• 한국환경보건학회지
• /
• 제27권3호
• /
• pp.43-48
• /
• 2001

Terephthalic acid and ethylene glycol resulting form the weight-reduction process of polyester make trouble in the operation of activated sludge process. Also, polyester weight loss wastewater shows high pH, high organic strength and wide variation of organic loading. Therefore, this study was conducted in order to improve treatment efficiency by activated sludge process with Pseudomonas sp degrading components of polyester weight loss wastewater. The CO $D_{Mn}$ and BO $S_{5}$ of the waste wastewater were 560~3,000 mg/$\ell$ and 8000~3,000 mg/$\ell$, respectively. pH was 11.8~12.3. COD removal efficiency by activated sludge-coagulation process with Pseudomonas sp was 94.1~95.8% for 35 hr of hydraulic retention time. Total organic carbon removal efficiency was 97.1%. Ethylene glycol and terephthalic acid in the wastewater were completely degraded during 32 hr of hydraulic retention time.e.

• 대한의용생체공학회:의공학회지
• /
• 제12권1호
• /
• pp.57-62
• /
• 1991

ABA type block copolymers composed of poly($\gamma-benzyl$ L-glutamate) (PBLG) as the A component and poly (ethylene glycol) as the B component were obtained by polymerization of $\gamma-benzyl$ L-gletamate N -carboxyanhydride, initiated by amino groups at both ends of poly(ethylene glycol) . From circular dichroism measurements in ethylene dichloride solution as well as from infrared spectTa measurements in solid state, it was found that the polypep- tide block exists in the a-helical conformation, as in PBLG homopolymer. $Poly-N^5$ (3-hydroxypropyl glutamine) (PHPG)/poly(ethylene glycol)block copolymer hydrogel was obtained by the treatment of PBLG/PBG block copolymer with the mixture of 3-ammine-1-propanol and diamlnooctane. The water content of PHPG/PEG block copolymer hydrogel was about 80wt% when the concentration of crosslinking agent was below 5 mole % per polymer.

• Fibers and Polymers
• /
• 제5권3호
• /
• pp.230-233
• /
• 2004

The optimum conditions for durable press treatment of cotton fabrics using glyoxal as a nonformaldehyde crosslinking agent were investigated. Crosslinking reaction was conducted in the presence of different catalysts such as aluminum sulfate, magnesium chloride, or magnesium chloride-citric acid mixture at various mole ratios of catalyst to glyoxal. Aluminum sulfate was proven the most effective one among those used. Glycol addition into a glyoxal padding bath increased the wrinkle recovery angle(WRA) and whiteness of treated fabrics. The optimum mole ratio of glycol to glyoxal was 1:1. Diethylene glycol addition produced better overall performance to the glyoxal-crosslinked fabric compared to ethylene glycol addition.

• 한국응용과학기술학회지
• /
• 제26권3호
• /
• pp.306-316
• /
• 2009

In this study, block copolymer of polystyrene and polyethylene glycol methyl ether methacrylate(PEGMA) by ATRP(atom transfer radical polymerization) method was synthesized. 4 arm-molecule which contained halogen atom was synthesized for an initiator. With 4 arm-molecule monodispered polystyrene were synthesized by ATRP method. The molecular change of synthesized monodispersed polystyrene with respect to time was investigated and living polymer characteristic was confirmed. Block copolymer of polystyrene and polyethylene glycol methyl ether methacrylate(PEGMA) was synthesized by ATRP with macroinitiator which was synthesized from the monodispersed polystyrene(Mn=12000). The molecular weight of obtained PS-b-PEGMA was 22,000.

• 한국미생물·생명공학회지
• /
• 제20권2호
• /
• pp.190-195
• /
• 1992

Polythylene glycol/dextran 수성 2단계에서 polyethylene glycol의분자량과 농도가 증가할수록 체적비는 증가하고 분배계수는 감소하였다. 또한 dextran의 분자량이 증가할 수록 체적비는 감소하고 분배계수는 증가하였다. 한편 dextran의 농도가 증가할수록 체적비와 분배계수는 감소하였다.

• 한국수정란이식학회지
• /
• 제11권1호
• /
• pp.35-40
• /
• 1996

This study was carried out to select the best cryoprotectant and to establish optimal concentration of the cryoprotectant in ultrarapid freezing of mouse 4-cell embryos and morulae, respectively. We investigated survival of ultrarapid frozen embryos according to various cryoprotectants such as glycerol, ethylene glycol, propylene glycol and dimethyl sulfoxide (DMSO). Suvival of the embryos frozen at different concentrations (3.0, 4.0 and 5.0 M) of indivisual cryoprotectant was also tested. Preimplantation developmental rate (96.3%, 83/86) of 4-cell mouse embryos treated with 4.0 M ethylene glycol after ultrarapid freezing and thawing was higher than those of other cryoprotectants (glycerol, propylene glycol and DMSO). In the ultrarapid freezing of mouse morulae, the highest developmental rate (98.8%, 89 /90) of the embryos to blastocysts was shown in the group of 5.0 M glycerol. Thus, these results demonstrate that 4.0 M ethylene glycol and 5.0 M glycerol are optimal for ultrarapid freezing of 4-cell mouse embryos and morulae, respectively.

• 한국태양에너지학회 논문집
• /
• 제23권4호
• /
• pp.45-54
• /
• 2003

For cooling of double effect absorption heat pump system of solar heating source, analysis of thermodynamic design data has been done to find the property of Libr-water + ethylene Glycol mixture for working fluid by computer simulation. Derived thermodynamic design data, enthalpy based coefficient of performance and flow ratio for possible combinations of operating temperature for water - LiBr and Ethylene Glycol mixture ($H_2O$ : CHO ratio 10:1 by mole) by computer simulation are done. The obtained results, COP and mass flow ratio of the water - lithium bromide - ethylene glycol system, are compared with data for the water-Libr pair solution.

• 한국태양에너지학회 논문집
• /
• 제22권4호
• /
• pp.51-61
• /
• 2002

Analysis of thermodynamic design data of double effect solar absorption heat pump system for heating has been done to find the property of Libr-water + ethylene Glycol mixture for working fluid by computer simulation. Derived thermodynamic design data. enthalpy based coefficient of performance and flow ratio for possible combinations of operating temperature for water - LiBr and Ethylene Glycol mixture (H2O: CHO ratio 10:1 by mole) by computer simulation. The obtained results, COP and mass flow ratio of the water-lithium bromide-ethylene glycol system, are compared with data for the water-Libr pair solution.

• EDISON SW 활용 경진대회 논문집
• /
• 제5회(2016년)
• /
• pp.140-146
• /
• 2016

Using density functional Theory, we studied local structure of liquid ethylene glycol and 1,3-propanediol. For both liquid, making intramolecular hydrogen bonding is not preferred, because relative energy between with and without intramolecular hydrogen bond is only -1.95kcal/mol, which is far less than intermolecular hydrogen bonding energy, about -7.5kcal/mol. Also, hydrogen bond induce polarization of hydroxyl group and make $2^{nd}$ hydrogen bond more stronger. This effect was small in intramolecular hydrogen bond of ethylene glycol. When considering energy per hydrogen bond, making only one intermolecular hydrogen bond for ethylene glycol pair is energetically favored, while two intermolecular hydrogen bond can be formed in 1,3-propanediol pair.

• 한국전기전자재료학회논문지
• /
• 제17권6호
• /
• pp.608-614
• /
• 2004

The gel polymer electrolyte was prepared by radical polymerization using tetra(ethylene glycol) diacrylate and tri(ethylene glycol) dimethacrylate to investigate affect of the number of ethylene oxide. The gel polymer electrolyte showed good electrochemical stability up to 4.5 V vs. Li/Li and high ionic conductivity at various temperatures. The lithium-ion polymer batteries with the gel polymer electrolyte, tetra(ethylene glycol) diacrylate- and tri(ethylene glycol) dimethacrylate-based, also represented good electrochemical performances such as rate capability, low-temperature performances and cycleability. However, the cell with tri(ethylene glycol) dimethacrylate, which has three ethylene oxide, showed better electrochemical performance.