• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.64 no.4
• /
• pp.560-566
• /
• 2015

The self-consistent simulation based on the drift-diffusion approximation with anisotropic transport coefficients was performed. The RHCP-wave propagation was observed in MICP and this wave was refracted toward the high-density region. The calculated impedance seen from the antenna terminal shows that resistance component of MICP is a higher than that of ordinary ICP. Because of a higher resistance, the power transfer efficiency was improved to 95%. This property is practically important for large-size, low-pressure plasma sources because high resistance corresponds to high power-transfer efficiency and stable impedance matching characteristics.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2010.02a
• /
• pp.284-284
• /
• 2010

Currently, hydrogen has been produced by Steam Reforming or partial oxidation reforming processes mainly from oil, coal, and natural gas and results in the production of $CO_2$. However, these are influenced greatly on the green house effect of the earth. so it is important to find the new way to produce hydrogen utilizing water without producing any environmentally harmful by-products. In our research, we use microwave water plasma and photocatalyst to improve dissociation rate of water. At low pressure plasma, electron have high energy but density is low, so temperature of reactor is low. This may cause of recombination in the generated hydrogen and oxygen from splitting water. If it want to high dissociation rate of water, it is necessary to control of recombination of the hydrogen and oxygen using photocatalyst. We utilize the photocatalytic material($TiO_2$, ZnO) coated plasma reactor to use UV in the plasma. The quantity of hydrogen generated was measured by a Residual Gas Analyzer.

• Korean Journal of Materials Research
• /
• v.17 no.6
• /
• pp.331-336
• /
• 2007

The pure Mg powder compacts were successfully fabricated using SPS process. The machined chip powder showed flake shaped morphology with coarse surfaces, while gas atomized powders were spherical in morphology with smooth surfaces. In this study, SPS process was used to consolidate the pure Mg powder because this process allows high density consolidation in a short time. The results showed that increased sintering temperature from $350^{\circ}C$ to $500^{\circ}C$ with pressure of 30MPa, the maximum values of the density was increased from 98.1% to 99.8% of theoretical density, respectively. However, density of the sintered chip powders was higher than that of gas-atomized powder due to larger contact areas between particles.

• The Korean Journal of Food And Nutrition
• /
• v.26 no.3
• /
• pp.526-534
• /
• 2013

This study was conducted to examine the effects of Opuntia ficus-indica complex (OF) on the lipid metabolism, bile acid in feces, alanine aminotransferase (ALT) activity, aspatate aminotransferase (AST) activity, composition of urine and expression of cholesterol related mRNA in streptozotocin (STZ)-induced diabetic rats. Thirty two male Sprague-Dawley rats were randomly divided into non-diabetic control (NC), diabetic control (DC), diabetic OF of 2% (OF-2) and diabetic OF of 5% (OF-5), then each group was fed for 3 weeks. Plasma total cholesterol, non-esterified fatty acids (NEFA), total cholesterol, low density lipoprotein (LDL), very low density lipoprotein (VLDL) were decreased significantly (p<0.05) in OF-5 group compared to DC, but high density lipoprotein (HDL) was not changed. AST and ALT were also reduced and bile acid excretion was improved. Composition of urine in OF-5 was almost same in NC. The expression of cholesterol $7{\alpha}$-hydroxylase (CYP7A1), 3-hydroxy-3-methylglutaryl-coenzyme A reductase (HMG-CoA-R), Low density lipoprotein receptor (LDL-R) mRNA indicated that feeding OF have the effects of cholesterol decreation in plasma by synthesis of bile acid from cholesterol. These results provide experimental evidence about improved lipid metabolism of the OF feeding in the STZ-induced diabetic rats.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.15 no.9
• /
• pp.822-829
• /
• 2002

This paper deals with the distribution characteristics of the current density and axial magnetic flux density for each slits made on the contact electrode in the vacuum interrupter with axial magnetic field type using 3-dimension finite element analysis. It has been known that the presence of an axial magnetic field parallel to the current flow in the arc plasma can increase the high current breaking capacity of vacuum interrupter by carrying out the arc plasma from constricted mode to diffusion mode. The axial magnetic field is created of itself by current flow in the segments of coil electrode behind the contact electrode. The analyzed results show that if the slits are made in the contact electrode, they can increase the current density and axial magnetic flux density in the contact electrode surface and at the gap distance, which is due to decrease the effect of eddy currents flowing in the contact electrode. The phase shift due to eddy currents, defined 3s time difference between the maximum value of current and axial magnetic field, is decreased still more by increasing the number of slits made in the contact electrode at the center point of gap distance. These results demonstrate that 3-dimension finite element analysis has a great deal of merits in the development and evaluation of new electrode at the design of vacuum interrupter.

• The Transactions of the Korean Institute of Electrical Engineers C
• /
• v.53 no.1
• /
• pp.8-14
• /
• 2004

An O-mode Ultrashort Pulse Reflectometry (USPR) system has been designed and developed for the measurement of electron density profiles on the Sustained Spheromak Physics Experiment (SSPX) spheromak. In the original design of SSPX, peak densities were envisioned to be in the range of 0.5-3${\times}$10$^{14}$ cm$^{-3}$ . The total duration of formation and sustained discharges is typically ∼2 msec. Moreover, diagnostic access on SSPX is severely restricted. Such high density and short duration plasmas coupled with stringent diagnostic access are quite challenging for conventional reflectometer systems. In USPR, the SSPX diagnostic requirements have been successfully satisfied by employing up-converting mixers and monostatic horn/waveguide configuration. As a result, the USPR system has proven its applicability for the density measurement of a future fusion device. In the density profile measurements, the USPR system is capable of routinely generating density profiles with a temporal resolution of 57 $\mu$s. This paper presents details regarding the USPR fundamental principles, associated subsystems and laboratory tests as well as the experimental results obtained on SSPX

• Journal of Pharmacopuncture
• /
• v.17 no.2
• /
• pp.34-40
• /
• 2014

Objectives: The objective of the present study was to investigate the lipid and the antioxidant regulatory potential of a multigrain diet in laboratory animals with reference to lipid profiles, tissue lipid peroxidation and antioxidant status. Methods: Two types of diets, with or without addition of cholesterol, were used in the study - a commercial diet and a formulated multigrain diet (with Sorghum vulgare, Avena sativa, Pennisetum typhoideum, Oryza sativa, Eleusine coracana and Zea mays grains). After a 10-week period of feeding the diets to albino rats the plasma, liver and fecal lipid profiles and the hepatic and renal antioxidant status of the animals that were fed the commercial and the formulated diets (with and without cholesterol addition) were assessed. Results: The commercial diet supplemented with cholesterol elevated the levels of plasma total lipids, total cholesterol, triglycerides, low-density lipoprotein cholesterol (LDL-C), and very low-density lipoprotein cholesterol (VLDL-C), as well as the atherogenic index (AI). The high-density lipoprotein cholesterol (HDL-C) content and the antioxidant profiles (total ascorbic acid, superoxide dismutase, catalase, glutathione peroxidase reduced glutathione) declined along with increases in lipid peroxidation. The formulated diet (with and without addition of cholesterol) was found to be more efficient than the commercial diet in controlling plasma, hepatic and fecal lipid profiles, as well as hepatic and renal lipid peroxidation and antioxidant status, than of the hypercholesteremic animals. Conclusion: The multigrain diet used in the present study is effective in countering the hyperlipidemia and oxidative stress caused by high cholesterol intake.

• The Bulletin of The Korean Astronomical Society
• /
• v.39 no.1
• /
• pp.74.1-74.1
• /
• 2014

We have investigated a supra-arcade structure associated with an M1.6 flare, which occurred on the south-east limb in the 4th of November 2010. It is ob- served in extreme ultraviolet (EUV) with the Atmospheric Imaging Assembly (AIA) onboard the Solar Dynamics Observatory (SDO), microwaves at 17 and 34 GHz with the Nobeyama Radioheliograph (NoRH), and soft X-rays of 8-20 keV with the Reuven Ramaty High Energy Solar Spectroscopic Imager (RHESSI). Interestingly, we found exceptional properties of the supra-arcade thermal plasma from the AIA 131 A and the NoRH: 1) plasma upflows along large coronal loops and 2) enhancing microwave emission. RHESSI detected two soft X-ray sources, a broad one in the middle of supra-arcade structure and a bright one just above the flare-arcade. We estimated the number density and thermal energy for these two source regions during the decay phase of the flare. In the supra-arcade source, we found that there were increases of the thermal energy and the density at the early and the last stages, respectively. On the contrary, the density and thermal energy of the source on the top of the flare-arcade decreases throughout. The observed upflows imply that there is continuous energy supply into the supra- arcade structure from below during the decay phase of the flare. It is hard to be explained by the standard flare model in which the energy release site is located high in corona. Thus, we suggest that the potential candidate as the energy source for the hot supra-arcade structure is the flare-arcade which has exhibited a predominant emission throughout.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2016.02a
• /
• pp.295-295
• /
• 2016

Recently, TCO films with low carrier concentration, high mobility and high work function are proposed beneficial as front electrode in HIT solar cell due to free-carrier absorption in NIR wavelength region and low Schottky barrier height in the front TCO/a-Si:H(p) interface. We report high transmittance and work function zirconium-doped indium tin oxide (ITO:Zr) films with various plasma (Ar/O2 and Ar) conditions. The role of (Ar/O2) plasma was to enhance the work function of the ITO:Zr films whereas the pure Ar plasma based ITO:Zr showed good electrical properties. The RF magnetron sputtered ITO:Zr films with low resistivity and high transmittance were employed as front electrode in HIT solar cells, yield the best performance of 18.15% with an open-circuit voltage of 710 eV and current density of 34.63 mA/cm2. The high work function ITO:Zr films can be used to modify the front barrier height of HIT solar cell.

• Journal of the Korean Vacuum Society
• /
• v.7 no.4
• /
• pp.374-380
• /
• 1998

Radical and ion densities in a $CF_4$plasma have been calculated as a function of input power density, gas pressure and feed gas flow rate using simple 0 dimensional global model. Fluorine atom is found to be the most abundant neutral particle. Highly fragmented species such as CF and $CF^+$ become dominant neutral and ionic radical at the high power condition. As the pressure increase, ion density increases but ionization rate decreases due to the decrease in electron temperature. The fractional dissociation of $CF_4$feed gas decreases with pressure after increasing at the low pressure range. Electron density and temperature are almost independent of flow rate within calculation conditions studied. The fractional dissociation of $CF_4$monotonically decreases with flow rate, which results in increase in $CF_3$and decrease in CF density. The calculation results show that the $SiO_2$etch selectivity improvement correlates to the increase in the relative density of fluorocarbon ion and neutral radicals which has high C/F ratio.