• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2009.06a
• /
• pp.321-322
• /
• 2009

Al doped ZnO films deposited on glass substrate using RF magnetron sputtering in Ar and $Ar+H_2$ gas ambient at $100^{\circ}C$. The films deposited in $Ar+H_2$ were hydrogen-annealed at the temperature of $150\sim300^{\circ}C$ for 1hr. The lowest resistivity of $4.25\times10^{-4}{\Omega}cm$ was obtained for the AZO film deposited in $Ar+H_2$ after hydrogen annealing at $300^{\circ}C$ for 1hr. The average transmittance is above 85% in the range of 400-1000 nm for all films. The absorption efficiency of solar cell was improved by using the optimized AZO films as a top electrode.

• Proceedings of the Korean Institute of Surface Engineering Conference
• /
• 2015.05a
• /
• pp.106-106
• /
• 2015

In this study, we investigated electrochemically formed nanotube shape on ternary Ti-25Ta-xHf alloys with Hf contents. Ti-25Ta-xHf (x=0~15 wt.%) alloys were manufactured by vacuum arc-melting furnace. The obtained ingots were homogenized in an argon atmosphere at $1050^{\circ}C$ for 2h and then water quenching. The specimens were cut from ingots to 4 mm thickness and first ground and polished using SiC paper (grades from #100 to #2000). The anodization treatments on Ti-25Nb-xHf alloys were carried out at room temperature for experiments. The formation of nanotubular film was conducted by electrochemical method in mixed electrolytes with 1 M $H_3PO_4$ + 0.8 wt. % NaF at 30 V for 2 h. The morphologies of nanotube depended on the Hf content in Ti-25Ta-xHf ternary system.

• Bulletin of the Korean Chemical Society
• /
• v.18 no.4
• /
• pp.379-384
• /
• 1997

High quality MCM-41 is prepared from a gel of molar composition SiO2:0.20 CTACl:0.18 TMAOH:25 H2O aged at 20 ℃ for 24 hours before crystallization lasting for 48 hours. The (110) and (200) peaks of XRD pattern of high quality MCM-41 are unusually well resolved and the FWHM (full-width-at-half-maximum) of the (100) peak is 0.13° for as-prepared MCM-41 and 0.21° for calcined one, which indicate well-developed crystals. The properties of the crystal depend on the source and concentration of the reactants and the gel aging time. There is no induction period in the course of the synthesis, which is conveniently monitored by pH measurement. Gel aging, during which a spatial distribution of silicate polyanions and micellar cations is established, is essential for preparing high quality MCM-41. Surfactants with the same cationic organic group but different counteranions change the crystallization behavior. Highly basic gel (pH=12.6) favours the lamellar product; the quality of MCM-41 is lower as insufficient TMAOH is available to dissolve the silica.

• Journal of the Korean Magnetics Society
• /
• v.5 no.5
• /
• pp.597-600
• /
• 1995

The effects of surface oxidation on magnetic properties were investigated at high frequencies (10k-100MHz) for $7-18\mu\textrm{m}$ thick $Co_{70}Fe_{5}Si_{15}B_{10}$ amorphous ribbons with controlled domain structure. Oxidation was accelerated by acid-treatment or anodic oxidation treatment, and the insulation layers were prepared on the surfaces of the ribbons. The acid-treatment was effective in improving permeability and magnetic loss. Although the anodic oxidation treatment was effective in both making oxide layer and thinning, the magnetic properties were not improved compared with the case of the acid-treatment.

• Journal of Korean Society of Occupational and Environmental Hygiene
• /
• v.29 no.3
• /
• pp.414-419
• /
• 2019

Objectives: The objective of this study was to evaluate the inhibitory effect of non-thermal dielectric barrier discharge (DBD) plasma by air volume against Mycobacterium tuberculosis (MTB). Methods: Plasma generators (TB-300, Shinyoung Airtec, Seongnam-si, Korea) were operated in a 2A type biosafety cabinet. The plasma generator was set to a wind flow rate of 14 ($80m^3/h$), 18 ($110m^3/h$), and 22 ($150m^3/h$), and exposure times were set to 0 hours, 3 hours, 6 hours, 9 hours, and 24 hours. Results: The inhibitory effects of plasma at air volume 14 with prolonged exposure time of three hours was 20%, 64% at six hours, 82.3% at nine hours, and 100% after 24 hours exposure. With air volume of 18, the inhibitory effects upon plasma exposure were 36% for three hours, and 100% from 24 hours. Greater air volume resulted in greater inhibition of tuberculosis bacterial growth. In particular, the maximum inhibitory effect (100%) was shown in air volume of 22 ($150m^3/h$) after three hours of plasma exposure. Conclusions: The results showed the correlating inhibitory effects of plasma on the growth of MTB in combination with increasing plasma exposure time and air volume.

• Korean Journal of Materials Research
• /
• v.22 no.4
• /
• pp.180-184
• /
• 2012

Nanostructures of ZnO, such as nanowires, nanorods, nanorings, and nanobelts have been actively studied and applied in electronic or optical devices owing to the increased surface to volume ratio and quantum confinement that they provide. ZnO seed layer (about 40 nm thick) was deposited on Si(100) substrate by RF magnetron sputtering with power of 60 W for 5 min. ZnO nanorods were grown on ZnO seed layer/Si(100) substrate at $95^{\circ}C$ for 5 hr by hydrothermal method with concentrations of $Zn(NO_3)_2{\cdot}6H_2O$ [ZNH] and $(CH_2)_6N_4$ [HMT] precursors ranging from 0.02M to 0.1M. We observed the microstructure, crystal structure, and photoluminescence of the nanorods. The ZnO nanorods grew with hexahedron shape to the c-axis at (002), and increased their diameter and length with the increase of precursor concentration. In 0.06 M and 0.08 M precursors, the mean aspect ratio values of ZnO nanorods were 6.8 and 6.5; also, ZnO nanorods had good crystal quality. Near band edge emission (NBE) and a deep level emission (DLE) were observed in all ZnO nanorod samples. The highest peak of NBE and the lower DLE appeared in 0.06 M precursor; however, the highest peak of DLE and the lower peak of NBE appeared in the 0.02 M precursor. It is possible to explain these phenomena as results of the better crystal quality and homogeneous shape of the nanorods in the precursor solution of 0.06 M, and as resulting from the bed crystal quality and the formation of Zn vacancies in the nanorods due to the lack of $Zn^{++}$ in the 0.02 M precursor.

• Korean Chemical Engineering Research
• /
• v.50 no.1
• /
• pp.11-17
• /
• 2012

Disinfection of Escherichia coli (E. coli) in drinking water was investigated by using $TiO_2$ and $TiO_2-SiO_2$ based photocatalyst prepared by sol-gel method. The disinfection test was carried out in an annular flow reactor with circulating sterile water containing the photocatalysts powder under UV-A irradiation. The disinfection activity was proportional to the anatase`s intensity of crystalline peak of the $TiO_2$ photocatalysts. 100% disinfection of E.coli without endotoxin was achieved with $TiO_2$ coated photocatalytic system under UV-A irradiation within 2 h. However, toxic endotoxine was exist in the disinfection of E.colithe under UV-C irradiation even though 100% disinfection of E.colithe within 30 min, which suggest that $TiO_2$ coated photocatalytic system with UV-A is useful tool for the disinfection of E.coli in drinking water.

• 한국신재생에너지학회:학술대회논문집
• /
• 2009.11a
• /
• pp.384-384
• /
• 2009

최근 태양전지 개발이 본격화 되면서 태양전지 웨이퍼 표면에서의 재결합에 의한 손실을 줄이고 반사도를 감소시키기 위한 ARC 개발이 활발히 진행되고 있다. 이를 위해 널리 사용하는 ARC 물질로 수소화된 실리콘 질화막이 있다. 수소화된 실리콘 질화막은 PECVD 법으로 저온에서 실리콘 기판 위에 증착 가능한 장점이 있다. 또한 실리콘 질화막의 광학적, 전기적인 특성은 화학적 조성비에 의해 결정되며 증착온도 가변에 따라 균일도 및 굴절률 조절을 가능케 하여 태양전지의 효율을 향상 시킬 수 있다. 따라서 본 연구에서는 수소화된 실리콘 질화막을 태양전지에 적용하기 위해 질소 가스 분위기에서 PECVD를 이용하여 증착하고 그 특성을 분석하였다. 박막은 0.8 Torr의 압력에서 $150^{\circ}C{\sim}450^{\circ}C$의 기판 온도로 증착되었으며 이때의 RF power은 100W ~ 300W로 가변 하였다. 증착된 박막은 1.94 에서 2.23의 폭넓은 굴절률 값을 가지고 있었다. $SiH_4/NH_3$ 가스 비의 증가에 따라 박막 두께와 굴절률이 감소함을 확인 할 수 있었다. 이는 $NH_3$ 가스의 상대적인 증가에 따라 Si 생성을 선행하는 $SiH_4$ 가스의 부분압이 제한되기 때문이고, 이러한 결과로 박막내에 질소 원자가 증가함에 따라 N-H 결합이 증가하여 n-rich인 박막 상태가 되기 때문으로 분석된다. 증착된 실리콘 질화막의 소수반송자 수명 측정 결과 굴절률 2.23인 박막의 경우 약 87 us의 수명을 나타냈으며, 굴절률이 1.94로 줄어듦에 따라 소수반송자 수명 역시 79 us로 감소하였다. 수소화된 실리콘 질화막은 n-rich 보다 Si-rich 인 경우 effective 반송자 수명을 증가시켜 표면 재결합 속도를 줄이는데 유용함을 확인하였다. 또한 증착온도가 증가할수록, RF power가 증가 할수록 소수반송자 수명 역시 증가하였다. 반사도의 경우 $SiH_4$의 비율이 증가할수록 반사도가 감소함을 확인 하였으며, 증착온도 증가에 따라, RF power 증가에 따라 반사도가 감소하였다. 결과적으로 $450^{\circ}C$의 기판온도와 300W의 RF power에서 증착된 실리콘 질화막의 경우 가장 우수한 전기적, 광학적 특성을 보여주었다.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.27 no.10
• /
• pp.96-100
• /
• 1990

The cordierite ($2MgO,2Al_{2}O_{3},5SiO_{2}$) is of great interest for packaging substrates of multilayer IC. The Cu layer was fabricated on the cordierite substrate by the screen printing method and the adhesion properties of the interfaces at the different cosintering conditions were studied. When cosinted in the $Ar+H_{2}O$atmosphere good adhesion was obtained and the heating was found out to be an important factor for the adhesion.

• Journal of the Korean Chemical Society
• /
• v.6 no.2
• /
• pp.176-197
• /
• 1962

Seasonal variations of chemical constituents of estuarine water at a definite station of the tidal flat in Guang Yang inlet have been determined for two days a month. The range and mean of the annual variations are as follows:Tidal variations through a year are as follows:1. Although the tidal value of pH is almost constant during one tidal cycle, it raises abruptly 0.1-0.2 intervals of pH value during the first period of flood.2. The lower values of chlorinity, magnesium and calcium contents have been determined the nearer the slack after ebb, and slightly higher during the first period of flood tide than the last of ebb. The tidal change of calcium contents is more remarkable than of magnesium.3. The higher per cent saturation values of dissolved oxygen, sometimes higher than 100 per cent, re determined the nearer the slack after ebb.4. The total nitrogen contents, relatively poor, varies accidentally during one tidal cycle, whereas phosphate-P and silicate-Si are rich at the slack after ebb and increase proportionally to the mixing percentage of fresh water. The average values, 52.2 and 18.5 of Si/P and N/P are greater than of the normal.5. The acid soluble iron contents, lower in winter than in summer, is also varies accidentally during one tidal cycle and the magnitude of the variation is large.6. The chemical composition considered from the value of Ca/Cl or Mg/Cl of estuarine water varies according to the chlorinity even at the high chlorinity of 18-19%.