• Magazine of the Korean Society of Agricultural Engineers
• /
• v.39 no.3
• /
• pp.128-137
• /
• 1997

In this study, examined influence of consolidation effect that had affected by location of pump inlet that was set collection well for drainage of pore water discharged by embankment on soft ground through the field test. The results of this study are summarized as follows; 1 Initial consolidation curve value were larger than theoritic value, the cause of these phenomena were thought influence of secondary consolidation and three dimensional strain of soft clay. 2. The settlement value of Hosino method was larger than that of Hyperbolic method, but settlement value of Hyperbolic method was accurate more than that of Hosino method in the prediction of settlement. 3. When pump inlet in collection well came down from GL+O.3m to GL-1.5m, settlement value increased about 10cm and when the ground water level was made insitu after pumping had completed , settlement was expanded about 7~8cm. So it is found that location change of pump inlet bad an influence on settlement remarkably. 4. If location of pump inlet in collection well for large scale estate or wide road site is lowered than original ground level, the settlement will be accelerated effectively, and at this stage automatic pump must be used in pumping.

• Journal of Integrative Natural Science
• /
• v.9 no.2
• /
• pp.144-151
• /
• 2016

The purpose of this study is to investigate the emotion effects on academic achievement for university students. The results are as follows. Resulting on the each emotions difference by the statistical variables, anxiety scores by gender showed a significant difference in the p<.01 level(F=7.685). The males anxiety(2.478, standard deviation: 0.180) had significantly lower scores than females(3.076, standard deviation: 0.168). But fear, anger, activity, and sociability scores were not significantly different respectively between male and female students. To see the emotions effect of academic achievement, the analysis method of the linear regression line was used. As the result, anxiety, fear, anger, activity, and sociability did not significantly influence academic achievement. And so unlike previous methods, the analysis method of the quadratic regression curve was used. As the result, anxiety, fear, anger, activity, and sociability showed did significantly influence academic achievement respectively within 5% of statistical significance level, to more than F=3.06. Therefore, the values on academic achievement of the each anxiety, fear, anger, activity, and sociability showed a quadratic regression curve. That is, [Academic achievement]=$-0.9685{\times}[Anxiety]^2+5.1342{\times}[Anxiety]+8.2679$,[Academic achievement]=$-1.0638{\times}[Fear]^2+5.5694{\times}[Fear]+7.5635$,[Academic achievement]=$-1.3497{\times}[Anger]^2+9.1284{\times}[Anger]+0.6720$,[Academic achievement]=$-1.0589{\times}[Activity]^2+7.4386{\times}[Activity]+1.8272$,[Academic achievement]=$-1.6830{\times}[Sociability]^2+11.2325{\times}[Sociability]-3.8258$. Therefore, we were able to determine the following conclusions. First, we were able to predict the degree of academic achievement by the each emotions scale. Second, when the each emotion scores of students was a moderate, the academic achievement was most excellent. So, in order for the students to become higher academic achievement, the maintenance of medium degree of the each emotions scores is required.

• Tunnel and Underground Space
• /
• v.12 no.4
• /
• pp.237-247
• /
• 2002

A total of 18 stress measurements were performed in the rock and rock-like blocks in the laboratory to estimate the influence of anisotropy in rock. Full scale overcoring equipment, which consists of a coring machine and a biaxial loading system by flat jacks, was developed to simulate the in-situ rock stress condition in the laboratory By comparing the isotropic analysis with the anisotropic analysis in measuring the stress, conclusions have been drawn as to the influence of anisotropy. The maximum difference between the isotropic and the anisotropic analysis was 34% and it was shown that the stress measurement considering the anisotropy was needed. To confirm the validity of the observed data, a diagnostic analysis of stress relief curve by overcoring was conducted using the three dimensional finite difference program, FLAC 3D.

• Journal of Wetlands Research
• /
• v.17 no.4
• /
• pp.436-446
• /
• 2015

It is suggested investigating method about the existing state of demand in this study. The total demand of 357 water amenity zones in 2014 is estimated based on the growth curve models. The effects of population density and distances between water amenity zones and metropolises populated over 1 million are investigated on each river system. The suitability like RMSE and MAPE of logistic and gompertz models are considered to select more suitable model for each water amenity zone. Demand for water amenity zones in 2014 is seemed to be rather high at Han Gang river system and Chungcheongbukdo after analyzing. The influence of population density is rarely effective except Geum Gang river system. The influence of metropolis on the demand for water amenity zones is higher at Geum Gang river system than others.

• Journal of the Korean Geotechnical Society
• /
• v.19 no.2
• /
• pp.27-38
• /
• 2003

The characteristics and prediction model of the shear strength of unsaturated residual granite soils were studied in this paper. In order to investigate the influence of the net normal stress on the shear strength, unsaturated triaxial tests and SWCC tests were carried out by varying the net normal stress. Experimental data for unsaturated shear strength tests were compared with predicted shear strength envelopes obtained from existing prediction models. It was shown that the soil-water characteristic curve and the shear strength of the unsaturated soil varied with the change of the net normal stress. Therefore, to achieve a truly descriptive shear strength envelope for unsaturated soils, the effect of the normal stress on the contribution of matric suction to the shear strength has to be taken into consideration. In this paper, a modified prediction model f3r the unsaturated shear strength was proposed.

• Membrane and Water Treatment
• /
• v.10 no.1
• /
• pp.45-55
• /
• 2019

Climate change has significantly affected the rainfall characteristics which can influence the pollutant build-up and wash-off patterns from the catchment. Therefore, this study explored the influence of varying rainfall characteristics on urban and agricultural runoff pollutant export using statistical approaches. For this purpose, Mann-Kendall and Pettitt's test were applied to detect the trend and breakpoint in rainfall characteristics time series. In addition, double mass curve and correlation analysis were used to drive the relationship between rainfall-runoff and pollutant exports from both catchments. The results indicate a significant decreased in total rainfall and average rainfall intensity, while a significant increased trend for antecedents dry days and total storm duration over the study periods. The breakpoint was determined to be 2013 which shows remarkable trend shifts for total rainfall, average rainfall intensity and antecedents dry days except total duration. Double mass curve exhibited a straight line with significant rainfall-runoff relationship indicates a climate change effect on both sites. Overall, higher pollutant exports were observed at both sites during the baseline period as compared to change periods. In agricultural site, most of the pollutants exhibited significant (p< 0.05) association with total rainfall, average rainfall intensity and total storm duration. In contrast, pollutants from urban site significantly correlated with antecedent dry days and average rainfall intensity. Thus, total rainfall, average rainfall intensity and total duration were the significant factors for the agricultural catchment while, antecedents dry days and average rainfall intensity were key factors in build-up and wash-off from the urban catchment.

• Journal of Korean Society on Water Environment
• /
• v.37 no.4
• /
• pp.249-262
• /
• 2021

This study investigated the pollution characteristics of the main pollution zone in the Hwangguji watershed and the influence of the tributary on the main stream. The characteristics of the main pollution zone, including, the water quality index (WQI), stream rating, load duration curve (LDC), delivery load density (DLD), and contribution of the tributary to the mainstream, were evaluated by time-series visual heatmap. The WQI of the mainstream of Hwangguji was lowered to the poor (IV) level from the inflow point of Suwon stream (SW) and the LDC excess rate in the T-P was higher than that of BOD₅, especially for the wet season, suggesting that management of non-point source with T-P is preferred. The contribution (%) of the tributaries in the upstream section of Hwangguji watershed were BOD₅ 14.54%, TOC 15.67%, T-N 5.43%, and T-P 6.97%. In particular, the Suwon sewage treatment plant located in the mainstream showed a high contribution of BOD₅ (64.40%) and T-P (53.54%), respectively, due to the high discharge rate (6.019 m³/sec). Meanwhile, Sammi and Gal stream have a large impact on the mainstream with high DLD and poor WQI. Thus, both streams were considered as pollution hot spots. These results provide useful basic data for preparing more effective water quality improvement and management plans in the watershed.

• The Journal of Economics, Marketing and Management
• /
• v.7 no.1
• /
• pp.1-14
• /
• 2019

Purpose - Currently, the economic globalization has become a common channel for China's enterprise to perform the international economic activities. Due to this background, this paper tries to analyze the influence of internationalization level on operation performance of enterprises. Research design, data, and Methodology - This paper aims at 296 companies going listed in Shanghai Stock Exchange and Shenzhen Stock Exchange. The data about the listed companies during the 12 years from 2005 to 2016 have been collected. Relevant theories, including the theory of comparative advantage, monopolistic advantage and product life cycle in developed countries as well as the small scale technology and state on localized technological capacities in developing countries, have been summarized to provide theoretical basis for the influence of international operation on operation performance of the enterprises. Moreover, the current status of international operation of China's enterprises, including the dynamic cause of the internationalization of China's enterprises, its competitive advantage and disadvantage as well as the interest and potential risk of the internationalization, have been also analyzed. Results - Via adopting the panel data to conduct an empirical analysis, It can be found that the relationship between international operation level and operation performance of China's enterprises can be expressed as the S-curve of declining, rising and declining again. Conclusions - This paper has taken the lead in using Ohlson corporate value model to fill the gap in the relevant researches in China. It can also provide guidance for the international operation of China's enterprises. Meanwhile, the two systems for international operation and performance evaluation index have been put forward. The performance of international operation can be classified as financial performance or corporate value so that the operation effect of those China's enterprises going abroad can be better evaluated.

• Imaging Science in Dentistry
• /
• v.52 no.3
• /
• pp.267-273
• /
• 2022

Purpose: The aim of this study was to assess the influence of kilovoltage- peak (kVp) and the metal artifact reduction (MAR) tool on the detection of buccal and lingual peri-implant dehiscence in the presence of titanium-zirconia (Ti-Zr) and zirconia (Zr) implants in cone-beam computed tomography (CBCT) images. Materials and Methods: Twenty implant sites were created in the posterior region of human mandibles, including control sites (without dehiscence) and experimental sites (with dehiscence). Individually, a Ti-Zr or Zr implant was placed in each implant site. CBCT scans were performed using a Picasso Trio device, with variation in the kVp setting (70 or 90 kVp) and whether the MAR tool was used. Three oral radiologists scored the detection of dehiscence using a 5-point scale. The area under the receiver operating characteristic (ROC) curve, sensitivity, and specificity were calculated and compared by multi-way analysis of variance (α=0.05). Results: The kVp, cortical plate involved (buccal or lingual cortices), and MAR did not influence any diagnostic values (P>0.05). The material of the implant did not influence the ROC curve values(P>0.05). In contrast, the sensitivity and specificity were statistically significantly influenced by the implant material (P<0.05) with Zr implants showing higher sensitivity values and lower specificity values than Ti-Zr implants. Conclusion: The detection of peri-implant dehiscence was not influenced by kVp, use of the MAR tool, or the cortical plate. Greater sensitivity and lower specificity were shown for the detection of peri-implant dehiscence in the presence of a Zr implant.

• Proceedings of the KSME Conference
• /
• 2004.11a
• /
• pp.325-330
• /
• 2004

Recently, the request for the high strength of material is more and more increased in the area of industrial environment and machinery. To accomplish the high strength of materials, carbonizing treatment, nitrifying treatment, shot-peening method are representatively applied, however, shot-peening method is generally used among the surface processes. Shot peening is a cold working process used to impact Compressive residual stressed in the exposed surface layers. Benefits due to shot peening are increase in resistance to fatigue, stress corrosion cracking, fretting, galling, erosion and closing of pores. In this study, the influence of shot peening on the corrosion was investigated on spring steel immersed in 3.5% NaCl. The immersion test as performed on the two kinds of specimens. Corrsion potential, polarization curve, residual stress and etc, were investigated from experiment results. From test result the effect of shot peening on the corrosion was evaluated. The important results of the experimental study on the effects of shot peened on the environment corrosion of spring steels are as follows; In case of corrosion potential, shot peened specimen shows more activated negative direction as compared with parent mental. Surface of specimen, which is treated with the shot peened is placed as more activated state against inner base metal. It can cause t도 anti-corrosion effect on the base metal.