• Journal of ILASS-Korea
• /
• v.4 no.4
• /
• pp.24-29
• /
• 1999

In the pressure swirl atomizer, the liquid is injected through tangential passages into a swirl chamber, from which it emerges with both tangential and axial velocity components to form a thin conical sheet at the nozzle exit. This sheet rapidly attenuates, finally disintegrating into ligaments and then drops. The purpose of this study is to measure the spray characteristics according to variation of viscosity of the spray produced by the pressure swirl atomizer. The nozzle tested here were especially designed for this investigation. The discharge coefficient is determined by measuring the volume flow rate with a flow meter and the cone angle of the liquid sheets issuing from the nozzle is obtained from series of photographs of the sheet for various liquid viscosity and injection pressure. And mean drop size is measured by image processing method. It is found that the geometrical characteristics of the nozzle and the variation of viscosity were the influential parameters to determine the spray characteristics such as the cone angle, discharge coefficients and SMD.

• Journal of the Korean Ceramic Society
• /
• v.50 no.1
• /
• pp.18-24
• /
• 2013

This study was conducted to recycle fly ash containing an abundance of CaO generated from combustion in a circulating layer as a carbon storage medium. The study utilized XRD, TG-DTA and XRF analyses during the hydration of fly ash and identified calcium substances within fly ash that could be used in a carbonation process. $Ca^{2+}$ ions in the calcium substances were easily converted to hydrates. A carbonation experiment was done, which used the method of $CO_2$ gas injection to produce suspensions by mixing fly ash with distilled water. The results were analyzed using TG-DTA, XRD, and pH meter measurements. The study was able to verify that the reaction was completed at a $CO_2$ flow rate of 300cc/min approximately 30 minutes after an injection into a solution with a solid-liquid ratio of 1 : 10 of fly ash and distilled water. Moreover, the stirring time of the suspensions did not influence the reaction, and the reaction time was found to diminish as the portion of the fly ash became smaller. Thus, this study produced carbon storage fly ash having a $CO_2$ storage rate of about 71% through the utilization of the CaO content contained within fly ash.

• Journal of the Korean Institute of Intelligent Systems
• /
• v.24 no.2
• /
• pp.147-154
• /
• 2014

In this study, chlorine modeling technique based on fuzzy system is proposed to reduce the carcinogenic substance and decide the optimal chlorine injection rate, which is affected by chlorine evaporation rate in sedimentation basin according to detention time, weather and water quality. The additional chlorine meter is installed in the inlet part of sedimentation to reduce the feedback time and implement cascade control, which leads to maintaining the residual chlorine concentration decided by fuzzy rule. It helps to take a preemptive action about long time delay, the characteristics of the disinfection process, and reduce the variation of residual chlorine rate by 7.3 times and the chlorine consumption by 40,000 dollars. It made a significant contribution to supply hygienically safe drinking water.

• The Korean Journal of Pain
• /
• v.9 no.1
• /
• pp.46-56
• /
• 1996

Many surgeons and anesthesiologists prefer using vasoconstrictor mixed with local anesthetic agent to reduce the incidence of side effects and prolong the duration of analgesia because most local anesthetic agents, except cocaine, were believed to possess vasodilating effect. However, some investigators recently reported vasoconstricting effect of local anesthetic agents. There is still controversy on the vasoactive effect of local anesthetic agents. So this study is aimed to clarify the vasoactive effect of local anesthetics in the animal model resembling clinical settings. Rabbits were anesthesized with ketamine and haloghane, and respirations were controlled with Harvard animal ventilator. Lidocaine (0.5%, 1.0%, 1.5%) and bupivacaine (0.125%, 0.25% and 0.5%) with or without 1:100,000 epinephrine were subdermaly injected on the femoral bupivacaine of the femoral artery were measured with Doppler flow meter in vivo. The mean arterial pressure, pulse rate, arterial blood gases, pH and level of serum electrolytes were measured at every 2 minute interval for 30 minutes. Results were as follows: 1) There was no significant vasoconstriction with 0.5% lidocaine and 0.125% bupivacaine. 2) Statistically significant (p<0.05) vasodilations were observed with lidocaine (1.0~2.0%) and bupivacaine (0.25~0.5%). 3) There were no changes on the duration of vasodilation induced by local anesthetic agents of various concentrations. 4) Onset of vasodilation induced by local anesthetic agents of high concentration were faster than that of lower concentrations. 5) In the mixed injection group of epinephrine and local anesthetic agent, the vasoconstriction induced by epinephrine was completely reversed by local anesthetics, approximately 5 minutes later. In conclusion, local anesthetic agents at dose exceeding 1.0% lidocaine and 0.25% bupivacaine increase local blood flow significantly in animal study in vivo which is applicable in human clinical settings. The increase blood flow may be due to dilatation of blood vessel. Further study on the analysis of association between amount of absorbed local anesthetics in blood vessels and dilatation of blood vessels is needed.

• Korean Journal of Agricultural Science
• /
• v.3 no.1
• /
• pp.61-65
• /
• 1976

This study was conducted to induce superovulation by P.M.S. injection and P.M.S. associate with Estrogen comparatively in the rabbit. The results obtained in this study are as follows. At 23-48 hours following mating, there were 21.3-24.1 ova (Ovulation rate was increased 50.5-63.6%) in average in the group of 40 I.U P.M.S. injected per day per herd for 5 days (total 200 I.U. of P.M.S.) and 32.5-37.8 ova (Ovulation rate was increased 87.5-100%) in the group of P.M.S. associats with 0.1mg at 5th day. She number of unovulated-follicle were fewer in P.M.S.-Estrogen group than PMS group. As the result that dia meter of ova were classified in 3 group as 1-1. 4mm, 1.5-2.4mm and 2.5mm and observed, the ova in P.M.S. Estrogen group were slightly larger in size than P.M.S. group. It was conclued that P.M.S. associate with Estrogen injection was not so much effect on growth of ova but effect on ovulation of ova. so the number of ovulated ova were increased than P.M.S. group.

• Korean Journal of Fisheries and Aquatic Sciences
• /
• v.3 no.4
• /
• pp.233-250
• /
• 1970

The present paper deals with the results of the observations on the characteristics of the eggs being ripen by injection of synahorin and the larvae of the black porgy. Mylio macrocehalus (Basilewsky). The adult fish used in the experiments, during May 11th to June 5th, 1970, were obtained from a fish-farm of the Atsumi Fish Culture Company in Aichi Prefecture, Japan, The results obtained are as follows: 1. The egg is colorless and buoyant, spherical in shape, measuring from $0.81\~0.96\;mm$ in dia-meter with a single oil globule, measuring $0.20\~0.23\;mm$. 2. Hatching took place within about 35 hours and 50 minutes after insemination of eggs at the water temperature $19.6\~22.5^{\circ}C$ (Mean, $20.6^{\circ}$). 3. The newly hatched larvae were 1.57 mm in total length, with the oil globule situated at the posterior part of the elongated oval-shaped yolk sac. Melanophores and xanthophores were distributed on the middle of the caudal region, and were scattered on the surface of the oil globule, but none on the yolk sac. 4. The diameter of the eggs ill each adult is distinguished into two types, large and small. The former is in the range of $0.811\~0.873\;mm$, the latter is $0.874\~0.963\;mm$. 3. The hatching rate of black porgy was in the range of $78.63\~95.19\%$ in large and $68.84\~74.80\%$ in small eggs. The mean hatching rate of total eggs was $79.80\%$. 6. The optimum temperature of hatching black porgy is in the range of $20\~26^{\circ}C$. The highest temperature limit of hatching the black porgy is from $26.71\~28.56^{\circ}C$. 7. The total length of hatched larvae is not maintained pararell to diameter of eggs and total length of the large larvae is from $1.976\~2.225mm$, and that of small larvae is $1.526\~1.90mm$. 8. The diameter of yolk sac of black porgy is in the range of $0.878\~0.979\;mm$ 9. The initial survived larva of the black porgy was $13.71\%$ in minimum, and $79\%$ in maximam. And the mean initial survived rate was $48.3\%$. 10. In conclusion, the biological characteristics of hatched larva of black porgy is seemed to be possible for large scale production of artificial seedlings. But experimental results make initial food the prime object believed to be supplemented.