• Current Photovoltaic Research
• /
• v.1 no.2
• /
• pp.115-121
• /
• 2013

ZnO film has been used for CIGS solar cells as a buffer layer as itself or by doping Mg and Sn; ZnO film also has been used as a transparent conducting layer by doping Al or B for solar cells. Since ZnO itself is a host material for many applications it is necessary to understand the electrical and optical properties of ZnO film itself with various preparation conditions. We prepared ZnO films by converting ZnS precursor into ZnO film by thermal annealing. ZnO film was formed at low temperature as low as $500^{\circ}C$ by annealing a ZnS precursor layer in air. In the air annealing, the electrical resistivity decreased monotonically with increasing annealing temperature; the intensity of the green photoluminescence at 505 nm increased up to $750^{\circ}C$ annealing. The electrical resistivity further decreased and the intensity of green emission also increased in reducing atmospheres. The results suggest that deep-level defects originated by oxygen vacancy enhanced green emission, which reduce light transmittance and enhance the recombination of electrons in conduction band and holes in valence. More oxidizing environment is necessary to obtain defect-free ZnO film for higher transparency.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2015.08a
• /
• pp.187-187
• /
• 2015

The past thirty years have seen increasingly rapid advances in the field of Indium Tin Oxide (ITO) transparent thin film.[1] However, a major problem with this ITO thin film application is high cost compared with other transparent thin film materials.[2] So far, in order to overcome this disadvantage, we show a transparent ITO/Ag/i-ZnO multilayer thin film electrode can be the solution. In comparison with using amount of ITO as a transparent conducting material, intrinsic-Zinc-Oxide (i-ZnO) based on ITO/Ag/i-ZnO multilayer thin film showed cost-effective and it has not only highly transparent but also conductive properties. The aim of this research has therefore been to try and establish how ITO/Ag/i-ZnO multilayer thin film would be more effective than ITO thin film. Herein, we report ITO/Ag/i-ZnO multilayer thin film properties by using optical spectroscopic method and measuring sheet resistance. At a certain total thickness of thin film, sheet resistance of ITO/Ag/i-ZnO multilayer was drastically decreased than ITO layer approximately $40{\Omega}/{\square}$ at same visible light transmittance.(minimal point $5.2{\Omega}/{\square}$). Tendency, which shows lowly sheet resistive in a certain transmittance, has been observed, hence, it should be suitable for transparent electrode device.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2009.02a
• /
• pp.139.2-139.2
• /
• 2009

• Proceedings of the Korean Vacuum Society Conference
• /
• 2010.08a
• /
• pp.110-110
• /
• 2010

현재 박막 트랜지스터는 비정질 실리콘 기반의 개발이 주를 이루고 있으며, 이 비정질 실리콘은 성막공정이 간단하고 대면적에 용이하지만 전기적인 특성이 우수하지 않기 때문에 디스플레이의 적용에 어려움을 겪고 있다. 이에 따라 poly-Si을 이용한 박막 트랜지스터의 연구가 진행되고 있는데, 이는 공정온도가 높고, 대면적에의 응용이 어렵다. 따라서 앞으로 저온 공정이 가능하며 대면적 응용이 용이한 박막 트랜지스터의 연구가 필수적이다. 한편 최근 박막 트랜지스터의 채널층으로 사용되는 물질에는 oxide 기반의 ZnO, SnO2, In2O3 등이 주로 사용되고 있고, 보다 적합한 채널층을 찾기 위한 연구가 많이 진행되어 왔다. 최근 Hosono 연구팀에서 IGZO를 채널층으로 사용하여 high mobility, 우수한 on/off ratio의 특성을 가진 소자 제작에 성공함으로써 이를 시작으로 IGZO의 연구 또한 세계적으로 활발한 연구가 이루어지고 있다. 특히, ZnO는 wide band gap (3.37eV)을 가지고 있어 적외선 및 가시광선의 투과율이 좋고, 전기 전도성과 플라즈마에 대한 내구성이 우수하며, 낮은 온도에서도 성막이 가능하다는 특징을 가지고 있다. 그러나 intrinsic ZnO 박막은 bias stress 같은 외부 환경이 변했을 경우 전기적인 성질의 변화를 가져올 뿐만 아니라 고온에서의 공정이 불안정하다는 요인을 가지고 있다. ZnO의 전기적인 특성을 개선하기 위해 본 연구에서는 hafnium을 doping한 ZnO을 channel layer로 소자를 제작하고 전기적 특성을 평가하였다. 이를 위해 DC magnetron sputtering을 이용하여 ZnO 기반의 박막 트랜지스터를 제작하였다. Staggered bottom gate 구조로 ITO 물질을 전극으로 사용하였으며, 제작된 소자는 semiconductor analyzer를 이용하여 출력특성과 전이 특성을 평가하였으며, ZnO channel layer 증착시 hafnium이 도핑 되는 양을 조절하여 소자를 제작한 후 intrinsic ZnO의 소자 특성과 비교 분석하였다. 그 결과 hafnium을 doping 시킨 소자의 field effect mobility가 $6.42cm^2/Vs$에서 $3.59cm^2/Vs$로 낮아졌지만, subthreshold swing 측면에서는 1.464V/decade에서 0.581V/decade로 intrinsic ZnO 보다 좋은 특성을 나타냄을 알 수 있었다. 그리고 intrinsic ZnO의 경우 외부환경에 대한 안정성 문제가 대두되고 있는데, hafnium을 도핑한 ZnO의 경우 temperature, bias temperature stability, 경시변화 등의 다양한 조건에서의 안정성이 확보된다면 intrinsic ZnO 박막트랜지스터의 문제점을 해결할 수 있는 물질로 될 것이라고 기대된다.

• Journal of the Semiconductor & Display Technology
• /
• v.7 no.3
• /
• pp.51-54
• /
• 2008

In this study, we investigated variations in undoped ZnO thin film properties with working pressure, $O_2$/Ar ratio, and annealing ambient. Higher vacuum pressure during deposition was observed to bring about slower growth rate resulting in samples with better crystallinity as well as hole generation efficiency through formation of shallower oxygen interstitial. Given that $O_2$/Ar ratio is greater than unity, O provided from the ambient to ZnO during annealing was found to preferably situate at interstitial sites. When He was used for the second annealing, significant changes were not observed. On the other hand, O ambient caused increased density of oxygen interstitial, thereby making the film more intrinsic-like high resistivity ZnO.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.20 no.10
• /
• pp.883-888
• /
• 2007

Investigation of improving the properties of UV detector which uses the wide bandgap of ZnO are under active progress. The present study focused on the design and fabrication of i-ZnO/p-inversion $layer/n^--Si$ Epi. which is characterized with very thin p-type inversion layer for UV detectors. The i-ZnO thin film for achieving p-inversion layer which was grown by RF sputtering at $450^{\circ}C$ and then annealed at $400^{\circ}C$ in $O_2$ gas for 20 min shows good intrinsic properties. High (0002) peak intensity of the i-ZnO film is shown on XRD spectrum and it is confirmed by XPS analysis that the ratio of Zn : O of the i-ZnO film is nearly 1 : 1. Measurement shows high transmission of 79.5 % in UV range (< 400 nm) for the i-ZnO film. Measurement of $V_r-I_{ph}$ shows high UV photo-current of 1.2 mA under the reverse bias of 30 V.

• Proceedings of the KIEE Conference
• /
• 2006.10a
• /
• pp.34-35
• /
• 2006

Transparent ZnO thin film transistor (TFT) is fabricated on the glass substrates. The device consists of a high mobility intrinsic ZnO as a semiconductor active channel, Ga doped ZnO (GZO) as an electrode, $HfO_2$ as a gate insulator. GZO and $HfO_2$ layers are prepared by using a pulsed laser deposition and intrinsic ZnO layers are fabricated by using an rf-magnetron sputtering, respectively. The transparent TFT is highly transparent (> 87 %) and exhibits n-channel, enhancement mode behavior with a field-effect mobility as large as $11.7\;cm^2/Vs$ and a drain current on-to-off ratio of about $10^5$.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.20 no.3
• /
• pp.202-206
• /
• 2007

ZnO is a promising material to make high efficient ultraviolet(UV) or blue light emitting diodes(LEDs) because of its large binding energy and energy bandgap. In this study, we prepared ZnO thin films with p-type conductivity on silicon(100) substrates by RF magnetron sputtering in the mixture of $N_2$ and $O_2$. The process was accompanied by low pressure in-situ annealing in $O_2$ at $600^{\circ}C$ and $800^{\circ}C$ respectively. Hall effect in Van der Pauw configuration showed that the N-doped ZnO film annealed at $800^{\circ}C$ has p-type conductivity. Photoluminescence(PL) spectrum of the film annealed at $800^{\circ}C$ showed UV emission related to exciton and bound to donor-acceptor pair(DAP) as well as visible emission related to many intrinsic defects.

• Journal of the Semiconductor & Display Technology
• /
• v.20 no.4
• /
• pp.1-5
• /
• 2021

Field-effect transistors based on solution-processed metal oxide semiconductors has attracted huge attention due to their intrinsic characteristics of optical and electrical characteristics with benefits of simple and low-cost process. Especially, spray-pyrolysis has shown excellent device performance which compatible to vacuum-processed Field-effect transistors. However, the high annealing temperature for crystallization of MOS and narrow range of precursors has impeded the progress of the technology. Here, we demonstrated the nc-ZnO/ZnO films performed by spray-pyrolysis with incorporating ZnO nanoparticles into typical ZnO precursor. The films exhibit preserving morphological properties of poly-crystalline ZnO and enhanced electrical characteristics with potential for low-temperature processability. The influence of nanoparticles within the film was also researched for realizing ZnO films providing good quality of performance.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.17 no.5
• /
• pp.187-191
• /
• 2007

The device performance of ZnO-thin film transistors(ZnO-TFTs) with gate dielectrics of $SiO_2,\;SiN_x$ and Polyvinylphenol(PVP) having a bottom gate configuration were investigated. ZnO-TFTs can induce high device performance with low intrinsic carrier concentration of ZnO only by controlling gas flow rates without additional doping or annealing processes. The field effect mobility and on/off ratio of ZnO-TFTs with $SiN_x$ were $20.2cm^2V^{-1}s^{-1}\;and\;5{\times}10^6$ respectively which is higher than those previously reported. The device adoptable values of the mobility of $1.37cm^2V^{-1}s^{-1}$ and the on/off ratio of $6{\times}10^3$ were evaluated from the device with organic PVP dielectric.