• Journal of Surface Science and Engineering
• /
• v.34 no.5
• /
• pp.378-383
• /
• 2001

An out line of the material process with using the atmospheric pressure glow plasma is described as follows : (1) TiO powder coating with SiO$_2$ (2) Surface treatment of Fluorinated polymers and (3) Surface cleaning of electronic circuit board with using splay type.

• Korean Circulation Journal
• /
• v.52 no.6
• /
• pp.475-477
• /
• 2022

• Journal of the Korean Association of Oral and Maxillofacial Surgeons
• /
• v.43 no.1
• /
• pp.49-52
• /
• 2017

Subcutaneous facial emphysema after dental treatment is an uncommon complication caused by the invasion of high-pressure air; in severe cases, it can spread to the neck, mediastinum, and thorax, resulting in cervical emphysema, pneumomediastinum, and pneumothorax. The present case showed subcutaneous cervicofacial emphysema with pneumomediastinum after class V restoration. The patient was fully recovered after eight days of conservative treatment. The cause of this case was the penetration of high-pressure air through the gingival sulcus, which had a weakened gingival attachment. This case indicated that dentists should be careful to prevent subcutaneous emphysema during common dental treatments using a high-speed hand piece and gingival retraction cord.

• Journal of Korean Academy of Nursing
• /
• v.48 no.1
• /
• pp.1-11
• /
• 2018

Purpose: The purpose of this study was to examine the effects of aromatherapy on stress responses, autonomic nervous system (ANS) activity, and blood pressure in patients hospitalized to receive coronary angiography (CAG). Methods: A non-equivalent control group with a pretest-posttest design was used. The subjects were patients admitted to the day angiography room to receive CAG at E University Hospital (34 in the experimental group and 30 in the control group). The experimental group treatment was inhalation of the aroma oil blended with lavender, ylang-ylang, and neroli at a ratio of 4:2:1 twice before and after CAG. The measurements of stress index, ANS activity, and blood pressure were performed 5 times as follows: at admission, at pre-CAG after treatment I, at post-CAG, 2 hours after treatment II, and 4 hours after treatment II. The data were analyzed using the Mann-Whitney U Test and repeated-measures analysis of variance. Results: Significant interactions in the high frequency of ANS (F=5.58, p=.005) were observed between group and time. Stress index (z=2.14, p=.016), systolic blood pressure (z=4.14, p<.005), and diastolic blood pressure (z=3.28, p=.001) were significantly different between the experimental and control groups after 4 hours of treatment II. Conclusion: The findings showed that aromatherapy was not effective before CAG, but was effective after CAG. Therefore, aromatherapy can be used as a nursing intervention for patients receiving CAG.

• The Korean Journal of Food And Nutrition
• /
• v.31 no.1
• /
• pp.135-142
• /
• 2018

We investigated the influence of germination and high hydrostatic pressure (HHP) treatment conditions on the conversion of functional compounds and antioxidant activity in adzuki bean. The adzuki bean germinated at $25^{\circ}C$ for three- or six-days, and was later subjected to HHP at 0.1, 50, 100, or 150 MPa for 24 h. The highest polyphenol content (5.36 mg gallic acid equivalents (GAE)/g) and flavonoid content (0.91 mg catechin equivalents (CE)/g) were observed after germination for six days and HHP treatment at 100 MPa for 24 h, respectively. The total phenolic acid contents increased with increasing applied pressure from 88.86 to $208.26{\mu}g/g$ (100MPa, 24h). Phenolic acids are divided into two categories; those that exhibit increased content upon HHP treatment, and those that exhibit decreased content. The increasing phenolic acids were gallic acid, chlorogenic acid, (+)-catechin, ${\rho}-coumaric$ acid, ferulic acid, heperidin, salicylic acid, protocatechuic acid, cinnamic acid, naringenin. The total anthocyanin content decreased with increasing applied pressure from 22.42 mg/100 g to 6.28 mg/100 g (150 MPa, 24 h). The highest ABTS radical scavenging activity (8.02 mg eq AA/g) and DPPH radical scavenging activity (1.22 eq Trolox/g) were observed after germination for six days and HHP treatment at 100MPa for 24h, respectively. These results suggested that the combination of HHP and germination can lead to improved functionality in adzuki bean.

• Transactions of Materials Processing
• /
• v.30 no.1
• /
• pp.43-48
• /
• 2021

The success of warm forming of Mg alloy sheet is greatly influenced by friction at elevated temperature, depending on the surface treatment of the tool. The tool coating affected the frictional characteristics of AZ31B Mg alloy sheet at elevated and room temperatures. The frictional behavior of the Mg alloy sheet at room temperature was not significantly affected by surface treatment conditions of the tool, but was significantly affected at elevated temperature. When the contact pressure is high, a few surface-treated tools exhibit a higher coefficient of friction than those without surface treatment. It is important to select the surface treatment conditions of the tool in order to ensure appropriate friction during warm forming of Mg alloy sheet.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2014.02a
• /
• pp.121.1-121.1
• /
• 2014

Recently, much attention has been given to plasma production under liquid and its applications [1]. However, most of plasma production techniques reported so far utilize high voltage dc, ac, rf or microwave power [2], where damage to discharge electrodes and small discharge volume are remained issues. As an alternative of plasma production method under liquid, we have proposed pulsed microwave excited plasma using slot antenna, where damage to the slot electrode can be minimized and plasma volume can be increased. We have also reported improvement of treatment efficiency with use of reduced-pressure condition during the discharge [3]. To realize low pressure conditions in liquid, various alternative technique can be considered. One possible technique is simultaneous injection of microwave power and ultrasonic wave. Ultrasonic wave induces pressure fluctuation with the wave propagation and is so far used for cavitation production in the water. We propose utilization of reduced pressure induced by ultrasonic cavitation for improvement of the plasma production. Correlation between the plasma production and the ultrasonic power will be discussed.

• Food Science of Animal Resources
• /
• v.32 no.1
• /
• pp.1-5
• /
• 2012

The objective of this study was to examine the effects of a combined treatment regarding antimicrobial food ingredients and high pressure processing (HP) on the inactivation efficiency of Escherichia coli and Listeria monocytogenes inoculated into ground pork. Ethanol extracted from garlic, leeks, onions, and ginger powder was prepared. Half of the prepared powder was irradiated at 5 kGy to see the effect of pasteurization before addition. The prepared food ingredients were added into radiation-sterilized ground pork (1%, w/w), and inoculated with E. coli and L. monocytogenes. The samples were vacuum-packed and applied with HP at 0.1 (control), 300, 450, and 600 MPa. Microbial log reduction increased with the increase of pressure up to 600 MPa. With minor exceptions, overall efficiency of HP treatment with regards to inactivation of pathogens increased. Inoculated microorganisms showed approximately 7-8 Log reductions by 600 MPa, except for L. monocytogenes treated with garlic (5.7 Log reductions). The E. coli reduction in ground pork mixed with ethanol extracted garlic showed the highest efficiency (1.86) compared to leeks (1.25-1.31), onions (1.17-1.44), and ginger (1.50-1.82) when treated at an HP of 450 MPa. There was no evidence for the advantage of pasteurization concerning the food ingredients before addition of antimicrobial food ingredients and HP. Results demonstrate that the combination of antimicrobial food ingredients and HP treatment may help improve the efficiency of sterilization in meat systems.

• The KSFM Journal of Fluid Machinery
• /
• v.19 no.3
• /
• pp.10-13
• /
• 2016

The wet-air oxidation in gravity pressure reactor is effective for organic waste treatment with energy saving under high pressure and high temperature. But its oxidation control is difficulty because its multi-phase flow characteristics is very complicated. The flow characteristics of an oxidizer feed section in the gravity pressure reactor were investigated using numerical method which are verified by comparison with experimental results. In this study, the results showed that the flow rate of oxidizer have an effect on the generation of bubble around feed section.

• Journal of Korean Society of Water and Wastewater
• /
• v.22 no.1
• /
• pp.141-148
• /
• 2008

This study was conducted to evaluate the effect of PAC(Powder Activated Carbon) retention time on stable operation of high concentration powered activated carbon(HCPAC-MBR) in the treatment of secondary domestic wastewater. The pilot scale HCPAC-MBR system was operated at two different SRTs, 25 days and 100 days. The main drawback of HCPAC-MBR system was the rapid increase of trans-membrane pressure. The increase rate of trans-membrane pressure was proportional to SRT value at constant flux. This result seemed to be caused by reduced amount of EPS adsorbed on the PAC in the reactor by decreasing the SRT of the PAC. The particle size of the PAC was also influenced by SRT. The PAC size was decreased as SRT was increased. The change of particle size could be one reason for the change of trans-membrane pressure. The pore volume in the cake-layer formed on the membrane surface became to be increased by reducing SRT, because the cake-layer was highly composed of the PAC. Therefore, increased pore volume might play a role to reduce the trans-membrane pressure. The removal rate of E260 and TOC was also inversely proportional to SRT value.