• Food Science and Preservation
• /
• v.4 no.2
• /
• pp.101-113
• /
• 1997

Temperature, relative humidity and ventilation are closely related one another, and they are the main factors to be controlled for the environmental control system of a storage facility. Conventional environmental control systems do not consider the interrelationship between temperature, relative humidity and ventilation, which results in low performance and high energy consumption. To overcome the inefficiency of the conventional ones, it was developed an on-off control system based on the interrelationship between the factors. The usefulness of the system was illustrated with the results produced by a set of experiments in a real world.

• 보존과학연구
• /
• s.21
• /
• pp.145-175
• /
• 2000

To examine the method for preservation of papers, 9 kinds of papers were purchased and pretreated for 6 months with various artificial conditions which were controlled as 3 temperature classes($20^{\circ}C$, $80^{\circ}C$, $-20^{\circ}C$&$20^{\circ}C$) and 4 humidity classes(40%, 60%, 80%, 100%).Whiteness, acidity and folding endurance were measured to examine the state of papers pretreated under each condition. From the resultexamining the state, all the papers were best condition at low temperature($20^{\circ}C$) and low humidity(40%) and damaged at high temperature($80^{\circ}C$) and high humidity(100%).The values of whiteness, acidity, and folding endurance were measure din relation with deterioration of papers. According to damage of papers caused by the chemical agent, papers became to be acidic, increased color difference and reduced the force of folding endurance. The effect of change of temperature($-20^{\circ}C$&$20^{\circ}C$) on degradation of papers was not well acquired. Because the period of investigation was not long enough to acquire the data. So the more studies are needed to find the cause of damage of papers.

• Tribology and Lubricants
• /
• v.9 no.2
• /
• pp.63-69
• /
• 1993

The wear properties of two types of $Si_3N_4$(silicon nitride) exposed to high and low humidity were examined experimentally for various sliding speed. Bearing steel was used as the disk material at pin-on-disk type sliding. Wear rates of pressureless sintered-plus-hot-isostatic pressed Si3N4 were slightly lower than those of pressureless sintered $Si_3N_4$. It was observed that adsorbed moisture and sliding speed markedly influenced the wear properties of $Si_3N_4$. The highest wear rate was obtained under the high humidity and low sliding speed condition. As the sliding speed was increased, wear rates were decreased and the humidity effect on the wear rates of $Si_3N_4$ was lowered. The result that the $Si_3N_4$ pin showed a high wear rate under the high humidity condition was explained by the property change due to the adsorbed moisture, plowing action by the hard particles of $Fe_2O_3$ from the disk, and the corrosion effect at $Si_3N_4$ surface. Increase in sliding speed was supposed to have reduced the humidity effect on wear rate of $Si_3N_4$ by raising the temperature of both the bearing steel disk and $Si_3N_4$ pin specimen.

• KIEAE Journal
• /
• v.12 no.6
• /
• pp.93-98
• /
• 2012

The concerns on high ozone concentration phenomenon is significantly growing in Seoul metropolitan area including the industry complex area, like Shiwha Banwol area. The aims of this research is the analysis of relationship between high concentrations of $O_3$ and solar radiation parameters in atmosphere. The understanding of the effects of solar radiation intensity, humidity, high air temperature on ozone concentration in a day is very useful to provide a direction for reducing of the high ozone concentration to a local government or a metropolitan government. The correlation analysis between maximum ozone concentration and various meteorological parameters in 2009 - 2011 carried out using IBM's SPSS program. The results showed that the mean correlations coefficient (R) between daily Ozone maximum and solar radiation resulted R = 0.64 during 2011. May - September in 10 air pollution stations. In case of correlations between daily ozone maximum and relative humidity showed negative correlation R = -0.61. The correlation analysis with mean air temperature during 1-3 PM resulted R = 0.29. This low correlation coefficient could be corrected by using of categorized data of ozone concentration. The daily maximum ozone concentration is more dependent on peak solar radiation and high air temperature during 1-3 PM than its simple daily maximum values. The results of this research would be used to develop the high ozone alert system around Seoul metropolitan area. This correlation analysis could be partially integrated to prediction of ozone peak concentration in connection with other methods like classification and regression tree(CART).

• Proceedings of the Korea Concrete Institute Conference
• /
• 2003.05a
• /
• pp.65-68
• /
• 2003

This study is intended to look into the influence of environment and construction factor on bleeding of concrete. According to the results, as wind is light, relative humidity is high and temperature is low, the amount of bleeding increases greatly, and evaporation speed is influenced greatly by order of wind, temperature and humidity. As the properties of bleeding by construction factor, the amount of bleeding increases with an increase of placing thickness, but the bleeding ratio, the amount of bleeding per unit volume, increases with a decrease of the placing thickness. Bleeding speed is fastest at about 90 minute after placing concrete. Also, as wind is light, relative humidity is high, temperature is low and the placing thickness is thick, bleeding speed grow faster.

• Journal of the Korea Institute of Military Science and Technology
• /
• v.9 no.1 s.24
• /
• pp.13-23
• /
• 2006

A propellant mainly consisting of nitric ester including nitrocellulose and nitroglycerine is characteristic of being decomposed naturally. And this phenomenon is known as being affected mostly by its storing temperature and humidity. In this research, the effect of storing temperature and humidity on self life has been studied by measuring the contained quantity of residual stabilizer of propellant KM30Al, which are parts of 155MM propelling charge K676 and K677; the method for the measurement is acceleration aging test, and decomposition reaction equation, Eyring Equation and Berthlot Equation were used for the calculation. As result of this study, it was found that the storing temperature influenced seven times as large as the storing humidity upon the self life of the propellant KM30Al, Furthermore, especially in the high temperature region, the storing temperature had a dominant effect on the self life.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.10 no.4
• /
• pp.433-439
• /
• 2015

Enclosures for CCTV internal short circuit are prevented due to wetting to maintain a constant humidity and temperature, to avoid condensation due to temperature difference, a constant temperature and humidity requirements of the equipment, such as high-temperature resistant and a constant temperature of the structure, degree of energy utilization is optimized for developing this corresponding housing automatic control system and humidity is required. Device being an expensive imaging equipment in side of the enclosure according to the temperature conversion from a hazard protection, there is a need for a constant temperature and humidity control apparatus that can prevent a short-circuit failure. This is a system in which the accessory device is absolutely required for the storage and transmission of an image in recording reliability and field conditions.

• Journal of Ginseng Research
• /
• v.6 no.1
• /
• pp.84-99
• /
• 1982

Water content and its seasonal change in reprodltctive organs were reviewed in relation to cultivation practice s. Precipitati on and humidity under shade roof were reviewed in relation to shading ,jystem and environmental factors. High water content of reproductive organs suggests vulnerability to water stress during reproductive growth stage. Watering during dehisconce treat menu seems to keep optimum temperature but cnoventional practice seems to be too often In watering. Information effe on water physiology of seeds is too rare to develop seed storing method and ctive seed use. Dehiscent mechanism was considered in terms of water absorption of embryo. Precipitation rate of conventional shade roof reaclled to 38% and at line level 50% and varied with shade patterns. Precipitation rate under shade has been investigated for itself but should be investigated in relation to light intensity and soil moisture content Relative humidity under shade depends mainly on air humidity and soil moisture, considerably on shade materials and lithe on pole height, bed width or plant density. Since relative humidity was lower in afternoon it was often less than 50% even in summer with high temperature suggesting possible disorder of phi biological function especially in photosynthesis. More information was needed on optimum humidity for productive physiological function of leaf.

• Polymer(Korea)
• /
• v.33 no.1
• /
• pp.19-25
• /
• 2009

New polyelectrolytes derived from ionene-containing photocurable reactive oligomer (PIDM) were prepared for water-resistant humidity-sensitive membranes. The mixture of PIDM, hexamethylene dimethacrylate (HDM), pentaerythritol triacrylate dimer (SP1013), and photoinitiator was simultaneously coated on the sensor electrode with photoinitiated radical polymerization. The pretreatment of the substrates with vinyl-type silane-coupling reagent was performed for improving the water durability and stability of the sensors at high temperature and humidity. When the resistance dependences on the relative humidity of the crosslinked PIDMs were measured, it was found that the resistance varied three orders of magnitude between 20 and 90%RH, which was required for the humidity sensor operating at ambient humidity. Their hysteresis, temperature dependence, response time, water durability, and high temperature/humidity stabilities were measured and evaluated as a humidity-sensing membrane.

• KOREAN JOURNAL OF CROP SCIENCE
• /
• v.45 no.5
• /
• pp.300-304
• /
• 2000

Tuberous roots of yacon (Polymnia sonchifolia Poeppig ＆ Endlicher) were stored in different temperature and relative humidity conditions after curing for 30 days. Non-decadent percentage, moisture contents, brix degree and sugars were investigated. Whether temperature and relative humidity were high or not, most of the tuberous root decayed during storage, and the decayed percentage was increased as long as the storage period. In final, only 13% of tuberous roots remain intact at 4$^{\circ}C$, 85% relative humidity condition to be appeared best storage condition in this experiment and all of the tuberous root decayed in other storage conditions after 6 months. Moisture contents decreased a little in the high relative humidity. Even though tuberous roots decayed when stored at 1$0^{\circ}C$ and 2$0^{\circ}C$, most of brix degree reached about 17.0. Fructose, glucose and sucrose contents were 1.65, 1.15 and 0.35% at early storage period, and 1.6, 1.1 and 0.5% after 6 months at 4$^{\circ}C$, 85% relative humidity, respectively. In 3 temperature conditions, fructose and glucose increased for a month and then decreased successively afterwards, but sucrose increased gradually during 6 months. Also in 4 relative humidity conditions, fructose, glucose and sucrose contents were changed with similar to that of in temperature. Changes of fructose and glucose were the same except on 4$^{\circ}C$, 85% relative humidity, that was lower level than moisture of tuberous root.