• Journal of the Optical Society of Korea
• /
• v.18 no.5
• /
• pp.436-441
• /
• 2014

We have demonstrated an amplified wavelength-division multiplexed (WDM) passive optical network (PON) by using broadband light source (BLS) seeded optical sources and chirped fiber Bragg gratings (FBGs) based dispersion compensators. Chirped FBGs located at central office (CO) were fabricated and used as channel-by-channel dispersion compensators in order to mitigate the dispersion-induced distortion of both downstream and upstream signals. Owing to a low insertion loss of chirped FBG based dispersion compensator, the optical signal-to-noise ratio (OSNR) of the downstream signal could be improved to be ~28 dB. Thus, we re-confirmed that an error-free transmission of 1.25 Gb/s signals over a 100 km single-mode fiber (SMF) link could be achieved with a proposed amplified WDM-PON architecture. We have also evaluated the impact of various noises on the system's performance, and found that the low OSNR of the downstream signal would be a main limiting factor on the maximum reach of the proposed amplified WDM-PON architecture. From the measured ~13 dB improvement in OSNR of the downstream signal compared to our previously-proposed dispersion compensating module based scheme, we believe that the proposed architecture can accommodate a reach of longer than 100 km SMF link easily.

• Journal of Fisheries and Marine Sciences Education
• /
• v.12 no.1
• /
• pp.1-10
• /
• 2000

In order to obtain the fundamental data on the auditory thresholds of fishes for marine ranching, the auditory thresholds of black rock fish Sebastes Schlegeli were measured in the presence of masking noise in the spectrum level range of 73 - 83dB (0dB re $1{\mu}Pa/{\sqrt{Hz}}$) with a classical cardiac conditioning technique. Critical ratios were about 19 - 30dB at 80 - 300Hz and 46 - 54dB at 500 - 800Hz. The ratio increased almost linearly with increasing frequency to 500Hz. The noise spectrum level at the start of masking was about 70dB within the frequency range of 80 - 800Hz excepting 65dB at 300Hz. This suggests that hearing of the black rock fish is masked in the natural environment with the noise spectrum level above 65dB. The sound pressure level of which the signal sound of 100 - 200Hz is recognized by black rock fish under the ambient noise is above 90dB and the critical ratio of them is above 20dB.

• Korean Journal of Materials Research
• /
• v.20 no.5
• /
• pp.241-245
• /
• 2010

One of the weak points of the Cr-doped SZO is that until now, it has only been fabricated on perovskite substrates, whereas NiO-ReRAM devices have already been deposited on Si substrates. The fabrication of RAM devices on Si substrates is important for commercialization because conventional electronics are based mainly on silicon materials. Cr-doped ReRAM will find a wide range of applications in embedded systems or conventional memory device manufacturing processes if it can be fabricated on Si substrates. For application of the commercial memory device, Cr-doped $SrZrO_3$ perovskite thin films were deposited on a $SrRuO_3$ bottom electrode/Si(100)substrate using pulsed laser deposition. XRD peaks corresponding to the (112), (004) and (132) planes of both the SZO and SRO were observed with the highest intensity along the (112) direction. The positions of the SZO grains matched those of the SRO grains. A well-controlled interface between the $SrZrO_3$:Cr perovskite and the $SrRuO_3$ bottom electrode were fabricated, so that good resistive switching behavior was observed with an on/off ratio higher than $10^2$. A pulse test showed the switching behavior of the Pt/$SrZrO_3:Cr/SrRuO^3$ device under a pulse of 10 kHz for $10^4$ cycles. The resistive switching memory devices made of the Cr-doped $SrZrO_3$ thin films deposited on Si substrates are expected to be more compatible with conventional Si-based electronics.

• Restorative Dentistry and Endodontics
• /
• v.21 no.2
• /
• pp.585-601
• /
• 1996

The purpose of this study was to elucidate the effect of blood-and saliva-contamination during dentin pretreatment procedure on tensile bond strength, and to investigate the effect of contaminant-removing treatments on the recovery of bond strength of dentin bonding agents. Dentin specimens prepared from freshly extracted bovine mandibular anterior teeth were divided into non-contaminated control and contaminated experimental groups. The specimens of the contaminated group were contaminated with saliva or blood after etching or priming procedure, followed by contaminant-removing treatments. All the specimens were bonded with All Bond$^{(R)}$ 2 dentin bonding agent and Bisfil$^{TM}$ composite resin or Scotchbond$^{TM}$ Multipurpose and Z100. After all the bonded specimens were stored in $37^{\circ}C$ distilled water for 24 hours, tensile bond strengths were measured. The contaminated dentin and fractured dentin surfaces were examined under the scanning electron microscope. The results were as follows : Contaminated specimens showed lower bond strength than non-contaminated ones regardless of the kind of contaminant, contamination time and contaminant-removing treatments, except specimens which were acid-etched following saliva contamination after etching in All Bond$^{(R)}$ 2 groups (p<0.05). Blood contaminant resulted in much bond strength decrease than saliva ones (p<0.01), and contamination after priming resulted in much decrease in bond strength than after etching (p<0.01). Re-etching resulted in increase of bond strength in the specimens contaminated with saliva after etching but not in blood contaminated ones. Re-priming resulted in increase of bond strength in the specimens contaminated after priming regardless of the kind of contaminant.

• Proceedings of the KSME Conference
• /
• 2000.11b
• /
• pp.314-320
• /
• 2000

In this study, the wet surface heat transfer coefficients and friction factors of PF heat exchangers are presented. Two sample with different fin pitch(1.25mm, 1.5mm) were tested. Tests were conducted in a open loop wind tunnel. The wet surface heat transfer coefficient was reduced following the procedure given in ARI 410-81. Results showed that the heat transfer coefficients of the heat exchanger with 1.5mm fin pitch were approximately the same as those with 1.25mm fin pitch, except at low reynolds number(Re<100), where the heat transfer coefficients of 1.5mm fin pitch were slighly higher than those with 1.25mm fin pitch. The friction factors of the 1.25mm fin pitch, however was 120 % to 160 % higher than those of the 1.5mm fin pitch. The wet surface heat transfer coefficients were lower than those of the dry surface. The wet surface friction factors, however, were higher than those of the dry surface.

• Electrical & Electronic Materials
• /
• v.5 no.4
• /
• pp.439-445
• /
• 1992

최근 광자기 기록매체로 주목받고 있는 RE-TM계 비정질 박막을 T $b_{x}$ (F $e_{0.9}$ $Co_{0.1}$)$_{100-x}$ (x=14, 17, 20, 23, 27[at%])의 조성비를 갖는 모합금을 만든후 진공증착방법으로 합금박막을 제작하였다. 각시료의 조성에 따른 자기광학효과를 알아보기 위하여 80K부터 600K에서 포화자화( $M_{s}$ )와 보자력( $H_{c}$)에 대한 온도의존성과 자기이방성상수(Ku), Polar Kerr 이력곡선을 측정하였다. 또한 Curie 온도 근처에서 열처리 시간에 따른 자기 토크 곡선의 변화를 분석 함으로써 합금박막 표면의 산화정도를 정성적으로 평가할 수 있었다. 실험결과 T $b_{22.72}$(F $e_{68.78}$ $Co_{8.5}$)인 시료가 상온에서 8.4KOe의 보자력을 가졌으며 T $b_{x}$(x=23[at%])인 경우가 가장 큰 수직자기이방성을 나타냈다. Polar Kerr 이력곡선은 Tb함량 x=25~26[at%]에서 부호가 반전됨을 알 수 있었다.다.다.다.

• International Journal of Air-Conditioning and Refrigeration
• /
• v.9 no.2
• /
• pp.19-27
• /
• 2001

In the present study, the effects of film Reynolds number (60∼200) and volumetric content of non-absorbable gases (0∼10%) in water vapor on the absorption process of aqueous LiBr solution were investigated experimentally. The formation of solution film on the horizontal tubes of six rows was observed to be complete for Re>100. Transition film Reynolds number was found to exist above which the Nusselt number and Schmidt number diminishes with solution flow rate. As the concentration of non-absorbable gases increased, mass transfer rate decreased more seriously than heat transfer rate did. the degradation effects of non-absorbable gases seemed to be significant especially when small amount of non-absorbable gases was introduced to the pure water vapor.

• Journal of Powder Materials
• /
• v.10 no.3
• /
• pp.190-194
• /
• 2003

Thin Ag films deposited onto $SiO_2/Si$ substrates by DC magnetron sputtering and thereafter annealed ,it temperatures 100-50$0^{\circ}C$ are investigated by scanning tunneling and atomic forte microscopy. It is shown that the film surface topography and microstructure are considerably changed as a result of annealing. To provide a quantitative estimation of the surface topography changes of Ag films the surface fractal dimension was calculated. Elasticity and hardness of the films are studied by a nanoindentation technique. The films are found to have value of elastic modulus close to that of bulk silver while their hardness and yield stress are essentially higher.

• Archives of Pharmacal Research
• /
• v.23 no.5
• /
• pp.495-500
• /
• 2000

We investigated whether S-adenosylmethionine (SAM) treatment improved ischemic injury using perfused rat liver after sequential periods of 24 h cold and 20 min re-warming ischemia. SAM (100 $\mu\textrm{mol/L}$) was added to University of Wisconsin (UW) solution and Ringers lactate solution. After cold and sequential warm ischemia, releases of lactate dehydrogenase (LDH) and purine nucleoside phosphorylase (PNP) markedly increased during repefusion. The increase in PNP was significantly reduced by SAM treatment. While the concentration of reduced glutathione (GSH) in ischemic livers significantly decreased, the concentration of glutathione disulfide (GSSG) increased. This decrease in GSH and increase in GSSG were suppressed by SAM treatment. Lipid peroxidation was elevated in cold and warm ischemic and reperfused livers, but this elevation was also prevented by SAM treatment. Hepatic ATP levels were decreased in the ischemic and reperfused livers to 42% of the control levels. However, treatment with SAM resulted in significantly higher ATP levels and preserved the concentration of AMP in ischemic livers. Our findings suggest that SAM prevents oxidative stress and lipid peroxidation and helps preserve hepatic energy metabolism.

• International Journal of Air-Conditioning and Refrigeration
• /
• v.13 no.3
• /
• pp.158-166
• /
• 2005

The present study investigated experimentally and numerically the enhancement of absorption performance due to the waviness of falling film in the vertical absorber tube. The momentum, energy and mass diffusion equations were utilized to find out temperature and concentration profiles at both the interfaces of liquid solution and refrigerant vapor and the wall. Flow visualization was performed to find out the wetting characteristics of the falling film. The maximum heat transfer coefficient was obtained for the wavy flow using spring as an insert device through both numerical and experimental studies. Based on the numerical and experimental results, the maximum absorption rate was found for the wavy-flow using spring as the insert device. The differences between experimental and analytical results ranged from $5.0\;to\;25\%\;when\;Re_j>100$.