• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.48 no.7
• /
• pp.23-29
• /
• 2011

A dB-linearity improved variable gain amplifier (VGA) for GPS receiver is presented. The Proposed dB-linear current generator has improved dB-linearity error of ${\pm}0.15$dB. The VGA for GPS is designed using proposed dB-linear current generator and composed of 3 stage amplifiers. The IF frequency is assumed as 4MHz and the linearity requirement of the VGA for GPS receiver is defined as 24dBm of IIP3 using cascaded IIP3 equation and the VGA satisfies 24dBm when minimum gain mode. The DC-offset voltage is eliminated using DC-offset cancelation loop. The gain range is from -8dB to 52dB and the dB-linearity error satisfies ${\pm}0.2$dB. The 3-dB frequency has range of 35MHz~106MHz for the gain range. The VGA is designed using 0.18${\mu}m$ CMOS process. The power consumption is 3mW with 1.8V supply voltage.

• Tuberculosis and Respiratory Diseases
• /
• v.82 no.4
• /
• pp.269-276
• /
• 2019

Idiopathic interstitial pneumonia (IIP) is a histologically identifiable pulmonary disease without a known cause that usually infiltrates the lung interstitium. IIP is largely classified into idiopathic pulmonary fibrosis, idiopathic non-specific interstitial pneumonia, respiratory bronchiolitis-interstitial lung disease (ILD), cryptogenic organizing pneumonia, desquamative interstitial pneumonia, and acute interstitial pneumonia. Each of these diseases has a different prognosis and requires specific treatment, and a multidisciplinary approach that combines chest high-resolution computed tomography (HRCT), histological findings, and clinical findings is necessary for their diagnosis. Diagnosis of IIP is made based on clinical presentation, chest HRCT findings, results of pulmonary function tests, and histological findings. For histological diagnosis, video-assisted thoracoscopic biopsy and transbronchial lung biopsy are used. In order to identify ILD associated with connective tissue disease, autoimmune antibody tests may also be necessary. Many biomarkers associated with disease prognosis have been recently discovered, and future research on their clinical significance is necessary. The diagnosis of ILD is difficult because patterns of ILD are both complicated and variable. Therefore, as with other diseases, accurate history taking and meticulous physical examination are crucial.

• Tuberculosis and Respiratory Diseases
• /
• v.58 no.6
• /
• pp.570-575
• /
• 2005

Introduction : Diffuse interstitial lung diseases (DILD) comprise of a large group of lung diseases with diverse etiologies. They are classified into four categories based on the etiology and pathological findings. In Korea, epidemiological data on DILD has never been reported in a prospective manner. Method : From May 2002 to April 2004, total 487 patients with DILD were prospectively registered at Samsung Medical Center. The prospective observational analysis of the etiologies, its classification based on 2002 ATS/ERS (American Thoracic Society/European Respiratory Society) guidelines, as well as diagnostic tests and the retrospective analysis of the treatment modalities were carried out. Any infectious and malignant causes were excluded. Results : 1) The patients were classified into idiopathic interstitial pneumonia (IIP) in 269 patients (55.2%), known causes of DILD in 168 patients (34.5%), sarcoidosis in 27 patients (5.5%), other forms of DILD in 14 patients (2.9%), and undetermined DILD in 9 patients (1.9%). 2) The diagnostic test showed that most patients had undergone chest high resolution computed tomography (HRCT) and pulmonary function test (PFT) (97%, 89%). Transbronchial lung biopsy (TBLB) and surgical lung biopsy (SLB) were performed in limited patients (38%, 29%). 3) Among 269 patients with IIP, 220 (82%) had idiopathic pulmonary fibrosis (IPF) while 23 (9%) had nonspecific interstitial pneumonia. SLB was carried out in 36% of patients with IIP. 4) Symptomatic supportive care was given to 67% of IPF, but specific medical treatment including corticosteroids was administered to 89% of non-IPF patients. Conclusion : A nationwide registry of DILD patients is required to determine the annual incidence, etiology, and practice pattern of diagnosis and treatment in Korea.

• Asian-Australasian Journal of Animal Sciences
• /
• v.15 no.2
• /
• pp.222-237
• /
• 2002

Effects of high and low levels of feeding with or without protected protein on the performance of lactating goats were studied. Twenty four German Fawn goats either from 1st ($43.37{\pm}3.937$ kg and 2 year old) or 3rd $62.64{\pm}6.783$ kg and 4-5 year old) parity were used for the trial. Feeding levels were 7.2 (I) and 5.2 (II) MJ ME/litre of milk of 3.5% fat in addition to that of the maintenance allowance. At each feeding level, diet had either unprotected (U) or formaldehyde protected (P) soya-meal. Thus, four diets were IU, IP, IIU and IIP, having six animals in each. The diets were composed of hay and pellet (10:4:1 of beet pulp : barley : soya-meal). Effect of feeding level, protein protection, parity, health status and kid number on intake, milk yield, milk composition, growth rate of goats were recorded across the 21 weeks of study. High feeding level resulted increase (p<0.001) in estimated metabolizable energy (ME) and metabolizable protein (MP) availability. Dietary inclusion of protected soya-meal increased (p<0.001) the estimated MP but not the ME availability. Animals in 1st parity ate more (p<0.001) DM (111 vs. 102 g/kg $W^{0.75}$/d) than those in 3rd parity. Animals with twin kids (110 g/kg $W^{0.75}$/d) had higher (p<0.001) DM intake than those with single kid (102 g/kg $W^{0.75}$/d). Fat (4%) corrected milk (FCM) yield was not effected by high (1,924 g/d) or low (1,927 g/d) feeding level but increased (p<0.001) with protected (2,166 g/d) compared with unprotected (1,703 g/d) soya-meal. FCM yield for four dietary combinations were 1,806, 2,078, 1,600 and 2,254 g/d for diets IU, IP, IIU and IIP, respectively. For unit increase (g) in estimated MP availability relative to ME (MJ) intake, FCM yield increased ($1,418{\pm}275.6$) g daily ($r^2$=0.58; p<0.001). Milk fat (3.14 vs. 3.54%; p<0.001) and protein (2.94 vs. 3.04% p<0.05) contents were lower at high than the low feeding level. Protected protein increased (p<0.001) the fat, lactose and net energy (NE) content of milk. Milk urea concentration of 175, 183, 192 and 204 mg/l for diets IU, IP, IIU and IIP, respectively indicated lower RDP content of these diets. The RDP contents were 6.97, 6.70, 7.30 and 6.83 g/MJ of ME for diets IU, IP, IIU and IIP, respectively. Live weight change over the experimental period were 41, 6, 17 and 19 g/d. Absence of any positive response of high feeding was probably due to inefficient rumen fermentation resulting from inadequate RDP supply. Protected protein improved production performance apparently by increasing MP:ME ratio in the absorbed nutrient.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.4 no.4
• /
• pp.293-299
• /
• 2004

An active RC 2nd order Butterworth filter suitable for a baseband channel-selection filter of a direct conversion receiver is presented. The linearity of the 2nd order Butterworth filter is analyzed. In order to improve the linearity of the filter, the operational amplifiers should have a high linear gain and low 3rd harmonic, and the filter should be designed to have large feedback factor. This second order Butterworth filter achieves-14dBV in-channel (400kHz, 500kHz) IIP3, +29dBV out-channel (10MHz, 20.2MHz) IIP3 and 15.6 $nV/\sqrt{Hz}$ input-referred noise and dissipates 10.8mW from a 2.7-V supply. The analysis and experimental results are in good agreement

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.18 no.4 s.119
• /
• pp.408-415
• /
• 2007

A switched-gain controlled LNA is designed and implemented in 0.18 um CMOS technology for $3.1{\sim}4.8\;GHz$ UWB system. In high gain mode, measurement shows a power gain of 12.5 dB, an input IP3 of 0 dBm, while consuming only 8.13 mA of current. In low gain mode, measurement shows a power gain of -8.7 dB, an input IP3 of 9.1 dBm, while consuming only 0 mA of current.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.2 no.2
• /
• pp.147-155
• /
• 2002

This paper describes RF front-end transceiver chipset for the dual-mode operation of PCS-Korea and IMT-2000. The transceiver chipset has been implemented in a $0.25\mutextrm{m}$ single-poly five-metal CMOS technology. The receiver IC consists of a LNA and a down-mixer, and the transmitter IC integrates an up-mixer. Measurements show that the transceiver chipset covers the wide RF range from 1.8GHz for PCS-Korea to 2.1GHz for IMT-2000. The LNA has 2.8~3.1dB NF, 14~13dB gain and 5~4dBm IIP3. The down mixer has 15.5~16.0dB NF, 15~13dB power conversion gain and 2~0dBm IIP3. The up mixer has 0~2dB power conversion gain and 6~3dBm OIP3. With a single 3.0V power supply, the LNA, down-mixer, and up-mixer consume 6mA, 30mA, and 25mA, respectively.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.16 no.5
• /
• pp.675-681
• /
• 2016

A 41dB gain control range $6^{th}$-order band-pass receiver front-end (RFE) using CMOS switched frequency translated impedance (FTI) is presented in a 40 nm CMOS technology. The RFE consists of a frequency tunable RF band-pass filter (BPF), IQ gm cells, and IQ TIAs. The RF BPF has wide gain control range preserving constant filter Q and pass band flatness due to proposed pre-distortion scheme. Also, the RF filter using CMOS switches in FTI blocks shows low clock leakage to signal nodes, and results in low common mode noise and stable operation. The baseband IQ signals are generated by combining baseband Gm cells which receives 8-phase signal outputs down-converted at last stage of FTIs in the RF BPF. The measured results of the RFE show 36.4 dB gain and 6.3 dB NF at maximum gain mode. The pass-band IIP3 and out-band IIP3@20 MHz offset are -10 dBm and +12.6 dBm at maximum gain mode, and +14 dBm and +20.5 dBm at minimum gain mode, respectively. With a 1.2 V power supply, the current consumption of the overall RFE is 40 mA at 500 MHz carrier frequency.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.29 no.9A
• /
• pp.1005-1012
• /
• 2004

In this paper, we have analyzed minimum performance required for W-CDMA Handset from standard and Implemented the receiver for W -COMA Handset. We have derived the noise figure and IIP3 of receiver and determined the selectivity about adjacent channel and minimum performance for front-end stage. Before the Implementation, we have verified the performance using AOS simulator In conclusion, we have implemented the receiver for W-COMA Handset using the heterodyne architecture and performed measurement. Therefore, this paper wlll gIVe a guideline for design of the W -COMA Handset.

• Journal of the Microelectronics and Packaging Society
• /
• v.7 no.3
• /
• pp.19-25
• /
• 2000

In this paper, we describe RF receiver module for IMT-2000 handset with 5 MHz channel bandwidth. The fabricated RF receiver module consists of Low Noise Amplifier, RF SAW filter, Down-converter, If SAW filter, AGC and PLL Synthesizer. The NF and IIP3 of LNA is 0.8 dB, 3 dBm at 2.14 GHz, conversion gain of down-converter is 10 dB, dynamic range of AGC is 80 dB, and phase noise of PLL is -100 dBc at 100 kHz. The receiver sensitivity is -110 dBm, adjacent channel selectivity is 48 dBm.