• Korean Journal of Optics and Photonics
• /
• v.11 no.5
• /
• pp.353-359
• /
• 2000

A harmonically mode-locked fiber ring laser cavlty was theoretically analyzed. The measured charactenstlcs of a 10 GHz erbium-doped fiber ring laser were used as a basis of the theoretical analysis. From the nonlinear Schroedinger equation of an actively mode-locked erblUm-doped fiber laser. the effects of the components inside the laser cavity have been analyzed includmg nonlinear effects from group-velocity dispersion (GVD) and self-phase modulation (SPM). Usmg the analysls. we have designed a laser cavity with minimum pulsewidth and chirp by changing the intracavity optical intensity and the bandwidth of the filter. In the new design, the chirp i, reduced by 2 times and the pulsewidth by 2A times. compared to the laser used in the experiment. iment.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.16 no.4 s.95
• /
• pp.410-417
• /
• 2005

In this paper, optical noise is reduced by a differential detector with a plastic optical fiber bundle in a wireless optical interconnection. A plastic optical fiber bundle divides the received optical signal equally and connects it to two photodiodes. In this configuration two photodiodes effectively detect the optical signal at one point, and the output voltage variation due to the abrupt change of optical noise distribution in space disappears. The signal to noise ratio in a differential detector with a fiber bundle was improved to be $10\;\cal{dB}$ higher than in a single photodiode with an optical filter.

• Journal of Electrical Engineering and Technology
• /
• v.12 no.3
• /
• pp.1007-1015
• /
• 2017

This paper proposes a new control technique of energy storage system (ESS) for smoothing the active power of renewable energy sources (RES) such as photovoltaic and wind turbine generation. As the penetration of RES into grid increases, it is difficult to maintain the permissible level of power quality, that is, voltage and frequency fluctuation in power systems. To solve this problem, ESS control methods using low pass filter (LPF) have been proposed for mitigating the fluctuation of RES output. However, those have a lot of drawbacks which need to be supplemented. Hence, this paper presents the improved active power control with additional reactive power control for maintaining power quality properly. The proposed method minimizes the capacity of ESS to be required for smoothing RES output fluctuation through mitigation of phase delay problem in LPF. In addition, the voltage regulation improves by using additional reactive power control. The proposed method was verified through simulation analysis using PSCAD/EMTDC.

• Proceedings of the Korean Institute of Navigation and Port Research Conference
• /
• v.2
• /
• pp.137-141
• /
• 2006

The purpose of GPS structural vibration monitoring is to obtain information on the frequency and amplitude of vibrations based on GPS observations that are often affected by various errors. Filters are frequently used to improve GPS accuracy and to retrieve vibration signals from GPS observational series. This paper studies the performances of four commonly used filters, i.e., Vondrak, wavelet, adaptive FIR and Kalman filters, for such applications. Controlled experiments are carried out and the results show that the capability of GPS in tracking structural dynamics and complex signals can be improved with any of the filters. The performances of Vondrak and wavelet filters are almost the same and superior to the adaptive FIR and Kalman filters. Recommendations are given for the selection of filters and filter parameters for different situations based on an analysis of the advantages and disadvantages of each of the filters.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.10 no.4
• /
• pp.388-396
• /
• 2005

SRM has not been put into practical applications widely because of its large torque ripple, acoustic noise and low power factor. In addition, a traditional position sensor is needed for the drive control. So we propose an improved sensorless drive method of Switched Reluctance Motors using impressed voltage pulses. Conventional impressed voltage pulse method has a problem of phase delay because of low-pass filter. So in this paper we propose an unproved sensorless driving method based on the impressed voltage pulse using new pulse-shift circuit technique that overcomes the phase delay and start-up problem. Proposed method is implemented in a simple analog circuit instead of using an expensive DSP.

• Journal of Power Electronics
• /
• v.15 no.1
• /
• pp.31-38
• /
• 2015

In this paper, a buck-boost type battery charger is developed for charging battery set with a lower voltage. This battery charger is configured by a rectifier circuit, an integrated boost/buck power converter and a switched capacitors circuit. A boost power converter and a buck power converter sharing a common power electronic switch are integrated to form the integrated boost/buck power converter. By controlling the common power electronic switch, the battery charger performs a hybrid constant-current/constant-voltage charging method and gets a high input power factor. Accordingly, both the power circuit and the control circuit of the developed battery charger are simplified. The switched capacitors circuit is applied to be the output of the boost converter and the input of the buck converter. The switched capacitors circuit can change its voltage according to the utility voltage so as to reduce the step-up voltage gain of the boost converter when the utility voltage is small. Hence, the power efficiency of a buck-boost type battery charger can be improved. Moreover, the step-down voltage gain of the buck power converter is reduced to increase the controllable range of the duty ratio for the common power electronic switch. A prototype is developed and tested to verify the performance of the proposed battery charger.

• Journal of Power Electronics
• /
• v.10 no.2
• /
• pp.138-145
• /
• 2010

This paper presents a single phase multilevel inverter for using as a voltage harmonic source. First, a single phase multilevel inverter system is presented and the structural parts of the inverter are described. In order to obtain multilevel output voltage waveforms, a switching strategy based on calculating switching angles is explained and an improved formula for determining switching angles is given. Simulation and experimental results of multilevel voltage waveforms are given for 15, 31 and 127 levels. The proposed topology does not only produce output voltages with low THD values. It also produces the required harmonic components on the output voltage. For this purpose, equations for switching angles are constituted and the switching functions are obtained. These angles control the output voltage as well as provide the required specific harmonics. The proposed inverter structure is simulated for various functions with the required harmonic components. The THD values of the output voltage waves are calculated. The simulated functions are also realized by the proposed inverter structure. By using a harmonic analyzer, the harmonic spectrums, which belong to the output voltage forms, are found and the THD values are measured. Simulation and experimental results are given for the specific functions. The proposed topology produces perfectly suitable results for obtaining the specific harmonic components. Therefore, it is possible to use the structure as a voltage harmonic source in various applications.

• Journal of Broadcast Engineering
• /
• v.8 no.2
• /
• pp.153-162
• /
• 2003

This paper describes a structure of adaptive equalizer to improve reception performance of ATSC digital television (DTV) for 8-VSB receivers. There are many strong and dynamic echoes affecting reliable reception of DTV signal. Conventional DFE based least mean square (LMS) algorithm is readily implemented and has good Performance. There are still problems to be solved, however, in handling strong echoes and indoor reception. In this paper, structure of adaptive equalizer to mitigate these Problems in strong multipath interference conditions and indoor reception environment is first presented. Methods to reduce error propagation effects on DFE and initialization scheme of filter coefficients for fast convergence are then introduced. Computer simulation results prove that an adaptive equalizer with proposed design methods can combat with Brazil Ensemble and the Threshold of Visibility(TOV) is improved.

• Proceedings of the KOSOMBE Conference
• /
• v.1996 no.05
• /
• pp.240-242
• /
• 1996

In this paper, we proposed a method of a hearing aid suitable for the sensorineural hearing impaired. Generally as the sensorineural hearing impaired have narrow audible ranges between threshold and discomfortable level, the speech spectrum may easily go beyond their audible range. Therefore speech spectrum must be optimally amplified and compressed into the impaired's audible range. The level and frequency of input speech signal are varied continuously. So we have to make compensation input signal for frequency-gain loss of the impaired, specially in the frequency band which includes much information. The input sigaal is divided into short time block and spectrum within the block is calculated. The frequency-gain characteristic is determined using the calculated spectrum. The number of frequency band and the target gain which will be added input signal are estimated. The input signal within the block is processed by a single digital filter with the calculated frequency-gain characteristics. From the results of monosyllabic speech tests to evaluate the performance of the proposed algorithm, the scores of test were improved.

• Journal of Electrical Engineering and Technology
• /
• v.9 no.5
• /
• pp.1614-1622
• /
• 2014

A novel equivalent flux sliding-mode observer (SMO) is proposed for dual three-phase interior permanent magnet synchronous motor (DT-IPMSM) drive system in this paper. The DT-IPMSM has two sets of Y-connected stator three-phase windings spatially shifted by 30 electrical degrees. In this method, the sensorless drive system employs a flux SMO with soft phase-locked loop method for rotor speed and position estimation, not only are low-pass filter and phase compensation module eliminated, but also estimation accuracy is improved. Meanwhile, to get the regulator parameters of current control, the inner current loop is realized using a decoupling and diagonal internal model control algorithm. Experiment results of 2MW-level DT-IPMSM drives system show that the proposed method has good dynamic and static performances.