• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.21 no.4
• /
• pp.290-300
• /
• 2009

The existing numerical methods on the vertical membrane breakwater have employed a linear analysis where the variable membrane tension occurring during membrane motions is assumed to be very negligible compared to the initial tension. In the present study, a quasi-nonlinear analysis is attempted such that the temporary tension of the membrane is substituted by the average tension for a wave period that is sought by an iterative calculation. The results showed that with the increase of the wave period the reflection coefficients appeared larger and the transmission coefficients smaller compared to the results of the linear analysis. The application of the quasi-nonlinear analysis also showed that the performance of the structure is closely dependent on the horizontal deformation of the membrane. In order to suppress the horizontal deformation, it may be required to take the larger initial tension of the membrane or to put additional mooring lines in the middle of the vertical faces of the membrane. But for theses methods to be effective, a largely sized surface float should be installed to secure enough buoyancy to support such downward forces.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.38C no.3
• /
• pp.311-317
• /
• 2013

In this paper, we proposed high speed LDPC decoding algorithm based on DVB-S2 standard for applying marine communications in order to multimedia transmission. For implementing the high speed LDPC decoder, HSS algorithm which reduce the iteration numbers without performance degradation is applied. In HSS algorithm, check node update units are update at the same time of bit node update. HSS can be accelerated to the decoding speed because it does not need to separate calculation of the bit nodes, However, check node calculation blocks need many clocks because of just one memory is used. Therefore, this paper proposed partial memory structure in order to reduced the delay and high speed decoder is possible. The results of the simulation, when the max number of iteration set to 30 times, decoding throughput of HSS algorithm is 326 Mbit/s and decoding speed of proposed algorithm is 2.29 Gbit/s. So, decoding speed of proposed algorithm more than 7 times could be obtained compared to the HSS algorithm.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.20 no.8
• /
• pp.806-812
• /
• 2009

In this paper, the omnidirectional circularly polarized(CP) antenna using arc-shaped mushroom structure with curved branch is proposed. To obtain a vertical polarization and an omnidirectional radiation pattern, the CP antenna uses zeroth-order resonance(ZOR) mode of composite right and left handed(CRLH) transmission line. The horizontal polarization is achieved by the curved branches. Also, the spacing between curved branch and arc-shaped mushroom structure gives the $90^{\circ}$ phase difference between vortical and horizontal polarization. The proposed antenna, therefore, has an omnidirectional CP radiation pattern In the azimuthal plane. The electrical size of the proposed antenna is reduced by 38%, compared with that of the previously presented omnidirectional CP antenna. In addition, the CP antenna is simply designed without $90^{\circ}$ phase shifter and dual feed line. The proposed antenna uses a Bazooka balun for good impedance matching and radiation pattern. To improve 3 dB axial ratio in XY plane, the designed antenna is optimized. After optimization, the measured 3 dB axial ratio in XY plane is observed in $86{\sim}282^{\circ}$.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2001.05a
• /
• pp.359-362
• /
• 2001

Analog communication systems using AM, FM modem have been developed. Digital communication systems using digital modems, which is by expansion of digital hardware skill have been recently developed. In order to accomplish a reliable communication it is important to overcome ocean environmental channel characteristics such as transmission loss, ambient noise and multipath effect etc. Specially, the effect of multipath is the most important element that determines the performance of underwater communication system in shallow water. Multipath channel can be divided a vertical and horizontal channel. the former is defined the channel to have large path-delay times between a direct wave and reflected waves. The latter shows relatively small path-delay times between a direct and reflected waves in compared with a vertical channel. In this paper, The performance of FSK, PSK and DPSK modem with respect to the vertical and horizontal multipath communication channels it described and compared.

• Geophysics and Geophysical Exploration
• /
• v.9 no.2
• /
• pp.148-154
• /
• 2006

The effect of small-scale near surface inhomogeneity on Rayleigh wave propagation and dispersion has been investigated in this study using two-dimensional FEM elastic modeling. Various inhomogeneity models with a variety of geometrical shape and embedment depth which exist in homogeneous half-space and two-layered media are considered. Results show that any near surface inhomogeneity greater than one wavelength in terms of minimum wavelength of Rayleigh wave shows dispersion characteristics. Such dispersion effect become stronger as the dimensions of the inhomogeneity increase. The effect of horizontal dimension is more dominant factor governing the dispersion characteristics than vertical dimension. However, the dispersion effect can not be identifiable in seismogram if the horizontal dimension is not wide enough. Nonetheless, even in this case, the existence of inhomogeneity can be inferred by the reflection or transmission event of Rayleigh wave. The results can be expected to provide insights on the behavior of Rayleigh wave which may be helpful for designating field work or new processing scheme to detect near surface inhomogeneity by surface wave method.

• The Journal of the Acoustical Society of Korea
• /
• v.38 no.2
• /
• pp.231-239
• /
• 2019

In sonar systems, the passive ranging of a target is an active research area. This paper analyzed the performance of passive ranging based on an array invariant method for different environmental and sonar parameters. The array invariant developed for source range estimation in shallow water. The advantages of this method are that detailed environmental information is not required, and the real-time ranging is possible since the computational burden is very small. Simulation was performed to verify the algorithm. And this method is applied to sea-going experimental data in 2013 near Jinhae port. This study shows the performance of ranging for source orientation, transmission signal length, and length of a receiver through numerical simulation experiments. Also, the results using nested array and uniform line arrays are compared.

• Journal of Soil and Groundwater Environment
• /
• v.26 no.5
• /
• pp.39-48
• /
• 2021

Analysis of the change in water content and distribution was conducted according to the supply of recirculation water to a landfill. An excavation sample analysis showed that the recirculation water injection zone had water content 8.8% point higher than that of the non-injection zone, after 8 months of operation. And due to the influence of recirculation water supply by vertical wells in injection zones, the water content increases along with depth more clearly than non-injection zone. According to an electrical specific-resistivity survey after 13 months of operation, the water content got higher towards the bottom of the landfill. The water transmission coefficient is 8.72×10^-4 cm/sec for injection zones and 3.36×10^-5 cm/sec for the intermediate cover layer; analysis shows that the intermediate cover layer may affect the penetration velocity of water supplied by the horizontal injection tube. For the scientific design and operation of re-injection facilities, it was deemed necessary to follow-up research on the residence time and behavior of re-injection water considering the ratio of recirculation water supply in horizontal and vertical tubes, and pitcher coefficient of intermediate and waste layers.

• Journal of Advanced Navigation Technology
• /
• v.26 no.3
• /
• pp.160-165
• /
• 2022

In this paper, we have proposed a magnetic resonant 6.78MHz WPT(wireless power transfer) technique which can be applied to a fixed transmitter and a receiver of varying relative distance and coil alignment, Power transmission characteristics are studied with the relative distance and misalignment ration of coil area between the transmitting and receiving coils. The coils are designed with the size of 60×80mm² by direct feeding method, and the characteristics are derived with the maximum relative distance of 50mm and horizontal area misalignment state of 0-40mm misalignment of coil center axis in the XY plane. The power transmission characteristics are compared between the 3D EM simulation and the measured data, and the power transmission shows larger than -3dB performance with the vertical distance of up to 30mm and 50% area misalignmment ratio. This work showsthe transmission characteristics according to relative distance and misalignment state between the cols and that direct feeding has advantage for the short relative distance and small misalignment ratio.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.13 no.9
• /
• pp.4126-4130
• /
• 2012

In this paper, we proposed planar spiral inductors based on AC coupling for high-frequency wireless signal transmission. Design and characteristics of various structures of the inductor were analyzed. Capacitance between the inductors can be reduced by positioning two thin-film inductors in parallel. So two structures were proposed. First structure is inter-diagonal structure. This structure was made not to overlap the wire part of the paralleled two inductors. Second structure is On-chip type structure that the two thin-film inductors were in parallel but located on diagonal line not to face each other. The resonance in this structure was reduced from twice to once by increasing horizontal distance between the two thin-film inductors, because the capacitance effect between the two thin-film inductors decreases when the distance between the two inductors increases.

• International Journal of Industrial Entomology and Biomaterials
• /
• v.31 no.2
• /
• pp.70-74
• /
• 2015

The current market size of insect industry in Korea is estimated at 300 million dollars and more than 500 local farms are related to many insect industry. One of the strong candidates for insect industry is Korean horn beetle, Allomyrina dichotoma. Early this year, we reported a viral disease extremely fatal to A. dichotoma larvae. While we were proceeding a nationwide investigation of this disease, it was informed that similar disease symptom has been occurred occasionally during past over 10 years. The symptom can be easily confused with early stage of bacterial infection or physiological damage such as low temperature and high humidity. A peroral infection with the purified virus to healthy larvae produced a result that only 21% of larvae survived and became pupae. Although some of the survived adult beetle was deformational, many of them had no abnormal appearance and even succeeded in mating. Later, these beetles were examined if they were carrying the virus, and all except one were confirmed as live virus carrier. This implies that these beetles may fly out and spread the disease to the nature. We found the evidence for this possibility by collecting a few wild A. dichotoma larvae which were virus infected, near two local farms rearing A. dichotoma larvae. So far, transovarial transmission of this virus to the eggs, or horizontal transmission to other commercially reared insects is not known yet.