• Journal of the Korea Society for Simulation
• /
• v.25 no.2
• /
• pp.21-29
• /
• 2016

Indoor location system has been used Wi-Fi to get a location. After the development of BLE(Bluetooth Low Energy), the interest in the method of a indoor positioning had been move on. It has more advantages than using Wi-Fi. Easy installation, low power consumption, low signal interference and changeable setting(Advertising interval, tx power, etc.). These things can improve efficiency or accuracy in a indoor positioning system. For this reason, recent indoor positioning system uses BLE rather than Wi-Fi. Accordingly, error factors of BLE beacon based indoor positioning should be studying for high accuracy of indoor positioning. In this research, set up few experiment scenarios and keep a close watch on how technological, environmental factor is affecting positioning accuracy. When a application uses largest signal strength to get the indoor location, the mean error of experimental results was decreased compare to using received signal strength in real-time. The result was same when the application applied average and standard deviation to get the indoor location. Changing advertising interval had an effect on the mean error of indoor positioning. Short advertising interval makes the lower mean error than large advertising interval.

• Journal of Radiation Protection and Research
• /
• v.31 no.4
• /
• pp.165-171
• /
• 2006

In Korea, a real-time effective dose measurement system is in development. The system uses 32 high-sensitivity MOSFET dosimeters to measure radiation doses at various organ locations in an anthropomorphic physical phantom. The MOSFET dosimeters are, however, mainly made of silicon and shows some degree of energy and angular dependence especially for low energy photons. This study determines the correction factors to correct for these dependences of the MOSFET dosimeters for accurate measurement of radiation doses at organ locations in the phantom. For this, first, the dose correction factors of MOSFET dosimeters were determined for the energy spectrum in the steam generator channel of the Kori Nuclear Power Plant Unit #1 by Monte Carlo simulations. Then, the results were compared with the dose correction factors from 0.652 MeV and 1.25 MeV mono-energetic photons. The difference of the dose correction factors were found very negligible $(\leq1.5%)$, which in general shows that the dose corrections factors determined from 0.662 MeV and 1.25 MeV can be in a steam general channel head of a nuclear power plant. The measured effective dose was generally found to decrease bit $\sim7%$ when we apply the dose correction factors.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.29 no.12A
• /
• pp.1319-1332
• /
• 2004

Multicarrier direct sequence code-division multiple access CDMA(MC DS-CDMA) is an attractive technique for achieving high data rate transmission even if the potentially large peak-to-average power ratio(PAPR) is an important factor for its application. On the other hand, code select CDMA(CS-CDMA) is an attractive technique with constant amplitude transmission of multicode signal irregardless of subchannels by introducing code selection method. In this paper we propose a new multiple access scheme based on the combination of MC DS-CDMA and CS-CDMA. Proposed scheme, which we called MC CS-CDMA, includes the sutclasses of MC DS-CDMA and CS-CDMA as special cases. The performance of this system is investigated for multipath Sequency selective fading channel and maximal ratio combining with rake receiver. In addition the PAPR of proposed system is compare with that of both MC BS-CDMA and CS-CDMA. Simulation results show that proposed system improves PAPR reduction than MC DS-CDMA at the expense of the complexity of receiver and the number of available non. Also, the numerical result shows that the proposed system is better performance than MC DS-CDMA due to the increasing processing gain and the number of time diversity gain.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.46 no.5
• /
• pp.26-35
• /
• 2009

OFDM (Orthogonal Frequency Division Multiplexing) system is robust to frequency selective fading and narrowband interference in high-speed data communications. However, an OFDM signal consists of a number of independently modulated subcarriers and the superposition of these subcarriers causes a problem that can give a large PAPR(Peak-to-Average Power Ratio). Phase rotation method can reduce the PAPR without nonlinear distortion by multiplying phase weighting factors. But computational complexity of searching phase weighting factors is increased exponentially with the number of subblocks and considered phase factor. Therefore, a new method, which can reduce computational complexity and detect phase weighting factors efficiently, should be developed. In this paper, a modeling process is introduced, which apply metaheuristic algerian in phase rotation method and optimize in PTS (Particle Swarm Optimization) scheme. Proposed algorithm can solve the computational complexity and guarantee to reduce PAPR We analyzed the efficiency of the PAPR reduction through a simulation when we applied the proposed method to telecommunication systems.

• Journal of the Ergonomics Society of Korea
• /
• v.32 no.1
• /
• pp.117-124
• /
• 2013

Objective: This paper presents additional considerations related to organization and safety culture extracted from recent human error incidents in Korea, such as station blackout(i.e., SBO) in Kori#1. Background: Safety culture has been already highlighted as a major cause of human errors after 1986 Chernobyl accident. After Fukushima accident in Japan, the public acceptance for nuclear energy has taken its toll. Organizational characteristics and culture became elucidated as a major contributor again. Therefore many nuclear countries are re-evaluating their safety culture, and discussing any preparedness and its improvement. On top of that, there was an SBO in 2012 in the Kori#1. Korean public feels frustrated due to the similar human errors causing to a catastrophe like Fukushima accident. Method: This paper reassesses Japan's incidents, and revisits Korea's recent incidents. It focuses on the analysis of the hazards rather than the causes of human errors, the derivation of countermeasures, and their implementation. The preceding incidents and conclusions from Japanese experience are also re-analyzed. The Fukushima accident was an SBO due to the natural disaster such as earthquakes and a successive tsunami. Unlike the Fukushima accident, the Kori#1 incident itself was simple and restored without any loss and radioactive release. However, the fact that the incident was deliberately concealed led to massive distrust. Moreover, the continued violation of rules and organized concealment of the accident are serious signs of a new distorted type of human errors, blatantly revealing the cultural and fundamental weakness of the current organization. Result: We should learn from Japanese experiences who had taken pride in its safety technology and fairly high confidence in safety culture. Japan's first criticality accident in JCO facility splashed cold water on that confidence. It has turned out to be a typical case revealing the problems in the organization and safety culture. Since Japan has failed to gain lessons and countermeasure, the issue persists to the Fukushima incident. Conclusion: Safety culture is not a specific independent element, which makes it difficult to either evaluate it properly or establish countermeasures from the lessons. It may continue to expose similar human errors such as concealment of incident and manipulation of bad data. Application: Not only will this work establish the course of research for organization and safety culture, but this work will also contribute to the revitalization of Korea's nuclear industry from the disappointment after the export contract to UAE.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.23 no.6
• /
• pp.682-690
• /
• 2012

In this paper, a highly linear self oscillating mixers(SOM) using second harmonic injections are presented. The H-slot defected ground structure(DGS) is designed as a balanced resonator for oscillation in the proposed SOM. Since the H-slot DGS resonator achieves a high Q factor, it is a suitable structure to provide low phase noise for the oscillator. The single balanced mixer is utilized in this work and it provides good LO-RF isolation since balanced LO signals are suppressed at the RF input port. In order to inject the second harmonic of the IF, we propose two different methods using feedback loops. In the first method, IF achieves a 3.08 dB conversion gain at 226 MHz with input power of -20 dBm at 5 GHz RF input signal. The IF achieves 2 dB conversion gain at 423 MHz with the input power of -20 dBm at 5.2 GHz RF input signal in the second method. The measured IMD3s are 61.8 dB and 65 dB for the each method. These SOMs present improved linearity compared to that without the second harmonic injection because IMD3s are improved by 18. dB and 21 dB for each method.

• Applied Chemistry for Engineering
• /
• v.29 no.5
• /
• pp.503-509
• /
• 2018

In this study, we used the ultrasonic extraction process as a method to extract antioxidant substances from kudzu, and measured the content of iso-flavonoids puerarin, daidzein, daidzin contained in kudzu. The response surface methodology which is a statistical analysis method for optimizing the extraction amount of iso-flavonoids from the kudzu and the process condition for maximizing the yield was applied. It is the final objective of this study to effectively derive the condition of the process that matches the target response with a minimum number of experiments and analyze the effect of each process condition on the response. In the response surface methodology, the central composite design was applied and the optimum condition was analyzed, and the three independent variables were set to ultrasonic irradiation time, volume ratio of ethanol/ultrapure water, ultrasonic irradiation power. Using the response surface methodology, the optimum conditions with the maximum extraction yield and the content of iso-flavonoids were evaluated as ultrasonic irradiation time (24.75 min), ethanol / ultrapure water volume ratio (39.75 vol%), ultrasonic irradiation power (592.36 W). The overall satisfaction level appears as high as 0.8938, which is recognized at a significance level within 5%. As a result of analyzing the optimization process, it was confirmed that the ultrasonic irradiation time is the factor that most affects the responses.

• Journal of the Economic Geographical Society of Korea
• /
• v.16 no.3
• /
• pp.423-444
• /
• 2013

Tourism in Thoi Son Islet has been the advanced model for rural tourism in the Mekong Delta region since the 1990s. The continuously rising number of tourists, however, has also created problems that affect sustainable rural development. To understand these problems, this research analyzed how rural tourism has been operated through the methodology of a stakeholder network. After investigating the network among key stakeholders (Ho Chi Minh travel agencies (HCMTAs), local travel agencies (LTAs), and local residents, the result showed that in the current model, HCMTAs and LTAs have played the role of connectors, working as hubs to shift tourists (demand) to match local residents (supply), with the networking being dominated by signed contracts (formal networks). The networks between LTAs and local residents are both formal and informal. Inter- and intra-networks among local residents are dominated by informal networks of established working relationships based on networks of family, friends, and neighbors. Moreover, this research has found that there is no cooperating network among LTAs. Among owners of tourist sites was not also found cooperating network. The primary motivating factor for these stakeholders is price competition; this has led to a disproportionately small share of revenue for local stakeholders, with most tourism revenue going to HCMTAs. Additionally, because of the high competition among local stakeholders, this results in local stakeholders having little or no negotiating power when conducting business with HCMTAs. Meanwhile the Tien Giang Tourism Association is inefficient in fostering cooperation among local stakeholders to increase their negotiating power.

• Journal of Wetlands Research
• /
• v.19 no.1
• /
• pp.90-102
• /
• 2017

In this study, various types of nutrient models were tested by using two tears's water quality data collected from the stormwater wetland in Korea. Based on results, most important factor influencing nitrogen removal was hydraulic loading rate, which indicates that surface area of wetland is more important than its volumetric capacity, and model proposed by WEF was found to give a least error between measured and calculated values. For the phosphorus, in case assuming a power relationship between rate constant and temperature, the best prediction result were obtained, but temperature was most sensitive parameter affecting phosphorus removal. In addition, denitrification was always a limiting step for the nitrogen removal in this particular wetland mostly due to the lack of carbon source and high dissolved oxygen concentration. In this paper, several alternatives to improve nitrogen removal, including proper arrangement and designation of wetland elements and use of floating plants or synthetic fiber mat to control oxygen level and to capture the algal particles were proposed and discussed.

• The KIPS Transactions:PartD
• /
• v.13D no.4 s.107
• /
• pp.557-564
• /
• 2006

Information is used effectively and contributes in profit creation and not only support management judgment quick but important resource to be possible recycled. The recent information systems improve enterprise's competitive power by reflection of user's various requirements and becoming big and complex for adaptation of rapidly circumstance change. Also it is trend that importance of information quality is emphasized gradually. The biggest problem in user requirement that is based on low quality data support. In case of business management is achieved by low quality information, company can not help dropping their competitive power such as company's strategy establishment, strategy achievement and management concentration breakup against competitor. Information of low quality increase time and expense to improve inaccurate data or revise and it is hard to accept correct information from specific situation. To solve these problems, we have to gain high quality data through definite comprehension, data management system establishment, and systematic data management achievement etc. Up to now, information quality and connected study were developed partially, but systematic methodology of information quality management's whole condition was not existed. Therefore, in this paper can show you how to extract process for information quality management & related evaluate factor with CMM (Capacity Maturity Mode]) 5 steps that is information warranty of quality process step. This paper whishes to contributes in competitive company or organization activity through information quality improvement management process.