• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.6 no.4
• /
• pp.389-396
• /
• 1994

We analyze existing time-dependent mild-slope equations, which were developed by Smith and Sprinks (1975) (or, equivalently, Radder and Dingemans (1985)) and Kubo et al. (1992), in terms of the dispersion relation and energy transport. One-dimensionally in the horizontal direction, we compare the modulation of wave amplitudes for the time-dependent mild-slope equations against the linear Scrodinger equation. In view of the dispersion relation and modulation of wave amplitudes, Smith and Sprinks' model is more accurate in shallower water (kh$\leq$0.2$\pi$) and satisfies the linear Scrodinger equation in very shallow water (kh>0.2$\pi$) and satisfies the linear Scrodinger equation at a point of intermediate water depth (kh=0.3$\pi$). In view of the energy transport, Kubo et al.'s model is more accurate but yields singular solutions at some higher frequency range.

• Proceedings of the KSRS Conference
• /
• 2002.10a
• /
• pp.587-592
• /
• 2002

A new digital correlator fur an airborne synthetic aperture radiometer was designed in order to replace the conventional analog correlator unit which will become very complicated while the number of channels is increasing. The digital correlator uses digital IQ demodulator instead of the intermediate frequency (IF) phase shifter to make the correlation processing performed digitally at base band instead of analogly at IF. This technique has been applied to the digital receiver in softradio. The down-converted IF signals from each pair of receiver channels become low rate base-band digital signals after under-sampled, Digitally Down-Converted (DDC), decimated and filtered by FIR filters. The digital signals are further processed by two digital multipliers (complex correlation), the products are integrated by the integrators and finally the outputs from the integrators compose of the real part and the imaginary part of a sample of the visibility function. This design is tested by comparing the results from digital correlators and that from analog correlators. They are agreed with each other very well. Due to the fact that the digital correlators are realized with the help of Analog-Digital Converter (ADC) chips and the FPGA technology, the realized volume, mass, power consumption and complexity turned out to be greatly reduced compared with that of the analog correlators. Simulations show that the resolution of ADC has an influence on the synthesized antenna patterns, but this can be neglected if more than 2bit is used.

• Parasites, Hosts and Diseases
• /
• v.58 no.2
• /
• pp.121-127
• /
• 2020

Pakistan is at intersection of hyperendemic regions for hydatidosis. Current study aimed to determine the prevalence of hydatid cysts and cyst characteristics in different intermediate hosts (sheep, goats, cattle and buffaloes) across the 4 provinces of Pakistan. A total of 991 sheep, 1,478 goats, 1,602 cattle and 1,343 buffaloes were examined for presence of hydatid cysts during 2 years (January 2016-December 2018). Differences in frequency of hydatidosis were observed with highest overall prevalence in buffaloes (11.9%) and sheep (11.5%). Highest prevalence and burden of infection were observed in older age animals (23.8%, 9.78±0.49) and females (26.5%, 12.53±0.67). Data for seasonal prevalence alluded to year-round presence of disease with non-significant statistical difference. Organ predilection indicated liver as the most preferred site of cyst localization followed mainly by lungs. An over-dispersion pattern was observed in all infected animals as majority of cysts belonged <10 cysts per infected host category. Highest percentage of fertile cysts was observed in liver of sheep. Interestingly, solitary form of cysts had higher fertility rate than multiple form. Amid lack of data and wide gap of knowledge, this study would try to fill up the lacunae regarding this neglected tropical disease. Extensive rearing of livestock, unregulated official slaughter and home slaughtering have played role in adaptability of E. granulosus in Pakistan.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.11 no.8
• /
• pp.1493-1499
• /
• 2007

Real-time applications in a wireless sensor network environment require real-time transmissions from sensing nodes to sink nodes. Existing congestion control mechanisms have treated congestion problems in sensor networks, but they only adjust the reporting frequency or the sending rate in intermediate nodes. They were not suitable for real-time applications from the transmission delays point of view. In this paper, we suggest a new mechanism that can reduce the transmission delay and can increase the throughput for real-time applications in sensor network. This mechanism classifies data on the real-time characteristics, processes the data maintaining the real-time characteristics prior to the other data such as the non real-time data or the data lost the real-time characteristics. A modified frame format is also proposed in order to apply the mechanism to IEEE 802.15.4 MAC layer. The simulation based on ns-2 is accomplished in order to verify the performance of the suggested scheme from transmission delay and throughput standpoints. The simulation results show that the proposed algorithm has a better performance specifically when It applies to the real-time applications in sensor networks.

• Journal of the Korean Physical Society
• /
• v.73 no.10
• /
• pp.1577-1583
• /
• 2018

Tumor-treating fields therapy involves placing pads onto the patient's skin to create a low- intensity (1 - 3 V/cm), intermediate frequency (100 - 300 kHz), alternating electric field to treat cancerous tumors. This new treatment modality has been approved by the Food and Drug Administration in the USA to treat patients with both newly diagnosed and recurrent glioblastoma. To deliver the prescribed electric field intensity to the tumor while minimizing exposure of organs at risk, we developed an optimization method for the electric field distribution in the body and compared the electric field distribution in the body before and after application of this optimization algorithm. To determine the electric field distribution in the body before optimization, we applied the same electric potential to all pairs of electric pads located on opposite sides of models. We subsequently adjusted the intensity of the electric field to each pair of pads to optimize the electric field distribution in the body, resulting in the prescribed electric field intensity to the tumor while minimizing electric fields at organs at risk. A comparison of the electric field distribution within the body before and after optimization showed that application of the optimization algorithm delivered a therapeutically effective electric field to the tumor while minimizing the average and the maximum field strength applied to organs at risk. Use of this optimization algorithm when planning tumor-treating fields therapy should maintain or increase the intensity of the electric field applied to the tumor while minimizing the intensity of the electric field applied to organs at risk. This would enhance the effectiveness of tumor-treating fields therapy while reducing dangerous side effects.

• Development and Reproduction
• /
• v.23 no.1
• /
• pp.21-34
• /
• 2019

The effects of the anaesthetic agents, clove oil and mixture of clove oil with lidocaine-HCl were evaluated on river puffer, Takifugu obscurus and tiger puffer, T. rubripes. Anaesthesia times of clove oil were affected by water temperature ($20^{\circ}C$, $24^{\circ}C$, and $28^{\circ}C$) and salinity (10, 20, and 30 ppt). Anaesthesia times of mixed samples were significantly similar with regard to exposure and recovery times, and all samples satisfied anaesthesia criteria (exposure time within 3 min and recovery time within 5 min) under the various temperatures and salinities, and the lowest to highest concentration of anaesthetics (p<0.05). Both species river puffer and tiger puffer had short exposure time with a high anaesthesia dose, high temperature ($28^{\circ}C$) and intermediate salinity (20 ppt), and were highly affected by temperature and salinity (p<0.05). The mixed anaesthetics had rapid exposure times and long recovery times in contrast to the effects of clove oil. Cortisol concentrations under the conditions of various clove oil dosages, salinity, and temperature for both species increased until 12 hrs after recovery from anaesthesia (p<0.05). After 12 hrs, cortisol concentrations decreased until after 48 hrs (p<0.05). During the simulated transportation of both species, control and sedated clove oil groups (5 ppm) were measured for water parameters, dissolved oxygen (DO), $CO_2$, respiratory frequency, $NH_4{^+}$, and pH for 6 hrs in 1 hr intervals. Water parameters of sedated groups and controls were significantly different after 2 hrs (p<0.05).

• Smart Structures and Systems
• /
• v.6 no.5_6
• /
• pp.561-578
• /
• 2010

This study proposes a multi-level damage localization strategy to achieve an effective damage detection system for civil infrastructure systems based on wireless sensors. The proposed system is designed for use of distributed computation in a wireless sensor network (WSN). Modal identification is achieved using the frequency-domain decomposition (FDD) method and the peak-picking technique. The ASH (angle-between-string-and-horizon) and AS (axial strain) flexibility-based methods are employed for identifying and localizing damage. Fundamentally, the multi-level damage localization strategy does not activate all of the sensor nodes in the network at once. Instead, relatively few sensors are used to perform coarse-grained damage localization; if damage is detected, only those sensors in the potentially damaged regions are incrementally added to the network to perform finer-grained damage localization. In this way, many nodes are able to remain asleep for part or all of the multi-level interrogations, and thus the total energy cost is reduced considerably. In addition, a novel distributed computing strategy is also proposed to reduce the energy consumed in a sensor node, which distributes modal identification and damage detection tasks across a WSN and only allows small amount of useful intermediate results to be transmitted wirelessly. Computations are first performed on each leaf node independently, and the aggregated information is transmitted to one cluster head in each cluster. A second stage of computations are performed on each cluster head, and the identified operational deflection shapes and natural frequencies are transmitted to the base station of the WSN. The damage indicators are extracted at the base station. The proposed strategy yields a WSN-based SHM system which can effectively and automatically identify and localize damage, and is efficient in energy usage. The proposed strategy is validated using two illustrative numerical simulations and experimental validation is performed using a cantilevered beam.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.26 no.3
• /
• pp.422-429
• /
• 2022

In this paper, the intermediate frequency transmission signal level between the network system-based baseband and RF unit consisting of multi-channel airborne relay devices and a lot of mission devices, which are currently undergoing technology development tasks, is kept constant at the reference signal level. Considering the other party's receiving input range, despite changes in the short-range long-range wireless communication environment, it presents a multi-link protection and MLP-A algorithm that allows signals to be transmitted stably and reliably through signal detection automatic gain control, and experiments and analysis considering short-distance and long-distance wireless environments were performed by designing, manufacturing, and implementing RF units to which MLP-A algorithms were applied, and applying distance calculation equations to the configuration of multiple air movements and verification networks. Through this, it was confirmed that a stable and reliable RF communication system can be operated.

• Journal of Korea Entertainment Industry Association
• /
• v.14 no.2
• /
• pp.131-139
• /
• 2020

This study intended to analyze the early childhood education freshmen's academic interest. For this study relationship pre-service early childhood teacher's playfulness and play teaching efficacy. The study subjects were 145 early childhood education students in third grade at K-college in Deagu. They answered the survey regarding playfulness scale and play teaching efficacy scale. The collected data were analyzed by frequency analysis, descriptive statistics, pearson correlation and multiple regression analysis using SPSS 18.0 program. The study finding are as follows. First, the average of playfulness and play teaching efficacy were near at the intermediate-level. Second, playfulness and play teaching efficacy were significantly correlated. Third, when examining the relative effect of pre-service early childhood teacher's playfulness on play teaching efficacy, cheerfulness and improvisation is influential factor in play teaching efficacy.

• Journal of Advanced Information Technology and Convergence
• /
• v.10 no.1
• /
• pp.71-83
• /
• 2020

In this paper, we propose a system that can detect the shape of a hand at high speed using an FPGA. The hand-shape detection system is designed using Verilog HDL, a hardware language that can process in parallel instead of sequentially running C++ because real-time processing is important. There are several methods for hand gesture recognition, but the image processing method is used. Since the human eye is sensitive to brightness, the YCbCr color model was selected among various color expression methods to obtain a result that is less affected by lighting. For the CbCr elements, only the components corresponding to the skin color are filtered out from the input image by utilizing the restriction conditions. In order to increase the speed of object recognition, a median filter that removes noise present in the input image is used, and this filter is designed to allow comparison of values and extraction of intermediate values at the same time to reduce the amount of computation. For parallel processing, it is designed to locate the centerline of the hand during scanning and sorting the stored data. The line with the highest count is selected as the center line of the hand, and the size of the hand is determined based on the count, and the hand and arm parts are separated. The designed hardware circuit satisfied the target operating frequency and the number of gates.