• Proceedings of the Korea Concrete Institute Conference
• /
• 2006.05b
• /
• pp.201-204
• /
• 2006

It should be noted that the critical chloride threshold level is not considered to be a unique value for all conditions. This value is dependent on concrete mix proportions, cement type and constituents, presence of admixtures, environmental factors, reinforcement surface conditions, and other factors. In this study, the accelerated corrosion test for reinforcing steel was conducted by electrochemical and cyclic wet and dry seawater method, respectively and during the test, corrosion monitoring by half-cell potential method was carried out to detect the time to initiation of corrosion for individual test specimen. For this purpose, lollypop and right hexahedron test specimens were made for 31%, 42%, and 50% of W/C, respectively, and then the accelerated corrosion test for reinforcing steel was executed. It was observed from the test that the time to initiation of corrosion was found to be different with the water-cement ratio and accelerated corrosion test method, respectively and the critical chloride threshold values were found to range from 0.91 to $1.47kg/m^3$.

• Journal of the Korean Vacuum Society
• /
• v.20 no.3
• /
• pp.205-210
• /
• 2011

Structural and electrochemical properties of spinel oxide $LiMn_2O_4$ thin films prepared by using a sol-gel method on Pt/Ti/$SiO_2$/Si substrates were investigated. When Li/Mn molar ratio of the film was smaller than 0.5, $Mn_2O_3$hase was found to coexist with $LiMn_2O_4$. Half-cell batteries fabricated using the $LiMn_2O_4$ films as the cathode were put into chargedischarge (C-D) cycles and the change in structural properties of the cathode after the cycles was examined by X-ray diffraction and Raman spectroscopy. As the C-D cycle number increases, the discharge capacity of pure $LiMn_2O_4$ battery gradually decreases, being reduced to 72% of the initial capacity at 300 cycles. Such capacity fading is attributable to the decrease in the number of $Li^+$ ions that return to the tetrahedral sites of the spinel structure during the discharge step and the resultant increase in $Mn^{4+}$ density in the film. Also, $Mn_2O_3$ phase gradually appeared in the film as the cycle number increases.

• Korean Journal of Veterinary Service
• /
• v.35 no.4
• /
• pp.295-305
• /
• 2012

The aim of this study was to isolate microorganisms from half milk samples of dairy goats by California mastitis test (CMT) during the lactation period and to further investigate the susceptibility of isolated organisms to antimicrobial drugs. From a total of 235 half milk samples with CMT scores of 2 or above from 366 dairy goats distributed throughout Jeonnam province, microorganisms were isolated from 198 (83.5%) samples either singly (99.0%) or in combination (1.0%). The most prevalent microorganism was the coagulase-negative Staphylococcus spp., (44.4%, n=88) followed by Staphylococcus aureus (24.2%, n=48), Escherichia coli (11.1%, n=22) and Streptococcus spp. (7.6%, n=15). Isolated bacteria also included Bacillus spp. (2.5%, n=5), Pseudomonas spp. (2.5%, n=5), Micrococcus spp. (1.5%, n=3), Corynebacterium spp. (1.5%, n=3), Enterococcus facium (1.0%, n=2), Morganella morganii (0.5%, n=1) and Streptococcus agalactiae (0.5%, n=1). During the summer season, a high prevalence of all microorganisms were observed in which Staphylococcus spp. (30.8%), Escherichia coli (8.6%), and Streptococcus spp. (5.6%) were among the most prevalent bacteria isolated. Staphylococcus spp. was also shown to be high in the winter (21.7%). In most samples, the presence of bacterial pathogens in goat milk led to the increase in the total somatic cell count (SCC). Most of the half milk samples of dairy goats with bacterial contamination showed SCC of ${\geq}1{\times}10^6cells/ml$ (90.4%). Minor pathogens (11.4%) were more detected from milk samples with SCC of < $1{\times}10^6cells/ml$ than major pathogens (4.1%), while the major pathogens tended to be higher from samples with SCC of ${\geq}3{\times}10^6cells/ml$. Susceptibility of these bacteria to 12 antimicrobial agents was tested by the Kirby-Bauer disc diffusion method. Results indicated that more than 90% of bacteria isolated from CMT 2+ dairy goat half milk samples were susceptible to trimethoprim/sulfamethoxazole, amoxicillin/clavulanic, enrofloxacin and cephalothin while they were resistant to tetracycline (44.7%).

• Bulletin of the Korean Chemical Society
• /
• v.33 no.9
• /
• pp.3025-3032
• /
• 2012

Carbon microcapsules containing silicon nanoparticles (Si NPs)-carbon nanotubes (CNTs) nanocomposite (Si-CNT@C) have been fabricated by a two step polymerization method. Silicon nanoparticles-carbon nanotubes (Si-CNT) nanohybrids were prepared with a wet-type beadsmill method. A polymer, which is easily removable by a thermal treatment (intermediate polymer) was polymerized on the outer surfaces of Si-CNT nanocomposites. Subsequently, another polymer, which can be carbonized by thermal heating (carbon precursor polymer) was incorporated onto the surfaces of pre-existing polymer layer. In this way, polymer precursor spheres containing Si-CNT nanohybrids were produced using a two step polymerization. The intermediate polymer must disappear during carbonization resulting in the formation of an internal free space. The carbon precursor polymer should transform to carbon shell to encapsulate remaining Si-CNT nanocomposites. Therefore, hollow carbon microcapsules containing Si-CNT nanocomposites could be obtained (Si-CNT@C). The successful fabrication was confirmed by scanning electron microscopy (SEM) and X-ray diffraction (XRD). These final materials were employed for anode performance improvement in lithium ion battery. The cyclic performances of these Si-CNT@C microcapsules were measured with a lithium battery half cell tests.

• Journal of Magnetics
• /
• v.19 no.1
• /
• pp.20-27
• /
• 2014

This study examined the relationships between protein expression and Poly ADP ribose polymerase in brain cell death in brains damaged by thrombotic stroke and treated with the Full Wave- Cockroft Walton (FWCW) method of Transcranial Magnetic Stimulation (TMS). The two-way switching element for TMS drove a half-bridge inverter of the current resonance of direct current voltage (+) and direct current voltage (-), and the experiment was conducted by stimulating the mice with thrombotic stroke through a range of pulses. Thrombotic stroke was caused of ligation of the common carotid artery of male SD mice, and blood reperfusion was conducted five minutes later. Protein expression was examined in immune reaction cells, which reacted to an antibody to Poly ADP ribose polymerase in the cerebrum cells, and western blotting. Observations of the PARP changes after thrombotic stroke showed that the number of Poly ADP ribose polymerase reactions were significantly lower (p < 0.05) in the group treated with TMS of the FWCW than the group with thrombotic stroke 24 hours after its onset. The application of FWCW-TMS helped prevent the necrosis of nerve cells and might prevent the brain damage that occurs as a result of thrombotic stroke, and improve the function recovery and disorder of brain cells.

• Journal of the Korean Vacuum Society
• /
• v.8 no.3B
• /
• pp.297-301
• /
• 1999

High quality CdTe single crystal for the solar cell fabrication was grown by vertical Bridgman method. The etch pits patterns of {111} surfaces of CdTe etched by Nakagawa solution was observed the {11} A composed of Cd atoms with typical triangle etch pits of pyramid mode. From the photoluminescence measurement of {111} A, we observed free exciton $(E_x)$ existing only high quality crystal and neutral acceptor bound exciton ($A^{\circ}$, X) having very strong peak intensity. Then, the full width at half maximum and binding energy of neutral acceptor bound exciton were 7 meV and 5.9 meV, respectively. By Haynes rule, and activation energy of impurity was 59meV. Therefore, the origins on impurity level acting as a neutral acceptor were associated Ag or Cu elements.

• Asian-Australasian Journal of Animal Sciences
• /
• v.12 no.7
• /
• pp.1142-1151
• /
• 1999

Today, laboratory animal production has decreased world-wide to half the number estimated in 1970 of more than 100 Mio. This is due to the cell-biological assays which replaced animal experimentation as a first allround method to solve biomedical problems. Animal experimentation remains the most significant experimental method for the study of higher organized physiological systems and their multifactorial connections. This requires maximal uniformity of all quantitative traits among the animals used for such studies (mainly mice and rats) and stability of these traits for reproducing such studies at any time world-wide. The success of the developed methods for the standardization of laboratory animals was analyzed and were found only partly be acceptable. Getting a higher degree of uniformity among standardized inbred animals is blocked by "intangible variance". This is caused by influences of ooplasm, shown by experimental twin and clone studies. Manipulation of this component of variance is essential in the future. - Genetic drifts impair the necessary stability of biological traits. There are a few disadvantages associated with the cryopreservation of embryos and other methods are required. - Dogs and cats were replaced by pigs as laboratory animals. A new line of animal production will evolve over the next 25 years with similarities to the present laboratory animal production, because in future pigs were used as donors for xenotransplants for men.

• Korean Journal of Fisheries and Aquatic Sciences
• /
• v.41 no.1
• /
• pp.68-72
• /
• 2008

The cellular viability of the human keratinocyte cell line HaCaT was compared after adding seaweed extracts to the culture medium. The viability was measured using a quick, quantitative, spectrophotometric crystal violet inclusion method. Of 36 common seaweed species tested, methanol extracts from Sargassum sagamianum and Gigartina tenella enhanced the viability of HaCaT cells by 1.6-fold, as compared to control cells, while methanol extracts from Dictyota dichotoma, Pachymeniopsis elliptica, and Enteromorpha linza decreased the viability to less than half that of controls.

• Corrosion Science and Technology
• /
• v.15 no.1
• /
• pp.18-27
• /
• 2016

In this study, the accelerated corrosion test by combined deteriorating action of salt damage and freeze-thaw was investigated. freeze-thaw cycle is one method for corrosion testing; corrosion initiation time was measured in four types of concrete samples, i.e., two samples mixed with fly ash (FA) and blast furnace slag (BS), and the other two samples having two water/cement ratio (W/C = 0.6, 0.35) without admixture (OPC60 and OPC35). The corrosion of rebar embedded in concrete occurred most quickly at the $30^{th}$ freeze-thaw cycle. Moreover, a corrosion monitoring method with a half-cell potential measurement and relative dynamic elastic modulus derived from resonant frequency measures was conducted simultaneously. The results indicated that the corrosion of rebar occurred when the relative dynamic elastic modulus was less than 60%. Therefore, dynamic elastic modulus can be used to detect corrosion of steel bar. The results of the accelerated corrosion test exhibited significant difference according to corrosion periods combined with each test condition. Consequently, the OPC60 showed the lowest corrosion resistance among the samples.

• Transactions of the Korean hydrogen and new energy society
• /
• v.3 no.2
• /
• pp.9-15
• /
• 1992

Electroless copper plating method using an alkaline bath have been employed in copper coating of the (LM)Ni4.5Co0.1MnO.2A10.2 hydrogen storage alloy powders for electrode preparation. The plating were conducted without any pretreatment of alloy powders. For the preparation of the electrodes, about 0.12g of the copper coated alloy powder (copper to alloy ratio 1/3 by weight) was compacted with pressure of 6 tons/cm2 at room temperature. The disk-type compacts had a diameter of 10mm and thickness of about 0.24mm. The electrode characteristics were examined through SEM observations and electrochemical measurements in a half cell. The electrochemical measurement showed that the maximum discharge capacity of the electrodes prepared by using alkaline bath were 245mAh per gram of coated alloy (327mAh per gram of alloy) and appeared a considerable degradation with increasing number of cycles. The decrease of the discharge capacity after 100 cycles was about 30% It can be suggested that, with a slight of improvement, this electroless copper plating method could be applied to the preparation of the rare earth-nickel based alloy electrode.