• 한국정밀공학회지
• /
• 제13권9호
• /
• pp.114-129
• /
• 1996

This paper describes the whole development phase for the underwater vehicle actuating system with high hydroload torque disturbance. This includes requirement analysis, system modeling, control algorithm design, real time implementation, test and performance evaluations. As for driving control algorithms, fuzzy logic, variable structure and PD(Proportional-Differential) algorithm were designed and implemented on board controller using a single chip microprocessor. Intel 8797. And test and performance evaluation is carried out both single test and wystem integration test. We could confirm the basic performance of actuating system through the single test and gereral developing work of any actuating systems was finished with a single performance test of actuating system without system integration test. But, we suggested that system integration test be needed. System integration test is carried out using G/C HILS(Guidance and Control Hardware-In-the -Loop Simulation) which is constituted flight motion simulator, load simulator, real time host computer and the related subsystems such as inertial navigation system, power supply system and Guidance and Control Computer etc.. The most important practical contribution of this paper is that full system characteristics such as minimal control effort, enhancement of guidance and autopilot performance by the actuating system using G/C HILS technique are investigated. Through full running G/C HILS, in spite of the passing to single tests, some control algorithm resulted in failure as to stability of full system and system time frame.

• 제어로봇시스템학회논문지
• /
• 제21권9호
• /
• pp.888-897
• /
• 2015

A flight capability to take a terrain following flight near the ground is required to reduce the probability that a fighter aircraft can be detected by foe's radar fence in the battlefield. The success rate for mission flight has increased by adopting TFS (Terrain Following System) to enable the modern advanced fighter to fly safely near the ground at the low altitude. This system has applied to the state-of-the-art fighter and bomber, such as B-1, F-111, F-16 E/F and F-15, since the research begins from 1960's. In this paper, the terrain following system and GCAS (Ground Collision Avoidance System) was developed, based on a digital database with UTAS's TERPRROM (TERrain PROfile Matching) equipment. This system calculates the relative location of the aircraft in the terrain database by using the aircraft status information provided by the radar altimeter and the INS (Inertial Navigation System), based on the digital terrain database loaded previously in the DTC (Data Transfer Cartridge), and figures out terrain features around. And, the system is a manual terrain following system which makes a steering command cue refer to flight path marker, on the HUD (Head Up Display), for vertical acceleration essential for terrain following flight and enables a pilot to follow it. The cue is based on the recognized terrain features and TCH (Target Clearance Height) set by a pilot in advance. The developed terrain following system was verified in the real-time pilot evaluation in FA-50 HQS (Handling Quality Simulator) environment.

• 한국항공우주학회지
• /
• 제48권4호
• /
• pp.285-293
• /
• 2020

본 논문에서는 Synthetic Aperture Radar (SAR, 합성개구레이다) 영상 품질을 향상시키기 위해 EGI/IMU (Embedded GPS/INS, Inertial Measurement Unit) 통합 항법 시스템에서 발생하는 시각 동기화 오차의 영향을 분석하고 이를 보상하기 위해 상태변수증강 기법을 적용한다. SAR 요동 측정 알고리즘으로 항체의 위치를 추적하기 위한 EGI와 추가적으로 안테나에 장착된 IMU를 결합하는 EGI/IMU 통합 항법 시스템이 많이 이용된다. 이와 같은 EGI/IMU 통합 항법 시스템에서 센서간의 시계가 동기화되지 않을 경우 시각 동기화 오차가 발생한다. 시각 동기화 오차가 항법 및 SAR 영상에 미치는 영향 분석을 통해 시각 동기화 오차가 SAR 영상 품질을 악화시키는 것을 확인하였다. 이를 보상하기 위해 상태변수증강 기법을 적용하고, 적용한 결과 SAR 영상 품질이 저하되지 않음을 확인하였다. 또한 기동에 따른 시각 동기화 오차 추정 성능과 가관측성을 분석하여 시각 동기화 오차를 효과적으로 추정하기 위해서는 회전 기동과 같은 시간에 따라 변화하는 기동이 필요함을 보였다. 따라서, SAR 영상에 미치는 시각 동기화 오차의 영향을 줄이기 위해서는 SAR 구간 전에 회전 기동 등 시간에 따라 변화하는 기동을 수행하여 시각 동기화 오차를 보상해 주어야 한다.

• 항공우주산업기술동향
• /
• 제8권2호
• /
• pp.76-85
• /
• 2010

본 논문에서는 우주환경에 사용되는 광섬유자이로(FOG)의 최근 개발동향에 대해 기술하고자 한다. 광섬유자이로는 샤냑효과를 이용하여 각속도를 측정하는 장치로 링레이저자이로(RLG)에 비해 짧은 개발역사를 가지고 있지만, 관련 소자 및 신호처리 방법의 발전으로 인해 고성능의 우주용 관성항법장치로 링레이저자이로를 대체하기에 충분한 것으로 알려져 왔다. 본 논문에서는 광섬유자이로의 개발동향을 현재까지 개발된 광섬유자이로 제품을 바탕으로 각각의 성능과 특징에 대해 알아보고, 앞으로 고성능 우주용 관성항법장치로서의 광섬유자이로의 발전 방향에 대해 살펴보기로 한다.

• 전자공학회논문지
• /
• 제50권1호
• /
• pp.276-284
• /
• 2013

본 논문에서는 관성항법시스템의 전달정렬시 속도정합 알고리듬에 대하여 지렛대 거리 오차의 가관측성 분석을 수행하였다. 이를 위해 지렛대 거리 오차를 포함한 칼만필터 상태 변수를 모델링하였고 측정 방정식을 구성하였다. 가관측성 분석 방법으로는 SOM을 이용하였고 다양한 항체의 운항 조건들에 대하여 가관측성 분석을 수행하였다. 기존의 지렛대 거리 오차를 포함한 가관측성 분석 기법들은 시뮬레이션을 통한 분석이 주를 이룬 반면에 본 논문에서는 상태 변수들이 완전 가관측하기 위한 항체의 운항 조건을 해석적으로 제시하였다. 그리고 시뮬레이션을 수행하여 분석 결과를 검증하였다.

• 전자공학회논문지SC
• /
• 제49권3호
• /
• pp.12-18
• /
• 2012

본 논문에서는 항공기에 장착된 안테나가 정지 위성을 향하도록 관성측정기를 사용하여 지향각을 계산하는 방식을 제시한다. 대상 시스템에서 안테나는 항공기 앞에 위치하고 있고 몸체 유연성을 고려하기 위해 관성측정기를 도입하며, 항공기 중심부 GPS/INS와 안테나부 관성항법장치(INS) 사이의 위치와 속도 차이를 활용하여 스트랩다운 INS 표류 오차를 억제하기 위한 칼만필터를 설계한다.

• 한국도로학회논문집
• /
• 제19권5호
• /
• pp.97-106
• /
• 2017

PURPOSES: This study aims to evaluate the effects of vehicle dynamic behaviors on ride quality. METHODS : Simulation and field test were conducted to analyze the behavior of a driving vehicle. The simulation program CarSIM was applied and an INS (Inertial Navigation System) was used for field experiments. A small simulator was developed to simulate vehicle behavior such as roll, pitch, and bounce. The panels evaluated the ride quality in five stages from "very satisfied"to "very dissatisfied."Experiments were conducted on a total of 144 cases of vehicle behavior combinations. RESULTS :In both simulation and field tests, pitch is the largest and yaw the smallest. Especially in the field test, the amount of yaw is very low, about 7% of pitch and 18% of roll. The sensitive and extensive analysis conducted related ride quality with changing the frequency and amplitude. It was found that the most sensitive frequency range is 8 Hz across all amplitudes. Moreover, the combination of the roll and bounce was most sensitive to the ride quality at the low-frequency range. CONCLUSIONS : This result show that the vertical vehicle behavior (bounce) as well as the rotational behavior (roll and pitch) are highly correlated with ride quality. Therefore, it is expected that a more reasonable roughness index can be developed through a combination of vertical and rotational vehicle behavior.

• 한국항공우주학회지
• /
• 제48권11호
• /
• pp.873-880
• /
• 2020

본 논문은 스트랩다운 탐색기 측정치와 INS 정보를 이용하여 시선각속도를 추정하는 유도필터 설계에 대해서 다룬다. 제안하는 유도필터는 탐색기 측정치와 유도탄 자세로부터 획득 가능한 시선각과 표적의 위치와 유도탄과의 상대 위치를 측정치로 하고 있으며, 주기 및 동기가 맞지 않는 두 센서의 출력을 사용하기 위해 비동기 필터를 기반으로 하고 있다. 제안한 방법을 통해 시간지연이 큰 탐색기 측정치를 사용함으로써 생길 수 있는 기생루프에 대한 영향을 줄이고 추정성능을 향상시킬 수 있다.

• 한국군사과학기술학회지
• /
• 제17권4호
• /
• pp.531-536
• /
• 2014

There are trapping and stripping methods as the technique to remove the dither motion from RLG(Ring Laser Gyro) output. V/F converter output of angular sensor to measure the dither motion is used in stripping method. But bias and scale factor error is always included in V/F converter output and is a critical limiting factor for the wide application of stripping method to RLG. Therefore there have been many researches to solve this problem. The method to accurately estimate the bias and scale factor error of V/F converter using measurements of the angular sensor acquired at data sampling rate of INS is presented in this paper. To this end, stripping technique based on model of dither motion is newly applied.

• 한국측량학회지
• /
• 제37권5호
• /
• pp.397-402
• /
• 2019

Recently, with the emergence of autonomous vehicles and the increasing interest in safety, a variety of research has been being actively conducted to precisely estimate the position of a vehicle by fusing sensors. Previously, researches were conducted to determine the location of moving objects using GNSS (Global Navigation Satellite Systems) and/or IMU (Inertial Measurement Unit). However, precise positioning of a moving vehicle has lately been performed by fusing data obtained from various sensors, such as LiDAR (Light Detection and Ranging), on-board vehicle sensors, and cameras. This study is designed to enhance kinematic vehicle positioning performance by using feature-based recognition. Therefore, an analysis of the required precision of the observations obtained from the images has carried out in this study. Velocity and attitude observations, which are assumed to be obtained from images, were generated by simulation. Various magnitudes of errors were added to the generated velocities and attitudes. By applying these observations to the positioning algorithm, the effects of the additional velocity and attitude information on positioning accuracy in GNSS signal blockages were analyzed based on Kalman filter. The results have shown that yaw information with a precision smaller than 0.5 degrees should be used to improve existing positioning algorithms by more than 10%.