• Journal of Broadcast Engineering
• /
• v.25 no.6
• /
• pp.870-881
• /
• 2020

This paper presents cell ID (cell identity) detection schemes using PSS/SSS (primary synchronization signal/secondary synchronization signal) for 5G NR (new radio) system and evaluates the detection performance. In this paper, we consider two cell ID detection schemes, i.e. two-stage detection and joint detection schemes. The two-stage detection scheme consists of two stages which estimate a channel gain between a transmitter and receiver and detect the PSS and SSS sequences. The joint detection scheme jointly detects the PSS and SSS sequences. In addition, this paper presents coherent and non-coherent combining schemes. The coherent scheme calculates the correlation value for the total length of the given PSS and SSS sequences, and the non-coherent combining scheme calculates the correlation within each group by dividing the total length of the sequence into several groups and then combines them non-coherently. For the detection schemes considered in this paper, the detection error rates of PSS, SSS and overall cell ID are evaluated and compared through computer simulations. The simulation results show that the joint detection scheme outperforms the two-stage detection scheme for both coherent and non-coherent combining schemes, but the two-stage detection scheme can greatly reduce the computational complexity compared to the joint detection scheme. In addition, the non-coherent combining detection scheme shows better performance under the additive white Gaussian noise (AWGN), fixed, and mobile environments.

• The Proceeding of the Korean Institute of Electromagnetic Engineering and Science
• /
• v.3 no.2
• /
• pp.30-38
• /
• 1992

In this paper, in order to apply the $\pi$/4 shift QPSK to TCM, we propose the $\pi$/8 shift 8PSK modulation technique and the trellis-coded $\pi$/8 shift 8PSK performing signal set expansion and set partition by phase difference. In addition, the Viterbi decoder with branch metrics of the squared Euclidean distance of the first phase difference as well as the Lth phase difference is introduced in order to improve the bit error rate(BER) performance in differential detection of the trellis-coded $\pi$/8 shift 8 PSK. The proposed Viterbi decoder is conceptually the same as the sliding multiple de- tection by using the branch metric with first and Lth order phase difference. We investigate the performance of the uncoded .pi. /4 shift QPSK and the trellis-coded $\pi$/8 shift 8PSK with or without the Lth phase difference metric in an additive white Gaussian noise (AWGN) and Rayleigh fading channel using the Monte Carlo simulation. The study shows that the $\pi$/4 shift QPSK with the Trellis-code i. e. the trellis-coded $\pi$/8 shift 8PSK is an attractive scheme for power and bandlimited systems and especially, the Viterbi decoder with first and Lth phase difference metrics improves BER performance. Also, the next proposed algorithm can be used in the TC $\pi$/8 shift 8PSK as well as TC MDPSK.

• Journal of Communications and Networks
• /
• v.12 no.4
• /
• pp.289-307
• /
• 2010

The problem of model selection arises in a number of contexts, such as subset selection in linear regression, estimation of structures in graphical models, and signal denoising. This paper studies non-asymptotic model selection for the general case of arbitrary (random or deterministic) design matrices and arbitrary nonzero entries of the signal. In this regard, it generalizes the notion of incoherence in the existing literature on model selection and introduces two fundamental measures of coherence-termed as the worst-case coherence and the average coherence-among the columns of a design matrix. It utilizes these two measures of coherence to provide an in-depth analysis of a simple, model-order agnostic one-step thresholding (OST) algorithm for model selection and proves that OST is feasible for exact as well as partial model selection as long as the design matrix obeys an easily verifiable property, which is termed as the coherence property. One of the key insights offered by the ensuing analysis in this regard is that OST can successfully carry out model selection even when methods based on convex optimization such as the lasso fail due to the rank deficiency of the submatrices of the design matrix. In addition, the paper establishes that if the design matrix has reasonably small worst-case and average coherence then OST performs near-optimally when either (i) the energy of any nonzero entry of the signal is close to the average signal energy per nonzero entry or (ii) the signal-to-noise ratio in the measurement system is not too high. Finally, two other key contributions of the paper are that (i) it provides bounds on the average coherence of Gaussian matrices and Gabor frames, and (ii) it extends the results on model selection using OST to low-complexity, model-order agnostic recovery of sparse signals with arbitrary nonzero entries. In particular, this part of the analysis in the paper implies that an Alltop Gabor frame together with OST can successfully carry out model selection and recovery of sparse signals irrespective of the phases of the nonzero entries even if the number of nonzero entries scales almost linearly with the number of rows of the Alltop Gabor frame.

• Journal of the Korea Society of Computer and Information
• /
• v.16 no.12
• /
• pp.23-31
• /
• 2011

The simple bacteria cooperative optimization (sBCO) algorithm that we developed as one of optimization algorithms has shown relatively good performances, but their performances were limited by step-by-step movement of individuals at a time. In order to solve this problem, we proposed a new method that assigned a speed to each individual according to its rank and it was confirmed that it improved the performances of sBCO in some degree. In addition to the assigning of speed to the individuals, we employed a new mutation operation that most existing evolutionary algorithms used in order to enhance the performances of sBCO in this paper. A specific percent of bad individuals are mutated within an area that is proportion to the rank of the individual in the mutation operation. That is, Gaussian noise of large standard deviation is added as the fitness of individuals is low. From this, the probability that the individuals with lower ranks can be located far from its parent will be increased. This causes that the probability of falling into local optimum areas is decreased and the probability of fast escaping the local optimum areas is increased. From experimental results with four function optimization problems, we showed that the performances of sBCO with mutation operation and individual speed were increased. If the optimization function is quite complex, however, the performances are not always better. We should devise a new method for solving this problem as a further work.

• The Journal of Korea Institute of Information, Electronics, and Communication Technology
• /
• v.12 no.6
• /
• pp.612-618
• /
• 2019

In the unmanned vehicle industry, the market is exploding due to the rapid development of public and private demands along with the technological development of the 4th Industrial Revolution. In addition, unmanned mobiles are being used for communication services. In this paper, we analyzed the communication performance of unmanned aerial vehicle according to the characteristics of Doppler frequency. The Doppler frequency was calculated using the geometric model of the unmanned aerial vehicle, and the Doppler frequency of 10km, 30km, 300km, 1000km per hour and the BER performance by AWGN were measured by considering the unmanned high speed unmanned vehicle based on the position of the controller. The Doppler frequency model uses a Dent model and adds additive white Gaussian noise (AWGN) to check the bit errors of the transmitter and receiver. Low speed unmanned vehicles generally exhibited a BER performance of 0.2, while high speed unmanned vehicles generally exhibited a BER performance of 0.06. As the frequency band increases at the same speed, the BER performance increases, and when the speed increases in the same frequency band, the BER performance decreases. This is confirmed by the simulation results to predict theoretically predictable BER performance. In the frequency bands of 2.6 GHz, 5 GHz, and 28 GHz, the BER characteristics by Doppler frequency and the BER characteristics by controller function are verified. effect was confirmed.