• Journal of Nuclear Fuel Cycle and Waste Technology(JNFCWT)
• /
• v.10 no.1
• /
• pp.37-43
• /
• 2012

Radioactive waste transport package was developed to transport eight drums of low and intermediate level waste(LILW) in accordance with the IAEA and domestic related regulations. The package is classified with industrial package IP-2. IP-2 package is required to undergo a free drop test and a stacking test. After free drop and stacking tests, it should prevent the loss or dispersal of radioactive contents, and loss of shielding integrity which would result in more than 20 % increase in the radiation level at any external surface of the package. The objective of this study is to establish the safety test method and procedure for stacking test and to prove the structural integrities of the IP-2 package. Stacking test and analysis were performed with a compressive load equal to five times the weight of the package for a period of 24 hours using a full scale model. Strains and displacements were measured at the corner fitting of the package during the stacking test. The measured strains and displacements were compared with the analysis results, and there were good agreements. It is very difficult to measure the deflection at the container base, so the maximum deflection of the container base was calculated by the analysis method. The maximum displacement at the corner fitting and deflection at the container base were less than their allowable values. Dimensions of the test model, thickness of shielding material and bolt torque were measured before and after the stacking test. Throughout the stacking test, it was found that there were no loss or dispersal of radioactive contents and no loss of shielding integrity. Thus, the package was shown to comply with the requirements to maintain structural integrity under the stacking condition.

• Proceedings of the Korean Radioactive Waste Society Conference
• /
• 2005.11a
• /
• pp.339-347
• /
• 2005

A type IP-2 transport package should prevent a loss or dispersal of the radioactive contents and a more than $20\%$ increase in the maximum radiation level at any external surface of the package when it were subjected to the drop test under the normal conditions of transport. If a shielding thickness of IP-2 transport package is thick, a bolted lid type may prevent a loss or dispersal of the radioactive contents than the door type of ISO containers which are generally used as a type IP-2 transport package. In this paper, to evaluate the effect of drop directions on the bolt tension and the coherence of a bolt, the drop tests of preliminary small model are tested and evaluated for seven directions before the drop test of a type IP-2 transport package with a bolted lid type under the normal conditions of transport. Seven drop directions which are a bottom-vertical drop, a lid-vortical drop. a horizontal drop and four corner drops have been carried out. Using a force sensor, the bolt tension during the drop impact is measured. The coherence of bolt is evaluated by the difference between the fastening torque of bolt before a drop test and the unfastening torque of bolt after a drop impact.

• Journal of Nuclear Fuel Cycle and Waste Technology(JNFCWT)
• /
• v.5 no.3
• /
• pp.199-212
• /
• 2007

If a type IP-2 transport package were to be subjected to a free drop test and a penetration test under the normal conditions of transport, it should prevent a loss or dispersal of the radioactive contents and a more than 20% increase in the maximum radiation level at any external surface of the package. In this paper, we suggested the analytic method to evaluate the structural safety of a type IP-2 transport package using a thick steel plate for a structure part and a bolt for tying a bolt. Using an analysis a loss or dispersal of the radioactive contents and a loss of shielding integrity were confirmed for two kinds of type IP-2 transport packages to transport radioactive waste drums from a waste facility to a temporary storage site in a nuclear power plant. Under the free drop condition the maximum average stress at the bolts and the maximum opening displacement of a lid were compared with the tensile stress of a bolt and the steps in a lid, which were made to avoid a streaming radiation in the shielding path, to evaluate a loss or dispersal of radioactive waste contents. Also a loss of shielding integrity was evaluated using the maximum decrease in a shielding thickness. To verify the impact dynamic analysis for free drop test condition and evaluate experimentally the safety of two kinds of type IP-2 transport packages, free drop tests were conducted with various drop directions. For the tests we examined the failure of bolts and the deformation of flange to evaluate a loss or dispersal of radioactive material and measured the shielding thickness using a ultrasonic thickness gauge to assess a loss of shielding integrity. The strains and accelerations acquired from tests were compared with those by analyses to verify the impact dynamic analysis. The analytic results were larger than the those of test so that the analysis showed the conservative results. Finally, we evaluated the safety of the type IP-2 transport package under the stacking test condition using a finite element analysis. Under the stacking test condition, the maximum Tresca stress of the shielding material was 1/3 of the yielding stress. Two kinds of a type IP-2 transport package were safe for the free drop test condition and the stacking test condition.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2009.10a
• /
• pp.777-779
• /
• 2009

Study for VoIP in MANET is mainly focused on transmission performance or voice quality of VoIP traffic as single traffic. In this study, VoIP performance is analyzed of MANET which has several types of traffics. Diffserv scheme is used to process the traffics. It is showed that VoIP traffic performance is improved by differv scheme, as a result of analysis for VoIP and FTP traffic. Simulator, which is implemented with NS-2 package and VoIP patch, is used.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.50 no.9
• /
• pp.60-67
• /
• 2013

Test cost reduction is necessary to test a complex System-on-a-Chip(SoC) which adopts various Intellectual Properties (IP). In this paper, test architecture with low pin count which is able to IP-based SoC test, using IEEE Std. 1149.7 and IEEE Std. 1500, is proposed. IEEE Std. 1500 provides independent access mechanism for each IP in IP-based SoC test. In this paper, just two test pins are required by composing that these independent access mechanism can be controlled by IEEE Std. 1149.7. The number of Chips which are tested at the same time is increased by reducing required test pin count at wafer and package level test, and consequently the overall manufacturing test cost will be reduced significantly.

• Proceedings of the Korean Radioactive Waste Society Conference
• /
• 2005.06a
• /
• pp.523-530
• /
• 2005

In this study, maximum exposure rate at DAW(Dry Active Waste) drum surface which is satisfying regulation limit was calculated for conceptual design of IP(Industrial Package). DAW can be classified as combustible and non-combustible waste and the calculation was conducted for single and mixed radionuclide for each type of waste. In case of combustible waste that mixed radionuclide is uniformly distributed, the maximum exposure rates at drum surface were 3.60E-01, 8.85E-01 and 1.27E+01 mSv/hr for IP Type 1, 2-a and 2-b, respectively. and 3.60E-01, 8.85E-01, 1.27E+01 mSv/hr for single radionuclide(Co-60). In case of non-combustible waste that mixed radionuclide is uniformly distributed, the maximum exposure rates at drum surface were 7.14E-01, 1.83E+00, 2.69E+01 mSv/hr for IP Type 1, 2-a and 2-b, respectively. and 7.13E-01, 1.81E-01, 2.62E+01 mSv/hr for single radionuclide(Co-60). Through this study, the maximum amount of DAW can be transported by IP was suggested as maximum exposure rate at drum surface and the calculation for the other types of waste will be conducted.

• The KIPS Transactions:PartC
• /
• v.12C no.2 s.98
• /
• pp.251-260
• /
• 2005

On the internet phone or PSTN(Public Switched Telephone Network), the automatic callback is an useful service in the case of busy state when one user calls the other. By using this service, automatic redial is possible when the other party hangs up. However, in the basic automatic callback service, the user who wants callback should wait until the other party hangs up even in the case of emergency. Therefore in this paper, to solve this problem we have extended CPL(Call Processing Language) and, within user system we have included and linked this extended CPL processing module and dialog event package which processes SIP INVITE initiated dialog state informations. We have implemented this system for being used in SIP(Session Initiation Protocol)-based VoIP(Voice over IP) system.

• Nuclear Engineering and Technology
• /
• v.40 no.6
• /
• pp.511-516
• /
• 2008

Korea Hydro & Nuclear Power Co., Ltd. (KHNP) developed new IP-2 packages to transport low- and intermediate-level radioactive waste (LILW) steel drums from nuclear power plants to a disposal facility in accordance with IAEA and Korean transport regulations of radioactive material. Radiation shielding evaluation of the packages was carried out to demonstrate compliance with the regulatory requirements for IP-2 packages of radioactive material. Dose rate limits of LILW drums contained in the packages were determined.

• International Journal of Internet, Broadcasting and Communication
• /
• v.11 no.2
• /
• pp.67-75
• /
• 2019

"No IP, No Content" has become a phenomenon in the content industry, high-quality IP has a strategic importance. It has become a Trinity in the movie-anime-game basic package, Competition is more intense. However, there is a tremendous amount of know-how hidden behind the use of IP to operate games well. We are worth exploring in detail. The research and analysis of digital IP market, the advantages and disadvantages will be the focus of our pragmatic research. As an emerging market in the digital industry, China has great research value. This paper analyzes the status quo of the current Chinese market by comparing the mature US and Japanese markets. For example, the research of American Disney Company analyzes the mature market structure of Japan. compared with the excellent case of the Chinese market legend of qin. By studying the current situation of China's digital market, analyzing the interest trends of the customer base, discovering existing problems and improving the accuracy of the prediction and judgment of the Chinese digital market in the future.According to the survey, the IP heat is mainly concentrated in six categories of games, animation, TV, variety, movies, and novels. At present, the most popular IP of manufacturers have three major categories. This article will conduct research and analysis on digital IP, and analyze the market status of China, the United States, and Japan and the research on outstanding representative works in the market.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.12 no.12
• /
• pp.2301-2306
• /
• 2008

SIP(Session Initiation Protocol) has become an universal standard for multimedia communications for both wired and wireless networks since it has been adopted as a standard protocol for IMS platform in 3GPP standardization organization at November 2000. In this paper, we design and implement a SIP-based softphone client program which provides telephony service between internet users and a call center equipped with VoIP gateway. A softphone client based on PC-to-phone connection should guarantee to provide interoperability with various VoIP gateways and higher portability to be able to operate on different PC environments. The softphone client program in this paper has been developed with SIP 2.0 standard protocol to support interoperability and with JAIN SIP and JMF package to achieve higher portability.