• Proceedings of the IEEK Conference
• /
• 2003.11c
• /
• pp.191-194
• /
• 2003

In IEEE 802.11b, Medium Access Control Sublayer consists of DCF (Distributed Coordination Function) and PCF (Point Coordination Function). DCF provides contention based services and PCF provides contention free services for QoS satisfaction. DCF uses CSMA/CA (Carrier Sense Multiple Access/Collision Avoidance) as an access protocol. And PCF uses Polling Scheme. In this paper, a modified New-PCF, which gives weights to channels with heavier traffic load, was suggested. NS-2 simulations were conducted to compare the service performances with original DCF, PCF and the modified New-PCF respectively. Simulation results has shown the increased overall throughput with the proposed New-PCF compared with other cases.

• Proceedings of the Korean Society of Computer Information Conference
• /
• 2023.01a
• /
• pp.423-424
• /
• 2023

4차 산업 시대로 진화하면서 스마트 홈 솔루션 개발이 활발히 진행 중이며 스마트 벽스위치에 대한 적용 사례가 증가하고 있다. 가격 경쟁력을 통해 시장을 선점하고 있는 중국 제품은 대부분 블루투스와 지그비 통신 방식의 스위치를 사용하고 있다. 하지만, 지그비 통신은 저전력인데 반해 블루투스보다 통신속도가 늦고 별도의 허브를 통한 네트워크 구성이 추가적으로 요구되는 단점이 있다. 블루투스 방식은 와이파이 통신에 비해 통신 범위와 속도가 낮고 통신 대기시간이 비교적 길며 보안성이 취약한 것이 문제점이다. 본 연구에서는 와이파이 통신 기술을 적용한 IEEE 802.11b/g/n 스마트 벽스위치를 개발하였다. 연구의 결과물은 기존 벽스위치에 비해 30%이상 저렴하여 기술 경쟁력뿐만 아니라 가격 경쟁력에서도 시장을 선점할 수 있을 것으로 판단한다.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.42 no.3 s.333
• /
• pp.39-44
• /
• 2005

The OFDM modulation and transmission block have been modeled in order to analyse the relationship between the 2.4GHz power amplifier distortion and output ACPR for the IEEE 802.11g wireless LAN. The nonlinear characteristic of the power amplifier has been modeled as AM-to-AM and AM-to-PM using the behavioral model, and the output spectrum is analysed with the phase distortion variation. Also, amplifier back-off value from P1dB to satisfy the required IEEE 802.11g standard spectrum mask s been simulated with modeled phase distortion, and the simulation data have been compared to the measured result by using the pre-distortion technique.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.34 no.2B
• /
• pp.107-118
• /
• 2009

In this paper, we present design and implementation for identification and location tracking techniques for vehicle information terminals in high-speed mobile environment using IEEE 802.11 wireless LAN technology. RSU be installed at a specific point. RSU recognizes it and then aware identification and location tracking for target vehicle when target vehicle that is equipped with information terminals pass near point. Issue of quick recognition using IEEE 802.11 access management frame, issue of weak wireless LAN security and tracking a range of restrictions be raised and we present solutions. Vehicle information terminal, RSU and a server-side GUI-based management program be implemented based on proposed solution. Implementation system be performed experiment at actual road environment and effectiveness be verified.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.34 no.4B
• /
• pp.360-367
• /
• 2009

In this paper, we propose a design methodology of IEEE 802.11n MAC which aims to achieve the higher throughput of more than 100Mbps in downlink as measured at the MAC-SAP and present the implementation results of MAC using the proposed design methodology. With our proposed methodology, different from the conventional design flow which has the separate codes for the protocol validation, for the network simulation, and for the system implementation, the unified code can be used for the network simulation and the implementation of software and hardware. Our MAC architecture is partitioned into two parts, Upper-layer MAC and Lower-layer MAC, in order to achieve the high efficiency for the new features of IEEE 802.11n standard. They are implemented in software and hardware respectively. The implemented MAC is tested on ARM based FPGA board.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.16 no.2 s.93
• /
• pp.154-160
• /
• 2005

Microwave Otters are essential device in modem wireless systems. A compact dimension BPF(Band-pass Filter) for IEEE 802.11a WLAN service is realized using LTCC multi-layer process. To extrude 2-stage band-pass equivalent circuit, band-pass and J-inverter transform applied to Chebyshev low-pass prototype filter. Because parallel L-C resonator is complicate and hard to control the inductor characteristics in high frequency, the shorted $\lambda/4$ stripline is selected for the resonator structure. The passive element is located in the different layers connected by conventional via structure and isolated by inner GND. The dimension of fabricated stacked band-pass filter which is composed of six layers, is $2.51\times2.27\times1.02\;mm^3$. The measured filter characteristics show the insertion loss of -2.25 dB, half-power bandwidth of 220 MHz, attenuation at 5.7 GHz of -32.25 dB and group delay of 0.9 ns at 5.25 GHz.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.30 no.10A
• /
• pp.965-970
• /
• 2005

In this paper, SPDT Tx/Rx MMIC switch applicable to IEEE 802.11a WLAN systems is designed and fabricated using a specific designed epitaxial layered pHEMT wafer and ETRI's $0.5{\mu}m$ pHEMT switch process. The SPDT switch exhibits a low insertion loss of 0.68dB, high isolation of 35.64dB, return loss of 13.4dB, power transfer capability of 25dBm, and 3rd order intercept point of 42dBm at frequency of 5.8GHz and control voltage of 0/-3V. The comparison of the measured performances with commercial products based on the GaAs pHEMT technology for low voltage operating at ${\pm}$ 3V/0V shows that the return loss is somewhat inferior to the commercial products and insertion loss is compatible with each other however, isolation characteristics are much better than in conventional chips. Based on these performances, we can conclude that the developed SPDT switch MMIC has an enough potential for IEEE802.11a standard 5 GHz-band wireless LAN applications.

• 한국정보통신설비학회:학술대회논문집
• /
• 2007.08a
• /
• pp.73-76
• /
• 2007

국내의 홈네트워크 서비스는 홈오토메이션 제공 중심에서 엔터테인먼트 요소가 강화된 멀티미디어 기반의 네트워크 서비스로 변모하고 있다. 홈네트워크를 구성하는 요소 중 PC와 TV는 댁내에 멀티미디어 기반의 네트워크 서비스를 구축하는데 있어 가장 중요한 역할을 수행할 것으로 예상된다. 그에 따라 PC와 TV 간 네트워크를 구축하는 것이 중요한 이슈로 떠오르고 있다. 그러나 PC와 TV 간 네트워크 구축을 위해서는 댁내 노출 배선 등의 문제로 인하여 무선 기술을 사용하는 것이 유용하지만, 현재 기존 무선 전송 기술(IEEE 802.11 a/b/g, Bluetooth 등)들은 HD 등의 대용량 컨텐츠 전송 및 QoS 를 제공하기가 어렵다. 따라서 본 논문에서는 PC와 TV 간 무선으로 네트워크 구축시 고려사항 및 무선전송기술개발 요소를 살펴본다. 특히 무선전송기술로는 고속 데이터 전송이 가능한 UWB(Ultra Widebnad)와 IEEE 802.11n 기술을 중심으로 고려한다. 또한 UWB와 IEEE 802.11n을 이용하여 네트워크가 구축되었을 때 제공 가능한 서비스 시나리오에 대해서도 소개한다.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2007.10a
• /
• pp.849-852
• /
• 2007

In this paper, the high gain and the broadband microstrip patch antenna, which is applicable to 5 GHz band wireless LAN, is designed in order to integrate IEEE 802.11a's detailed standards($a:5.15{\sim}5.25$, $b:5.25{\sim}5.35$, $c:5.725{\sim}5.875$ [GHz]). Designed patch antenna has settled resonance frequency by insert substance(polyurethane: ${\varepsilon}_r=6.5$) between the separated parasitic patch and radiation patch for the purpose of miniaturize. And the form (${\varepsilon}_r=1.03$) were to fix the separated radiation patch and ground plans by air. Designed frequency bandwidth(VSWR 2:1) of the antenna showed broadband characteristic of $4.9[GHz]{\sim}6.1[GHz]$ to about 1.2[GHz]. Also the E-plan and H-plan profit 12[dBi] above, the 3[dB] beamwidth showed the characteristic over the E-plan $30^{\circ}$ and H-plan $60^{\circ}$ to be improved.

• Journal of The Institute of Information and Telecommunication Facilities Engineering
• /
• v.2 no.4
• /
• pp.17-27
• /
• 2003

This paper presents the channel estimation method with STBC applied to IEEE802.11a. Tenacious channel estimation method for OFDM system, that generally uses STTC, has been presented once and massive amount of calculation was needed However, regarding this paper, the amount of calculation can be reduced by using Curve Fitting, and channel tracking performance improvement can be achieved Based on the estimation method, computer simulation was done for the performance analysis and delay spread Doppler frequency and many other group sizes and numbers were considered As a result of the testing, we found out that Doppler frequency deviation effects equally as frequency offset. Also compared to the existing technique, channel estimated performance confirmed that have 0.9dB SNR improvement than old method.