• 반도체디스플레이기술학회지
• /
• 제6권4호
• /
• pp.17-22
• /
• 2007

Vibration isolation equipments are mostly required in precise measurement and manufacturing system. Among all the vibration isolation equipments, air-spring is the most widely used equipment because of low resonant frequency and high damping ratio. In this study, we used Takagi-Sugeno fuzzy method to design an active vibration isolation system using air-spring, and compared the fuzzy method with passive control method and PID control method. Due to the non-linearity characteristics of air-spring, fuzzy controller was verified to be the most effective both in simulation and experiment.

• ETRI Journal
• /
• 제39권3호
• /
• pp.383-389
• /
• 2017

A small dual-polarized base station antenna with a simple isolation patch is presented. A high isolation is achieved when using a shorted metallic isolation patch. The experimental results indicate that the measured impedance bandwidth of the proposed antenna is 1.72 GHz to 1.89 GHz for small cell systems and that the isolation is more than 30 dB. The proposed antenna exhibits good radiation patterns with a peak gain of 8 dBi.

• 한국소음진동공학회논문집
• /
• 제21권4호
• /
• pp.352-356
• /
• 2011

The isolation performance of a linear vibration isolator is limited to the ratio of stiffness to mass it supports. The stiffness of the isolator must be large enough to hold the weight. This results in the deterioration of the isolation performance. Recently, to overcome this fundamental limitation, the HSLDS(high-static-low-dynamic-stiffness) magnetic vibration isolator was introduced and its isolation characteristic was investigated theoretically. In this paper, the isolation performance of the HSLDS magnetic isolator is examined experimentally. Considerable amount of experiments are performed by carefully considering nonlinear characteristics. The experimental results verify the practical usability promisingly and agree with the theoretical studies, i.e. its performance is largely dependent on the key design parameter.

• 한국ITS학회 논문지
• /
• 제7권2호
• /
• pp.56-61
• /
• 2008

움직이는 차량 내에서 WiBro 서비스를 사용하기 위해서는 Multi-Fading 환경에 강한 Diversity 안테나 시스템이 필수적으로 요구된다. 일반적으로 Diversity System Gain을 올리기 위해서는 안테나간의 높은 격리도를 확보해야 한다. 본 논문에서는 안테나간의 격리도를 확보하기 위하여 안테나의 편파를 직교시키는 편파 다이버시티 안테나를 제안하였다. 또한 한정된 크기의 Ground를 공유한 상태에서 안테나 간의 편파특성을 개선하기 위한 HWLLA (Half Wave Length Loaded Antenna)구조를 설계 및 측정하였다. 결과적으로 두 Diversity 안테나 간의 격리도가 HWLLA 타입을 적용했을 때 PIFA Type보다 12 dB 이상 개선되었다.

• 한국소음진동공학회:학술대회논문집
• /
• 한국소음진동공학회 2003년도 추계학술대회논문집
• /
• pp.1026-1031
• /
• 2003

A vibration isolation system fur a large reverberation chamber (1,228㎥, 1,000ton) has been installed. The reverberation chamber generates loud noise and induces high level of vibration to perform spacecraft acoustic environmental tests. The isolation system prevents vibration transfer from the chamber to enclosure buildings. This paper describes logical design process and commissioning experiments of the system. Design criteria have been induced from rigid body model of the chamber. Finite element model has been employed to select the characteristics of rubber pads. A total of 21 rubber pads have been installed between the chamber and supporting pedestals. A sand bag of 800kg was dropped on the chamber floor to measure the natural frequency of the isolation system. Absolute transmissibility has been measured while generating 145㏈ in the chamber. The natural frequency of the chamber is 10.5㎐, which is 80% of estimated value. Overall transmissibility at working frequency range (25㎐-10,000㎐) is less than -6㏈.

• 생명과학회지
• /
• 제13권2호
• /
• pp.143-149
• /
• 2003

This experiment was undertaken to investigate proper conditions for protoplast isolation and regeneration from the mycelia of Lyophyllum ulmnrium. Protoplast isolation and regeneration are influenced by a variety of factors such as enzyme, osmotic stabilizer, reaction time and age of mycelia. A combination of Novozyme 234 (10mg/ml) and cellulase Onozuka R-10 (10 mg/ml) with 0.6 M $MgSO_4$ was most effective for isolation of the protoplasts. The optimum reaction time of the mycelia with the lytic enzymes was 3.5~4 hours at $28^{\circ}C$ in shaking condition at 120 strokes per min. High yield of the protoplasts were obtained from its 4~5 days old mycelia on complete agar media. Its protoplasts were regenerated to normal hyphae. Regeneration media with 0.6 M sucrose were proper for regeneration of the protoplasts. Their regeneration frequency on complete agar media was 2.3~2.7%.

• 한국소음진동공학회논문집
• /
• 제14권11호
• /
• pp.1066-1074
• /
• 2004

A vibration isolation system for a large reverberation chamber (1,228 $m^3$ and 1,000 ton) has been installed and verified. The reverberation chamber generates loud noise and induces high level of vibration while performing spacecraft acoustic reliability tests. The isolation system prevents vibration transfer from the chamber to the enclosure buildings. This paper describes design process and commissioning experiments of the system. Design criteria have been derived from rigid body model of the chamber. The stiffness of neoprene pads has been selected by employing finite element analysis of the reverberant chamber and isolation system. A total of 21 neoprene pads have been installed between the chamber and supporting Pedestals. A sand bag of 800kg was dropped on the chamber floor to measure the natural frequency of the isolation system. While 136.9 dB noise is generated in the chamber, absolute transmissibility of the isolation system has been measured. The measured natural frequency of the chamber is 10.2Hz, which is 80% of the predicted value. Overall transmissibility at working frequency range (25∼10.000 Hz) is less than -12.4 dB.

• 한국소음진동공학회논문집
• /
• 제24권7호
• /
• pp.517-524
• /
• 2014

Micro-vibration induced by on-board equipments such as fly-wheel and cryogenic cooler with mechanical moving parts affects the image quality of high-resolution observation satellite. Micro-vibration isolation system has been widely used for enhancing the pointing performance of observation satellites. In general, the micro-vibration isolation system requires a launch locking mechanism additionally to guarantee the structural safety of mission payloads supported by the isolation system with low stiffness under launch environment. In this study, we propose a passive launch and on-orbit vibration isolation system using shape memory alloy mesh washers for the micro-vibration isolation of spaceborne compressor, which does not require the additional launch locking mechanism. The basic characteristics of the isolator were measured in static and free vibration tests of the isolator, and a simple equivalent model of the isolator was proposed. The effectiveness of the isolator design in a launch environment was demonstrated through sine vibration, random vibration and shock tests.

• Nuclear Engineering and Technology
• /
• 제50권1호
• /
• pp.170-181
• /
• 2018

Because of the design and construction requirements, the nuclear structures need to maintain the structural integrity under both design state and extreme earthquake shaking. The base-isolation technology can significantly reduce the damages of structures under extreme earthquake events, and effectively protect the safeties of structures and internal equipment. This study proposes a base-isolation design for the AP1000 nuclear shield building on considering the performance requirements of the seismic isolation systems and devices of shield building. The seismic responses of isolated and nonisolated shield buildings subjected to design basis earthquake (DBE) shaking and beyond-design basis earthquake (BDBE) shaking are analyzed, and three different strategies for controlling the displacements subjected to BDBE shaking are performed. By comparing with nonisolated shield buildings, the floor acceleration spectra of isolated shield buildings, relative displacement, and base shear force are significantly reduced in high-frequency region. The results demonstrate that the base-isolation technology is an effective approach to maintain the structural integrity which subjected to both DBE and BDBE shaking. A displacement control design for isolation layers subjected to BDBE shaking, which adopts fluid dampers for controlling the horizontal displacement of isolation layer is developed. The effectiveness of this simple method is verified through numerical analysis.

• 한국광학회:학술대회논문집
• /
• 한국광학회 2009년도 동계학술발표회 논문집
• /
• pp.541-542
• /
• 2009

We have developed an image reversal photoresist with high thermal stability and electric insulating properties for the single isolation structure of OLEDs. The thermal stability and electric insulating properties are investigated and compared with those of conventional insulator and cathode separator materials. The single isolation structure using the image reversal photoresist reduces the fabrication process steps and cuts down the manufacturing cost.