• Journal of Korean Society for Atmospheric Environment
• /
• 제21권E2호
• /
• pp.41-48
• /
• 2005

A novel hybrid system composed of a biotrickling filter and an activated sludge reactor was investigated under the conditions of four different SRTs (sludge retention times). The performance of the hybrid reactor was found to be directly comparable among the four different sludge ages. Discernible differences in the removal performance were observed among four different SRTs of 2, 4, 6, and 8 days. High removal efficiency was achieved by continuous circulation of activated sludge over the immobilized mixture culture, which allowed on pH control, addition of nutrients, and removal of paint VOCs (volatile organic compounds). The results also showed that the removal efficiency for a given pollutant depends on the activity of microorganisms based on the SRT. As the SRT increased gradually from 2 to 8 days, the average removal performance decreased. The highest removal rate was achieved at the SRT of 2 days at which the highest OUR (oxygen uptake rate), $6.1mg-O_2/liter-min$ was measured. Biological activity in the recycle microbes decreased to a much lower level, $3.6mg-O_2/liter-min$ at a SRT of 8 days. It is thus believed that young microorganisms were more active and more efficient for the VOCs removal of low concentrations and high flow rates. The apparent correlation of $R^2=0.996$ between the average removal efficiency and the average OUR at each SRTs suggests that VOCs degradation by young cells significantly affected the overall removal efficiency for the tested SRTs.

• 한국환경과학회지
• /
• 제17권12호
• /
• pp.1343-1351
• /
• 2008

The activated sludge obtained from wastewater coke oven plant was immobilized by entrapment with polyethylene glycol (PEG). The effects of several factors on the biodegradation of $CN^-$ from. synthetic wastewater were investigated using batch and continuous reactors. The degradation rate of $CN^-$ increased with increasing of the immobilized bead volume in the reactor. Approximately 7.65mg/L of $NH_4-N$ was produced upon the degradation of 35mg/L of $CN^-$. When high concentrations of the toxic cyanide complex were used in the testing of cyanide degradation, the free activated sludge could be inhibited more than that of the immobilized activated sludge. When the phenol concentration was higher than 400mg/L in the synthetic wastewater, approximately 98.4% of $CN^-$ was removed within 42 hours by the immobilized activated sludge. However, the cyanide was not completely degraded by the tree activated sludge. This indicates that high phenol concentrations can act as a toxic factor for the free activated sludge. A $CN^-$ concentration of less than 1mg/L was achieved by the immobilized sludge at the loading rate of 0.025kg $CN^-/m^3-d$. Moreover, it was found that the HRT should be kept for 48 hours in order to obtain stable treatment conditions.

• 기술사
• /
• 제18권3호
• /
• pp.28-35
• /
• 1985

As the paper industry consumes much water in process and discharge wastewater containing suspended solid and COD(chemical oxygen demand), relevant law against this discharge has been set up to limit the total containment of COD in discharge. This study has been carried out to improve the treatment method for the soluble COD in wastewater produced during the process of paste-board production, which is made of semichemical pulp and waste paper. Applicated methods are, O$_2$AS : O$_2$ activated sludge process DAS : Deep well activated sludge process SAS : standard activated sludge process and proper combination of DAS and SAS 1) As a result of this experiment, we get the following conclusion between in COD sludge loading "X" and COD removable rate in the process of treating waste-water. COD removable rate(％)=(0.778+0.0146/X)${\times}$100(％)……(7) 2) In case that the COD sludge loading is high, it has been cleared out that the COD removable rate shall become low due to unknown unsoluble substances contained in the process. Meanwhile, to increase the efficiency rate of treatment, it is thought to be necessary, to provide long-time contacts with activated sludge. 3) Once the COD of original waste-water and the target COD of treated water are decided, COD sludge loading is obtained from equation(7), and capacity of aeration tank in the effective systems such as O$_2$AS, DAS, to bet the required COD removable rate can be decided. Therefore the choice among SAS, O$_2$AS, DAS methods is made in consideration of required COD removable rate and allowable installation area. 4) In the sedimentation tank with sludge bulking, it is possible to increase the COD removable rate by 3～7％ but still there exist many obstacles to manage this operation.

• 상하수도학회지
• /
• 제21권3호
• /
• pp.279-285
• /
• 2007

Toxicity evaluations using oxygen uptake rate (OUR) on activated sludge process were investigated. On toxicity evaluations of heavy metals, all toxicants in experiments decreased OUR with respect to the concentrations of the toxicants, while high toxicities with cyanide and mercury were observed respectively. On toxicity evaluations of composite heavy metals, composite toxicities had similar results as to the total sum of each toxicants that presents accurate toxicity evaluation using OUR. From these results, it is concluded that activated sludge is effective indicator for toxicity evaluation on wastewater of biological treatment plants.

• Environmental Sciences Bulletin of The Korean Environmental Sciences Society
• /
• 제3권3호
• /
• pp.169-175
• /
• 1999

2,4-Dinitrophenol(DNP) is a metabolic uncoupler that prevents cells from creating energy for growth and it has been suggested that the availability of sodium ions may be important in mitigating the effects of uncouplers. Accordingly, the degradation of DNP was investigated using activated sludge which had been adapted to mineralize DNP. After the acclimation of the activated sludge, the effect of sodium ions on the toxicity of high concentrations(80 to 100mg/L) of DNP was investigated over a sodium ion concentration range of 9.3$\times$10-5 to 94mM. The concentration of sodium ions in the activated sludge mixed liquor seemed to have little effect on the DNP toxicity. However, a lack of sodium in the grwoth media resulted in a reduction of the DNP degradation rate by a bacterial isolate from the activated sludge culture identified as Nocardia asteroides.

• 상하수도학회지
• /
• 제14권1호
• /
• pp.117-126
• /
• 2000

Solubilization pretreatments were conducted to enhance the anaerobic digestion of the waste activated sludge. Four pretreatment techniques including heating, sonication freezing and thawing, and enzyme addition were employed to solubilize the waste activated sludge under various conditions. Thermal pretreatment by heating showed the highest efficiency compared with other methods, and freezing and thawing was confirmed as a feasible alternative of solubilization as well as the pretreatment of dewatering. There is a clear correlation between the solubilization efficiency of the waste activated sludge and the gas production. Batch digestion results showed the cumulative gas production as much as four times after thermal pretreatment as compared with that by the control sludge without pretreatment. As a result, hydrolysis or solubilization pretreatment might play a significant role in the high rate digestion of the waste activated sludge.

• 한국환경과학회지
• /
• 제4권3호
• /
• pp.259-267
• /
• 1995

This study was conducted to evaluate the effects of pressure and dissolved oxygen concentration on the activated slut비e and to determine the optimum depth of deep shaft process. Some results from this study were summarized as follows. 1. It is considered that low sludge product in the activated sludge system maintaining high dissolved oxygen concentration is attributed to the increase of endogeneous respiration rate caused by the increase of aerobic zone in the sludge floe. 2. The increase of dissolved oxygen concentration does not affect to the increase of organic removal efficiency greatly and therefore the limiting factor is the substrate transfer into the inner part of floe. 3. The yield coefficient, Y is decreased in proportion to the increase of oxygen concentration. In this study, Y values arre ranged from 0.70 to 0.41 according to the variation of dissolved oxygen concentration from 18.0mg/$\ell$ to 258 mg/$\ell$. 4. The optimum depth of deep shaft process should be determined within the limits of non-toxicity to the microorganism and it is about loom in this study.

• 상하수도학회지
• /
• 제10권2호
• /
• pp.104-116
• /
• 1996

Anaerobic digestion is generally used for the treatment of volatile organic solids such as manure and sludge from waste water treatment plants. However, the reaction rate of anaerobic process is slow, and thus it requires a large reactor volume. To minimize such a disadvantage, physical and chemical pre-treatment is generally considered. Another method to reduce the reactor size is to adopt different reactor system other than CSTR. In this paper, the effects of heat pre-treatment and reactor configurations on the anaerobic treatability of volatile solids was studied. Carrot, kale, primary sludge, and waste activated sludge was chosen as the test materials, and the BMP method was used to evaluate the maximum methane production and first order rate constants from each sample. After the heat treatment at $130^{\circ}C$ for 30min., the measured increase in SCOD per gram VS was up to 394 mg/L for the waste activated sludge. However, the methane production potential per gram VS was increased for only primary and waste activated sludge by 17-23%, remaining the same for carrot and kale. The overall methane production process for the tested solids can be described by first order reactions. The increased in reaction constant after heat pre-treatment was also more significant for the primary and waste activated sludge than that for carrot and kale. therefore, the heat pre-treatment appeared to be effective for the solids with high protein contents rather than for the solids with high carbohydrate contents. Among the four reactor systems studied, CSTR, PFR, CSTR followed by PFR, and PFR with recycle, CSTR followed by PFR appeared to be the best choice considering methane conversion rate and the operational stability.

• 한국환경과학회지
• /
• 제19권9호
• /
• pp.1119-1127
• /
• 2010

The behavior of copper throughout the whole process of wastewater treatment plant that uses the activated sludge process to treat the wastewater of petrochemical industry that contains low concentration of copper was investigated. Total inflow rate of wastewater that flows into the aeration tank was $697\;m^3$/day with 0.369 mg/L of copper concentration, that is, total copper influx was 257.2 g/day. The ranges of copper concentrations of the influent to the aeration tank and effluent from the one were 0.315 ~ 0.398 mg/L and 0.159 ~ 0.192 mg/L, respectively. The average removal rate of copper in the aeration tank was 50.8 %. The bioconcentration factor (BCF) of copper by microbes in the aeration tank was 3,320. The accumulated removal rate of copper throughout the activated sludge process was 71.3%, showing a high removal ratio by physical and chemical reactions in addition to biosorption by microbes. The concentration of copper in the solid dehydrated by filter press ranged from 74.8 mg/kg to 77.2 mg/kg and the concentration of copper by elution test of waste was 2.690 ~ 2.920 mg/L. It was judged that the copper concentration in dehydrated solid by bioconcentration could be managed with the control of that in the influent.

• KSBB Journal
• /
• 제16권2호
• /
• pp.133-139
• /
• 2001

질소를 포함한 난분해성 오염불칠을 다량 함유한 축산폐수 (양돈폐수)의 오염물질을 효과적으로 처려를 위해서 생물학적 인 처리방안으로 활성슬러지 공정 및 입상활성란이 채워친 BACC 담제를 이용한 생물반응가에서의 유기물질 및 질소의 제거능에 때하여 조사하였다. 축산폐수를 일반 활성슬러지 공정으로 처려 할 경우 유압수를 희석하여 BOD 유입농도 약 600 mgfL의 폐수를 처리할 때 유출수의 BOD를 100 mgfL 이하로 유지하고자 할 경우 체류시간올 8일 이상 운전 해야하는 것으로 나타났다. 그러나 BACC 생물반응기에서 축산폐수를 처리할 때 체류시간이 200 시간일 때 유출수획 BOD, $COD_{Cr} $, TKN의 농도는 각각 94, 75, 64.3%의 제거효율을 나타내었다. BACC 생물반응기와 활성슬러지 공정을 비교 할 때 용적부하 0.3일 때 BOD 비기질제거속도가 활성슬러지 공정에서는 0.14 gBOD removedf L.day이고 BACC 생물반응기는 0.27 gBOD removed/L.day로서 통일부하에서 높은 제거효율을, 고부하에서도 안정된 제거효율을 나타내고 있기 때문에 BACC 생물반응기가 부하변통 및 고부하의 폐수처리에서 활성슬러지 공정보다 우수한 것으로 평가되었다.