ treatments. After a week's water deficit, severely wilted seedlings were observed in control seedlings (untreated with KCl), but no wilted seedlings were observed in the KCl treated seedlings, and the relative water content (RWC) of the untreated seedlings significantly decreased by 23 %, while that of the pretreated seedlings only decreased by 8 %. The increase in ion leakage of KCl treated seedlings at low temperatures was less than that of untreated seedlings. Furthermore, there was far lower damage proportion on pretreated seedlings at (9, 12, and 15)℃ storage temperatures after 20 days, compared with on unpretreated seedlings. Our results suggest that high-salinity potassium fertilizer, especially KCl, is effective in preventing tomato seedling overgrowth, while it also improves tolerance.

• Journal of the Korean Chemical Society
• /
• v.54 no.3
• /
• pp.269-274
• /
• 2010

The solubility and the physicochemical property (refractive index) in the NaCl-$CaCl_2$-$H_2O$ and KCl-$CaCl_2$-$H_2O$ systems were determined at $50^{\circ}C$ and the phase diagrams and the diagrams of physicochemical property vs composition were plotted. One invariant point, two univariant curves, and two crystallization zones, corresponding to sodium Chloride (or potassium chloride), dihydrate ($CaCl_2{\cdot}2H_2O$) showed up in the phase diagrams of the ternary systems. The mixing parameters ${\theta}_{M,Ca}$ and ${\Psi}_{M,Ca,Cl}$ (M = Na or K) and equilibrium constant $K_{sp}$ were evaluated in NaCl-$CaCl_2-H_2O$ and KCl-$CaCl_2-H_2O$ systems by least-squares optimization procedure, in which the single-salt Pitzer parameters of NaCl, KCl and $CaCl_2$ ${\beta}^{(0)}$, ${\beta}^{(1)}$, ${\beta}^{(2)}$ and $C^{\Phi}$ were directly calculated from the literature. The results obtained were in good agreement with the experimental data.

• Journal of the Korean Society of Food Science and Nutrition
• /
• v.14 no.1
• /
• pp.82-87
• /
• 1985

Some biological activities showed as ATPase activity of myofibril, actomyosin and myosin extracted from chicken leg and pectoral skeletal muscle were investigated. The $Mg^{+2}$-ATPase activity at 0.05 M KCl were 0.82, 0.38 and 0.11 ${\mu}mole$ Pi/mg protein/min. in actomyosin, myofibril and myosin from pectoral muscle while 0.71, 0.32 and 0.08 ${\mu}mole$ Pi/mg protein/min. in actomyosin, myofibril and myosin from leg muscle. EDTA-ATPase activity at 0.6M KCl were 0.80, 0.42 and 0.40 ${\mu}mole$ Pi/mg protein/min. in actomyosin, myofibril and myosin from pectoral muscle. In case of leg muscle, that activity was noted as 0.69, 0.33 and 0.28 ${\mu}mole$e Pi/mg protein/min in proteins. ATPase activity of myosin from leg and pectoral muscle were inhibited in 10% at a higher concentration of $Mg^{+2}$ than molar concentration of EDTA, and the ATPase activity was increased to 400% compared with control at $10^{-3}M$ of $Ca^{+2}$. Actomyosin from pectoral muscle was solubilized at 0.1 M KCl above and that from leg muscle was solubilized at 0.15 M KCl above. In case of myosin, pectoral muscle was solubilized at 0.25M KCI above and leg muscle was solubilized at 0.30M KCl above.

• Applied Chemistry for Engineering
• /
• v.9 no.5
• /
• pp.786-790
• /
• 1998

K-GIC of the new carbon electrode to improve performance of carbon negative electrode in lithium ion secondary battery was prepated and its electrical characteristics were studied. Form this study, intercalated K quantity was increased in order of $2>3>1mole/{\ell}$ of KCl solution. And, for KCl solution of 1mole, the mole ratio of carbon and potassium was 156~388 carbon/potassium. The proper condition of K-GIC preparation was KCl solution of $1mole/{\ell}$, reaction temperature of $700^{\circ}C$, reaction time of 1 hour. From this condition, the intercalation and deintercalation behavior of lithium was very excellent. Also the reversibility was excellent.