• Journal of Ginseng Research
• /
• v.7 no.1
• /
• pp.52-62
• /
• 1983

This study was undertaken to investigate the influence of kinetin and 2, 4-dichlorophenoxyacetic acid on the rate of growth, the contents of RNA, DNA, and protein. And also the effect of plant growth regulator on isoperoxidases in callus derived from root (root-callus) and petiole (petiolecallus) was investigated. The rate of growth in petiole-callus was higher than the rootcallus at 0.1 mg/l kinetin and 1mgfl 2,4-D. At 1mgll kinetic, the rate of growth increased, but at high concentration the rate of growth decreased fast. The contents of RNA, DNA and protein also increased, but it did not coincide with the increase of the growth rate of callus. The isoperoxidases of callus grown at various amounts of 2,4-D and kinetic occurred in an almost fashion, but those of root-callus appeared different from those of petiole-callus.

• Transactions of the Korean Society of Mechanical Engineers
• /
• v.10 no.2
• /
• pp.208-214
• /
• 1986

To establish the evaluation of the fatigue crack growth behavior in 5083-O aluminum alloy, constant load-amplitude fatigue crack growth tests were carried out under the small scale yielding conditions. Crack length and closure of this material were measured by the compliance method using a clip-on gage. The main results obtained as follows: The fatigue crack growth rate against stress intensity factor range .DELTA.K exhibits the trilinear form with two transitions at the growth rate 5.5*10$^{-6}$ and 5.5*10$^{-5}$ mm/cycle, in the so-caled Region II. The trilinear form appears still in the plot of growth rate versus effective stress intensity factor range .DELTA. $K_{eff}$. Stress ratio R affects the relationship of crack growth rates versus .DELTA.K but does not affect the reation of crack growth rate versus .DELTA. $K_{eff}$. The experimental results indicate that the effective stress intensity range ratio U depends on the maximum stress intensity factor $K_{max}$, but not on the stress ratio R.o R.R.

• Journal of the Korean Ceramic Society
• /
• v.29 no.3
• /
• pp.189-194
• /
• 1992

In order to grow a 127.86$^{\circ}$rotated LiNbO3 single crystal with good characteristics of surface acoustic wave (SAW) up to 80 mm in diameter, the temperature gradient of furnace, the growth rate and the rotation rate of crystal were changed. We could grow a crystal which had few macro defects at the conditions of temperature gradient as 30~6$0^{\circ}C$/cm, growth rate as 5 mm/hr and rotation rate as 8 rpm. The experimental ranges of the growth conditions are as follows. Temperature gradient was varied from 20 to 20$0^{\circ}C$/cm, growth rate as 5~7 mm/hr and crystal rotation rate as 6~12rpm.

• Proceedings of the KSME Conference
• /
• 2003.11a
• /
• pp.67-72
• /
• 2003

Numerical calculation has been performed to investigate the effect of inlet configuration on the growth rate of GaN layer on the heated susceptor. The conventional single inlet, where the gas is mixed by force in the inlet, is compared with separated flow inlet. Two-parallel gas flow $H_{2}$ and $NH_{3}$ are separated by a plate with finite length which are also parallel to the susceptor. The effect of separated plate length, carrier gas and flow rate of each precursor on the mixing of reactant gases and growth rate were investigated. Furthermore the three dimensional model is employed to predict the transverse variation of growth rate.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.13 no.5
• /
• pp.247-253
• /
• 2003

In this study, a numerical analysis of the deposition of gallium arsenide from TMGa and arsine in a horizontal MOCVD reactor is performed to investigate the effect of inlet diffuser shape of reactor on the flow and deposition characteristics. The effects of two geometric parameters (diffuser angle, diffuser shape) on the growth rate, growth rate uniformity, flow uniformity and pressure loss are presented. As a results, it is found that the optimum linear diffuser angle is in the range of $50^{\circ}$∼$55^{\circ}$ and parabolic diffuser in the range of $40^{\circ}$∼$45^{\circ}$ from the viewpoint of growth rate uniformity, flow uniformity and average growth rate. It is also found that variation of diffuser angle has greater impact on growth rate uniformity than average growth rate particularly in parabolic diffuser.

• Korean Journal of Agricultural Science
• /
• v.51 no.1
• /
• pp.25-39
• /
• 2024

This study aimed to determine a method for restoring grasslands to forests in mountainous areas. The study was conducted in an area damaged by trampling due to construction activity and herding. Additionally, there were concerns of hindered tree growth due to the alpine region climate, characterized by the low temperatures, drying, and strong winds. Therefore, forest restoration treatments such as tillage, furrow, and shading were performed to improve growth conditions. From July 2021 to April 2023, soil temperature and moisture were monitored for each treatment plot, and changes in the initial growth and survival rate of Abies holophylla were investigated. Both soil temperature and soil moisture showed significantly higher values during the four seasons in the grassland-furrow treatment plot (p < 0.05). Compared to the grassland-control plot, the average soil temperature in winter was as high as 1.1℃, and the soil moisture in summer was as high as 20.3%. Additionally, the survival rate and relative growth rate were the largest in the grassland-furrow treatment plot. The survival rate was 87.5%, the relative growth rate in terms of height was 0.013, and the relative growth rate in terms of diameter at root collar was 0.023, indicating that furrow treatment had a positive effect on the initial survival and growth of seedlings. These results suggest that furrow treatment may be an appropriate restoration method when implementing forest restoration projects in areas where tree growth is challenged.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.10 no.4
• /
• pp.136-140
• /
• 2002

High temperature fatigue crack growth behavior of P92 and STS 316L steel were investigated under four load conditions using CT type specimens. Loading and unloading times for the low wave forms were combinations of 1 sec. and 50 sec., which were two symmetric wave forms and two unsymmetric wave forms. Their behaviors are characterized using ΔK parameter. In STS 316L, Crack growth rate generally increases as frequency decreases. However, sensitivity of the loading rate to crack growth rate was fecund to be far greater than that of the unloading time. It is because as loading time increases, creep occurs at crack tip causing the crack growth rate to increase. However creep does not occur at the crack tip even if the unloading time is increased. In P92 steel, crack growth rate showed same behavior as in STS 316L. But the increase in loading or unloading time made almost no difference in crack growth rate, suggesting that no significant creep occurs in P92 steel even though loading time increases. After conducting high temperature tensile tests and comparing high temperature fatigue crack growth rates under various wave forms, it was proved that P92 steel has not only good high temperature properties but also improved, better high temperature fatigue properties than STS 316L.

• The Journal of Asian Finance, Economics and Business
• /
• v.7 no.7
• /
• pp.229-239
• /
• 2020

This article aims to measure the impact of economic growth and urbanization on poverty reduction in Vietnam, and verify whether economic growth and urbanization will help reduce poverty rates. Data for this study are tabular data related to growth, urbanization and poverty at the provincial level for the period of nine years, from 2006 to 2014 provided by the Vietnam General Statistics Office and the Vietnam General Department of Customs. The level of economic growth and urbanization mentioned in the study is reflected in such indicators as GDP value, exports value, imports value, urbanization rate and employment rate. The authors used logistic regression models with fixed-effects and logistic regression models with random effects. With 5% confidence level tested by the Chi-Square test of Hausman trial with the fixed-effect model, research results show that: (1) factors with significant negative impact on the poverty rate include imports value, urbanization rate and, employment rate; (2) factors that do not affect the poverty rate include exports value and GDP value. Based on the research results, this study proposes a number of policy recommendations to help promote economic growth, to sustain the urbanization process, and to contribute directly and positively to poverty reduction in Vietnam.

• KSBB Journal
• /
• v.10 no.4
• /
• pp.455-460
• /
• 1995

Specific growth rate was controlled for the repression of acetic acid formation in the fed-batch fermentation of recombinant Escherichia coli. With controlled specific growth rate, we studied the effect of the specific growth rate on cell growth, glucose consumption, acetic acid formation, and the expression of recombinant protein (${\beta}$-lactamase). High specific growth rate caused the accumulation of glucose and acetic acid, and lowered the production of recombinant protein. However, the addition of methionine recovered the gene expression by alleviating the negative effect of acetic acid at high specific growth rate.

• Journal of Ecology and Environment
• /
• v.30 no.2
• /
• pp.127-133
• /
• 2007

The effects of water flow rate and phytoplankton concentration on the growth of the sandy shore clam Gafrarium tumidum was investigated in a laboratory flume study using a $3{\times}3$ factorial design. After 60 days, shell length, shell weight and tissue dry weight increased significantly with phytoplankton concentration. For the effect of flow rate, growth was faster when flow rate increased from low to medium level; further increases in flow rate, however, either did not sustain faster growth or resulted in a reduction in growth. The condition index (CI) of a standard-sized clam was significantly higher at low flow rate than at medium and high flow rates and was negatively correlated with phytoplankton concentration. The uncoupled growth of shell and tissue in response to flow rate and phytoplankton concentration may be adaptations to low food environments, so that energy can either be stored to sustain life or reserved for gametogenesis during the reproductive period.