• 한국세라믹학회지
• /
• 제28권9호
• /
• pp.689-695
• /
• 1991

Dielectric properties of Ba1-$\chi$Sr$\chi$Ti1-yCayO3-y ceramics, where Sr and Ca were doped to Ba-site and Ti-site within the range of 0 x 0.24 and 0 y 0.05, respectively, were investigated. The substitution of Ca for Ti, which maintained the high resistivity of these formulations after sintering in a reducing atmosphere, was confirmed. Ca addition decreased the tetragonality c/a, increased the unit cell volume, and lowered Curie temperature, which were attributed to the occupancy of Ca2+ ions on Ti-sites. The lowering of Curie temperature by Ca addition was affected by the substitution of Sr for Ba-site; within 2 mol% of Ca, Curie temperature was lowered at a rate of 2$0^{\circ}C$ and 16$^{\circ}C$ per mol% of Ca at x=0 and x=0.08, respectively. Whereas the resistivity of the formulations without Ca was reduced to 107 {{{{ OMEGA }}cm, when sintered at low oxygen partial pressure of 10-9 MPa, the resistivity value higher than 1011 {{{{ OMEGA }}cm was maintained for the formulations containing Ca more than 0.5 mol%. Dielectric loss factor, tan$\delta$, was about 1% for most formulations.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 1999년도 추계학술대회 논문집
• /
• pp.33-36
• /
• 1999

In this paper, $Ba_{0.5}$Sr$_{0.5}$TiO$_3$ thin-films were prepared on Pt/Ti/Si0$_2$/Si substrates by RF magnetron sp-uttering method. We investigated electric and dielectric properties of BST thin-films with various ann-ealing temperature using in-sute RTA. Deposition conditions of BST films were set substrate temperat-ure, 30$0^{\circ}C$ and working gas ratio, Ar:O$_2$=90:10. After BST films deposited, we fabricated a capacitor of MIM structure with Al top electrode for measurement. Post-annealing using RTA performed at 40$0^{\circ}C$, $600^{\circ}C$, 80$0^{\circ}C$ for 60 sec, respectively. Also we exacted crystallization and composition of BST thin-films by XRD analysis. In measurement result, this capacitors showed a dielectric constant of about 200 at 1MHz and leakage current density of 5$\times$10$^{-8}$ A/$\textrm{cm}^2$ at 1.5V Microstructure of BST thin-films exhibited effective quality in low-temperature annealed 71ms than high-temperature annealed 71ms.s.s.

• 한국재료학회:학술대회논문집
• /
• 한국재료학회 2010년도 춘계학술발표대회
• /
• pp.48.2-48.2
• /
• 2010

The effect of additives as rare-earth in dielectric materials has been studied to meet the development trend in electronics on the miniaturization with increasing the capacitance of MLCCs (multi-layered ceramic capacitors). It was reported that the addition of rare-earth oxides in dielectrics would contribute to enhance dielectric properties and high temperature stability. Especially, dysprosium and thulium are well known to the representative elements functioned as selective substitution in barium titanate with perovskite structure. The effects of these additives on microstructure and electric properties were studied. The 0.8 mol% Dy doped $BaTiO_3$ and the 1.0 mol% Tm doped $BaTiO_3$ had the highest electric properties as optimized composition, respectively. According to the increase of rare-earth contents, the growth of abnormal grains was suppressed and pyrochlore phase was formed in more than solubility limits. Furthermore, the effect of two rare-earth elements co-doped $BaTiO_3$ on the dielectric properties and insulation resistance was investigated with different concentration. The dielectric specimens with $BaTiO_3-Dy_2O_3-Tm2O_3$ system were prepared by design of experiment for improving the electric properties and sintered at $1320^{\circ}C$ for 2h in a reducing atmosphere. The dielectric properties were evaluated from -55 to $125^{\circ}C$ (at $1KHz{\pm}10%$ and $1.0{\pm}0.2V$) and the insulation resistance was examined at 16V for 2 min. The morphology and crystallinity of the specimens were determined by microstructural and phase analysis.

• 한국결정성장학회지
• /
• 제6권2호
• /
• pp.155-165
• /
• 1996

Growth of $LiNbO_3$ single crystal by Czochralski method was carried out to study the piezoelectric effects. Piezoelectric coefficients and elastic compliances of the $LiNbO_3$ single crystal were determined by the resonance method of length-extentional mode of bar resonator from the room temperature up to $100^{\circ}C$. Two dielectric constants of $LiNbO_3$ were also determined by measuring the capacitance of the plate specimen. Measured constants were piezoelectric coefficients $d_{15},d_{22},d_{31},d_{33}$ elastic compliances $s^E_{11},s^E_{33},2s^E_{13}+2s^E_{44},s^E_{14}$ and dielectric constants $K^T_{11},K^T_{33}$. As temperature increased, elastic compliances changed very slowly while piezoelectric coeffiecients and dielectric constant $K^T_{33}$ changed very rapidly. Electromechanical coupling constant of zyw ($45^{\circ}C$)-bar was as high as 0.51 in room temperature and nearly constant up to $1000^{\circ}C$. The increase of piezoelectric coefficients was mainly due to the increase of dielectric permittivity.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2000년도 추계학술대회 논문집
• /
• pp.480-483
• /
• 2000

Polyimide is a well-known organic dielectric material, which has not only high chemical and thermal stability but also good electrical insulating and mechanical properties. In this research, the electrical properties of PI LB films were investigated at room temperature. At low electric field, ohmic conduction(I∝V) was observed and the calculated electrical conductivity was about 9.7$\times$10$^{-15}$ S/cm. At high electric field, conduction(I∝V$^2$) was observed and the conduction mechanism was explained by space charge limited region effect. The dielectric constant of LB film was about 7.5.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2005년도 추계학술대회 논문집 Vol.18
• /
• pp.220-223
• /
• 2005

We studied the effect of composition, processing, and sintering temperature on the microwave properties of $Mg_{3-x}Co_x(VO_4)_2$ system which is applicable to LTCC. When $Mg_{3-x}Co_x(VO_4)_2$ was fabricated by solid-state reaction process and sintered at the temperature range of $800\sim910^{\circ}C$, it was found that the optimum composition of x was 2 at which microwave properties of 910$^{\circ}C$-sintered one were as follows: $Q\times f_0\sim55,200GHz$ and $\varepsilon_r\sim10$. When $(MgCo_2)(VO_4)_2$ was fabricated by sol-gel process and sintered at 800$^{\circ}C$, $Q\timesf_0$was 34,400GHz which is much high compared to those fabricated by solid-state reaction process at the same sintering temperature.

• 한국세라믹학회지
• /
• 제18권1호
• /
• pp.13-22
• /
• 1981

This study is to investigate the effective mineralizer in the manufacture of forsterite porcelain as a high frequency insulator. A mixture of $Mg(OH)_2$. and $SiO_2$.($\alpha$-Quartz) corresponding to the molar ratio of 2.0 MgO: 1.0 $SiO_2$ was prepared from the materials of high purity. It was heated to 140$0^{\circ}C$ at the rate of 20$0^{\circ}C$/hr, which was kept constantly for 1 hour, and one has made chamotte after cooling. Six kinds of glasses were prepared by an 0.1 atomic equivalent of K ions substitution-Ba, Bi, Zn, Cd, Zr-to the basic K-glass (0.333 $K_2O$.1.14 $SiO_2$) and were melted approximately at 150$0^{\circ}C$. The forsterite bodies were provided by adding each glass (10, 15, 20, 25, 30%) to the forsterite chamotte, which was fired at 1320, 1360, 1400, 144$0^{\circ}C$. (1 hr). One has examined the physical and dielectric properties for the specimens. The results of the experiments are as follows; 1. As for water absorption: Bodies were better vitrified with an addition and temperature change of Ba, Bi, Zn-glasses. The specimen containing Cd-glass showed deviation of slow decreasing, where as K-glass was completely not vitrified. 2. Bodies containing Ba, Zn, Bi-glasses appeared comparatively high Modulus of Rupture at 136$0^{\circ}C$, while containing Zr-glass had the highest Modulus of Rupture as the addition changes remarkably at 140$0^{\circ}C$. 3. It was estimated that 20-25% glass present in a forsterite bodies were in good conditions as for physical properties. 4. Specimens of Ba, Bi, Zr-glasses were superior as for dielectric properties, where among Ba-glass was most excellent. 5. Dielectric constant commonly increases in a slight gradient as firing temperature rises. 6. The petrographic examination showed that the bodies containing Ba, Bi-glasses had fine crystals, and were observed distinctly large mosaic crystals in the Zn-glass.

• 한국진공학회:학술대회논문집
• /
• 한국진공학회 2016년도 제50회 동계 정기학술대회 초록집
• /
• pp.301.2-301.2
• /
• 2016

Metal-oxide thin-film transistors (TFTs) have gained a considerable interest in transparent electronics owing to their high optical transparency and outstanding electrical performance even in an amorphous state. Also, these metal-oxide materials can be solution-processed at a low temperature by using deep ultraviolet (DUV) induced photochemical activation allowing facile integration on flexible substrates [1]. In addition, high-dielectric constant (k) inorganic gate dielectrics are also of a great interest as a key element to lower the operating voltage and as well as the formation of coherent interface with the oxide semiconductors, which may lead to a considerable improvement in the TFT performance. In this study, we investigated the electrical properties of solution-processed high-k strontium-doped AlOx (Sr-AlOx) gate dielectrics. Using the Sr-AlOx as a gate dielectric, indium-gallium-zinc oxide (IGZO) TFTs were fabricated and their electrical properties are analyzed. We demonstrate IGZO TFTs with a 10-nm-thick Sr-AlOx gate dielectric which can be operated at a low voltage (~5 V).

• 한국정보디스플레이학회:학술대회논문집
• /
• 한국정보디스플레이학회 2000년도 제1회 학술대회 논문집
• /
• pp.181-182
• /
• 2000

The glass compositions of $PbO-SiO_2-B_2O_3$ system and $P_2O_5-PbO-ZnO$ system for the transparent dielectric materials for front panel and $P_2O_5-ZnO-BaO$ and $SiO_2-ZnO-B_2O_3$ for the reflective dielectric materials for back panel of PDP(Plasma Display Panel) were investigated. As a transparent dielectric materials for front panel, $PbO-SiO_2-B_2O_3$ glass showed good dielectric properties, high transparency and proper thermal expansion matching to soda-lime glass substrate. And the reflective dielectric materials for back panel were prepared from parent glass of $SiO_2-ZnO-B_2O_3$ system and oxide filler. It was found that these glass-ceramics are useful materials for reflective dielectric layers, as those have a similar thermal expansion to soda-lime glass plate, high reflectance, low sintering temperature.

• 한국전기전자재료학회논문지
• /
• 제23권3호
• /
• pp.211-215
• /
• 2010

Pulsed laser deposition is a very efficient technique for fabricating thin films of complex compounds. In the present work, $Bi_2O_3$-MgO-ZnO-$Nb_2O_5$ (BMZN) pyrochlore thin films were deposited on platinized Si substrates at various temperatures by using pulsed laser deposition technique. These films have been characterized by X-ray diffractometer (XRD), atomic force microscopy (AFM) to investigate their structural, morphological properties. MIM structure was manufactured to analyze di-electrical properties of BMZN thin films. XRD results reveal the thin films deposited at less than $400^{\circ}C$ show only amorphous phase, the crystallized thin films was observed when the thin films were prepared temperature at above $500^{\circ}C$. From AFM, it was known that the thin film grown at $400^{\circ}C$ is the densest. Dielectric constant increased with increasing temperature up to $400^{\circ}C$ at 100 kHz and dramatically decreased at the higher temperature. A aspect of dissipation factor was the exact opposite of dielectric constant. BMZN thin films grown at $400^{\circ}C$ exhibited a high dielectric constant of 60.9, a low dissipation factor of 0.007 at 100 kHz.