• Progress in Superconductivity
• /
• 제12권1호
• /
• pp.1-5
• /
• 2010

In this work we synthesized both MgB2 and Carbon doped MgB2 superconductor with Ag addition via high energy milling and substituent heat treatment. Heat treatments were performed at $900\;^{\circ}C$ for 30 min in flowing Ar gas. We varied amount of Ag powder. In a range of Ag powder was 0~5wt%. The effect of Ag was correlated with superconducting properties. The results show a slight decrease in critical temperature ($T_c$) and a reduction of critical current density ($J_c$) at high fields for the Ag-doped samples as compared to the un-doped samples. Reduction of $J_c$ may be due to the formation of MgAg compound.

• 한국초전도ㆍ저온공학회논문지
• /
• 제17권1호
• /
• pp.28-31
• /
• 2015

An in-flight fragment separator, which aims to produce and study rare isotopes, consists of superferric quadrupole triplets and $30^{\circ}$ dipole magnets to focus and bend the beams for achromatic focusing and momentum dispersion, respectively. The separator is divided into pre and main stages, and we plan to use superconducting magnets employing high-Tc superconductor (HTS) coils in the pre-separator area, where radiation heating is high. The HTS coils will be cooled by cold He gas in 20-50 K, and in the other area, superferric magnets using low-temperature superconductor (LTS) will be used at 4 K. A few LTS coils were wound and successfully tested in a LHe dewar, and the design of cryostat has been optimized. Development of the HTS coils is ongoing in collaboration with a group at KERI. An HTS coil of racetrack shape was wound and tested in a $LN_2$ bath and in a dewar with cryocooler. No degradation on critical current due to coil winding was found.

• 한국초전도학회:학술대회논문집
• /
• 한국초전도학회 2000년도 High Temperature Superconductivity Vol.X
• /
• pp.1-1
• /
• 2000

The infinite layer compound $ACuO_2$, (A-Alkaline earth) consists of infinite stacking of $CuO_2$ planes separated only by alkaline earth ions. This compound attracted much attention because it contains only key ingredient of all cuprate high temperature superconductor; $CuO_2$ plane with controllable carrier concentration without charge reservoir block. High pressure synthesis method has been found to be preferable for this system due to its ability of doping various lanthanide ion into A site with larger superconducting volume fraction. But rigorous study on this rudimentary compound has been hindered by insufficient quality of sample. Especially superconductlng volume fraction was often too small to identify its origin. In this presentation, we report high pressure synthesis of $Sr_{0.9}Ln_{0.1}CuO_2$ (Ln=La, Sm). By controlling the heating temperature precisely during high pressure synthesis we could have superconductors with quite high superconducting volume fraction for this compound. The magnetic properties of the graln aligned samples show very different behavior compared to the cuprate high temperature superconductors. Details will be discussed.

• 한국재료학회:학술대회논문집
• /
• 한국재료학회 1992년도 추계학술발표강연 및 논문개요집
• /
• pp.16-16
• /
• 1992

We have studied the effect of platinum addition on the supercon ducting properties of YB $a_2$C $u_3$$O_{7-x}$ (123) compound and elucidated the mechanism of fine dispersion of $Y_2$BaCu $O_{5}$(211) particles in YB $a_2$C $u_3$$O_{7-x}$ superconductor prepared by melting method from the metallurgical point of view. In this study, BaCu $O_2$ and CuO-rich phase unreacted during the peritecitc reaction markedly decreased by the 211 powder addition. The 211 particle of Pt-fee sintered samples exhibited 8~10$\mu$m in size, but in 1wt%Pt-added sample, 211 particles were finely dispersed in 123 matrix and the size of 211 particle was about 1~2$\mu$m. And, the critical temperature( $T_{c. zero}$) of Pt doped samples was 91.5K and the transport critical current density ( $J_{c}$) of Pt-doped samples was much more than 10$^4$A/$\textrm{cm}^2$. The high $J_{c}$ and fine dispersion of 211 particles of Pt doped YB $a_2$C $u_3$$O_{7-x}$ superconductor are attributed to $Ba_4$CuP $t_2$ $O_{8}$ compounds formed during the partial melting, which were considered als nucleation sites of 211 particles, rather than Pt inself.han Pt inself.

• 한국초전도저온공학회:학술대회논문집
• /
• 한국초전도저온공학회 2002년도 학술대회 논문집
• /
• pp.297-299
• /
• 2002

To wind a HTS (High Temperature Superconductor) tape conductor on a bobbin, double pancake winding technique is widely used to reduce number of splicing contacts between conductor pieces. However, this makes some Ic (critical current) degradation on kink points which is unavoidable. This paper describes the two ways of winding; usual double pancake and soldered double pancake. Characteristics of the two windings are measured and compared.

• 한국초전도ㆍ저온공학회논문지
• /
• 제5권3호
• /
• pp.26-29
• /
• 2003

Nowadays, one of the serious problems in KEPCO system is much higher fault current than the SCC(Short Circuit Capacity) of circuit breaker. As the superconductivity technology has developed, the HTS-FCL(High Temperature Superconductor-Fault Current Limiter) can be one of the attractive alternatives to solve the fault current problem. But the parameters of HTS-FCL should be designed optimally to have the best performance. Under this background, this paper presents the optimal design method of parameters for resistive type HTS-FCL using Monte Carlo technique.

• 한국초전도학회:학술대회논문집
• /
• 한국초전도학회 2006년도 High Temperature Superconductivity Vol.XVI
• /
• pp.64-64
• /
• 2006

• Transactions on Electrical and Electronic Materials
• /
• 제6권4호
• /
• pp.186-189
• /
• 2005

We have fabricated superconducting HTSC ceramic thick films by chemical process. c-axis oriented HTSC thick films have been attempted bi-axially textured Ni tapes. The x-ray diffraction pattern of the HTSC thick films contained superconducting phase crystal. The critical temperature and critical current density was 110K.

• 한국초전도저온공학회:학술대회논문집
• /
• 한국초전도저온공학회 2001년도 학술대회 논문집
• /
• pp.142-144
• /
• 2001

We designed superconducting four-element patch array antenna which has single-feed circularly polarization and a resonance frequency of 11.85 GHz for DBS receiving system. Antennas have been fabricated from both gold conductor and $YBa_{2}$$Cu_{3}$$O_{7-x}$(YBCO) superconductor (thin films) for comparison. Simulated and measured results, and analysis on resonant frequency(fr), return loss, and bandwidth are presented.

• 한국초전도저온공학회:학술대회논문집
• /
• 한국초전도저온공학회 2003년도 학술대회 논문집
• /
• pp.263-265
• /
• 2003

A winding machine to fabricate the double pancake coils was manufactured. A race-track type double pancake coil using high temperature superconductor (HTS) tape was prepared and I-V and I-H characteristic curves were obtained at the atmosphere of liquid nitrogen. The winding method to make the double pancake coil and its properties is discussed.