• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.24 no.12
• /
• pp.1678-1682
• /
• 2000

In this article, the concept of gradient thickness is further extended to characterize the gradient behavior of the thermal and momentum boundary layer near a solid surface. The gradient thickness can replace the use of the conventional of the Nusselt and Reynolds numbers in terms of the gradient thickness provides a much easier grasp of the physical and practical meaning of the processes involved. Although there is no urgent need to discard the concept of the conventional convective heat transfer coefficient, the concept of the gradient thickness is believed to serve an efficient tool in helping students understand physics.

• Korean Journal of Air-Conditioning and Refrigeration Engineering
• /
• v.3 no.1
• /
• pp.51-60
• /
• 1991

The aim of this study is to investigate the heat transfer characteristics in the transient cooling process of a high temperature wall. The slow transient cooling experiment was carried out with a copper block of high thermal capacity. The results of these experiments are as follows. 1. Temperature histories measured by the thermocouple, which is 0.99, 2.00, 2.99mm from the heat transfer surface showed monotonous during the cooling process. These variation are the curves of typical temperature histories in film-boiling, transition-boiling, and nucleate-boiling regions. 2. The temperature histories were measured by thermocouple installed in the copper block. The variations of the surface heat fluxes and surface temperature were computed from the numerical solution method TDMA from the measured temperature histories for radial position one dimensional heat transfer inverse problem. The boiling curves were found by the computed temperature histories. 3. The rewetting point which starts to change from film boiling to nucleate boiling is not connected with the mass velocity and it were found that the temperature of rewetting point indicated about $100^{\circ}C$. 4. The heat flux of rewetting point was about $10^5Kcal/m^2h$, at that time, the heat transfer coeficient indicated about $1000Kcal/m^2h^{\circ}C$ irrelevent to mass velocity. 5. The wall superheat decreases as the pressure increases. But I found that rewetting point appeared under higher condition in the wall temperature.