• JSTS:Journal of Semiconductor Technology and Science
• /
• 제2권3호
• /
• pp.157-163
• /
• 2002

A new flash EEPROM device with p^＋ poly-Si control gate and n^＋ poly-Si floating side gate was fabricated and characterized. The n^＋ poly-Si gate is formed on both sides of the p^＋ poly-Si gate, and controls the underneath channel conductivity depending on the number of electron in it. The cell was programmed by hot-carrier-injection at the drain extension, and erased by direct tunneling. The proposed EEPROM cell can be scaled down to 50 nm or less. Shown were measured programming and erasing characteristics. The channel resistance with the write operation was increased by at least 3 times.

• 한국세라믹학회지
• /
• 제40권7호
• /
• pp.667-671
• /
• 2003

테이프 캐스팅법을 이용하여 알루미나/지르콘(반응결합 뮬라이트/지르코니아 유도)을 내부층으로 하고 알루미나/지르코니아 혹은 뮬라이트/지르코니아를 외부층으로 하는 산화물 층상 복합체를 고온가압소결법으로 제조하였다. 나노압입시험법을 이용하여 층상 산화물 복합체의 기계적 성질(경도 및 탄성계수)을 측정하고, SEM을 통하여 복합체의 미세구조를 관찰하였다. 산화물 층상 복합체의 제조를 위한 가열·냉각시 유도된 구성 산화물간의 열팽창 계수의 차이로 인하여 생성된 잔류응력을 하중-변위곡선을 이용하여 확인할 수 있었다.

• Journal of information and communication convergence engineering
• /
• 제4권2호
• /
• pp.84-87
• /
• 2006

Lateral distributions of locally injected electrons and holes in an oxide-nitride-oxide (ONO) dielectric stack of two different silicon-oxide-nitride-oxide-silicon (SONOS) memory cells are evaluated by single-junction charge pumping technique. Spatial distribution of electrons injected by channel hot electron (CHE) for programming is limited to length of the ONO region in a locally ONO stacked cell, while is spread widely along with channel in a fully ONO stacked cell. Hot-holes generated by band-to-band tunneling for erasing are trapped into the oxide as well as the ONO stack in the locally ONO stacked cell.

• 한국항공운항학회지
• /
• 제15권3호
• /
• pp.1-5
• /
• 2007

In this paper, effective thermal conductivities of water-based Al203-nanofluids with low concentration from 0.01 vol. % to 0.3 vol. % are experimentally obtained by transient hot wire method (THWM). The water-based Al203-nanofluids are manufactured by two-step method which is widely used. To examine suspension and dispersion characteristics of the water-based A1203-nanofluids, Zeta potential as well as transmission electron micrograph (TEM) is observed. We confirm the manufactured Al203-nanofluids have good suspension and dispersion. The effective thermal conductivities of the water-based Al203-nanofluids with low concentration are enhanced up to 1.64% compared with that of DI water at $21^{\circ}C$. In addition, experimental results are compared with theoretical results from Jang and Choi model.

• 한국정보통신학회:학술대회논문집
• /
• 한국해양정보통신학회 2001년도 추계종합학술대회
• /
• pp.656-659
• /
• 2001

최근 반도체 기술의 발달로 소자의 크기가 줄어들면서 높은 에너지를 갖는 핫 캐리어 전송 해석이 매우 중요하게 되었다. Auger 과정과는 반대인 임팩트이온화현상은 핫 캐리어에 의한 산란에 의하여 전자-정공쌍을 생성하는 과정으로 소자의 전송특성 해석을 위한 시뮬레이션에 정확한 임팩트 이온화모델이 필수적이다. 본 연구에서는 Monte Carlo 시뮬레이터를 이용한 임팩트이온화 모델과 TCAD 그리고 Micro-Tec을 이용한 임팩트이온화 모델을 분석하여 보다 정확한 임팩트이온화 모델을 제시하고자 한다.

• 한국세라믹학회지
• /
• 제56권3호
• /
• pp.269-276
• /
• 2019

This article reports on the conditions required for the growth of crystalline boron films on silicon substrates by hot filament chemical vapor deposition method. The reactive gas was 3% diborane diluted in hydrogen. The films were characterized by optical, electronic, and atomic force microscopies; x-ray diffraction; and energy dispersive, electron energy loss, Raman, x-ray photoelectron, and Auger spectroscopies. The parameters that affect the morphologies of the films have been investigated. It was concluded that faceted crystals are produced at low B₂H₆ flows and working pressures below 200 mT. α-boron is produced between 530 and 600℃. Deposition outside this range produces thin films with a wide variety of morphologies. This result indicates that the films crystallize through a process called "abnormal or discontinuous grain growth." It is assumed that this is due to the anisotropic surfaces of boron allotropes.

• 한국재료학회지
• /
• 제3권3호
• /
• pp.223-229
• /
• 1993

본 연구에서는 Cholestery1 bipheny1 ester계열 화합물을 합성하여 편광현미경이 부착된 hot-stage와 시차열분석기로 물성을 조사하였다. 이 계열 화합물들은 모두 콜레스테릭 액정상을 나타내며, 알콕시 사슬 3번부터 스메틱상이 형성됨을 보여 준다. 또한, 일반적인 콜레스테릭 액정화합물에 비해 높은 상전이 온도를 보유하고 있으며, 넓은 온도 범위에 걸쳐 액정상을 나타낸다.

• 대한금속재료학회지
• /
• 제50권6호
• /
• pp.433-438
• /
• 2012

Strength change in ultra low carbon steel carburized at $880^{\circ}C$ and $930^{\circ}C$ for 10, 30, 60 and 120 minutes was investigated. The results were analyzed by a tensile test, chemical composition analysis, optical microscopy and scanning electron microscopy. Stress in the 0.5% strain specimen in the tensile test increased as the time treated at $880^{\circ}C$ and $930^{\circ}C$ increased, because the carbon diffusion layer and the martensite of the specimen increased with increasing treatment time. Martensite was found in the ferrite region in the specimen treated at $880^{\circ}C$, which is attributed to grain boundary diffusion.

• 한국재료학회지
• /
• 제10권3호
• /
• pp.246-252
• /
• 2000

기계적 합금화 공정을 이용하여 제조한 $Bi_2(Te_{0.85}Se_{0.15})_3$ 가압소결체의 가압소결온도에 따른 열전특성을 분석하였다. $Bi_2(Te_{0.85}Se_{0.15})_3$ 가압소결체는 $300^{\circ}C$에서 $550^{\circ}C$ 범위의 가압소결온도에 무관하게 n형 전도를 나타내었다. $Bi_2(Te_{0.85}Se_{0.15})$ 합금분말을 (50% $H_2+50%$ Ar) 분위기에서 환원처리시, 분말 표면의 산화층 제거 및 과잉 Te 공격자의 소멸에 기인한 전자 농도의 감소로 가압소결체의 Seebeck 계수가 양의 값으로 변화하였다. $450^{\circ}C$ 이상의 온도에서 가압소결시 가압소결온도의 증가에 따라 $Bi_2(Te_{0.85}Se_{0.15})$ 합금의 성능지수가 증가하였으며, $550^{\circ}C$에서 가압소결시 $1.92{\times}10^{-3}/K$의 최대성능지수를 얻을 수 있었다.

• Applied Microscopy
• /
• 제6권1호
• /
• pp.1-7
• /
• 1976

To investigate the nature of typhoid cells, three cases of clinically, serologically and histopathologically proven typhoid lesions of the small intestine and regional lymph nodes were studied light and electron microscopically, Light microscopically, typhoid cells were swollen mononuclear cells characterized by abundant amount of eosinophilic cytoplasm and frequent phagocytoses of red blood cells, bacterial clumps and other tissue debris. These cells were pyronin negative, Electron microscopically, these cells showed marked and diffuse dilatation of RER cisternae and disappearance of ordinary cytoplasmic organelles, but frequent phagocytosed materials, The meaning and reason of RER cisternal dilatation and reduction of cytoplasmic organelles were discussed, and are regarded as degenerative process due to bacterial endotoxin. Although there was hot enough cytoplasmic organelles to pinpoint the origin of typhoid cells, active phagocytosis and evidences against being either plasmacytic or lymphocytic nature favored retuculoendothelial nature of the typhoid cells.