• Applied Microscopy
• /
• v.28 no.1
• /
• pp.21-38
• /
• 1998

The present study was performed to determine the effect of cold stress on myocardium of aging rat. Control groups, which aged 6, 12 and 24 months, were compared with age-matched experimental groups that were exposed to moderate cold stress for a hours daily in a week at laboratory cold room $(4{\pm}1^{\circ}C)$. The histological, histochemical and ultrastructural changes of myocardium were observed. The results were summarized as follow: 1. Age-dependent histological change of control groups was observed the formation of contraction band in 24months aged group. The experimental groups submitted to cold stress showed a similar change pattern as seen in control groups. However, the degree of change in the experimental groups was significantly larger than that of control groups. In the 34 months aged group the formation of hypercontraction band was observed. 2. Regarding age-dependent histochemical changes of control groups, we observed the increase activities of PAS and Masson's trichrome. In experimental groups the activities of PAS and Masson's trichrome were also increased with age. Compare with control group, the activities of PAS was increased but the activities of Masson's trichrome was decreased. 3. Age-dependent ultrastructural changes on vacuolization, lysosome were observed. In control groups the structural changes occur at 12 months. The accumulation of lipofuscin, contraction band, hypercontraction band and a component of connective tissue were observed in 24 months. However, the degree of change in the experimental groups was significantly larger than that of control groups. In contract, the myelin body in intercalated discs was observed in 24 months of experimental groups.

• Applied Microscopy
• /
• v.28 no.1
• /
• pp.1-19
• /
• 1998

Ultrastructural study of the development of the atrioventricular (AV) node was studied by electron microscopy in human fetus ranging from 30 mm to 260 mm crown rump length, and compared with human adult. By 30 mm fetus, the right AV nodal primordium was located below the attachment of the right venous valve. The left AV nodal primordium was observed below the attachment of septum primum. The cytoplasm of the nodal primordia contained few mitochondria, and myofibrils. These cells were apposed to each other with occasional desmosomes. In 40 mm fetus, the AV node cells were poorly organized myofibrils, while working myocardial cells were well organized myofibrils with sarcomere. At 70 mm fetus, intercalated discs were developed in the working myocardial cells. At 100 mm fetus, the nodal cells contained a relatively clear cytoplasm with a few groups of myofibrils and mitochondria. By $140\sim200$ mm fetuses, the nodal cells were an increasing number of myofibrils and mitochondria and these were scattered throughout the cytoplasm. At 260 mm fetus, the nodal cells were small and contained a clear cytoplasm with sparse and poorly organized myofibrils and mitochondria. All major ultrastructural features which characterize the adult AV nodal cells were found in this stage. The working myocardial cells were larger and had a more compact cytoarchitecture than nodal cells. Zonula adherens or fasciae adherens type junction were not found between nodal cells, but they frequently observed between nodal and working myocardial cells.

• Journal of the Korean Ceramic Society
• /
• v.41 no.1
• /
• pp.41-44
• /
• 2004

Hydrophilicity and hydrophobicity of pottery bodies can be controlled via chemical substitution of layered clay with hydrophilic and hydrophobic organics. In this study, organo-clay nanocomposites were prepared by ion-exchange of montmorillonite with dodecylamine and hexadecylamine, respectively. Substitution sites of organics and the interval changes of layered materials are characterized by FT-IR and WAXD and organics amounts loaded and water comtents contained by C/S analysis and TG-DSC. The organics were selectively intercalated so that increase layer interval from 12${\AA}\; to\;16{\AA}$. Organo-modified clay is changed to more hydrophobic comparing to clay itself.

• Journal of the Korean Electrochemical Society
• /
• v.13 no.3
• /
• pp.186-192
• /
• 2010

In situ electrochemical atomic force microscopy (ECAFM) observations of the surface of highly oriented pyrolytic graphite (HOPG) was performed before and after cyclic voltammetry in lithium bis(fluorosulfonyl)imide (LiTFSI) dissolved in 1-buthyl-2,3-dimethylimidazolium (BDMI)-TFSI to understand the interfacial reactions between graphite and BDMI-based ionic liquids. The formation of blisters and the exfoliation of graphene layers by the intercalation of $BDMI^+$ cations within HOPG were observed instead of reversible lithium intercalation and de-intercalation. On the other hand, lithium ions are reversibly intercalated into the HOPG and de-intercalatied from the HOPG without intercalation of the $BDMI^+$ cations in the presence of 15 wt% of 4.90 mol/$kg^{-1}$ LiTFSI dissolved in propylene carbonate (PC). ECAFM results revealed that the concentrated PC-based solution is a very effective additive for preventing $BDMI^+$ intercalation through the formation of solid electrolyte interface (SEI).

• Macromolecular Research
• /
• v.11 no.4
• /
• pp.260-266
• /
• 2003

Ethylene vinyl acetate (EVA)/clay nanocomposites were synthesized by blending a solution of ethylene vinyl acetate copolymer containing 12% vinyl acetate abbreviated as EVA-12 in toluene and dispersion of dodecyl ammonium ion intercalated montmorillonite (l2Me-MMT) in N,N-dimethyl acetamide (DMAc). X-ray patterns of sodium montmorillonite ($Na^+$-MMT) and 12Me-MMT exhibited $d_{001}$ peak at $2{\theta}=7.4^{\circ}$ and $2{\theta}=5.6^{\circ}$ respectively; that is, the interlayer spacing of MMT increased by about 0.39 nm due to intercalation of dodecyl ammonium ions. The XRD trace of EVA showed no peak in the angular range of $3-10^{\circ}(2{\theta})$. In the XRD patterns of EVA/clay hybrids with clay content up to 6 wt% the basal reflection peak of 12Me-MMT was absent. leading to the formation of delaminated configuration of the composites. When the 12Me-MMT content was 8 wt% in the EVA-12 matrix, the hybrid revealed a peak at about $2{\theta}=5.6^{\circ}$, owing to the aggregation of aluminosilicate layers. Transmission electron microscopic photograph exhibited that an average size of 12-15 nm clay layers were randomly and homogeneously dispersed in the polymer matrix, which led to the formation of nanocomposite with delaminated configuration. The formation of delaminated nanocomposites was manifested through the enhancement of mechanical properties and thermal stability, e.g. tensile strength of an hybrid containing only 2 wt% 12Me-MMT was enhanced by about 36% as compared with neat EVA-12.

• Elastomers and Composites
• /
• v.42 no.4
• /
• pp.224-231
• /
• 2007

Polyurethane (PU) was prepared with the compositions of polytetramethylene glycol (PTMG) having two different molecular weight (250, 1000 g/mol). The optimum composition of PTMG 250/1000 was 60/40 based on the mechanical properties. PU/organoclay nanocomposites were prepared with several kinds of organoclay. The mechanical properties of nanocomposite prepared with 93A were considerable. The improvement in tensile strength and modulus for PU/organoclay nanocomposite with the application of ultrasound compared to the PU/organoclay nanocomposite without the application of ultrasound was factors of 1.2, and hardness (shore A type) increased from 90 to 95. The difference in thermal degradation was not observed. The results of transmission electron micrographs and X-ray measurements suggest that the intercalated organoclay in PU matrix was observed.

• Journal of the Society of Cosmetic Scientists of Korea
• /
• v.24 no.3
• /
• pp.116-122
• /
• 1998

It is well known that all-trans-retinol is not only very unstable in heat, light, air, and water, but also skin-irritant despite a good anti-wrinkle effect. Therefore, it is very difficult to stabilize retinol and make the safe retinol containing cosmetics by using a certain concentration of retinol with real effect. In order to dissolve these problems and apply retinol for skin care cream, firstly retinol is to be encapsulated in the vesicle called Liposphere (pseudo-liposome) which is made by homogenizing under high pressure the mixtures of lecithin, retinol, caprylic/capric triglyceride, and hydroalcoholic solution ; and then this retinol containing Liposphere is to be intercalated in lamellar liquid crystal layer which is prepared by emulsifying in an optimal ratio the mixtures composed of non-ionic emulsifier (cetearyl glucoside, sorbitan stearate & sucrose cocoate etc), cetearyl alcohol, stearic acid, cholesterol, and ceramide. In addition, the stability of the retinol containing oil in water cream by adding the polymeric emulsifier such as acrylate /C10-30 alkyl alkylate crosspolymer is to be ensured even at 55 C. Retinol containing oil in water cream prepared through above procedure could be very stable at 45 C for at least 50 days. The structure identification of lamellar liquid crystal was determined using polarized light microscope and electron microscope Conclusively, we could make the very stable retinol containing oil in water cream by triple procedure, that is, encapsulation of retinol in Liposphere, intercalation of retinol in lamellar liquid crystal layer, and assurance of the high temperature stability of cream even at 55 C.

• Bulletin of the Korean Chemical Society
• /
• v.31 no.6
• /
• pp.1615-1620
• /
• 2010

Bis-[dipyrido[3,2-$\alpha$:2',3'-c]phenazine)$_2$(1,10-phenanthroline)$_2Ru_2$]$^{2+}$ complexes (bis-Ru(II) complexes) tethered by linkers of various lengths were synthesized and their binding properties to DNA investigated by normal absorption and linear dichroism spectra, and fluorescence techniques in this study. Upon binding to DNA, the bis-Ru(II) complex with the longest linker (1,3-bis-(4-pyridyl)-propane), exhibited a negative $LD^r$ signal whose intensity was as large as that in the DNA absorption region, followed by a complicate $LD^r$ signal in the metal-to-ligand charge transfer region. The luminescence intensity of this bis-Ru(II) complex was enhanced. The observed $LD^r$ and luminescence results resembled that of the [Ru(1,10-phenanthroline)$_2$ dipyrido[3,2-$\alpha$:2',3'-c]phenazine]$^{2+}$ complex, whose dipyrido[3,2-$\alpha$:2',3'-c]phenazine (dppz) ligand has been known to intercalate between DNA bases. Hence, it is conclusive that both dppz ligands of the bis-Ru(II) complex intercalate. The binding stoichiometry, however, was a single intercalated dppz per ~ 2.3 bases, which violates the "nearest binding site exclusion" model for intercalation. The length between the two Ru(II) complexes may be barely long enough to accommodate one DNA base between the two dppz ligands, but not for two DNA bases. When the linker was shorter (4,4'-bipyridine or 1,2-bis-(4-pyridyl)-ethane), the magnitude of the LD in the dppz absorption region, as well as the luminescence intensity of both bis-Ru(II) complexes, was half that of the bis-Ru(II) complex bearing a long linker. This observation can be elucidated by a model whereby one of the dppz ligands intercalates while the other is exposed to the aqueous environment.

• Journal of the Korean Electrochemical Society
• /
• v.1 no.1
• /
• pp.28-32
• /
• 1998

The electrochemical behavior of film and charge-discharge capacity of Li-ion cell in 1 M $LiPF_6/EC:DME$ (1 : 1, by volume ratio) electrolyte solution was studied using chronopotentiometry, cyclic voltammetry, chronoamperometry, and impedance spectroscopy. The first irreversible capacity was higher than the second irrversible capacity because of solvent decomposition. Especially, passivation film that is electron insulating and ionic conducting were formed on the MPCF by solvent decomposition during the first charge. The solvated Li is co-intercalated with solvent into MPCF electrode. Part of the MPCF is expoliated during co-intercalation of solvent-Li. The MPCF ends up nonuniformly covered by a relatively thick layer of exfoliated particles embedded in a matrix of product by solvent decomposition.

• YAKHAK HOEJI
• /
• v.53 no.4
• /
• pp.222-227
• /
• 2009

Human topoisomerase I (Topo I) plays a pivotal role in cell replication, transcription and repair and, therefore, is an important anti-cancer target. 20S-camptothecin (CPT) is a representative Topo I inhibitor. Compounds belonging to CPT family inhibit the religation step of Topo I-DNA by binding to the DNA cleavage site. Computational docking studies with Surflex-Dock were carried out to investigate the binding modes between Topo I-DNA binary complex structure and the ligand such as 20S-CPT and 9,10-substituted 20S-CPT analogues. The docking results demonstrated that most of the compounds with $IC_{50}$ value under $0.5{\mu}M$ intercalated exactly between the -1 and +1 DNA bases, deeply toward the cleavage site. The complex was stabilized by hydrogen-bonding and hydrophobic interactions with both the enzyme and the DNA. The compounds with $IC_{50}$ value above $0.5{\mu}M$ were poorly docked and did not intercalate. In addition, the docking results confirmed the overall correlation between the $IC_{50}$ values and docking scores, indicating the possible use of the modeling for the prediction of biological activity and design of potential inhibitors.