• 한국조명전기설비학회:학술대회논문집
• /
• 한국조명전기설비학회 2008년도 춘계학술대회 논문집
• /
• pp.37-40
• /
• 2008

This paper presents the results of a simulation to analyze the effects of voltage sag on high-pressure discharge lamp(400[W]). In this paper, voltage sag is considered a reduction between 0 and 0.9[p.u] in nominal voltage magnitude, with duration between 0.01 and 90cycle. The simulation results depict the characteristics of the lamp about operating limits during voltage sag by the magnitude and duration of sag in CBEMA curve.

• 한국조명전기설비학회:학술대회논문집
• /
• 한국조명전기설비학회 1992년도 추계학술발표회논문집
• /
• pp.11-15
• /
• 1992

Currently-using low-pressure lamps are usually drivel by the AC power supply. There are good and bad points according to high or low frequency in AC power driving type. For the low-pressure lamps, its efficiency increases and flicker decreases when it ignites at high frequency. So we already use the high-frequency electronic ballast of the low-pressure discharge lamps broadly. But there are EMI interference in high-frequency driving type because of giving the fluorescent lamp the high- frequency current. So recently, we have a tendency to compensate for that defects by DC driving method. As follows, we suggest pseudo DC discharging electronic bar lasts for fluorescent lamps which have the characteristics of high efficiency and no flicker by driving constant current boosted square wave.

• 생물환경조절학회지
• /
• 제22권4호
• /
• pp.400-407
• /
• 2013

본 연구는 식물공장용으로 방전램프로서 메탈할라이드램프(MH), 고압나트륨램프(HPS), 제논램프(XE)를 사용하고, 냉백색형광등(FL)을 대조구로 사용한 가운데 상추(Lactuca sativa L. cv. Jeokchima)의 생육 및 파이토케미컬의 특성을 분석하고자 수행되었다. 식물공장 내부의 환경조건은 광주기 16/8h, 광합성유효광양자속(photosynthetic photon flux, PPF) $200{\mu}mol{\cdot}m^{-2}{\cdot}s^{-1}$, 기온 $22/18^{\circ}C$, 습도 70%, $CO_2$ 농도 $400{\mu}mol{\cdot}mol^{-1}$로 조절하였다. 각 램프의 분광 특성을 이용하여 PPF에 대한 청색광 영역(400~500nm), 녹색광 영역(500~600nm), 적색광 영역(600~700nm)의 비율을 계산하였다. MH램프의 청색광 영역은 23.0%로서 다른 처리구에 비해서 가장 높게 나타났다. 한편 HPS램프의 청색광 영역은 4.7%로서 가장 낮게 나타났으나, 적색광 영역은 38.0%로서 다른 처리구에 비해서 높게 나타났다. 정식 후 11일째와 21일째에 측정된 상추의 엽장, 엽폭, 엽면적, 지상부 생체중 및 건물중은 방전램프의 광질에 따른 유의차가 나타날 정도로 다르게 나타났다. HPS 처리구의 엽면적은 $143,486mm^2$로서 대조구의 $98,474mm^2$에 비해서 45.7% 크게 나타났으며, MH와 XE 처리구는 대조구에 비해서 각각 16.3%, 9.5%로 크게 나타났다. 이러한 결과는 지상부 생체중에서도 유사하게 나타났다. 적색광 영역의 비율이 높은 HPS 처리구에서는 상추의 잎 관련 생장 특성에서 최대치가 나타났으나, 청색광 영역의 비율이 높은 MH와 XE 처리구에서는 낮게 나타났다. 방전등 처리구에 따라 상추 잎에 축적된 아스코르빈산 함량은 대조구에 비해서 작게 나타났으며, 처리구 사이에 유의차가 인정되지 않았다. 상추 잎의 안토시아닌 함량은 MH 처리구에서 0.70mg/100g으로 최대치가 나타났으며, XE와 HPS 처리구는 대조구의 0.58mg/100g에 비해서 각각 79.3%, 8.6%수준이었다. 결과적으로 방전램프의 종류에 따라 상추의 생장 특성, 아스코르빈산 및 안토시아닌 함량이 다르게 나타났다. 따라서 식물공장용 인공광원으로서 방전램프를 효율적으로 활용하면서, 상추의 생장 및 파이토케미컬 함량을 증진시키기 위해서는 분광 특성이 상이한 방전램프의 병용 또는 단색광 LED의 추가 설치 등과 같은 방전램프의 광질 개선이 요구된다.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1999년도 하계학술대회 논문집 E
• /
• pp.2426-2427
• /
• 1999

This study is the result of determination and analysis to draw out six schools in order to research into the lighting properties of the school Almost schools are supported and used large area by a high brightness lamp, for example high pressure mercury discharge lamp etc. The gymnasium of A, B, E schools have a good capacity of the illuminance.

• 조명전기설비학회논문지
• /
• 제27권3호
• /
• pp.16-25
• /
• 2013

Now it's a trend to install a series of white fluorescent light and orange high pressure sodium lamps because tunnel lighting should be opaque to the safety of drivers from soot, dust, humidity, and fog. Also fluorescent lighting is replaced to LED due to the fact that it improves amenity and object recognition and LED lighting has gradually been improved its nature. In this paper, we have implemented the circuits of the yellow series of high-pressure sodium lamps and white series of LED lights at one board to improve the transparency and recognition of objects. It is possible for inductive high-pressure sodium lamps and the capacitive LED drivers to circuit without power factor compensation. Two circuit parts share only a small number of parts, so low cost LED drivers compared to conventional ones are possible. Therefore, the implementation of the hybrid lighting with high-pressure sodium lamps and LED lights that can be driven at the same time by one driving circuit is possible. The LED capacitive power factor was 0.91 while individually implemented the sodium lamp power factor was 0.98. It shows not only the 2% improvement of hybrid forms but also the efficiency and THD.

• 한국조명전기설비학회:학술대회논문집
• /
• 한국조명전기설비학회 2003년도 학술대회논문집
• /
• pp.185-190
• /
• 2003

The most shortcoming of metalhalide lamps is what the instant restarting cannot be realized when the arc tube is in the hot condition. The discharge starting voltage of arc tube in the hot condition is much higher than in the cold condition. Therefore it takes about five minutes to restart the metalhalide lamps, that is to say, it is possible to start when the pressure and the temperature are decreased. But, if the lamp is restarted in the hot condition, we must supply the high voltage pulse with 20kV at the both sides of lamp. The proposed electronic ballast is consist of a electromagnetic interference (EMI) filter, a power factor correction (PFC) circuit, a flyback converter, a half-bridge inverter, and a high voltage igniter circuit. By this composition we can restart the lamp with the voltage 20kV, even if the lamp is in the hot condition.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2000년도 전력전자학술대회 논문집
• /
• pp.74-77
• /
• 2000

Today there is an ever increasing effort to control high-pressure discharge lamps with electronic ballast. HID lamps can be ignited by high-voltage pulses and need an ignitor to start them. An ignitor gives high-voltage pulses to HID lamps which have the type of the arc discharge. Three kinds of ignitor circuits have been analyzed by the P-spice program and we have shown experimental results in this paper. The result of this study seems to be able to help to develope various ignitors.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2005년도 춘계학술대회 논문집
• /
• pp.15-18
• /
• 2005

As a display becomes large recently, Acquisition of high luminance and Luminance uniformity is becoming difficult in the existing CCFL or EEFL backlight system. So, study for a performance enhancement has enforced. but lamp development of flat type is asked for high luminance and a luminance uniformity security in of LCD and area anger trend ultimately. In this paper, we changed a tip shape of an electrode for production by the most suitable LCD backlight surface light source, and confirmed discharge characteristic along discharge gas pressure and voltage, and confirmed electric field distribution and discharge energy characteristic through a Maxwell 2D simulation. Therefore the discharge firing voltage characteristic showed a low characteristic than a rectangular type and round type in case of electrode which used tip of a triangle type, and displayed a discharge electric current as a same voltage was low.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2006년도 추계학술대회 논문집 광주전남지부
• /
• pp.35-38
• /
• 2006

As a display becomes large recently, Acquisition of high luminance and Luminance uniformity is becoming difficult in the existing CCFL or EEFL backlight system. So, study for a performance enhancement has enforced. but lamp development of flat type is asked for high luminance and a luminance uniformity security in of LCD and area anger trend ultimately. In this paper, we changed a tip shape of an electrode for production by the most suitable LCD backlight surface light source, and confirmed discharge characteristic along discharge gas pressure and voltage, and confirmed electric field distribution and discharge energy characteristic through a Maxwell 2D simulation. Therefore the discharge firing voltage characteristic showed a low characteristic than a rectangular type and round type in case of electrode which used tip of a triangle type, and displayed a discharge electric current as a same voltage was low.

• 분석과학
• /
• 제6권3호
• /
• pp.297-305
• /
• 1993

글로우 방전 방출원을 다색화장치에 연결시켜 개발된 글로우방전/방출분광법으로 탄소의 농도가 수 퍼센트에 이르러 스파크방출분광법으로서는 분석이 곤란한 주철시료를 분석하고 정확성을 검토하고자 하였다. 알곤가스 압력, 전압, 방전시간 등 glow discharge lamp(GDL)의 방전조건을 최적화시키고 이 조건에서 두 종류의 주철 표준시료(BAS, LECO)에 대해 원소별 방출 복사선의 세기와 농도의 상관관계를 조사하였다. Mn, Si, P, S 등 대부분 원소의 검정곡선이 양호한 직선성을 보여 주었고 탄소의 경우에는 표준시료의 종류에 따라 절편과 기울기값이 미소하게 계통적인 차이를 나타내었다.