• Bulletin of the Korean Chemical Society
• /
• 제16권5호
• /
• pp.398-400
• /
• 1995

Selective oxidation of cyclohexane in acetone solution has been studied using iron catalysts with hydrogen peroxide in-situ produced by palladium catalyst. Iron tetraphenylporphyrin chloride shows the highest activity among the tested chlorides and porphyrin complexes of some metals of the first transiton series. Iron chloride and iron tetraphenylporphyrin chloride were supported on four kinds of 4-vinylpyridine copolymer with styrene or divinyl-benzene. Nitrogen 1s photoelectron spectra give the evidence that pyridyl nitrogens of the 4-vinyl pyridine copolymer act as ligands to bind iron species. The copolymer with styrene is the most efficient support for the binding because its solubility in catalyst preparation solvent (methylene chloride) gives the pyridyl group advantage to contact with the iron catalysts. However, better catalytic activity per iron atom could be obtained with a rigid crosslinked polymer due to active site isolation.

• 환경위생공학
• /
• 제24권4호
• /
• pp.80-89
• /
• 2009

In the organic waste, food waste is the most difficult controls. In the study, food waste was treatmented to removal only the dockage. To decrease the hydrogen sulfide($H_2S$) in the produced biogas, iron chloride put in the anaerobic digester. Respectively treatment quantity of the food waste, content of the methane($CH_4S$) gas in the biogas, produced gases quantity, put in the quantity of the Iron chloride, pH, TS, Alkalinity, VFA, Ammonia. The results obtained from the experiment are as follows: 1. The produced biogases quantity/the treatment quantity of the food waste was $83.82{\sim}129.41m^3/ton$. 2. The content of the hydrogen sulfide($H_2S$) in the produced biogas is below of the 500ppm. The iron chloride put in the anaerobic digester. 200~300kg of the iron chloride put in the anaerobic digester at the steady-state. 400~850kg of the iron chloride put in the anaerobic digester at the unsteady-state. 3. Factor of the operator was the pH: 7.7~8.4, content of mathane: 55~65%. 4. TS(total solid) of the digestor sludge was 17~20%, Alkalinity was 38,500~41,750ppm, VFA(Volatile Fatty Acids) was 2,800~2,420ppm, Ammonia was 4,300~3,650ppm.

• 한국세라믹학회지
• /
• 제18권2호
• /
• pp.105-111
• /
• 1981

The iron precipitates were prepared by adding sodium carbonate solution to ferrous chloride and ferric chloride solutions to pH=9 and pH=4.5, respectively. The thermal reaction of the iron precipitates was investigated by means of TGA, DTA and X-ray diffraction. In the former the crystallization of $\alpha$-$Fe_2O_3$ begins at about 35$0^{\circ}C$, while in the latter at about 30$0^{\circ}C$, during the calclnation in air. In the iron precipitate from ferrous chloride solution, the activation energy for the crystallite-growth or $\alpha$-TEX>$Fe_2O_3$ in air is about 7.6$\times$104J/mole between 800 and 100$0^{\circ}C$. As the result of X-ray diffration for the reduction product of hematite, it was found that maghemite, magnetite and wustite are formed and that hematite is transformed to magnetite through maghemite.

• Bulletin of the Korean Chemical Society
• /
• 제23권9호
• /
• pp.1325-1327
• /
• 2002

• Journal of Applied Biological Chemistry
• /
• 제61권4호
• /
• pp.383-389
• /
• 2018

Degradation of the insecticide O,O-diethyl O-3,5,6-trichloro-2-pyridyl phosphorothioate (chlorpyrifos) in aqueous solution was investigated using iron salts and potassium persulfate during ZVI treatment through a series of batch experiments. The degradation rate of chlorpyrifos increased with increases in the concentrations of iron salts and potassium persulfate in the aqueous system. Ferric chloride was found to be the most effective iron salt for the ZVI-mediated degradation of chlorpyrifos in aqueous solution. Further, the iron salts tested could be arranged in the following order in terms of their effectiveness: $FeCl_3$> $Fe_2(SO_4)_3$> $Fe(NO_3)_3$. The persulfate-ZVI system could significantly degrade chlorpyrifos present in the aqueous medium. This revealed that chlorpyrifos degradation by treatment with $Fe^0$ was promoted on adding ferric chloride and potassium persulfate. The kinetics of the degradation of chlorpyrifos by persulfate-amended $Fe^0$ was higher than that for iron-salt-amended $Fe^0$. This suggests that using a sequential $Fe^0$ reduction-ferric chloride or $Fe^0$ reduction-persulfate process may be an effective strategy to enhance the removal of chlorpyrifos in contaminated water.

• 청정기술
• /
• 제18권2호
• /
• pp.183-190
• /
• 2012

PCB에칭에 의해 발생한 염화철 폐식각액 중 염화철을 산화시키고 구리를 석출시키는 전기화학적 재생공정은 환경오염을 줄이면서도 부산물을 얻어내어 경제성이 크다. 그러나, 염화철 폐식각액은 철과 구리, 두 가지 금속이 함께 함유되어 있기 때문에 전해조에서 일어나는 반응이 복잡하다. 본 연구에서는 회분식 공정을 통하여 전기화학적인 염화철 산화 및 구리 석출반응의 특성을 조사하고 관련된 공정변수들의 최적 조건을 도출해내었다. 염화철의 산화는 항상 원하는 수준으로 되었으며, 탄소 음전극을 사용한 반응에서 $350mA/cm^2$의 전류밀도와 12 g/L의 구리 농도 조건에서, $Fe^{2+}$이온의 비율이 높을수록 구리 석출 효율이 높았다. 또한, 도출해낸 최적 조건을 바탕으로 Bench 장치 연속운전을 통해서 scale-up 가능성을 확인하였다.

• 펄프종이기술
• /
• 제40권5호
• /
• pp.42-46
• /
• 2008

The papers in preserved books and archives experience aging which was affected by a variety of factors. Thus, the studies concerning impacts of those factors on paper aging are required. In this research, a simulation of a short-time accelerated paper aging was conducted in order to examine the effects of acid and metals (alum, copper (II) sulfate, copper (II) chloride, and iron (III) chloride) on the natural paper aging for a long time. As a result of experiments, it is found that both acid and metals have impacts on paper aging. Alum resulted in the significant decrease of pH, brightness, folding endurance, and viscosity of paper. Both copper (II) chloride and iron (III) chloride also resulted in the decrease of brightness, folding endurance, and viscosity of paper. In more detail, paper aging by iron (III) chloride showed much more significant than that by copper (II) chloride. The paper aging in case of copper (II) sulfate coexisting sulfate ion, where metal absorbed moisture was higher than in case of paper treated only by alum. This result indicated that metal catalyzes paper aging by acid. Based on these results, it was revealed that both alum and metal are the major factors in paper aging. In particular, paper aging was far more accelerated in case when acid and metals existed in paper at the same time.

• 자원리싸이클링
• /
• 제17권3호
• /
• pp.29-34
• /
• 2008

이온강도가 센 염산용액에서 Alamine336과 TBP에 의한 염화 제 2철의 용매추출거동을 MaCabe-Thiele도를 이용하여 비교하였다. 초기 추출조건으로부터 수상과 유기상에서 철의 평형농도를 계산하여 두 추출제에 의한 철 추출의 등온추출곡선을 구했다. 평형농도 계산시 수상에서 착물형성반응과 물질수지 및 추출반응을 고려하였다. 1M의 Aalmine336으로 0.5M의 철을 3M의 염산용액에서 수상과 유기상의 부피비가 6/5인 조건에서 추출시 2단에 철의 대부분이 유기상으로 추출되는 것을 MaCabe-Thiele도에서 알 수 있었다. 1M의 Alamine336은 염산용액에서 철의 추출능력면에서 TBP 2-3M과 비슷하였다. MaCabe-Thiele도와 두 추출제의 물리적 특성으로부터 Alamine336이 TBP보다 염산용액에서 철의 추출특성이 우수한 것을 알 수 있었다.

• 기술혁신학회지
• /
• 제7권3호
• /
• pp.641-656
• /
• 2004

L Company is producing the second sept pin, Shadow Mask which is the chief part of CRT in W, Monitor. Inside of the CRT pan, Shadow Mask leads the electronic beam to express the three primary colors; red, green, blue, and it is the core part to embody the colors. In the etching process, it produces this part with manufacturing by eroding the iron chloride. Even though the iron chloride is harmless to human body. it is necessary to diminish the amount of it on the view of preservation of environment. In addition, by studying the method of the dispossed liquid process, cutting down the manufacturing cost is a necessary task on the aspect of reconsideration of competitive business. This study shows the case that through the six sigma innovation activity, it reforms the following the former processing flow, and it reduces the amount of it by improving the efficiency of the iron chloride. By rationalization of the standard requirement cooperative company, it could cut down the manufacturing cost in the cooperative company, so it could promote the common profits.

• 한국표면공학회지
• /
• 제40권1호
• /
• pp.44-56
• /
• 2007

Excavated archaeological iron artifacts are usually conducted the conservation treatment for removal of chloride ions in the corrosion products. However, some iron artifacts are corroded again even after the conservation treatment due to unremoved chloride ions. Therefore, it is important to prevent desalinized artifacts from the occurrence of corrosion after the treatment. In this paper, we investigated the characteristics of corrosion products on salinized iron artifacts and evaluated the variety of desalination methods such as autoclave, intensive washing and NaOH. It was also found that ${\beta}-FeOOH$ (Akaganeite) played an important role on the occurrence of corrosion and the treatment for removal of chloride ions. The extents of desalination were compared between the desalination methods. Results showed that the autoclave method represented the highest efficiency for desalination while the intensive washing method was the lowest.