• 대한기계학회논문집A
• /
• 제23권11호
• /
• pp.1886-1895
• /
• 1999

The delamination behavior of multidirectional carbon-fiber/epoxy composite laminates under 10NA intermediate and high rates of test, up to rate of about 11.4m s has been investigated using the double cantilever beam specimens. The mode I loading under rates above l.0m/s showed considerable dynamic effects on the load-time curves and thus higher values of the average crack velocity than that expected from a simple proportional relationship with the test rate. The modified beam analysis utilizing only the opening displacement and crack length exhibited an effective means for evaluating the dynamic fracture energy $G_{IC}$. Based on the assumption of constant flexural modulus, values of $G_{IC}$ at the crack initiation and arrest were decreased with an increase of the test rate up to 5.7m/s, but the maximum $G_{IC}$ was increased at 11.4m/s.

• Structural Engineering and Mechanics
• /
• 제74권5호
• /
• pp.711-722
• /
• 2020

In this study, on-site testing was carried out to investigate the vibration serviceability of a composite steel-bar truss slab with steel girder system. Impulse excitations (heel-drop and jumping) and steady-state motion (walking and running) were performed to capture the primary vibration parameters (natural frequency and damping ratio) and distribution of peak acceleration. The composite floor possesses low frequency (<8.3Hz) and damping ratio (<2.47%). Based on experimental, theoretical, and numerical analyses on fundamental natural frequency, the boundary condition of SCSS (i.e., three edges simply supported and one edge clamped) is deemed more comparable substitutive for the investigated composite floor. Walking and running excitations by one person (single excitation) were considered to evaluate the vibration serviceability of the composite floor. The measured acceleration results show a satisfactory vibration perceptibility. For design convenience and safety, a crest factor β_rp describing the ratio of peak acceleration to root-mean-square acceleration induced from the walking and running excitations is proposed. The comparisons of the modal parameters determined by walking and running tests reveal the interaction effect between the human excitation and the composite floor.

• 한국안전학회지
• /
• 제10권4호
• /
• pp.13-21
• /
• 1995

On mini-bus with diesel engine, at idle rpm for taking measurement to reduce gear rattle noise, was tested by the three clutch disc samples by turns, then measured the fluctuation of revolution of engine & transmission and parallel vibration of differential gear & transmission. By analyzing the measured data, the gear rattle noise, the matching design and tuning technic of transmission are comprehended and established. Conclusions of this test are as follows ; (1) Fluctuation of revolution on transmission is greatly affected by torsion of clutch disc according to fluctuation of engine revolution transmit to transmission through clutch system. Especially, gear rattle noise can be reduced by minimaizing the fluctuation of the revolution of transmission using pre-damper type clutch disc. (2) The reason of gear rattle noise is higher in summer than winter and driving longer period than initial driving is due to affection by drag torque changing. So, it is necessary for manufacturer to choose proper oil to transmission. (3) It can be occurred jumping and crash noise by applying the pre-damper type clutch disc for reducing the gear rattle noise. So, it is necessary to do test with actual vehicle according to test procedure.

• Journal of Mechanical Science and Technology
• /
• 제20권8호
• /
• pp.1125-1138
• /
• 2006

The optimal design of the squeeze film damper (SFD) for rotor system has been studied in previous researches. However, these researches have not been considering jumping or nonlinear phenomena of a rotor system with SFD. This paper represents an optimization technique for linear and nonlinear response of a simple rotor system with SFDs by using a hybrid GA-SA algorithm which combined enhanced genetic algorithm (GA) with simulated annealing algorithm (SA). The damper design parameters are the radius, length and radial clearance of the damper. The objective function is to minimize the transmitted load between SFD and foundation at the operating and critical speeds of the rotor system with SFD which has linear and nonlinear unbalance responses. The numerical results show that the transmitted load of the SFD is greatly reduced in linear and nonlinear responses for the rotor system.

• Structural Engineering and Mechanics
• /
• 제65권3호
• /
• pp.349-357
• /
• 2018

An extensive research was undertaken to study the vibration serviceability of a long-span and light-weight floor subjected to human loading experimentally and numerically. Specifically, heel-drop test was first conducted to capture the floor's natural frequencies and damping ratios, followed by jumping and running tests to obtain the acceleration responses. In addition, numerical simulations considering walking excitation were performed to further evaluate the vibration performance of a multi-panel floor under different loading cases and walking rates. The floor is found to have a high frequency (11.67 Hz) and a low damping ratio (2.32%). The comparison of the test results with the published data from the 1997 AISC Design Guide 11 indicates that the floor exhibits satisfactory vibration perceptibility overall. The study results show that the peak acceleration is affected by the walking path, walking rate, and adjacent structure. A simpler loading case may be considered in design in place of a more complex one.

• 한국멀티미디어학회논문지
• /
• 제16권7호
• /
• pp.897-904
• /
• 2013

The recursive circulant network G(N,d) can be widely used in the design and implementation of parallel processing architectures. It consists of N identical nodes, each node is connected through bidirectional, point-to-point communication channels to different neighbors by jumping $d^i$, where $0{\leq}i{\leq}{\lceil}{\log}_dN{\rceil}$ - 1. In this paper, we investigate the routing of a message on $G(2^m,4)$, a special kind of RCN, that is key to the performance of this network. On $G(2^m,4)$ we would like to transmit k packets from a source node to k destination nodes simultaneously along paths on this network, the $i^{th}$ packet will be transmitted along the $i^{th}$ path, where $1{\leq}k{\leq}m-1$, $0{{\leq}}i{{\leq}}m-1$. In order for all packets to arrive at a destination node quickly and securely, we present an $O(m^4)$ routing algorithm on $G(2^m,4)$ for generating a set of one-to-many node-disjoint and nearly shortest paths, where each path is either shortest or nearly shortest and the total length of these paths is nearly minimum since the path is mainly determined by employing the Hungarian method.

• 한국통신학회논문지
• /
• 제36권1B호
• /
• pp.37-42
• /
• 2011

최근 이동통신 단말기들의 분실 또는 도난을 통해 개인 정보의 유출로 타인의 도용에 우려가 되는 바, 본 논문에서는 이동통신 단말기의 분실 시에 잠금 기능 설정을 설정하지 않은 경우에도 단말기 안의 정보를 원격으로 제어 할 수 있는 방법을 구현하고자 한다. 제안하는 시스템의 주요 가능은 크게 4가지 부분으로 구성되는 데 사용자가 단말기를 원격 제어할 수 있도록 인터페이스 역할을 하는 웹사이트 제공부, 사용자가 본인임을 확인하며 가입된 이동통신사 시스템으로부터 가입자확인 정보를 수행하는 사용자 확인부, 단말기의 실 소유자임이 확인되면 원격제어 프로그램을 가동시키기 위한 접속코드를 단말기로 전송하여 접속을 설정하는 접속 관리부, 단말기를 원격 제어하기 위한 원격 제어 서비스 코드 및 환경 설정 값을 단말기로 전송하고 단말기로부터 서비스 완료 코드를 수신하는 서비스 실행부를 포함한다.

• 한국지능시스템학회:학술대회논문집
• /
• 한국퍼지및지능시스템학회 2003년도 춘계 학술대회 학술발표 논문집
• /
• pp.321-324
• /
• 2003

본 논문은 임의로 변화하는 입력지연을 갖는 불확실 T-S 퍼지 시스템의 강인 안정화를 논의한다. 임의로 변화하는 입력지연은 유한개의 상태를 갖는 마코프 확률과정으로 표현된다. 디지털 안정화기를 설계하기 위하여 연속시간 T-S 퍼지 시스템을 이산화하며 제어기의 입출력단에 영차의 샘플/홀드 함수를 가정한다. 이산화된 시스템은 확률적 과정에 따라 변화하는 도약 시스템으로 표현된다. 확률적 강인 안정가능성 조건은 선형 행렬 부등식의 현태로 표현된다.

• 대한기계학회논문집B
• /
• 제29권11호
• /
• pp.1199-1208
• /
• 2005

The flow fields including velocities, turbulence intensities, Reynolds shear stress and turbulent kinetic energy were investigated using particle image velocimetry(PIV) to study the flow characteristics around two square cylinders in a tandem arrangement. The experiments were carried out in the range of the spacing from 1.0 to 4.0 widths of cylinder, Reynolds number of 5.3$\times$10$^{3}$ and 1.6$\times$10$^{4}$ respectively. Discontinuous jumping at the drag coefficient variation was found for two cylinders simultaneously when the spacing between two cylinders is varied. This phenomenon is attributed to a sudden change of the flow pattern which depends on the reattachment of the shear layer separated from the upstream cylinder. Near such a critical spacing, the changes of the flow fields as well as the effect of Reynolds number were studied in detail.

• 한국소음진동공학회논문집
• /
• 제22권2호
• /
• pp.130-138
• /
• 2012

Environmental noise in the residential area is appeared with different types and features along with the growth of society. In particular when the economic level is raised up, the demand of residents for the environmental noise becomes more sensitive. The existing research on the environmental noise was initiated in the 1980's and resulted that the children's jumping sound was most annoying among the noises transmitted from the other unit. This result caused such activities that the researches were focused on the floor impact noise and that the laws in relation to environmental noise within residential area were revised strictly. This study aimed to survey the consciousness of residents for the environmental noise and to see how it is changed comparing with the previous one. Ultimately this result could be useful to establish the target for research or noise control to make the comfortable residential environment.