• 제목/요약/키워드: Growth Rate

검색결과 12,491건 처리시간 0.039초

고려인삼(Panax ginseng C.A.Meyer) 조직배양에서 2.4-dichloro phenoxyacetic acid와 kinetin첨가가 Isoperoxidase 변이에 미치는 영향 (Effect of 2,4-Dichlorophenoxyacetic Acid and Kinetin on Peroxidase Isoenzymes in Ginseng(Panax ginseng C. A. Meyer) Callus Cultures)

  • 김명원;강영희
    • Journal of Ginseng Research
    • /
    • 제7권1호
    • /
    • pp.52-62
    • /
    • 1983
  • This study was undertaken to investigate the influence of kinetin and 2, 4-dichlorophenoxyacetic acid on the rate of growth, the contents of RNA, DNA, and protein. And also the effect of plant growth regulator on isoperoxidases in callus derived from root (root-callus) and petiole (petiolecallus) was investigated. The rate of growth in petiole-callus was higher than the rootcallus at 0.1 mg/l kinetin and 1mgfl 2,4-D. At 1mgll kinetic, the rate of growth increased, but at high concentration the rate of growth decreased fast. The contents of RNA, DNA and protein also increased, but it did not coincide with the increase of the growth rate of callus. The isoperoxidases of callus grown at various amounts of 2,4-D and kinetic occurred in an almost fashion, but those of root-callus appeared different from those of petiole-callus.

  • PDF

5083-0 알루미늄合金의 疲勞균열進展 擧動과 균열닫힘에 관한 硏究 (A study of Fatigue Crack Growth Behavior and Crack Closure in 5083-O Aluminum Alloy)

  • 박영조;김정규;김일현
    • 대한기계학회논문집
    • /
    • 제10권2호
    • /
    • pp.208-214
    • /
    • 1986
  • 본 연구에서는 균열 닫힘에 관한 연구의 일환으로 5083-O 알루미늄합금을 사용하고 소규모강복조건하에서 일정진폭하중피로시험을 시행하여 이 재료의 피로균열 진전속도와 균열닫힘에 관하여 검토하였다.

Czochralski법에 의한 $LiNbO_3$ 단결정 성장 (The Growth of LiNbO3 Crystals by Czochralski Technique)

  • 이상학;윤의박
    • 한국세라믹학회지
    • /
    • 제29권3호
    • /
    • pp.189-194
    • /
    • 1992
  • In order to grow a 127.86$^{\circ}$rotated LiNbO3 single crystal with good characteristics of surface acoustic wave (SAW) up to 80 mm in diameter, the temperature gradient of furnace, the growth rate and the rotation rate of crystal were changed. We could grow a crystal which had few macro defects at the conditions of temperature gradient as 30~6$0^{\circ}C$/cm, growth rate as 5 mm/hr and rotation rate as 8 rpm. The experimental ranges of the growth conditions are as follows. Temperature gradient was varied from 20 to 20$0^{\circ}C$/cm, growth rate as 5~7 mm/hr and crystal rotation rate as 6~12rpm.

  • PDF

MOCVD 반응로내 GaN 성장에 미치는 입구형상의 영향 (Effect of inlet configuration on the growth rate of GaN layer in a MOCVD reactor)

  • 윤성규;백병준;박복춘
    • 대한기계학회:학술대회논문집
    • /
    • 대한기계학회 2003년도 추계학술대회
    • /
    • pp.67-72
    • /
    • 2003
  • Numerical calculation has been performed to investigate the effect of inlet configuration on the growth rate of GaN layer on the heated susceptor. The conventional single inlet, where the gas is mixed by force in the inlet, is compared with separated flow inlet. Two-parallel gas flow $H_{2}$ and $NH_{3}$ are separated by a plate with finite length which are also parallel to the susceptor. The effect of separated plate length, carrier gas and flow rate of each precursor on the mixing of reactant gases and growth rate were investigated. Furthermore the three dimensional model is employed to predict the transverse variation of growth rate.

  • PDF

수평 화학기상증착 반응기의 입구형상 설계가 단결정 박막증착률 특성에 미치는 영향에 관한 수치적 연구 (Numerical study of the influence of inlet shape design of a horizontal MOCVD reactor on the characteristics of epitaxial layer growth)

  • 정수진;김소정
    • 한국결정성장학회지
    • /
    • 제13권5호
    • /
    • pp.247-253
    • /
    • 2003
  • 본 연구에서는 반응기의 유입 확대부의 형상이 반응기 내의 유동 및 증착특성에 미치는 영향을 연구하기 위하여 수평형 MOCVD 반응기에서 TMGa와 $AsH_3$로부터의 GaAs 증착에 관한 수치적 연구를 수행하였다. 두 개의 기하학적인자(확대각, 확대부 형상)가 증착률, 증착률 균일도. 유속 균일도, 압력강하에 미치는 영향을 연구하였다 웨이퍼 위에서의 증착률 균일도, 평균증착률, 유속 균일도를 고려한 결과, 직선형 확대부의 최적 확대각은 $50^{\circ}$$55^{\circ}$이며 포물선형 확대부의경우, $40^{\circ}$$45^{\circ}$이다. 또한 확대부의 확대각의 변화는 평균증착률 보다 증착률의 균일도에 큰 영향을 미치고 있음을 알 수 있으며 직선확대부보다 포물선형의 확대부에서 더 민감하게 나타남을 알 수 있었다.

Effect of forest restoration treatment on Abies holophylla growth and soil condition: Focusing on the Daegwallyeong alpine pastures

  • Ju-Eun Kim;Jeong-Hyeon Bae;So-Jin Kim;Ki-Hyung Park;Namin Koo;Won-Seok Kang;YuGyeong Jung
    • 농업과학연구
    • /
    • 제51권1호
    • /
    • pp.25-39
    • /
    • 2024
  • This study aimed to determine a method for restoring grasslands to forests in mountainous areas. The study was conducted in an area damaged by trampling due to construction activity and herding. Additionally, there were concerns of hindered tree growth due to the alpine region climate, characterized by the low temperatures, drying, and strong winds. Therefore, forest restoration treatments such as tillage, furrow, and shading were performed to improve growth conditions. From July 2021 to April 2023, soil temperature and moisture were monitored for each treatment plot, and changes in the initial growth and survival rate of Abies holophylla were investigated. Both soil temperature and soil moisture showed significantly higher values during the four seasons in the grassland-furrow treatment plot (p < 0.05). Compared to the grassland-control plot, the average soil temperature in winter was as high as 1.1℃, and the soil moisture in summer was as high as 20.3%. Additionally, the survival rate and relative growth rate were the largest in the grassland-furrow treatment plot. The survival rate was 87.5%, the relative growth rate in terms of height was 0.013, and the relative growth rate in terms of diameter at root collar was 0.023, indicating that furrow treatment had a positive effect on the initial survival and growth of seedlings. These results suggest that furrow treatment may be an appropriate restoration method when implementing forest restoration projects in areas where tree growth is challenged.

P92와 STS 316L강의 고온 피로 균열 성장에 미치는 하중 파형의 영향 (The Effect of Loading Waveform on the High Temperature Fatigue Crack Propagation in P92 and STS 316L Steel)

  • 김수영;임병수
    • 한국자동차공학회논문집
    • /
    • 제10권4호
    • /
    • pp.136-140
    • /
    • 2002
  • High temperature fatigue crack growth behavior of P92 and STS 316L steel were investigated under four load conditions using CT type specimens. Loading and unloading times for the low wave forms were combinations of 1 sec. and 50 sec., which were two symmetric wave forms and two unsymmetric wave forms. Their behaviors are characterized using ΔK parameter. In STS 316L, Crack growth rate generally increases as frequency decreases. However, sensitivity of the loading rate to crack growth rate was fecund to be far greater than that of the unloading time. It is because as loading time increases, creep occurs at crack tip causing the crack growth rate to increase. However creep does not occur at the crack tip even if the unloading time is increased. In P92 steel, crack growth rate showed same behavior as in STS 316L. But the increase in loading or unloading time made almost no difference in crack growth rate, suggesting that no significant creep occurs in P92 steel even though loading time increases. After conducting high temperature tensile tests and comparing high temperature fatigue crack growth rates under various wave forms, it was proved that P92 steel has not only good high temperature properties but also improved, better high temperature fatigue properties than STS 316L.

The Effect of Economic Growth and Urbanization on Poverty Reduction in Vietnam

  • NGUYEN, Huyen Thi Thanh;NGUYEN, Chau Van;NGUYEN, Cong Van
    • The Journal of Asian Finance, Economics and Business
    • /
    • 제7권7호
    • /
    • pp.229-239
    • /
    • 2020
  • This article aims to measure the impact of economic growth and urbanization on poverty reduction in Vietnam, and verify whether economic growth and urbanization will help reduce poverty rates. Data for this study are tabular data related to growth, urbanization and poverty at the provincial level for the period of nine years, from 2006 to 2014 provided by the Vietnam General Statistics Office and the Vietnam General Department of Customs. The level of economic growth and urbanization mentioned in the study is reflected in such indicators as GDP value, exports value, imports value, urbanization rate and employment rate. The authors used logistic regression models with fixed-effects and logistic regression models with random effects. With 5% confidence level tested by the Chi-Square test of Hausman trial with the fixed-effect model, research results show that: (1) factors with significant negative impact on the poverty rate include imports value, urbanization rate and, employment rate; (2) factors that do not affect the poverty rate include exports value and GDP value. Based on the research results, this study proposes a number of policy recommendations to help promote economic growth, to sustain the urbanization process, and to contribute directly and positively to poverty reduction in Vietnam.

초산 생성 및 비성장속도가 재조합 대장균 유가식 발효의 생산성에 미치는 영향 (Effect of Acetic Acid Formation and Specific Growth Rate on Productivity of Recombinant Escherichia coli Fed-Batch Fermentation)

  • 구태영;박태현
    • KSBB Journal
    • /
    • 제10권4호
    • /
    • pp.455-460
    • /
    • 1995
  • 재조합 대장균의 유가식 발효에서 초산 생성 억제를 위해 세포 비성장속도를 제어하였다. 세포 비성장속도가 알정한 값으로 제어되는 유가삭 발효를 수 행하여 세포 비성장속도에 따른 세포생장, 포도당 소모량, 초산 생성량 및 재조합 단백질인 H lactamase의 발현 등을 관찰하였다. 세포 비성장속 도의 제어값이 클수록, 포도당이 축척되고 초산 생 성이 늘어나며 재조합 단백질의 서l포당 발현율은 떨 졌다. 그러냐 높은 세포 비성장속도의 경우에도 m methionine을 첨가하여 초산의 저해작용을 경감시킴 으로써 단위세포당 발현율을 높은 값으로 회복시킬 수 있었다.

  • PDF

A Laboratory Study of the Effect of Phytoplankton Concentration, Water Flow and Their Interaction on the Growth of the Sandy Shore Suspension Feeding Clam Gafrarium tumidum

  • Shin, P.K.S.;Cheung, S.G.
    • Journal of Ecology and Environment
    • /
    • 제30권2호
    • /
    • pp.127-133
    • /
    • 2007
  • The effects of water flow rate and phytoplankton concentration on the growth of the sandy shore clam Gafrarium tumidum was investigated in a laboratory flume study using a $3{\times}3$ factorial design. After 60 days, shell length, shell weight and tissue dry weight increased significantly with phytoplankton concentration. For the effect of flow rate, growth was faster when flow rate increased from low to medium level; further increases in flow rate, however, either did not sustain faster growth or resulted in a reduction in growth. The condition index (CI) of a standard-sized clam was significantly higher at low flow rate than at medium and high flow rates and was negatively correlated with phytoplankton concentration. The uncoupled growth of shell and tissue in response to flow rate and phytoplankton concentration may be adaptations to low food environments, so that energy can either be stored to sustain life or reserved for gametogenesis during the reproductive period.