• Korean Journal of Applied Biomechanics
• /
• v.20 no.4
• /
• pp.381-386
• /
• 2010

This study examined the changes in the walking pattern during level walking under low illumination conditions. Fourteen male subjects ($22.1{\pm}2.21$ years, $174{\pm}3.74\;cm$, $68.86{\pm}10.81\;kg$) with normal vision and no disabilities were enrolled in this study. All experiments were performed on a level walkway with three conditions: normal walking (preferred & low speed) and walking with low illumination. 3D motion capturing system was used for acquisition and analysis of the walking motion data with a sampling frequency of 120Hz. The walking speed, normalized jerk(NJ) at the center of mass(COM), wrist and heel, knee and elbow joint angle, ratio of the knee joint angle to elbow joint angle and the toe clearance on stance phase were used to compare the differences in walking pattern between the two illumination conditions, The results showed that the walking speed and joint angles decreased in low illumination, whereas the NJ and toe minimum clearance increased. In low illumination, most variables were similar to effects of low speed walking, but toe clearance was different from the effects of low speed. These results can be used as primary data for examining the changes in the level walking pattern of young adults under low illumination. Further study will be needed to compare these results in young adults with those in the elderly.

• Journal of the Ergonomics Society of Korea
• /
• v.28 no.4
• /
• pp.71-76
• /
• 2009

Effects of dark adaptation have large safety implications. This study was aimed to investigate the effects of varying illuminance and the size of critical detail on visual performance (i.e., time-to-detect) in a dark room environment. While adapting to the dark environment, ten subjects were asked to detect and answer simple numerical expressions under 9 experimental conditions (3 illuminance level $\times$ 3 target size). The ANOVA results revealed that the time-to-detect was significantly affected by both of the illumination level and the size of critical detail. As illumination increased from 10 lux to 20 lux, the time-to-detect was significantly declined. For the size of critical detail, 0.5/min size (i.e., equal to 2 minutes of visual angle) resulted in a shorter time-to-detect, as compared to 0.7/min size (i.e., equal to 1.6 minutes of visual angle). Potential applications of this research include the development of design guidelines for illumination and warning signs in poorly illuminated viewing environments.

• Proceedings of the Korea Crystallographic Association Conference
• /
• 2003.05a
• /
• pp.11-11
• /
• 2003

전자현미경내에서 일부 무기 및 금속 시료들은 전자빔 조사에 의해 시료구조가 손상되거나 비정질화 또는 상전이 등과 같은 구조전이 현상들을 겪게 된다. 즉, 전자빔 조사에 의해 시료는 원자간 결합이 끊어져 나타나는 Knock-on damage, 시료 원자 주위의 전자들과의 상호 작용에 의해 나타나는 Ionization damage, 빔 에너지의 시료온도 상승 기여에 의한 Radiolysis damage 등의 현상들을 경험하게 된다. 이러한 현상은 전자현미경의 가속전압, 전자밀도, 시료 조건 등에 따라 그 지배기구가 다르며 동일한 시편이라도 시료의 두께와 시편온도를 결정하는 전자빔 조사선량에 따라 그 양상과 전이 속도가 달라진다. 본 연구에서는 전자빔 조사에 의해 구조 전이를 겪게 되는 대표적 무기수화물의 하나인 Cibbsite에 대해 전자빔 조사효과에 대한 정량적 고찰을 에너지 여과 투과전자현미경 (EF-TEM)을 이용하여 시도하였다. 전자빔 조사는 120분까지 실시하였고 각 시간별로 에너지 필터와 Imaging plate를 이용하여 Gibbsite의 회절패턴과 미세조직 변화를 기록하였다 빔조사 시엔 illumination angle을 1.25mrad(Dose rate : 334 × 10³ e/sup -//sec·n㎡)으로 하였으며 사진기록 시엔 최소 illumination angle인 0.04mrad(Dose rate : 413 e/sup -//sec·n㎡)을 사용하였다. 시료의 관찰방향은 [001]방향이고 관찰시료두께는 약 50nm로 평가되었으며 시료의 화학변화는 EDS를 이용하여 분석하였다. 회절자료의 Intensity는 ELD/CRISP 프로그램을 이용하였으며 빔조사선량은 평행조사빔이 시료와 상호 작용하는 면적과 상호작용하지 않을 때의 빔을 회절모드에서 faraday cup으로 측정한 빔전류로 부터 계산하였다. Gibbsite에 대한 전자빔 조사 시 1분 이내에 급격한 Hydroxyl Ion(OH-)의 이탈로 인해 Cibbsite의 구조는 거시적 비정질화가 되며 시간증가에 따라 χ-alumina → ν-alumina → σ-alumina or δ-alumina의 순으로 상전이를 겪는다. 전자빔 조사 시 관찰된 회절자료의 가시적 변화를 통해 illumination angle 1.25mrad(Dose rate : 334 × 10³ e/sup -//sec·n㎡)일 경우 약 3초 이내에 비정질화가 시작됨을 알 수 있었고 이는 약 1 × 10/sup 6/ e/sup -//sec·n㎡ 의 전자선량에 해당되며 이를 기준으로 각각의 illumination angle에 대한 임계전자선량을 평가할 수 있었다. 실질적으로 Cibbsite와 같은 무기수화물의 직접가열실험 시 전자빔 조사에 의해 야기되는 상전이 영향을 배제하고 실험을 수행하려면 illumination angle 0.2mrad (Dose rate : 8000 e/sup -//sec·n㎡)이하로 관찰하고 기록되어야 함을 본 자료로부터 알 수 있었다.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.19 no.4
• /
• pp.954-964
• /
• 2015

In this research, an overlapped illumination model was newly proposed for designing a freeform LED lens with a uniform illuminance distribution on its illuminating plane. Based on the proposed model and conventional illumination models, freeform lenses were designed and their performances and tolerances were compared. As a result of the tolerance analysis about thickness change in lens, position, size change, central direction change of light emission and characteristic change in LED source. This proposed model and divergent illumination model are similar to the performance about central direction change of light emission in LED source. but the uniformity illumination value in this proposed model is more remarkably value than it in divergent illumination model about characteristic change in LED source.

• Proceedings of the Korean Society of Precision Engineering Conference
• /
• 2003.06a
• /
• pp.443-446
• /
• 2003

The vibration mode shape changed by the phase angle that can be controlled by phase-shifting ESPI system is discussed. For the phase-shifting ESPI experiment the stroboscopic illumination by using AOM(Acousto-Optic Modulator) is needed, and the initial phase angle can be adjusted by the program. The vibration mode shape is changed when the initial phase angle is changed. We examined the vibration mode shape change due to the initial phase angle change at each resonance frequency. Through this study, we found that in the vibration testing using phase-shilling ESPI the vibration mode shape is improved in the quality by adjusting exact phase angle and the error of the quantitative vibration analysis can be reduced.

• Korean Journal of Optics and Photonics
• /
• v.35 no.1
• /
• pp.18-23
• /
• 2024

In exhibition spaces such as art museums, lighting should primarily illuminate the walls where exhibits are displayed rather than the floor. Commonly used LED lighting consists of an LED and a diffusion plate that closely resembles a Lambertian light source with uniform light distribution at every angle. This type of illumination focuses on the floor surface where normal incidence occurs. Consequently, this general illumination method is not well-suited for effectively lighting the wall surface. Specifically, to illuminate a wall, it is necessary to increase the light intensity in areas with a large incident angle in the light distribution. In response to this issue, our study proposes an illumination system that uses an ultra wide converter to adjust the divergence angle from the light source to 180 degrees.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.4 no.2
• /
• pp.137-146
• /
• 1996

Behaviour of ultra-high pressure diesel spray and its structure in a constant-volume pressure chamber were studied with injection pressure ranging from 35 to 110MPa. Sprays were observed by using the back illumination scattering method and righ angle scattering method. The spray process mechanism were investigated with both photographs. As a result, the spray angle and air entrainment angle was larger as injection pressure and back pressure increase. It becomes clear that mean air-fuel ratio is increased by increasing the injection pressure.

• Korean Journal of Optics and Photonics
• /
• v.23 no.5
• /
• pp.179-188
• /
• 2012

Lenses with an ultra wide angle of view are usually called fisheye lenses since a fish can see an ultra wide panoramic view under water. As the angle of view for these kinds of lenses reaches a wide angle, the illumination on an image sensor is reduced by a rapid drop. In this paper, we discuss the causes and the ways to correct for a rapid drop. First, it is treated for the sign convention of directional cosine vectors and normal vectors on the curved surface by means of analytic geometry. And, from the fundamental discussion for these vectors, the rapid illumination drop is numerically analyzed for various kinds of causes by utilizing geometrical optics and radiometry as well as Fresnel equations derived from electromagnetic boundary conditions. As a result, we are able to get the full understanding for the rapid illumination drop and to propose ways to correct effects due to an wide angle of view.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.28 no.4
• /
• pp.271-275
• /
• 2015

The floodlighting assists the pilot in taxiing the aircraft into and out of the final parking position and provide lighting suitable for passenger to embark and debark and for personnel to load and unload cargo. It is composed of sodium lamps which is consuming high energy. It needs to develop a dedicated LED lamp to replace the existing lamps. In this paper, We propose a suitable asymmetric angle of LED lamps to avoid a pilot's glare and to meet the standard illumination. For this, we analyze asymmetric angle of sodium lamps which are using in airport and confirm whether the illumination distribution and glare index meet the relating standards by using simulation method. Also, we study the needs of asymmetric characteristics of LED ramp by simulating the LED lamps with and without asymmetric characteristics of ramp respectively. With the simulation result, finally we propose the best asymmetric angle of LED lamp to meet the average illumination standard, and avoid a pilot's glare.

• Journal of the Korea Furniture Society
• /
• v.26 no.4
• /
• pp.328-333
• /
• 2015

The museum is a important place to inform the value of various antiquities and relics. The museum, founded in domestic, were increased 90% in 2013 compared to 2006, and total number of including private museums were increased more than three times over the past decade. There are installing a variety of illumination and air-conditioning system, such as the spot lighting of exhibition explanation. But the exhibition explanation should not happen to visual perception disabilities by lighting. According to ICOM (International Council of Museum), it is stipulating that the museum should not to occur glare. However, we confirmed some occurred the glare and it was lack of previous studies about prevention plan. In this study, we verified occurrence of the glare by illumination angles and visitor's eye-level. The luminance values were determined by using DSLR camera and illuminometer. As a result, when illumination angle is 90 degree, the glare did not occurred by the luminance value ratio of over 0.167 regardless of eye-level. By contrast, the angle 30 degree was appeared glare with all level. And this study was compared luminance values that obtained through experiment and surveying.