• Proceedings of the Korean Vacuum Society Conference
• /
• 2014.02a
• /
• pp.346.2-346.2
• /
• 2014

To use the GaN based light-emitting diodes (LEDs) as solid state lighting sources, the improvement of light extraction and internal quantum efficiency is essential factors for high brightness LEDs. In this study, we suggested the new materials system of a zinc tin oxide (ZTO) layer formed on blue LED epi-structures to improve the light extraction. ZTO is a representative n-type oxide material consisted of ZnO and SnO system. Moreover, ZTO is one of the promising oxide semiconductor material. Even though ZTO has higher chemical stability than IGZO owing to its SnO2 content this has high mobility and high reliability. After formation of ZTO layer on p-GaN layer by using the spin coating method, structural and optical properties are investigated. The x-ray diffraction (XRD) measurement results show the successful formation of ZTO. The photoluminescence (PL) and absorption spectrum shows that it has 3.6-4.1eV band gap. Finally, the light extraction properties of ZTO/LED chip using electroluminescence (EL) measurement were investigated. The experimental and theoretical analyses were simultaneously conducted.

• Korean Journal of Optics and Photonics
• /
• v.19 no.5
• /
• pp.381-385
• /
• 2008

We have analyzed the effect of the substrate removal and packaging schemes on light output characteristics in InGaN/Sapphire LEDs. The removal of the sapphire substrate helps to dissipate the heat generated in the junction, but the advantage comes only with the detrimental effect of degrading the photon extraction efficiency. If the substrate-removed chip is attached to a metallic mount with good thermal conductivity, the maximum driving current is increased drastically, producing significantly increased light output and therefore compensating the photon extraction efficiency degradation. On a dielectric mount with a relatively poor thermal conductivity, however, it produces smaller light output, over most input current range, than the regular type of chips with the sapphire substrate remaining. Thus, for low power applications, the regular chips may be preferred over the substrate-removed chips, regardless of the chip mounts employed.

• Journal of the Microelectronics and Packaging Society
• /
• v.14 no.4
• /
• pp.87-92
• /
• 2007

A $CaAl_{12}O_{19}:Mn^{4+}$ red phosphor showed the highest emission intensity at a concentration of 0.02mole $Mn^{4+}$ and the high crystallinity and luminescent properties were obtained at $1600^{\circ}C$ firing temperature for 3hr. The synthesized phosphor showed a broad emission band at 658nm wavelength. Red light-emitting diodes(LEDs) were fabricated through the integration of on InGaN UV bare chip and a 1:3 ratio of $CaAl_{12}O_{19}:Mn^{4+}$ and epoxy resin in a single package. This coated LED can be applicable to make White LEDs under excitation energy of UV LED.

• Current Optics and Photonics
• /
• v.3 no.2
• /
• pp.164-171
• /
• 2019

Photoluminescence (PL) properties of GaN-based light-emitting diodes (LEDs) were analyzed to study the effects of carrier leakage on the luminescence properties at room temperature. The electrical leakage and PL properties were compared for LEDs showing leakages at forward bias and an LED with an intentional leakage path formed by connecting a parallel resistance of various values. The leakages at the forward bias, which could be observed from the current-voltage characteristics, resulted in an increase in the excitation laser power density for the maximum PL efficiency (ratio of PL intensity to excitation power) as well as a reduction in the PL intensity. The effect of carrier leakages on PL properties was similar to the change in PL properties owing to a reduction of the photovoltage by a reverse current since the direction of the carrier movement under photoexcitation is identical to that of the reverse current. Valid relations between PL properties and electrical properties were observed as the PL properties deteriorated with an increase in the carrier leakage. The results imply that the PL properties of LED chips can be an indicator of the electrical properties of LEDs.

• Journal of the Optical Society of Korea
• /
• v.18 no.5
• /
• pp.582-588
• /
• 2014

We study polarization-dependent spontaneous emission (SE) rate and light extraction efficiency (LEE) in localized-surface-plasmon (LSP)-coupled light emitting diodes (LEDs). The closely packed seven $Ag/SiO_2$ core-shell (CS) nanoparticles (NPs) lie on top of the GaN surface for LSP coupling with a radiated dipole. According to the dipole direction, both the SE rate and the LEE are significantly modified by the LSP effect at the $Ag/SiO_2$ CS NPs when the size of Ag, the thickness of $SiO_2$, and the position of the dipole source are varied. The enhancement of the SE rate is related to an induced dipole effect at the Ag, and the high LEE is caused by light scattering with an LSP mode at $Ag/SiO_2$ CS NPs. We suggest the optimum position of the quantum well (QW) in blue InGaN/GaN LEDs with $Ag/SiO_2$ CS NPs for practical application.

• Journal of Advanced Marine Engineering and Technology
• /
• v.34 no.7
• /
• pp.991-996
• /
• 2010

Blue-green and green LEDs have been successfully fabricated grown by MBE, which has introduced the $ZnS_ySe_{1-x-y}:Te_x$ (x=0.04, y~0.11-0.14) ternary epilayer as an active layer. From the I-V characteristics, the built-in voltage (~2.1 V) is very small compared to other wide bandgap LEDs, such as commercial InGaN-based LEDs (>3.2 V). From the C-V profiling, the effective carrier concentration in the p-type ZnMgSSe cladding layer was evaluated as ${\sim}2.8{\times}10^{16}\;cm^{-3}$ for the present LEDs.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.13 no.1
• /
• pp.329-332
• /
• 2012

LEDs are using widely in a field of illumination, LCD LED backlight, mobile signals because they have several merits, such as low power consumption, long lifetime, high brightness, fast response, environment friendly. To achieve high performance LEDs, one needs to enhance output power, reduce operation voltage, and improve device reliability. In this paper, we have proposed that the optimum design and specialized process could improve the performance of LED chip. It was showed an output power of 7cd and input supplied voltage of 3.2V by the insertion technique of current blocking layer. In this paper, GaN-based LED chip which is built on the sapphire epi-wafer by selective MOCVD were designed and developed. After that, their performances were measured. It showed the output power of 7cd more than conventional GaN-based chip. It will be used the lighting source of a medical equipment and LCD LED TV with GaN-based LED chip.

• Current Optics and Photonics
• /
• v.2 no.5
• /
• pp.468-473
• /
• 2018

We investigate the temperature dependence of efficiency droop in InGaN/GaN multiple-quantum-well (MQW) blue light-emitting diodes (LEDs) in the temperature range from 20 to $80^{\circ}C$. When the external quantum efficiency (EQE) and the wall-plug efficiency (WPE) of the LED sample were measured as injection current and temperature varied, the droop of EQE and WPE was found to be reduced with increasing temperature. As the temperature increased from 20 to $80^{\circ}C$, the droop ratio of EQE was decreased from 16% to 14%. This reduction in efficiency droop with temperature can be interpreted by a temperature-dependent carrier distribution in the MQWs. When the carrier distribution and radiative recombination rate in MQWs were simulated and compared for different temperatures, the carrier distribution was found to become increasingly homogeneous as the temperature increased, which is believed to partly contribute to the reduction in efficiency droop with increasing temperature.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.5 no.2
• /
• pp.127-130
• /
• 2005

The structural and electrical properties of InN/GaN multiple quantum wells, which were grown by metalorganic chemical vapor deposition, were characterized by transmission electron microscopy and electroluminescence measurements. As the quantum well growth time was changed, the wavelength was varied from 451 to 531 nm. In the varied current conditions, the blue LED with the InN MQW structures did not have the wavelength shift. With this result, we can expect that the white LEDs with the InN MQW structures do not show the color temperature changes with the variations of applied currents.

• 한국정보디스플레이학회:학술대회논문집
• /
• 2004.08a
• /
• pp.676-678
• /
• 2004

In order to develop new yellow phosphor that emit efficiently under the 450 - 470 nm excitation range, we have synthesized a $Eu^{2+}$-activated $Sr_3SiO_5$ yellow phosphor and investigated an attempt to develop white LEDs by combining it with a InGaN blue LED chip (460 nm). Two distinct emission bands from the InGaN-based LED and the $Sr_3SiO_5$:Eu phosphor are clearly observed at 460 nm and at 570 nm, respectively. These two emission bands combine to give a spectrum that appears white to the naked eye. Our results showed that InGaN (460 nm chip)-based $Sr_3SiO_5$:Eu exhibits a better luminous efficiency than that of the industrially available product InGaN (460 nm chip)-based YAG:Ce.