• 한국수소및신에너지학회논문집
• /
• 제28권2호
• /
• pp.225-230
• /
• 2017

Coal oil is widely used as a home heating fuel for portable and installed coal oil heaters. Today, Coal oil is widely used as fuel for jet engines and some rocket engines in several grades. This paper describes the performance characteristics according to the compression ratio of spark ignition engine fuelled with coal oil. As a result, the following knowledge is obtained: As the compression ratio is decreased, there is an increase in torque, indicated mean effective pressure (IMEP), heat release rate, and brake thermal efficiency. Higher compression ratio of the engine decreases the ignition delay period, combustion period, and cooling loss.

• Nuclear Engineering and Technology
• /
• 제52권7호
• /
• pp.1486-1494
• /
• 2020

To evaluate transport-induced cladding embrittlement after interim-dry storage, ring compression tests were carried out at room temperature(RT) and 135 ℃. The ring compression test specimens were prepared by simulating the interim-dry storage conditions that include four peak cladding temperatures of 250, 300, 350 and 400 ℃, two tensile hoop stresses of 80 and 100 MPa, two hydrogen contents of 250 and 500 wt.ppm-H and a cooling rate of 0.3 ℃/min. Radial hydride fractions of the ring specimens vary depending on those interim-dry storage conditions. The RT compression tests generated lower offset strains than the 135 ℃ ones. In addition, the RT and 135 ℃ compression tests indicate that a higher peak cladding temperature, a higher tensile hoop stress and the lower hydrogen content generated a lower offset strain. Based on the embrittlement criterion of 2.0% offset strain, an allowable peak temperature during the interim-dry storage may be proposed to be less than 350 ℃ under the tensile hoop stress of 80 MPa at the terminal cool-down temperature of 135 ℃.

• 한국진공학회지
• /
• 제15권1호
• /
• pp.14-23
• /
• 2006

스크롤 펌프는 초청정 진공 시스템에서 많이 사용되고 있지만 막상 수소 배기 특성에 대해서 잘 알려져 있지 않다 이런 정보부족은 수소를 다량 사용하는 핵융합 실험장치에서 스크롤 점프가 사용 가능한지 판단하기 어렵게 만든다 이 논문에서는 특히 수소에 대한 스크롤펌프의 배기속도, 압측비 및 역류특성을 측정하기 위해 구성한 실험장치, 측정절차와 실험결과에 대해 기술하고 논의했다.

• 한국수소및신에너지학회논문집
• /
• 제34권2호
• /
• pp.141-148
• /
• 2023

The thermodynamic performance of the electrochemical hydrogen compressor was analyzed to perform a comparative analysis with the performance of the mechanical compressor. The performance was analyzed through the applied current and the measured voltage value. The test results showed that the efficiency of the electrochemical hydrogen compressor was high in the low current density range. In addition, it was confirmed that the amount of increasing compress work of the electrochemical hydrogen compressor is smaller than that of the mechanical compressor. Therefore, it is expected to have higher efficiency than mechanical compression when compressed with a sufficiently high-pressure range.

• 한국자동차공학회논문집
• /
• 제21권4호
• /
• pp.106-112
• /
• 2013

Compression ratio is an important factor affecting engine performance and emission characteristics since thermal efficiency of spark ignition engine can be theoretically improved by increasing compression ratio. In order to evaluate the effect of compression ratio change in HCNG engine, natural gas engine was employed using HCNG30 (CNG 70 vol%, hydrogen 30 vol%). Combustion and emission characteristics of CNG and HCNG fuel was analyzed with respect to the change of compression ratio at each operating condition. The results showed that thermal efficiency improved and $CH_4$, $CO_2$ emission decreased with the increase in compression ratio while $NO_x$ emissions were decreased at a certain excess air ratio condition. Higher thermal efficiency and further reduction of exhaust emissions can be achieved by the increase of compression ratio and the retard of spark timing.

• 한국수소및신에너지학회논문집
• /
• 제20권4호
• /
• pp.274-282
• /
• 2009

Diaphragm compressor is widely used for hydrogen compression because it achieves high gas pressure without gas contamination. Diaphragm deflecting in the cavity with high pressure formed by an oil compression is the most important component in the compressor. Therefore, it is necessary to obtain deflection degree of diaphragm to predict the damage point of diaphragm. The objective of this study is to estimate the diaphragm's damage point through diaphragm deflection test by implementing with strain gauges attached on several radial points. Without gas compression, strain sum of each points varied as similarly as the variation of the pressure with respect to time. And while the motor speed was slower than 400rpm, the strain near the rim was larger than that of the center. When motor speed, however, was over 500rpm, strain became similar to that of the center and the rim. With gas compression, it was shown that the variation of the strain sum was delayed against that of the pressure and the strain near the rim was much higher than that of the center.

• 한국수소및신에너지학회논문집
• /
• 제24권6호
• /
• pp.472-479
• /
• 2013

A free piston linear engine could be operated under HCCI combustion due to its variable compression ratios. To obtain HCCI combustion, the free piston linear engine needs a high compression ratio to achieve auto-ignition of the fuel/air mixture. In this study, an idea for obtaining a high compression ratio using the transition from SI combustion to HCCI combustion was proposed. The fuel used in this study is hydrogen, which is considered to be an environmentally friendly fuel. Besides, the effects of key parameters such as equivalence ratio (${\phi}$), load resistance ($R_L$) and intake temperature ($T_{in}$) on the SI-HCCI transition were numerically investigated. The simulation results show that the SI-HCCI transition is successful without any significant reduction of in-cylinder pressure as the intake temperature is increased from $T_{in}$=300K (SI mode) to $T_{in}$=450K (HCCI mode), while the load resistance and equivalence ratio are retained respectively at $R_L=120{\Omega}$ and ${\phi}$=0.6 in both SI mode and HCCI mode.

• 한국산학기술학회논문지
• /
• 제19권12호
• /
• pp.41-46
• /
• 2018

본 연구에서는 바이오가스 기반 예혼합 압축착화(Homogeneous charged compression ignition, HCCI) 엔진에 수소를 첨가하였을 때, 연소실 내부 압력, 온도 배출가스에 미치는 영향에 대해 살펴보았다. 자세히는 수소 첨가량과 과다공기량(${\lambda}$) 변화에 따른 연소실 압력 온도, 그리고 생성물로서의 NO, $CO_2$ 배출 특성을 화학 반응 해석 프로그램을 사용하여 고찰하였다. 대상의 엔진은 2300cc 바이오가스 엔진 발전기로서 압축비 13:1, 발전량 15kW 급이다. 과급압은 1.2bar 고정 조건이며, rpm은 1800rpm의 정속 조건이다. 엔진 연소 방식은 예혼합 압축 착화를 모사하였다. 본 연구를 진행하기에 앞서 바이오가스의 주요 조성인 메탄의 연소 및 산화 메커니즘에 대한 선행 연구에 대한 고찰을 통하여 연소반응 메커니즘을 규명하기 위한 반응 메커니즘 연구 기술의 경향을 살펴보고, 본 연구에 적용 가능한 반응 메커니즘을 선정하여 해석을 진행하였다. 수소를 첨가할 때 NO는 증가하는 반면, $CO_2$등의 배출량은 감소하였고 실린더 내부 압력이 상승하며, 상승 구간이 진각 됨을 알 수 있었다. 또한, 희박영역에서 수소 첨가가 가연 한계를 증가시켰다.

• 한국수소및신에너지학회논문집
• /
• 제21권1호
• /
• pp.42-49
• /
• 2010

Increasing environmental concerns regarding the use of fossil fuels and global wanning have prompted researcher to investigate alternative fuels. The purpose of this study is to investigate the syngas production by biogas reforming using a compression spark ignition engine. The parametric screening studies were carried out according to the variations of oxygen enrichment rate, biogas $CO_2$ ratio, intake gas temperature, and engine revolution. When the oxygen enrichment rate and input gas temperature increased, hydrogen and carbon monoxide were increased. But the biogas $CO_2$ ratio and engine revolution increased, the syngas were reduced. For the reforming of methane 100% only, generation of hydrogen and carbon monoxide was 58% and 17%, respectively. However when the biogas $CO_2$ ratio was 40%, hydrogen and carbon monoxide concentration were about 20% each.

• 한국수소및신에너지학회논문집
• /
• 제31권2호
• /
• pp.259-264
• /
• 2020

In this study, comparison study has been performed between two-stage compression and a vapor-recompression refrigeration cycle and a liquefaction using LNG cold heat. When using a first method using two-stage compression and a refrigeration cycle, at least three compressors are required, however when using LNG cold heat, no compressor is required since carbon dioxide can be pumped after condensing with the heat exchange with -160℃ of LNG. Through this study, we can save more than one hundred million KRW annually by using LNG cold heat instead of using gas compression and refrigeration cycle.