• The Journal of the Korea institute of electronic communication sciences
• /
• v.5 no.3
• /
• pp.288-293
• /
• 2010

In these information-communication society, the wireless system technologies are increasing to do all things with wireless solution for fast and convenient works. This trend drives ubiquitous solutions which are based on broadband wireless network that gives network connection whenever, everywhere. This paper deals a bookshelf management system using plower line communication and RFID module. This system includes a 900 MHz RFID reader, Passive RFID-Tags, an Atmeg128 microprocessor board attached LED Display Module, and a management PC with GUI Software. This system works well in power line communication, tag reading and LED display, and PC Management Software.

• Journal of Surface Science and Engineering
• /
• v.42 no.4
• /
• pp.173-178
• /
• 2009

DLC film was synthesized on plastic injection mold(SKD11, $30\;mm\;{\times}\;19\;mm\;{\times}\;0.5\;mm$) and Si(100) wafer for 2 h at $130^{\circ}C$ under 6 mTorr using hybrid method of rf sputtering and ion source. The obtained film was analysed by Raman spectroscopy, AFM, TEM, Nano indenter and scratch tester, etc. The film was defined as an amorphous phase. In the Raman spectrum, broad peak of $sp^2$-bonded carbon attributed to graphite at $1550\;cm^{-1}$ were observed, and the ratio of ID($sp^3$ diamond intensity)/IG($sp^2$ graphite intensity) was approximately 0.54. The adhesion of DLC film was more than 80 N with scratch tester when $0.2\;{\mu}m$ thickness Cr was coated as interlayer. The micro-hardness was distributed at 35~37 GPa. The friction coefficient was 0.02~0.07, and surface roughness(Ra) was 0.34~1.64 nm. The lifetime of DLC coated plastic injection mold using as a connector part in computer was more than 2 times of non-coated mold.

• Journal of Microbiology and Biotechnology
• /
• v.22 no.12
• /
• pp.1776-1781
• /
• 2012

Multiple viruses such as Lily symptomless virus (LSV), Lily mottle virus (LMoV), and cucumber mosaic virus (CMV) are the most prevalent viruses infecting lilies in Korea. Leaf samples and bulbs showing characteristic symptoms of virus infection were collected from Gangwon, Chungnam, and Jeju provinces of Korea in 2008-2011. Coat protein (CP) genes of LSV and LMoV were amplified from collected samples by reverse transcription-polymerase chain reaction (RT-PCR) and cloned into a pET21d(+) expression vector to generate recombinant CPs. The resulting carboxy-terminal His-tagged CPs were expressed in Escherichia coli strain BL21(DE3) by isopropyl-1-thio-${\beta}$-D-galactoside induction. The recombinant proteins were purified using Ni-NTA agarose beads, and the purified proteins were used as an immunogen to produce polyclonal antibodies in rabbits. The resulting polyclonal antisera recognized specifically LSV and LMoV from infected plant tissues in Western blotting assays. Indirect enzymelinked immunosorbent assay and immunocapture RT-PCR using these polyclonal antisera were developed for the sensitive, efficient, economic, and rapid detection of Lily viruses. These results suggest that large-scale bulb tests and economic detection of Lily viruses in epidemiological studies can be performed routinely using these polyclonal antisera.

• Korean Institute of Interior Design Journal
• /
• no.37
• /
• pp.3-11
• /
• 2003

The study Is Intended to investigate and analyze the system and practice that have been applied to Interior Architecture, comparing with a number of similar foreign cases, in an attempt to seek the way toward its development as well as to come up with the solution for enhancing the competitiveness, thereby making a recommendation on how to create the desirable work environment of Interior Architecture down the road. The conclusion and recommendation we have made is highlighted as follow. Among the practical or procedural challenges in the process of improving work environment of Interior Architecture, development of current national technical qualification system in a way of further detailing the categories of Ki-sul-sa(highest engineer grade) or Ki-neung-jang(highest technician grade) as part of measures aimed at gradual approaching for improvement of design fees and rates or supervision fees will be very crucial, that calls for close coordination with the Ministry of Labor and Human Resources Development Service of Korea. In a bid to upgrade the Interior Architecture to become the part of knowledge-based industry, amendment to Korean Standard Industrial Classification along with Standard Classification of Occupations and Academic Classification will be essential, and moreover with the attitude of reflection and self-improvement, the endeavors to be able to deal with the revision of existing laws and regulations in a consistent way and manner, by forming a joint committee among the three Interior Architecture-related organizations(KOSID, ICC, KlID), will be more than important.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2006.05a
• /
• pp.986-989
• /
• 2006

앞으로의 네트워크는 Convergence와 Integrate라는 키워드를 기반으로 IP 중심의 통합된 망으로 발전되고 있다. IP 중심의 망은 각각의 다양한 access 기술을 포함하며, voice, multimedia, 그리고 새롭게 정의되는 서비스가 모두 제공될 수 있어야 한다. 따라서 점차 인터넷을 중심으로 하는 하나의 통합된 망의 형태로 진화 될 것이다 이러한 차세대 네트워크상의 단말은 소형화, 지능화, 그리고 이동성을 지니고 있으며, 다양한 access 기술을 사용하기 위한 multiple 인터페이스를 가진 멀티호밍 환경에 놓여있다. 따라서 이 네트워크는 기본적으로 이동성과 멀티호밍을 지원해야 하는 것이다. 그러나 현재 인터넷의 핵심인 Internet Protocol 구조는 이를 지원하지 못한다. 현재 IP 주소는 최종 단말의 식별자 (Identifier)와 단말의 위치 식별자 (locator)의 의미를 함께 사용하고 있어, 통신 중인 단말이 이동하면 IP 주소도 변경되어 통신 중인 세션이 끊기는 문제가 발생한다. 멀티호밍 환경에서도 역시 통신 중인 노드들의 경로를 바꾸게 되면 세션이 끊기게 되는 문제가 발생한다. 본 논문은 이와 같은 린 구조의 근본적인 문제를 해결하기 위해 Identifier와 locator를 분리하며, 단순하게 단말에 스택으로 존재하는 L3SHIM을 소개하고, 모든 단말에 이 기능이 지원되었을 때 기존의 인터넷 프로토콜의 확장과 인터넷의 구조에 어떤 영향을 줄 수 있는지에 대해 선행 연구를 하였다.

• Journal of Advanced Marine Engineering and Technology
• /
• v.28 no.1
• /
• pp.29-38
• /
• 2004

The Condensation heat transfer coefficients of R-22 and R-l34a were measured in smooth horizontal copper tubes with inner diameters of 1.77. 3.36 and 5.35 mm. respectively. The experiments were conducted in a closed loop. which was driven by a magnetic gear pump. They were Performed for the following ranges of variables: mass flux (200 to $500\;kg/\textrm{m}^2{\cdot}s$) saturation temperature $30^{\circ}C$ and quality (0 to 1.0). The main results obtained are as follows Condensation heat transfer coefficients in the small diameter tubes (ID < 7 mm) were observed to be strongly affected by inner diameter change and to differ from those in the large diameter tubes. The heat transfer coefficients in the small diameter tubes were 20 ~ 40 % higher than those in the large diameter tubes as the inner diameter of the tube was reduced. Also. it was very difficult to apply some well-known previous predictions (Cavallini-Zecchin's. Haraguchi's and Dobson's correlation) to small diameter tubes. Based on an analogy between heat and mass transfer the new correlation is Proposed to predict the experimental data more accurately.

• Journal of Advanced Marine Engineering and Technology
• /
• v.20 no.3
• /
• pp.91-100
• /
• 1996

Experimental results for forced convection condensation of non-azeotropic refrigerant mixtures inside a horizontal smooth tube are presented. The mixtures of R-22+R-134a and pure refrigerants R-22 and R-134a are used as the test fluids and a double pipe heat exchanger of 7.5mm ID and 4800mm long inside tube is used. The range of parameters are 100-300kg/h of mass flow rate, 0-1.0 of quality, and 0, 33, 50, 67, and 100 weight percent of R-22 mass fraction in the mixtures. The heat flux, vapor pressure, vapor temperature and tube wall temperature were measured. Using the data, the local and average heat transfer coefficients for the condensation have been obtained. In the same given experimental conditions, the liquid heat transfer coefficients for NARMs were considerally lower than that of the pure refrigerant of R-22 and R-134a. Local heat transfer characteristics for NARMs were different from pure refrigerant R-22 and R-134a. In some regions, local heat transfer coefficients for NARMs were increased in the following order ; Bottom$\rightarrow$Top$\rightarrow$Side. The condensation heat transfer coefficients for NARMs increased with mass velocity, heat flux, and quality, but were considerably lower than that of pure refigerant R-22 and R-134a.

• Journal of the Korean Society for Precision Engineering
• /
• v.20 no.3
• /
• pp.221-229
• /
• 2003

In the early phases of the product life cycle, Life Cycle Assessment (LCA) is recently used to support the decision-making fer the conceptual product design and the best alternative can be selected based on its estimated LCA and its benefits. Both the lack of detailed information and time for a full LCA fur a various range of design concepts need the new approach fer the environmental analysis. This paper suggests a novel approximate LCA methodology for the conceptual design stage by grouping products according to their environmental characteristics and by mapping product attributes into impact driver index. The relationship is statistically verified by exploring the correlation between total impact indicator and energy impact category. Then a neural network approach is developed to predict an approximate LCA of grouping products in conceptual design. Trained learning algorithms for the known characteristics of existing products will quickly give the result of LCA for new design products. The training is generalized by using product attributes for an ID in a group as well as another product attributes for another IDs in other groups. The neural network model with back propagation algorithm is used and the results are compared with those of multiple regression analysis. The proposed approach does not replace the full LCA but it would give some useful guidelines fer the design of environmentally conscious products in conceptual design phase.

• Bulletin of the Korean Chemical Society
• /
• v.9 no.1
• /
• pp.1-4
• /
• 1988

Rates of solvolysis of trans-[Co$(N-eten)_2Cl_2$]$^+$ have been investigated using spectrophotometric method at various pressures and temperatures in the mixtures of water with the t-butyl alcohol which possesses a high structure inducing capacity in water. The values of ${\Delta}V^{\neq}$ obtained from pressure effect on the rate constants were 2.55∼ 5.83 $cm^3mol^{-1}$. These values were discussed in terms of dissociative mechanism. Extrema found in the variation of ${\Delta}H^{\neq}$ and ${\Delta}S^{\neq}$ with solvent composition correlated with extrema in the variation of the physical properties of the mixtures. The logarithms of rate constants correlated linearly with both Grunwald-Winstein parameter and the reciprocal of dielectric constant ($Ds^{-1}$). The gradient, m of Grunwald-Winstein plot for the trans-[Co$(N-eten)_2Cl_2$]$^+$ was 0.09, which is significantly lower than those for the other cobalt (Ⅲ)-dichloro complexes. It was suggested that the reaction is an Id mechanism with long extension of Co-Cl bond in the transition state, as found for the C-Cl bond in the transition state for the solvolysis of t-butyl chloride.

• Korean Journal of Remote Sensing
• /
• v.19 no.5
• /
• pp.351-361
• /
• 2003

As the launches of a series of remote sensing satellites, there are various multiresolution and multi-spectral images available nowadays. This diversity in remotely sensed image data has created a need to be able to integrate data from different sources. The C-band imaging radar of ERS-2 due to its high sensitivity to coastal wetlands holds tremendous potential in mapping and monitoring coastal wetland features. This paper investigates the advantages of using ERS-2 SAR data combined with IRS-ID LISS-3 data for mapping complex coastal wetland features of Tamil Nadu, southern India. We present a methodology in this paper that highlights the mapping potential of different combinations of filtering and integration techniques. The methodology adopted here consists of three major steps as following: (i) speckle noise reduction by comparative performance of different filtering algorithms, (ii) geometric rectification and coregistration, and (iii) application of different integration techniques. The results obtained from the analysis of optical and microwave image data have proved their potential use in improving interpretability of different coastal wetland features of southern India. Based visual and statistical analyzes, this study suggests that brovey transform will perform well in terms of preserving spatial and spectral content of the original image data. It was also realized that speckle filtering is very important before fusing optical and microwave data for mapping coastal mangrove wetland ecosystem.