• Journal of the Korean Institute of Telematics and Electronics C
• /
• v.36C no.6
• /
• pp.18-26
• /
• 1999

This paper presents the architecture and design of a DSSS MODEM ASIC chip for wireless local area networks (WLAN). The implemented MODEM chip supports the DSSS physical layer specifications of the IEEE 802.11. The chip consits of a transmitter and a receiver which contain a CRC encoder/decoder, a differential encoder/decoder, a frequency offset compensator and a timing recovery circuit. The chip supports various data rates, i.e., 4,2 and 1Mbps and provides both DBPSK and DQPSK for data modulation. We have performed logic synthesis using the $SAMSUNG^{TM}$ $0.6{\mu}m$ gate array library and the implemented chip consists of 53,355 gates. The MODEM chip operates at 44MHz, the package type is 100-pin QFP and the power consumption is 1.2watt at 44MHz. The implemented MODEM architecture shows lower BER compared with the Harris HSP3824.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.16 no.5
• /
• pp.152-161
• /
• 2017

The CBTC(Communication based Train Control) system employed on 2.4GHz ISM band adopt the IEEE802.11.x standard. Therefor communication time delay, distortion and data losses will be produced. To overcome these problems, CPSK(Continuous Phase shift keying) modulated DS/SS(Direct Sequence Spread Spectrum) transmitter with 908MHz carrier frequency is proposed. Through the eye diagram and scatter diagram the performance is analysed. And the phase noise characteristic of the local oscillator is measured about 60dBc/Hz, this means that the phase noise performance is very good compared to the signal. Reference frequency suppression of the 2nd local oscillator is 50dB below compared to the signal. Through the polarities of the complementary signal equally probable, the line spectrum of the output spectrum is eliminated. The nonlinear effects which introduce the spectral spreading or spectral regeneration is reduced remarkably.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.39A no.7
• /
• pp.413-423
• /
• 2014

With the increasing demands on high data rate, there has been growing interests in multi-input multi-output (MIMO) technology based on spatial multiplexing (SM) since it can transmit independent information in each spatial stream. Recent standards such as 3GPP LTE-advanced and IEEE 802.11ac support up to eight spatial streams, and massive MIMO and mm-wave systems that are expected to be included in beyond 4G systems are considering employment of tens to hundreds of antennas. Since the complexity of the optimum maximum likelihood based detection method increases exponentially with the number of antennas, low-complexity SM MIMO detection becomes more critical as the number of antenna increases. In this paper, we first review the results on the detection schemes for SM MIMO systems. In addition, massive MIMO reception schemes based on simple linear filtering which does not require exponential increment of complexity will be explained, followed by brief description on receiver design for future high dimensional SM MIMO systems.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.46 no.2
• /
• pp.15-23
• /
• 2009

This paper presents a novel high-speed, low-complexity flexible 128/64-point $radix-2^4$ FFT/IFFT processor for the applications in high-throughput MIMO-OFDM systems. The high radix multi-path delay feed-back (MDF) FFT architecture provides a higher throughput rate and low hardware complexity by using a four-parallel data-path scheme. The proposed processor not only supports the operation of FFT/IFFT in 128-point and 64-point but can also provide a high data processing rate by using a four-parallel data-path scheme. Furthermore, the proposed design has a less hardware complexity compared with traditional 128/64-point FFT/IFFT processors. Our proposed processor has a high throughput rate of up to 560Msample/s at 140MHz while requiring much smaller hardware expenditure satisfying IEEE 802.11n standard requirements.

• Journal of Advanced Navigation Technology
• /
• v.23 no.6
• /
• pp.542-547
• /
• 2019

Autonomous train is investigated to increase the capacity of railroad, and the reliability of wireless communication plays a critical role in terms of decreasing the inter-train distance. In this paper, we propose a transmission scheme for autonomous train communication in highly congested environment. The proposed scheme, namely distributed uplink orthogonal frequency division multiple access (OFDMA) random access (UORA), applies the triggered uplink access (TUA) and the UORA, introduced in the sixth generation WLAN standard, IEEE 802.11ax, for communication devices on vehicle and platform in a distributed manner. The simulation results show that the proposed scheme efficiently improves the packet transmission success rate in highly congested channel conditions compared to the conventional enhanced distributed channel access (EDCA) transmission scheme.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.9 no.4
• /
• pp.753-757
• /
• 2005

Wireless LAN was developed by alternative of LAN and because establishment was easy, have used into special field and special expenditure. Recently, Standard and a technology developed by leaps and bounds. Present is used into purpose of the Building to Building or wide connection etc. and relay of the high speed Internet and usage of picture communication that require multimedia band width. Specially, campus wireless LAM is thought that must secure radius $100\;\~\;200\;m$ dimension at the minimum 10Mbps speed as Internet transit trunk. But, there is difference as degressive here. In this paper, wireless LAN measured for effectiveness proof as Internet transit trunk in actuality utilization environment. Proved that should compose IEEE802.11b as AP more than minimum 3 when compose network to base as measuring result. Hereafter, there is the purpose that achieve performance evaluation of wireless UM in marine environment.

• Journal of KIISE:Information Networking
• /
• v.31 no.2
• /
• pp.158-170
• /
• 2004

Mobile IP is a base protocol to support host mobility in IP-based wireless network. It is well known that the protocol contains two main delay factors on a handoff process; one is to detect a host movement, and the other is to register the host's current location to its home network. This paper examines Layer 2(L2) handoff procedure in the IEEE 802.11 Wireless LAN, and identifies these L2 triggers that can be usefully applied to Layer 3(L3) handoff. Then, the MCAA(Multiple-Casting using Anchor Agent) mechanism is proposed. It makes use of the L2 trigger and the network topology to construct an anchor agent dynamically, and the multiple-casting scheme to prevent an ongoing packet to be lost. Using a network simulator, the proposed mechanism has been evaluated the handoff delay and the packet lost point of view, in comparison with the regional registration protocol which is the most well known micro mobility support mechanism.

• Journal of Digital Convergence
• /
• v.12 no.11
• /
• pp.273-279
• /
• 2014

In this paper, we propose a novel algorithm for three dimensional positioning system and implement a system over indoor wireless channel. A commercial modules are used for mobile and fixed nodes which are product of German company Nanotron Co. This module adopts chirp spread spreading scheme as modulation method to improve the ranging resolution and the module satisfies the IEEE standard 802.15.4a. The distance computation is based on received signal strength(RSS) levels and trilateration method. A testbed was set up to measure and compare the positioning estimation error of the proposed algorithm. The experiments results showed that the accuracy of location estimation was sufficiently good as much as 1m distance error in a wireless environment in an office building.

• Journal of Digital Convergence
• /
• v.11 no.7
• /
• pp.201-207
• /
• 2013

The chirp signaling has been mainly used in radar systems due to its good correlation characteristics, and nowadays it is applied to real time locating system(RTLS). The RTLS with chirp signaling was chosen as a standard such as ISO/IEC 24730-5 and IEEE 802.15.4a. In this paper, the performance of a real time locating system with chirp signaling was evaluated and simulated with relative distance error rates. We considered three cases of S/I = -30[dB], -20[dB], and -10[dB] with Rician factor K=10 and K=20. The performance was enhanced with K factor improvement by 25%, 27% and 50% for respective three cases of S/I. As results, in case of S/I < -20[dB], the minimum signal power is required for performance improvement even though the line of sight component is helpful. And also, in case of S/I ${\geq}$ -20[dB], as the line of sight component is stronger the better performance is obtained.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• v.9 no.2
• /
• pp.499-503
• /
• 2005

The objective of this thesis is to measure the limit of the real space where wireless Local Area Network(LAN) is used, and to apply this result as reference to set up a real Wireless LAN environment. The organized circumference was composed of Wireless LAN based on IEEE 802.11b of the American standard, and the examination is carried out on the campus. On the real condition of office environment and open space, the ratio of available distance to a signal at each distance was measured and this result was studied as data to embody wireless LAN on the campus. The measurement under an indoor environment was executed under circumstance having two wall and open space, however, was executed respectively under three circumstances : Where no obstacle, where one wall exists, and where two or more walls exist.