• 상하수도학회지
• /
• 제25권1호
• /
• pp.63-74
• /
• 2011

The degradation characteristics of 2-chlorophenol(2-CP) by Ferrate(VI) were studied. The degradation efficiency of 2-CP in aqueous solution was investigated at various values of pH, Fe(VI) dosage, initial concentration and aqueous solution temperature. The maximum degradation efficiencies of 2-CP were obtained at pH 7.0 and aqueous solution temperature of 25$^{\circ}C$. The degradation efficiency was proportional to dosage of Fe(VI). Also, the initial rate constant of 2-CP degradation increased with decreasing of the 2-CP initial concentration. In addition, the degradation pathway study for 2-CP was conducted with GC-MS analysis. Acetic acid, formic acid, benzaldehyde and benzoic acid were identified as reaction intermediates of the 2-CP degradation by Ferrate(VI).

• 상하수도학회지
• /
• 제26권1호
• /
• pp.69-76
• /
• 2012

A laboratory experiment on methyl orange degradation in pulsed corona discharges was carried out. Effects of operating parameters such as applied voltage, pH, conductivity and initial concentration on methyl orange degradation were investigated. The pulsed corona discharges decreased the pH of solution and increased conductivity, probably due to products generated from methyl orange degradation by corona discharges. The decrease of initial pH enhanced the methyl orange degradation. The methyl orange degradation was fastest in $100{\mu}S/cm$ conductivity solution, followed by 50 and $200{\mu}S/cm$, indicating that $100{\mu}S/cm$ is the most favorable in the aspect of radical generation among the experimented conditions. The methyl orange of initial concentration from 20 to 60mg/L was effectively degraded in pulsed corona discharges. The lower initial concentration of methyl orange, the faster degradation was observed.

• Environmental Engineering Research
• /
• 제25권3호
• /
• pp.316-323
• /
• 2020

The degradation of aqueous oxytetracycline (OTC) from an aqueous solution antibiotic using H₂O₂/Fe²⁺ process was studied in one 1 L batch chemical reactor. The extent of OTC degradation (20 mg/L) was investigated from a known initial pH solution, temperature and the type of catalyst (Fe²⁺, Fe³⁺) and for various initial concentrations of OTC, H₂O₂ and Fe²⁺. The degradation efficiency achieved was found to be very important (90.82% and 90.63%) at initial pH solution of 3 and 4, respectively. However, the type of catalyst and the reaction temperature had a slight impact on the final degradation of OTC. The results showed that the OTC removal increased with increasing initial H₂O₂ concentration in the range of 70 to 150 mg/L and initial Fe²⁺ concentrations in the range of 2 to 5 mg/L. The highest degradation efficiency obtained at ambient temperature was 90.95% with initial concentration of OTC of 10 mg/L, H₂O₂ = 150 mg/L and Fe²⁺ = 5 mg/L. Moreover, biodegradability improved from 0.04 to 0.36 and chemical oxygen demand degradation was 78.35% after 60 min of treatment. This study proved that Fenton process can be used for pretreatment of wastewater contaminated by OTC before a biological treatment.

• Environmental Engineering Research
• /
• 제23권1호
• /
• pp.1-9
• /
• 2018

The degradation of methylene blue (MB) in an aqueous solution by nano-metallic particles (NMPs) was studied to evaluate the possibility of applying NMPs to remove MB from the wastewater. Scanning electron microscopy (SEM), Fourier-transform infrared (FTIR) spectroscopy and X-ray photoelectron spectroscopy (XPS) were used to characterize the synthesized NMPs before and after the reaction. The effects of the NMP dosage, the initial pH, the initial concentration of MB and the amount of $H_2O_2$ on the MB degradation outcomes were studied. The highest removal rate of MB was achieved to be 100% with an initial MB concentration of 5 mg/L, followed by 99.6% with an initial concentration of 10 mg/L under the following treatment conditions: dose of NMP of 0.15 g/L, concentration of $H_2O_2-100mM$ and a temperature of $25^{\circ}C$. The SEM analysis revealed that the nano particles were not spherical in shape. FTIR spectra shows occurrence of metal oxides on the surfaces of the NMPs. The XPS analyses results represent that Fe, Zn, N, Ca, C and O were occurred on the surfaces of the NMPs. The degradation of MB was suitable for the pseudo-first-order kinetics.

• 신재생에너지
• /
• 제3권1호
• /
• pp.60-67
• /
• 2007

Catalyst coated membrane [CCM] type and catalyst coated substrate [CCS] type of membrane electrode assembly [MEA] were manufactured and evaluated their performance. Degradation test were conducted to find the difference of long term stability in two types of MEA and the factor for performance degradation problem occurred. Performance degradation test of single cell in two different types of MEA were carried out when current density was $200mA/cm^{2}$. The degradation test had proceeded for 230 hours and performance degradation was checked by I-V curve and impedance measurement at regular intervals. Also, MEA before/after operation and changes of catalyst layer were characterized by SEM, TEM, and XRD. Maximum power density of CCM type was higher than that of CCS type. Meanwhile, an increase of particle size of catalyst and an increase of impedance resistance after long term operation were observed. In the case of using CCM type MEA, the performance was deteriorated 38% of initial performance. In the case of using CCS type MEA, the performance was deteriorated 43% of initial performance. In consideration of difference of initial performance, performance of CCM type is higher than that of CCS type but both types had similar problems during degradation test.

• 상하수도학회지
• /
• 제25권5호
• /
• pp.643-649
• /
• 2011

Degradation of benzothiophene(BT) in the aqueous phase by potassium ferrate(VI) was investigated. Potassium ferrate(VI) was prepared by the wet oxidation method. The degradation efficiency of BT was measured at various values of pH, ferrate(VI) dosage and initial concentration of BT. BT was degraded rapidly within 30 seconds by ferrate(VI). While the highest degradation efficiency was achieved at pH 5, the lowest degradation efficiency was achieved at pH 9. Also, the initial rate constant of BT increased with decreasing of the BT initial concentration. In addition, the intermediate analysis for the reaction of BT and ferrate(VI) has been conducted using GC-MS. Benzene, styrene, benzaldehyde, formaldehyde, benzoic acid, formic acid, and acetic acid were identified as reaction intermediates, and ${SO_4}^{2-}$ was identified as an end product.

• Asian-Australasian Journal of Animal Sciences
• /
• 제1권4호
• /
• pp.219-222
• /
• 1988

Degradation of deoxyribonucleic acid(DNA) and ribonucleic acid(RNA) by cell-free extract of mixed rumen protozoa of buffalo rumen was investigated. DNA was observed to be degraded rapidly during an initial incubation period of 2 hr with simultaneous appearance of degradation products. RNA on the other hand recorded a rapid degradation during an initial incubation period of 1 hr. RNA degradation products appeared upto an incubation period of 2 hr. DNA was observed to degrade into oligo- and mononucleotides. pyrimidine nucleosides, purine nucleoside adenosine and bases xanthine, hypoxanthine and thymine. Degradation products of RNA comprised of pyrimidine nucleosides, purine nucleoside, adenosine and bases xanthine, hypoxanthine and uracil besides oligo- and mononucleotides.

• 도시과학
• /
• 제8권2호
• /
• pp.13-18
• /
• 2019

Using self-made coil dielectric barrier discharge reactor, the removal efficiency of ethyl acetate under simulated experimental parameters such as initial concentration of waste gas, total flow rate, relative humidity and voltage was investigated. The results show that the degradation rate of ethyl acetate increases with the increase of output voltage. When other conditions remain unchanged, the degradation rate decreases with the increase of initial concentration of ethyl acetate; with the increase of total flow rate, the degradation rate of ethyl acetate decreases; with the increase of relative humidity, the degradation rate first increases and then decreases, and when the relative humidity is 64%, the degradation efficiency is the highest.

• Journal of Advanced Marine Engineering and Technology
• /
• 제40권10호
• /
• pp.888-893
• /
• 2016

In this study, the solution plasma process was utilized with the aim of degrading synthetic dyes in water at atmospheric pressure. The experiments were conducted in a batch-type reactor consisting of a symmetric wire-wire electrode configuration with rhodamine B (RhB) as the target synthetic dye. The effects of the plasma treatment time and initial dye concentration on the RhB degradation were investigated by monitoring the change in absorbance of RhB solutions. The RhB solutions turned lighter in color and finally colorless with prolonged plasma treatment time, indicating the destruction of dye molecules. The RhB solutions were found to have degraded, following the first-order kinetic process. However, for high initial RhB concentrations, another kinetic process or factor seems to play a dominant role at the initial degradation stage. The fitted first-order rate constant decreased as the initial concentration increased. This result suggests that the degradation behavior and kinetic process of the RhB solution strongly depends on its initial concentration. The RhB degradation is considered to be due to a combination of factors, including the formation of chemically oxidative species, as well as the emission of intense UV radiation and high-energy electrons from the plasma. We believe that the solution plasma process may prove to be an effective and environment-friendly method for the degradation or remediation of synthetic dye in wastewater.

• Journal of Microbiology and Biotechnology
• /
• 제8권2호
• /
• pp.185-187
• /
• 1998

Pseudomonas putida KCTC 2401 degrades 1,1, 2-trichloroethylene (TCE) using phenol as a cosubstrate. The initial TCE degradation rate decreased with the initial TCE concentration up to 20mg/l of TCE at $30^{\circ}C$ and pH 6.5. The initial degradation rate and total removal efficiency increased with inoculum size. The strain also degraded dichloroacetic acid, which was supposed to be a degradation by-product. Phenol monooxygenase apparently participates in the TCE degradation mechanism.