• Journal of the korean Society of Automotive Engineers
• /
• v.5 no.1
• /
• pp.32-44
• /
• 1983

In case of $K_{Imax}$ < $K_{Iscc}$, the corrosion fatigue of high strength steel in 0.1N $H_{2}$S $O_{4}$ solution and 3.5% salt water is as follows. 1. The fatigue life shortens in order of 3.5% salt water and 0.1N $H_{2}$S $o_{4}$ solution. 2. The fatigue crack growth rate in air is obtained as the following equation. (dc/dN)$_{atr}$=7.23*10$^{-6}$ (.DELTA. K)$^{2.23}$ 3. The corrosion fatigue crack growth rate in environment is divided into three regions, that is, First Region, Second Region and Third Region from the small cyclic stress intensity. 4. The formation rate of the active surface on metal is slower than the mechano-chemical reaction rate in First Region. The crack growth rate depends on time and the cyclic stress intensity and is expressed as the following equation. (dc/dN)$_{I}$=C(/DELTA. K)$^{\delta}$ 5. The formation rate of the active surface is faster than the mechano-chemical reaction rate in Second Region and the synergistic effect by stress and corrosion becomes slow. In case the fatigue load is large, we have the critical crack growth rate which is not related to the cyclic stress intensity. 6. The corrosion crack growth rate by the mechano-chemical reaction is the same in $H_{2}$S $O_{4}$ solution and salt water, so Hydrogen accelerates the crack growth. 7. The environment has no effect on the corrosion fatigue crack growth rate in Third Region. 8. In First Region and Second Region, dimple is observed on the fatigue fracture surface in 0.1N $H_{2}$S $O_{4}$ solution. 9. The striation is observed in any environment as in air in Third Region and its interval approximately coincide with the crack growth rate.ate.e.e.

• Journal of Ocean Engineering and Technology
• /
• v.9 no.2
• /
• pp.98-111
• /
• 1995

High temperature low cycle fatigue shows that cycle-dependent crack growth owing to cyclic plastic deformation occurred simultaneosly with time-dependent crack growth owing to intergranular deformation. Consequently, to estimate crack growth rate uniquely, many to investigators have proposed various kinds of parameters and theories but these could not produce satisfactory results. Therefore the goal of this study is focused on prediction of crack growth rate using predominant damage rule, linear cumulative damage rule and transitional parameter ${\Delta}J_c/{\Delta}J_f$. On the basis of these sinusoidal loading waveform at 600$^{\circ}C$ and 700$^{\circ}C$.

• Journal of Ecology and Environment
• /
• v.29 no.5
• /
• pp.461-467
• /
• 2006

The growth pattern and the seasonal changes in nutrient contents of Humulus japonicus were investigated. Stem length of H. japonicus reached the maximum from 240 to 260 Julian date and the median value was found at 255 Julian date. The maximum leaf area was observed from 235 to 248 Julian date and the median value was at 240 Julian date. The maximum growth rate of the stem length ranged from 205 to 227 Julian date. The leaf area showed the maximum growth rate from 196 to 214 Julian date. The median date in the growth rate of the stem length and leaf area was 212 and 205 Julian date, respectively. The growth rate of H. japonicus was related to rainy season and precipitation. Phosphorus and sodium contents of H. japonicus were correlated with maximum potential rate of relative growth. Although stem biomass of H. japonicus was $ 1.5{\sim}3.5$ times larger than that of leaf, N content of the leaf ($4.48{\sim}5.27%$) was about 2 times higher than that of the stem ($2.00{\sim}3.62%$). High content of N might be responsible for the high growth rate of H. japonicus in summer. This result provides valuable information for appropriate timing for the removal of H. japonicus.

• Journal of Distribution Science
• /
• v.11 no.10
• /
• pp.55-62
• /
• 2013

Purpose - The purpose of this study is to suggest a risk factor that significantly explains foreign currency risk premia. In recent years, some studies have found that the performance of the simultaneous consumption risk model improves considerably when tested on foreign currency portfolios, which are constructed based on the international interest rates differentials. However, this paper focuses on the long-run consumption risk factor. In our empirical research, we found that the real excess returns of high interest rate currency portfolios depreciate on average, when the future American long-run consumption growth rate appears low. This makes the high interest rate currency portfolios have relatively high risk premia. Meanwhile, the real excess returns of low interest rate currency portfolios appreciate on average, under the same conditions, which results in relatively low risk premia for these portfolios. Therefore, this long-run consumption risk factor might explain why low interest rate currencies do not appreciate as much as the interest rate differential, and why high interest rate currencies do not depreciate as much as the interest rate differential. Research design, data, methodology - In our explanation, we provide new evidence on the success of long-run consumption risks in currency risk premia by focusing on the long-run consumption risks borne by American representative investors. To uncover the hidden link between exchange rates and long-run consumption growth, we set the eight currency portfolios as our basic assets, which have been built based on the foreign interest rates of eighty countries. As these eight currency portfolios are rebalanced every year, the first group always contains the lowest interest rate currencies, and the last group contains the highest interest rate currencies. Against these basic eight currency portfolios, we estimate the long-run consumption risk model. We use recursive utility framework and the stochastic discount factor that depends on the present value of expected future consumption growth rates. We find that our model is optimized in the two-year period of constructing the durable consumption expectation factor. Our main results surprisingly surpass the performance of the existing benchmark simultaneous consumption model in terms of R², relatively risk aversion coefficient γ, and p-value of J-test. Results - The performance of our model is superior. R², relatively risk aversion coefficient γ, and p-value of J-test of our long-run durable consumption model are 90%, 93%, and 65.5%, respectively, while those of EZ-DCAPM are 87%, 113%, and 62.8%, respectively. Thus, we can speculate that the risk premia in foreign currency markets have been determined by the long-run consumption risk. Conclusions - The aggregate long-run consumption growth risk explains a large part of the average change in the real excess returns of foreign currency portfolios. The real excess returns of high interest rate currency portfolios depreciate on average when American long-run consumption growth rate is low, and the real excess returns of low interest rate currency portfolios appreciate under the same conditions. Thus, the low interest rate currency portfolios allow investors to hedge against aggregate long-run consumption growth risk.

• Journal of Microbiology and Biotechnology
• /
• v.18 no.5
• /
• pp.918-925
• /
• 2008

Controlling the light energy and major nutrients is important for high cell density culture of cyanobacterial cells. The growth phase of Anabaena variabilis can be divided into an exponential growth phase and a deceleration phase. In this study, the cell growth in the deceleration phase showed a linear growth pattern. Both the period of the exponential growth phase and the average cell growth rate in the deceleration phase increased by controlling the light intensity. To control the light intensity, the specific irradiation rate was maintained above $10\;{\mu}mol/s/g$ dry cell by increasing the incident light intensity stepwise. The final cell density increased by controlling the nutrient supply. For the control of the nutrient supply, nitrate, phosphate, and sulfate were intermittently added based on the growth yield, along with the combined control of light intensity and nutrient concentration. Under these control conditions, both final cell concentration and cell productivity increased, to 8.2 g/l and 1.9 g/l/day, respectively.

• Environmental Engineering Research
• /
• v.20 no.4
• /
• pp.347-355
• /
• 2015

The growth kinetics of phototrophic microorganisms can be controlled by the light irradiance, the concentration of an inorganic nutrient, or both. A multi-component kinetic model is proposed and tested in novel batch experiments that allow the kinetic parameters for each factor to be estimated independently. For the cyanobacterium Synechocystis sp. PCC6803, the estimated parameters are maximum specific growth rate $({\mu}_{max})=2.8/d$, half-maximum-rate light irradiance $(K_L)=11W/m^2$, half-inhibition-rate light irradiance $(K_{L,I})=39W/m^2$, and half-maximum-rate concentration for inorganic carbon $(K_{S,Ci})=0.5mgC/L$, half-maximum-rate concentration for inorganic nitrogen $(K_{S,Ni})=1.4mgN/L$, and half-maximum-rate concentration for inorganic phosphorus $(K_{S,Pi})=0.06mgP/L$. Compared to other phototrophs having ${\mu}max$ estimates, PCC6803 is a fast-growing r-strategist relying on reaction rate. Its half-maximum-rate and half-inhibition rate values identify the ranges of light irradiance and nutrient concentrations that PCC6803 needs to achieve a high specific growth rate to be a sustainable bioenergy source. To gain the advantages of its high maximum specific growth rate, PCC6803 needs to have moderate light illumination ($7-62W/m^2$ for ${\mu}_{syn}{\geq}1/d$) and relatively high nutrient concentrations: $N_i{\geq}2.3 mgN/L$, $P_i{\geq}0.1mgP/L$, and $C_i{\geq}1.0mgC/L$.

• Journal of the Korean Society of Safety
• /
• v.16 no.4
• /
• pp.52-57
• /
• 2001

Fatigue crack growth behaviour of Ti-6A-4V alloy is investigated in air and salt solution environment at room temperature and $200^{\circ}C$. Fatigue crack growth rate is blown to be fast for the formation of corrosive product in hot salt environment. For the effect on corrosion fatigue crack growth behaviour of region II. fatigue crack growth rate in atmosphere had a little gap to both case, $200^{\circ}C$ and room temperature. However, it showed very fast tendency in salt corrosive atmosphere, and it was remarkably accelerated in $200^{\circ}C$ temperature salt environment. When $\Delta$K was approximately 30MPa(equation omitted), fatigue crack growth rate had a little difference between at room temperature and at $200^{\circ}C$ high temperature, however in case of salt corrosive environment the room temperature was 3.5 times Inter and $200^{\circ}C$ high temperature for 16 times than air environment respectively.

• Korea journal of population studies
• /
• v.31 no.1
• /
• pp.27-54
• /
• 2008

The purpose of this study is to analyze the effect of policy boosting fertility and labor participation rate on potential GDP growth rate. To do this, we employ a growth accounting approach, which decomposes per capita GDP into two parts. The first one is the change of dependency ratio and the other is the change of labor input. The labor input is again decomposed into the qualitative and quantitative parts. The quantitative part considers the change of labor participation rate and working time. The qualitative aspects is based on the trend of productivity of labor. From the scenarios of NSO(National Statistics Office), the effect of the fertility-raising policy on per capita potential GDP growth rate is calculated and projected to the year of 2050. We also forecast the policy effect inducing high labor participating rate of female labor and beyond 55-year old labor. The baseline results show that the per capita GDP growth rate will show mid 4% to the year of 2010, gradually declining to 3.94% by 2020, 3.03% by 2030, 2.41% by 2040. The high fertility rate scenario will not have effects on the potential growth by 2030, but show 0.10%p higher per capita GDP growth rate than that of baseline scenario result. By the high female labor participation policy, the per capita GDP growth rate will reach 0.04%p higher per capita GDP growth rate than that of baseline scenario. Based on the results of this paper, we conclude that the quantitative labor input cannot solely account for the trend decline of potential GDP, and the qualitative aspect, like labor productivity, is much more important element to sustain and boots the economic growth.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2000.07a
• /
• pp.735-738
• /
• 2000

This paper shows experimentally that oxide layer on the p-type Si-substrate can grow at low temperature(500$^{\circ}C$∼600$^{\circ}C$) using high pressure water vapor system. As the result of experiment, oxide layer growth rate is about 0.19${\AA}$/min at 500$^{\circ}C$, 0.43${\AA}$/min at 550$^{\circ}C$, 1.2${\AA}$/min at 600$^{\circ}C$ respectively. So, we know oxide layer growth follows reaction-controlled mechanism in given temperature range. Consequently, granting that oxide layer growth rate increases linearly to temperature over 600$^{\circ}C$, we can expect oxide growth rate is 5.2${\AA}$/min at 1000$^{\circ}C$. High pressure oxidation of silicon is particularly attractive for the thick oxidation of power MOSFET, because thermal oxide layers can grow at relatively low temperature in run times comparable to typical high-temperature, 1 atm conditions. For higher-temperature, high-pressure oxidation, the oxidation time is reduced significantly

• Korean Journal of Agricultural Science
• /
• v.51 no.1
• /
• pp.25-39
• /
• 2024

This study aimed to determine a method for restoring grasslands to forests in mountainous areas. The study was conducted in an area damaged by trampling due to construction activity and herding. Additionally, there were concerns of hindered tree growth due to the alpine region climate, characterized by the low temperatures, drying, and strong winds. Therefore, forest restoration treatments such as tillage, furrow, and shading were performed to improve growth conditions. From July 2021 to April 2023, soil temperature and moisture were monitored for each treatment plot, and changes in the initial growth and survival rate of Abies holophylla were investigated. Both soil temperature and soil moisture showed significantly higher values during the four seasons in the grassland-furrow treatment plot (p < 0.05). Compared to the grassland-control plot, the average soil temperature in winter was as high as 1.1℃, and the soil moisture in summer was as high as 20.3%. Additionally, the survival rate and relative growth rate were the largest in the grassland-furrow treatment plot. The survival rate was 87.5%, the relative growth rate in terms of height was 0.013, and the relative growth rate in terms of diameter at root collar was 0.023, indicating that furrow treatment had a positive effect on the initial survival and growth of seedlings. These results suggest that furrow treatment may be an appropriate restoration method when implementing forest restoration projects in areas where tree growth is challenged.